• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.9
• /
• pp.932-936
• /
• 2002

This paper has been studied a calibration techniques in CISPR A for 1 m monopole antenna factor in the frequency range below 30 MHz. The equivalent capacitance substitution method uses a dummy antenna in place of the actual rod element. Dummy antenna measure frequency from 150 kHz to 30 MHz and good results factor from 150 kHz to 25 MHz compare to using 1 m monopole antenna factor. It will be use to substitute dummy antenna factor for 1 m monopole antenna factor.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.6
• /
• pp.1754-1762
• /
• 2016

Finite difference analysis were applied to study the principle operation of monopole antenna for moisture determination in oil palm fruit at 2 GHz. The electromagnetic field interact with oil palm fruit on the interface between the antenna and oil palm fruit and cause a reflection. The reflection measurement is based on mismatch impedance or dielectric properties between two media. Reflection coefficient is used to quantify the level of reflection. The monopole antenna was made of RG405/U semi-rigid coaxial cable with an inner and outer diameter of 0.45 mm and 1.50 mm, respectively with 2.23 mm length of protruding conductor over 5.66 cm length of monopole antenna. This monopole antenna for moisture detection was compared with induced EMF method in terms of reflection coefficient at 2 GHz. The results show that the complex reflection coefficient measured using monopole antenna provides significant results to predict moisture content in oil palm fruit.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.61 no.3
• /
• pp.149-152
• /
• 2012

In this paper, a wideband monopole antenna with ring loop by modified ground plane is presented. The proposed antenna consist of monopole antenna, ring loop by ground plane. This antenna is fed CPW-fed and wide slot antenna of a novel structure for broadband characteristics is proposed. To enhance the impedance bandwidth of the wide slot antenna, we proposed the wide slot structure with CPW-fed which is combined with four ${\lambda}/2$ rectangular radiation modified monopole and inductively coupled. The measured impedance bandwidth is about 2.5 GHz(3.65~6.15 GHz) then less -10 dB.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.5
• /
• pp.135-141
• /
• 2020

This paper summarizes the data of a monopole antenna with a sleeve structure that can be applied in various ways. Sleeve monopole antennas have broadband characteristics and are used for multi-frequency applications. The sleeve monopole antenna is composed of a vertical conductor, which is a radiator, and a sleeve having the same structure as a coaxial cable. The sleeve acts as a radiator and an open stub. The length of the sleeve should be 1/3~2/3 of the total length of the antenna. A monopole antenna having a sleeve structure is applicable to a vehicle wiper antenna. In addition, the case of applying this antenna to a broadband sleeve antenna using a loading coil, a broadband printed sleeve monopole antenna for an ISM band, a gap sleeve and a double sleeve, and a UWB planar monopole antenna using half cutting was summarized and analyzed in terms of structure and broadband.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.8 no.6
• /
• pp.515-519
• /
• 2015

In this paper, we suggested the novel monopole antenna for dual band characteristics by a linear monopole antenna combined with crossed planar monopole antenna. The target frequency is ISM(Industrial Scientific Medical) 2.45GHz/5.8GHz. The distinctive features of the proposed antenna in this paper is based on the slit in the surface of a crossed planar monopole for the dual band characteristics and the omnidirectional radiation patterns. The compact size of the proposed antenna is $36mm{\times}5.4mm{\times}5.4mm$. According to the simulation results, the bandwidth, the reflection coefficients below -10dB, of 2.45GHz and 5.8GHz are 150MHz and 1.43GHz, respectively. Consequently the proposed antenna structures is apply to the antenna for dual band characteristics.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.10a
• /
• pp.564-566
• /
• 2012

In this paper, a design method for a compact broadband planar monopole antenna fed by coplanar waveguide (CPW) is studied. The proposed broadband monopole is optimized for terrestrial digital television (DTV) receiving. The monopole is fed by a CPW with 75-ohm characteristic impedance on an FR4 substrate and its size is $100mm{\times}200mm$. A pair of slit is appended for size reduction and an inductive stub is loaded for the impedance matching between the feedline and monopole. The optimized monopole antenna for DTV band (470-806 MHz) is fabricated on an FR4 substrate and tested experimentally to verify the results of this study.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.60 no.2
• /
• pp.53-55
• /
• 2011

The printed wide band monopole antenna having characteristics of dipole by modified coplanar wave guide(CPW) ground plane is presented. We are called a slot-arm printed monopole antenna and investigated the effect of the surface currents of the radiator on ground plane. The proposed antenna is treated as two asymmetric dipoles with the included angle of $90^{\circ}$ degrees which lie along Z-direction symmetrically. It is observed that the effect of the surface currents on the radiation patterns is similar to that of the corresponding dipole. The length and width of the ground plane correspond the radius and length of the dipole respectively. This approach is also valid to general printed monopole antennas. The simulation impedance bandwidth of the proposed antenna the range of 2.4 to 4.6 [GHz] for a voltage stand wave ratio (VSWR)${\leq}$2 and got pick gain of 6 [dBi]. So the proposed antenna is satisfied the requirement of the industry science medical (ISM) band operation.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.61 no.1
• /
• pp.5-9
• /
• 2012

In this paper, multi folded dual monopole antenna for WLAN communication of dual bend is designed and fabricated. The proposed multi folded dual monopole antenna are consisted of two folded rectangle loops by microstrip fed that is modified dual monopole antenna. Therefore, the outside rectangle loop structure of the proposed antenna is extended a dual monopole. The characteristics of the proposed antenna is analyzed return loss and radiation patterns by the FDTD tools. As a result a bandwidth of proposed antenna has about 0.82GHz from 2.0 to 2.82[GHz] and 0.7GHz from 5.46 to 6.16[GHz]. It is used WLAN communications of 2[GHz] and 5[GHz].

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.10
• /
• pp.1261-1268
• /
• 2019

In this paper, we present the analysis of a novel monopole antenna with a reflector. The proposed monopole antenna is printed on a TRF-45 substrate, and the reflector, which is positioned near the base of the antenna, is printed on the FR-4 substrate. Positioning the reflector near the base of the antenna was found to suppress current radiation toward the back of the monopole antenna. Comparative analysis of the proposed monopole antenna and a conventional monopole antenna without a reflector revealed that the bandwidths of the antenna with and without a reflector were 2.65 GHz and 2.88 GHz, respectively. Additionally, the antenna without a reflector was observed to have a bi-directional radiation pattern in the E-plane, and an omni-directional radiation pattern in the H-plane. However, only the antenna with a reflector was found to suppress back radiation, and provide non-uniform directional radiation in the E-plane and H-plane.

• Journal of information and communication convergence engineering
• /
• v.7 no.3
• /
• pp.263-267
• /
• 2009

Cylindrical monopole antenna is one of most promising candidates for multi-band applications such as PCS, WLAN, DMB, and UWB wireless services. In this research, we demonstrate that there exist two types of current distributions according to the exciting frequency in a double band cylindrical monopole antenna, in which double resonance is achieved by adjusting the coupling structure of the antenna base. The operating modes of current distributions are identified from CST software simulations, the standing wave mode in a lower band and the traveling wave mode in a higher band. Also it is noticed that the mode behavior is quite similar to a helical antenna, a standing-wave (resonance) mode and a traveling-wave (non-resonance) mode according to the electrical dimensions of antenna. The effective ranges for operating modes and design formulas of the double band antenna are derived from simulation and measured results.