• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.4 no.3
• /
• pp.30-36
• /
• 1993

This paper presents the RAKE receiver over a multipath fading channel. This interference between the propagation paths in a multipath fading causes a serious degradation in the mobile communication environment. In order to derive the path interference and reduce the fading effect, the RAKE receiver is used. As a result, the RAKE receiver gives a better performance than the DS / SS receiver over a multipath fading channel.

• The Journal of the Acoustical Society of Korea
• /
• v.15 no.1E
• /
• pp.65-69
• /
• 1996

This paper presents an algorithm for multipath channel parameter estimation by an improved Prony method. This algorithm applies a modified regularized spectral estimation to the conventional SVD Prony method. This method requires no a priori information on the number of multipath. The performance of the proposed algorithm is almost the same as that of the SVD based multipath channel parameter estimation algorithm.

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.525-528
• /
• 2003

This paper describes the effective and rigorous analytic method of multipath effect which results from insufficient isolation characteristics between adjacent channels in communication payload system. It is very important to analyze the multipath effect for verifying the performance of transponder subsystem that especially is consist of multi channels. Finally the multipath effect are analyzed by calculating the GR and GDR for two adjacent channels of Ku-band transponder subsystem on the Communication & Broadcasting Satellite(CBS).

• Journal of the Korea Institute of Military Science and Technology
• /
• v.6 no.1
• /
• pp.59-67
• /
• 2003

Multipath is an inevitable error source in radio navigation system such as GPS, it causes signal tracking errors such as carrier tracking errors, code tracking errors. Since code tracking error is a dominant error in absolute positioning, this paper focuses on the improvement of code tracking performance. This paper proposes a method that detects the change of autocorrelation function's slope and mitigates the multipath error. Also, this paper shows the performance evaluation results by post-processing the digitized RF samples.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.3
• /
• pp.231-241
• /
• 2004

This paper drives the exact expression of bit error rate(BER) performance for groupwise iterative-multipath interference cancellation(GWI-MPIC) algorithm for cancelling multipath interference components in a coherent high-speed downlink packet access(HSDPA) system of W-CDMA downlink and the BER performance is evaluated by numerical analysis. The performance of GWI-MPIC is compared to the successive interference cancellation(SIC) algorithm for multipath components. From numerical results, the optimal average BER performance of weighting factor ${\beta}$$\_$h/ for interference cancellation is obtained at ‘${\beta}$$\_$h/=0.8’ and then this weighting factor is hereafter applied to other performance analysis. Numerical results showed that the average BER performance of GWI-MPIC algorithm is rapidly degraded at multipath L=6, but is revealed the good performance than that of SIC algorithm in terms of increasing the number of multipath. This results also indicated that the average BER performance is greatly degraded due to increasing interference power more than multicode K=8. The average BER performance of the proposed algorithm is superior to the performance of SIC algorithm about 3 ㏈ for processing gain PG=128 at multipath L=2 and Average BER=1.0${\times}$10$\^$-5/. And also, the results produced good performance in case of linear monotonic reduction of multipath fading channel gain than that of constant channel gain variation, because multipath fading channel gain which is arrived later is small.

• KIPS Transactions on Computer and Communication Systems
• /
• v.5 no.12
• /
• pp.447-454
• /
• 2016

The research on multipath routing has been studied to solve the problem of frequent path breakages due to node and link failures and to enhance data delivery reliability in wireless sensor networks. In the multipath routing, mobile sinks such as soldiers in battle fields and rescuers in disaster areas bring about new challenge for handling their mobility. The sink mobility requests new multipath construction from sources to mobile sinks according to their movement path. Since mobile sinks have continuous mobility, the existing multipath can be exploited to efficiently reconstruct to new positions of mobile sinks. However, the previous protocols do not address this issue. Thus, we proposed an efficient multipath reconstruction protocol called LGMR for mobile sinks in wireless sensor networks. The LGMR address three multipath reconstruction methods based on movement types of mobile sinks: a single hop movement-based local multipath reconstruction, a multiple hop movement-based local multipath reconstruction, and a multiple hop movement-based global multipath reconstruction. Simulation results showed that the LGMR has better performance than the previous protocol in terms of energy consumption and data delivery delay.

• International Journal of Control, Automation, and Systems
• /
• v.5 no.4
• /
• pp.388-396
• /
• 2007

This paper describes a multipath estimation method for Global Positioning System (GPS) dual frequency carrier phase measurements. Multipath is a major error source in high precision GPS applications, i.e., carrier phase measurements for precise positioning and attitude determinations. In order to estimate and remove multipath at carrier phase measurements, an array GPS antenna system has been used. The known geometry between the antennas is used to estimate multipath parameters. Dual frequency carrier phase measurements increase the redundancy of measurements, so it can reduce the number of antennas. The unscented Kalman filter (UKF) is recently applied to many areas to overcome some of the limitations of the extended Kalman filter (EKF) such as weakness to severe nonlinearity. This paper uses the UKF for estimating multipath parameters. A series of simulations were performed with GPS antenna arrays located on a straight line with one reflector. The geometry information of the antenna array reduces the number of estimated multipath parameters from four to three. Both the EKF and the UKF are used as estimation algorithms and the results of the EKF and the UKF are compared. When the initial parameters are far from true parameters, the UKF shows better performance than the EKF.

• KIISE Transactions on Computing Practices
• /
• v.23 no.2
• /
• pp.116-121
• /
• 2017

In wireless sensor networks, the multipath prefers energy efficient routing method due to the characteristic of low-power sensor which uses geographic method to transmit data packet through information of the neighbor nodes. However, when multipath meets the routing fail area called hole area, path overlap problem can occur, resulting in failed maintenance of disjoint multipath. To solve this problem, multipath research studies have been performed to exploit the modeling and detouring method in routing fail area by keeping the disjoint multipath. However, in an energy point of view, additional method like modeling can lead to a lot of energy consumption of sensor node. Moreover, lots of energy consumption of sensor node can shorten the life span of sensor network. In this study, we proposed an energy efficient geographic routing by keeping the disjoint multipath in routing fail area. The proposed scheme exploited the face routing using the geographic recovery method without additional method like modeling.

• Journal of Advanced Navigation Technology
• /
• v.18 no.3
• /
• pp.236-241
• /
• 2014

In a mobile ad hoc networks, multi-hop transmission is used to transfer data from source node to destination node and the routing protocol is the one of the important technical issues. The links between nodes can be unstable due to the changes of node location and channel conditions, and it can induce link error. To solve this problem, multipath routing was proposed. Multipath routing can reduce the data congestion and increase data throughput. In the multipath routing, however, each path can be interfered by the other path, and it can aggravate network performance. In this paper, we propose the multipath routing technique in the multi-rate MANET. The proposed multipath routing can avoid interference without the knowledge of node location. Simulation results show that the proposed multipath routing can reduce transmission delay and error.

• ETRI Journal
• /
• v.42 no.1
• /
• pp.108-117
• /
• 2020

This study proposes a robust range-only beacon mapping method for registering the locations of range-only beacons automatically. The proposed method deals with the multipath propagation of signals from range-only beacons using the range-only measurement association (RoMA) and an unscented Kalman filter (UKF). The RoMA initially predicts the candidate positions of a range-only beacon. The location of the range-only beacon is then updated using the UKF. With the proposed method, the locations of range-only beacons are accurately estimated in a multipath environment. The proposed method also provides the location uncertainty of each range-only beacon. Simulation results using the model for multipath propagation and experimental results in a real indoor environment verify the performance of the proposed method.