• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.2A
• /
• pp.128-133
• /
• 2010

We investigate the optimal chip rate of power or rate adapted direct-sequence code division multiple access (DS/CDMA) communication systems in Nakagami fading channels. We find that the optimal chip rate that maximizes the spectral efficiency depends upon both the channel parameters, such as multipath intensity profile (MIP) and line-of-sight (LOS) component, and the adaptation scheme itself. With the rate adaptation, the optimal chip rate is less than $1/T_m$, irrespective of the channel parameters, where $1/T_m$ is multipath delay spread. This indicates that with the rate adaptation, correlation receiver achieves higher spectral efficiency than RAKE receiver. With the power adaptation, however, the optimal chip rate and the corresponding number of tabs in RAKE receiver are sensitive to MIP and LOS component.

• Proceedings of the IEEK Conference
• /
• 2000.06a
• /
• pp.69-72
• /
• 2000

This paper shows the more improved design of MRI receiver compared to conventional one based on Elscint Spectrometer. At first, the low-cost ADC is 16 bits, 3MHz sampling A/D converter Comparing to conventional one with signal bits of 14 bits, this device with those of 16 bits helps getting Improved the image resolution improved. If frequency is designed centering around 7.6 MHz to be satisfied in 10 MHz of maximum input bandwidth of ADC. For 1st demodulation, fixed IF is used for the purpose of the implementing multi nuclei system. Control parts & partial digital parts are integrated on one chip(FPGA). In DDC(Digital Down Converter), we got required bandwidth of LPF by controlling its decimation rate. With above considerations, we designed optimal receiver for high resolution imaging to be implemented through PC interface & experimental test of receiver of MRI after receiver's fabrication.

• ETRI Journal
• /
• v.46 no.2
• /
• pp.238-249
• /
• 2024

Equivalent-time sampling can improve measurement or sensing systems because it enables a broader frequency band and higher delay resolution for periodic signals with lower sampling rates than a Nyquist receiver. Meanwhile, a digital down-conversion (DDC) technique can be implemented using a straightforward radio frequency (RF) circuit. It avoids timing skew and in-phase/quadrature gain imbalance instead of requiring a high-speed analog-to-digital converter to sample an intermediate frequency (IF) signal. Therefore, when equivalent-time sampling and DDC techniques are combined, a significant synergy can be achieved. This study provides a parameter design methodology for optimal equivalent-time sampling using DDC.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.7
• /
• pp.1785-1796
• /
• 1998

This paper is concerned with the relationships between optimal number of wavelengths and tuning time in time division multiplexing(TDM) scheduling on wavelength division multiplexing(WDM) optical passive star networks. We assume that the traffic is nonuniform and each node has a tunable transmitter and a fixed receiver. Each node transmits spckets to all other nodes. Most of the earlier protocols on TDM based scheduling for WDM star networks [7, 8, etc.] use whold given wavelength chnnels. But in this paper, we investigate the optimal number of wavelengths that yidels minimum frame length when tuning time exists. It appears within the availble number of wavelengths that yields minimum frame length when tuning time exists. It appears within the available number of wavelengths. We analyze the relationships between optimal number of wavelengths and tuning time by experiments. We analyze the reationships between optimal number of wavelengths and tuning time by experiments. We also discuss on the possibility of reduction of frame length by increasing the number of nodes trans-mitters and receivers.

• Journal of the Korean Society of Physical Medicine
• /
• v.9 no.3
• /
• pp.301-305
• /
• 2014

PURPOSE: The purpose of this study was to determine the optimal thresholds of serum lipid level related to hypertension according to age in Korean adults. METHODS: In total, 564 adults who visited the health examine center in general hospital were included. The blood pressure and lipid profiles of low density lipoprotein cholesterol(LDL), high density lipoprotein cholesterol (HDL), triglyceride(TG) were measured. Receiver operating characteristic (ROC) curve were used to establish optimal thresholds between blood pressure and lipid profiles. RESULTS: The optimal TG cutoff value were 110.50(mg/dl) in the 18-39 and 81.50(mg/dl) in the 40-59 age group, and optimal cutoff value of LDL were 126.50(mg/dl) in the 40-59 age group and 111.00(mg/dl) in the 60 and over age group. There was a negative correlation between HDL and hypertension, a higher HDL decreased hypertension. The optimal cutoff value of HDL was 49.50(mg/dl) in the 18-39 age group. CONCLUSION: The thresholds of hypertension were lower in LDL and TG with aging. This result indicated that elderly people needs to concern more about their lipid profiles to maintain healthy cardiovascular function.

• Journal of Satellite, Information and Communications
• /
• v.11 no.2
• /
• pp.60-64
• /
• 2016

In this paper, we propose a scheme for MIMO beamforming for the backscatter communication using a multi-tag to improve the efficiency of energy harvesting and the BER of received signals. We obtain a normal channel information through a communication between the H-AP and multi-tag. The H-AP sets parameters for the transmission scenario of the spatial channel model (SCM) using the obtained channel information and generates a SCM channel information. Then, the H-AP transmits signals that have optimal transmission power to increase the signal-to-interference-plus-noise ratio (SINR) to each of tags. Tags perform a backscatter communication with signals. The receiver performs a time switching technique of energy harvesting using backscatter signals from the multi-tag. Simulation results demonstrate effectiveness of the proposed scheme, and the harvesting efficiency and BER at the receiver is greatly improved.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6C
• /
• pp.626-633
• /
• 2009

ISO/IEC/WD 24753 defines new modem specifications for a long-range RFID communications and application protocol for a sensor tag system. According to the standard, the frequency offset of the tag is 4%. In general wireless communications systems, it is known that a coherent receiver is superior to a non-coherent receiver. However, if the frequency offset is large, it is difficult to restore the original data accurately with a coherent receiver, and the performance of a coherent receiver is easily degraded. In this paper, a non-coherent receiver structure is adopted to solve the frequency offset problem of long-range RFID communications. We designed a frequency estimation block to find an optimal frequency from the received signal with 4% frequency offset and proposed a start frame delimiter (SFD) detection algorithm to determine the start position of the payload. The frequency estimation block finds the optimal frequency from the received signal using 9-correlators. And the SFD detection block searches the received signal to find the start position of the payload with dual correlator. We implemented a long-range RFID reader with the proposed methods and evaluated its performance in a wired/wireless test network. The implemented long-range RFID reader showed more superior performance than the commercial RFID reader in terms of recognition range.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.3
• /
• pp.558-564
• /
• 2016

The network interference gives positive and negative effects to security and QoS simultaneously by disturbing the decoding of receiver and eavesdropper. The transmission of artificial noise enables to indirectly control these contradicting effects. This paper proposed the secrecy enhancement technique via artificial noise with protected zones of transmitter and receiver and investigated its gain by using stochastic geometry. For given arbitrary artificial noise power ratio, we first analyzed connection outage probability and secrecy outage probability for four different scenarios (separated, overlapped, included secrecy protected zones- type A, B) according to distance and size of protected zones of the transmitter and receiver. We then derive the secrecy transmission rate and find the optimal artificial noise power ratio to maximize it. Finally, with numerical examples, we investigate the effects of the system parameters such as size of protected zones of transmitter and receiver on the optimal artificial noise power ratio.

• Bulletin of the Korean Mathematical Society
• /
• v.48 no.3
• /
• pp.523-537
• /
• 2011

A receiver operating characteristic (ROC) curve plots the true positive rate of a classier against its false positive rate, both of which are accuracy measures of the classier. The ROC curve has several interesting geometrical properties, including concavity which is a necessary condition for a classier to be optimal. In this paper, we study the nonparametric maximum likelihood estimator (NPMLE) of a concave ROC curve and its modification to reduce bias. We characterize the NPMLE as a solution to a geometric programming, a special type of a mathematical optimization problem. We find that the NPMLE is close to the convex hull of the empirical ROC curve and, thus, has smaller variance but positive bias at a given false positive rate. To reduce the bias, we propose a modification of the NPMLE which minimizes the $L_1$ distance from the empirical ROC curve. We numerically compare the finite sample performance of three estimators, the empirical ROC curve, the NMPLE, and the modified NPMLE. Finally, we apply the estimators to estimating the optimal ROC curve of the variance-threshold classier to segment a low depth of field image and to finding a diagnostic tool with multiple tests for detection of hemophilia A carrier.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.8
• /
• pp.3642-3646
• /
• 2012

In this paper, the bandwidth of the filters used in optical communication systems and systems for the correlation between the error probability has been studied. Preamplifier that occurs in the system error probability as a function of the sensitivity of the receiver on the receiver sensitivity was shown for the various error probability calculation is performed. In addition, the channel data rate on the probability of various errors, changes in the function of the optimal bandwidth for the receiver filter was calculated, as required to operate at optimal range of the filter bandwidth, data rate per channel in a 10Gb/s the range of when is between 0.2 and 3.5nm.