• Journal of Mechanical Science and Technology
• /
• 제18권4호
• /
• pp.640-648
• /
• 2004

This paper describes a new magnetization method for non-destructive testing with magneto-optical sensor (denoted as MO sensor) which have the following characteristic : high observation sensitivity, independence of the crack orientation, and precise imaging of a complex crack geometry such as multiple cracks. When a magnetic field is applied normally to the surface of a specimen which is significantly larger than its defects, approximately the same magnetic charge per unit area occurs on the surface of the specimen. If there is a crack in the specimen, magnetic charge per unit area has the same value at the bottom of the crack. The distribution of the vertical component of the magnetic flux density, B$\_$Z/, is almost uniform over the no-crack area (denoted as B$\_$Z,BASE/), while the magnetic flux density is smaller in the surroundings of the crack(denoted as B$\_$Z,CRACK/) If B$\_$Z, BASE/ is a bit larger than the saturated magnetic flux density of the MO sensor (B$\_$s/) , then small magnetic domains occur over the crack area and a large domain over the non-crack area because B$\_$Z,CRACK/ is smaller than B$\_$s/.

• 천문학회보
• /
• 제35권2호
• /
• pp.41.1-41.1
• /
• 2010

It has been suggested that merging plays an important role in the formation and the evolution of early-type galaxies. Optical-NIR color gradients of early-type galaxies in high density environments are found to be less steep than those in low density environment, hinting frequent merger activities in early-type galaxies in high density environment. In order to confirm if the flat color gradient is the result of dry merger, we decided to look deeply to find merging features and get their relation with color gradient. We selected samples which show extreme values of optical-NIR color gradients based on the data of previous study, and observed them at Maidanak observatory 1.5m telescope with long exposure. After masking out overlaid sources, our analysis reveals that these galaxies do not have extreme color gradient values. High degree sky flat technique was used during observation to aid discovery of faint, extended features. However, flatness of detector (SNUCAM) was good enough, so we could not see any marked improvement in image quality compared to those using normal sky flats. Additionally we noticed a feature that looks like merging tidal tail in the CFHT archival image, but this does not show up on the image we obtained. This demonstrates that flatness and correct sky estimation is very important when we look for faint merging features. In future we plan to enlarge the number of the sample.

• 한국통신학회논문지
• /
• 제34권2C호
• /
• pp.175-180
• /
• 2009

우수한 에러 정정 부호 기법인 LDPC(Low Density parity Check) 부호를 고밀도 광 기록 시스템에 적용하는 경우, 변조 부호 복호기는 연판정 채널 출력 검출기를 통과해 나온 정보 중에서 패리티 부분을 받아서 연판정 값을 출력해줘야 하는 알고리즘이 필요하다. 따라서 본 논문에서는 고밀도 광기록 채널에서 17PP 변조 부호에 대한 효과적인 연판정 입력 연판정 출력 런-길이 제한 부호의 복호 알고리즘을 제안하고, 이 때 LDPC 부호의 성능을 비교하였다. 그 결과 기존에 연구되었던 (1, 7) RLL을 이용한 연판정 입력 연판정 출력 복호 알고리즘 보다, 고밀도 광 기록 채널에서는, 제안한 17PP를 이용한 연판정 입력 연판정 출력 복호 알고리즘이 0.8dB 정도의 성능 이득이 있는 것을 알 수 있었다.

• Journal of Acupuncture Research
• /
• 제23권5호
• /
• pp.199-206
• /
• 2006

Objectives : The aim of this study was to investigate the effect of various electroacupuncture stimulation on neuronal nitric oxide synthase(nNOS) in cerebral cortex, brain stem, cerebellum of spontaneously hypertensive rats. Methods : We evaluated the changes of nNOS-positive neurons using a immunohistochemical method. The staining intensity of nNOS positive neurons was assessed in a quantitative fashion using a microdensitometrical method based on optical density by means of an image analyzer. Results : The average optical density of nNOS-positive neurons of 100 Hz (bipolar square wave 0.2 ms duration and 100 Hz frequency) electroacupuncture treatment group significantly decreased in most cortical areas comparison between the manual acupuncture and 2 Hz (bipolar square wave 0.2 ms duration and 2 Hz frequency) electroacupuncture groups. In the brain stem, the optical density of nNOS-positive neuron at superficial gray layer of the superior colliculus area, dorsolateral periaqueductal gray area and paralemniscal nucleus were same as cerebral cortex. Conclusion : We conclude that the morphological evidence for nNOS-positive neurons may be have regional change in cerebral cortex brain stem and cerebellum according to various electroacupuncture stimulations.

• 한국세라믹학회지
• /
• 제53권5호
• /
• pp.563-567
• /
• 2016

The structural properties of $HfO_2$ films could be improved by thermal treatment owing to their crystallization. We deposited $HfO_2$ films on sapphire by radio frequency (RF) magnetron sputtering, whose base vacuum pressure was lower than $4.5{\times}10^{-6}$ Pa, RF power was 100 W, working temperature was $200^{\circ}C$, working pressure was 3 mTorr, and the density of the active gas (Argon) was 20 sccm. After depositing the $HfO_2$ films, the samples were thermally treated by rapid thermal annealing (RTA) in $O_2$ ambient at different temperatures. Subsequently, the measured physical properties (structural, morphological, and optical) indicated that the crystallite size, refractive index at a wavelength of 632 nm, and packing density increased with rising temperatures. In particular, an $HfO_2$ film thermally treated at $800^{\circ}C$ in $O_2$ ambient had the highest refractive index of 2.0237 and packing density of 0.9638. The relation between optical and structural properties was also analyzed.

• Journal of Microbiology and Biotechnology
• /
• 제22권7호
• /
• pp.967-974
• /
• 2012

Cultivation of Spirulina platensis using ammonium salts or wastewater containing ammonium as alternative nitrogen sources is considered as a commercial way to reduce the production cost. In this research, by analyzing the relationship between biomass production and ammonium-N consumption in the fed-batch culture of Spirulina platensis using ammonium bicarbonate as a nitrogen nutrient source, an online adaptive control strategy based on optical density (OD) measurements for controlling ammonium feeding was presented. The ammonium concentration was successfully controlled between the cell growth inhibitory and limiting concentrations using this OD-based feedback feeding method. As a result, the maximum biomass concentration (2.98 g/l), productivity (0.237 g/l d), nitrogen-to-cell conversion factor (7.32 gX/gN), and contents of protein (64.1%) and chlorophyll (13.4mg/g) obtained by using the OD-based feedback feeding method were higher than those using the constant and variable feeding methods. The OD-based feedback feeding method could be recognized as an applicable way to control ammonium feeding and a benefit for Spirulina platensis cultivations.

• 열처리공학회지
• /
• 제9권4호
• /
• pp.271-280
• /
• 1996

This study has been performed to investigate into some effects of power density and traverse speed of laser beam on optical microstructure, hardness and wear characteristics of gray cast iron treated by laser surface hardening technique. Optical micrograph has shown that large martensite and a small amount of retained austenite appear in outermost surface layer with fine martensite in inside hardened zone. Hardness measurements have revealed that the range of maximun hardness value is $Hv=650{\pm}15$ and as the power density increases and the traverse speed decreses, the depth of hardened zone increases due to as increase in input power density. Wear test has exhibited that wear rasistance of laser surface hardened specimen is superier compared to that of untreated specimen under the condition of same load at a given sliding distance, showing that absorption results of an wxidized substance due to a heavy abrasion appear in untreated specimen. The amount of weight loss of laser surface hardened specimen with respect to sliding distance at a given load decreses with increasing traverse speed at a given power density and with increasing power density at a given traverse speed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.251-254
• /
• 2001

In this paper, we analyzed the properties change of electric wire when the thermal stress was applied to NFR-8 and FR-PVC 600[V] wire. Messurement is made of the attenuation of a light beam by smoke accumulating with in a closed chamber due to nonflaming pyrolytic decomposition and flaming combustion. Results are expressed in terms of specific optical density which is derived from a geometrical factor and the measured optical density a measurement characteristic of the concentration of smoke. Referenced documents were ASTM E662 standard test method for specific Ds genalated by solid materials. The furnace control system shall maintain the required irradiance level under steady-state condition with the chamber door closed of $2.5{\pm}0.04[w/cm^{2}]$ for 20 min. According to the results of the smoke density analysis of NFR-8 and FR-PVC the highest decomposition flaming smoke density range of NFR-8 and FR-PVC were 25.2 to 37.5 and 51.1 respectively. Nonflaming smoke density range of NFR-8 and FR-PVC were 100.4 to 112.2 and 126.5 to 398.8. The amount of carbon monoxide generated was found to be much higher in FR-PVC decomposition than in NFR-8 due to incomplete combustion of FR-PVC which has high content of carbon in compound.

• Journal of the Optical Society of Korea
• /
• 제13권1호
• /
• pp.42-47
• /
• 2009

The propagation of an intense laser pulse through an upward density-gradient plasma in a self-modulated laser wakefield acceleration (SM-LWFA) is investigated by using particle-in-cell (PIC) simulations. In the fully relativistic and kinetic PIC simulations, the relativistic and kinetic effects including Landau damping enhance the electron dephasing. This electron dephasing is the most important factor for limiting the energy of accelerated electrons. However, the electron dephasing, which is enhanced by relativistic and kinetic effects in the homogeneous plasma, can be forestalled through the detuning process arising from the longitudinal density gradient. Simulation results show that the detuning process can effectively maintain the coherence of the laser wake wave in the spatiotemporal wakefield pattern, hence considerable energy enhancement is achievable. The spatiotemporal profiles are analyzed for the detailed study on the relativistic and kinetic effects. In this paper, the optimum slope of the density gradient for increasing electron energy is presented for various laser intensities.

• 천문학회보
• /
• 제36권1호
• /
• pp.57.1-57.1
• /
• 2011

It has been suggested that merging plays an important role in the formation and the evolution of early-type galaxies (ETGs). Optical-NIR color gradients of ETGs in high density environments are found to be less steep than those of ETGs in low density environments, hinting frequent merger activities in ETGs in high density environments. In order to examine if the flat color gradients are the result of dry mergers, we studied the relations between merging features, color gradient, and environments of 281 low redshift ETGs selected from Sloan Digital Sky Survey (SDSS) Stripe82. The sample contains 222 relaxed ETGs, 38 ETGs with tidal features, 10 galaxies with dust features and 11 galaxies with tidal and dust features, and Near Infrared (NIR) images are taken from UKIRT Infrared Deep Sky Survey (UKIDSS) Large Area Survey (LAS). We find that r-K color gradients of field sample galaxies are steeper than those of sample ETGs within cluster environments. For the field sample galaxies, a relatively large number of galaxies with peculiar features contribute to the steeper color gradients, while the absence of these peculiar early-type galaxies make color gradients of the cluster sample galaxies intact. In high density environment, ETGs are already evolved and relaxed, resulting flat color gradients. However, in low density environments, a majority of ETGs undergone merging recently which makes the color gradients steep.