• Geomechanics and Engineering
• /
• v.30 no.2
• /
• pp.139-151
• /
• 2022

The mechanical properties of expansive soil are very unstable, highly sensitive to water, and thus easy to cause major engineering accidents. In this paper, the expansive soil foundation pit project of the East Huada Square in the eastern suburb of Chengdu was studied, the moisture content of the expansive soil was considered as an important factor that affecting the mechanics properties of expansive soil and the stability of the non-equal-length double-row piles in the foundation pit support. Three groups of direct shear tests were carried out and the quantitative relationships between the moisture content and shear strength τ, cohesion c, internal friction angle φ were obtained. The effect of cohesion and internal friction angle on the maximum displacement and the maximum bending moment of piles were analyzed by the finite element software MIDAS/GTS (Geotechnical and Tunnel Analysis System). Results show that the higher the moisture content, the smaller the matrix suction, and the smaller the shear strength; the cohesion and the internal friction angle are exponentially related to the moisture content, and both are negatively correlated. The maximum displacement and the maximum bending moment of the non-equal length double-row piles decrease with the increase of the cohesion and the internal friction angle. When the cohesion is greater than 33 kPa or the internal friction angle is greater than 25.5°, the maximum displacement and maximum bending moment of the piles are relatively small, however, once crossing the points (the corresponding moisture content value is 24.4%), the maximum displacement and the maximum bending moment will increase significantly. Therefore, in order to ensure the stability and safety of the foundation pit support structure of the East Huada Square, the moisture content of the expansive soil should not exceed 24.4%.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2013.05a
• /
• pp.29-30
• /
• 2013

Steel corrosion is the most serious problem in RC structures. Even though patch repair method is normally applied in repair system, the effectiveness is not enough. Cathodic protection in active repair method to deteriorated RC structures. FEM model was developed to simulate the optimized cathodic protection condition. Iro oxidation, hydrogen evolution and oxygen reduction were considered to expect current distribution. Moisture content in concrete which can affect the electrolyte conductivity was used as initial condition.

• Preventive Nutrition and Food Science
• /
• v.20 no.3
• /
• pp.162-168
• /
• 2015

Lotus (Nelumbo nucifera Gaertn.) seed is widely used as a traditional medicine in countries of Asia. Among many functions of the lotus seed, one interesting activity is its skin protection from the sunlight and scar. In this study, we focused on the skin protective property of lotus seed tea against ultraviolet B (UVB) irradiation. Two groups of a hairless mouse model, water as control (water group) and lotus seed tea (LST group), were administrated a fluid drink water for six months. After 6 month of administration, UVB exposure was carried out to both groups for another 3 months. During and after the administration, the skin moisture content and the morphological and histopathological analyses through biopsy were carried out. Prior to UVB irradiation, no significant difference was discovered in the skin moisture content for the water group and LST group (P<0.05). However, drastic changes were observed after the UVB treatment. The LST group showed a clear evidence of skin protection compared to the control group (P<0.05). The moisture content, epidermal and horny layer thickness, and protein carbonyl values all revealed that the intake of the lotus seed tea enhanced protection against UVB exposure. As a result, the long-term intake of the lotus seed tea showed the effect of preventing loss of skin moisture, mitigating the formation of abnormal keratinocytes, and contributing to protein oxidation inhibition.

• Food Science of Animal Resources
• /
• v.34 no.1
• /
• pp.26-32
• /
• 2014

This study was conducted to examine the effects of eggshell membrane hydrolysates (ESMH) on the anti-inflammatory, anti-wrinkle, anti-microbial activity, and moisture-protection for cosmetic use. Whole ESMH (before fractionation), and fraction I (>10 kDa), fraction II (3-10 kDa), and fraction III (<3 kDa) of the hydrolysates were assessed in this experiment. As lipopolysaccharide (LPS) and IFN-${\gamma}$ caused the inflammation on Raw264.7 cell, whole ESMH and fraction I showed to be effective in inhibiting the induction of cell inflammation depending on the concentration, and also showed outstanding effect to suppress the skin inflammation. Fraction I inhibited collagenase and elastase activities to a greater extent than the other fractions, while all fractions had antibiotic effects at concentrations of 10 mg/disc and 20 mg/disc. In addition, it showed the moisture protection effects of skin on the holding amount and losing amount of moisture in upper-inner arm of the human body with a relatively low loss rate in skin, which confirmed that the hydrolyzed fractions of ESM helps to form the superior protective layer of moisture. It was concluded that ESMH fractions with different molecular weights, especially the 10 kDa fraction, have anti-lipopolysaccharide, anti-IFN-${\gamma}$-induced inflammation, anti-collagenase and elastase activities, and thus can be used as a cosmetic agent to protect skin.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.3
• /
• pp.690-698
• /
• 2016

In this paper, a study is carried out to investigate the dielectric, physical and chemical properties of Palm Oil (PO) and Coconut Oil (CO) under open thermal ageing condition. The type of PO used in this study is Refined Bleached and Deodorized Palm Oil (RBDPO) Olein. The ageing experiment was carried out at 85 ℃ and 115 ℃ for 1, 3, 5, 7 and 14 days. Several parameters were measured such as AC breakdown voltage, dielectric dissipation factor, relative permittivity, resistivity, viscosity, moisture and acidity throughout the ageing duration. Based on the study, it is found that there are no significant changes on the AC breakdown voltages and relative permittivities for both RBDPO and CO. At ageing temperature of 115℃, there are clear reduction trends of dielectric dissipation factor for CO and resistivities for most of RBDPO. On the other hand, no clear trends are observed for viscosities, moisture and acidities of RBDPO and CO throughout the ageing duration.

• Journal of Food Hygiene and Safety
• /
• v.32 no.4
• /
• pp.321-328
• /
• 2017

Fusarium graminearum is a mycotoxigenic plant pathogen, which could remain in harvested barley grains and produces mycotoxins at preferable conditions during storage. To elucidate the factors affecting contamination of Fusarium and Fusariotoxin in hulled barley during storage, three hulled barley grain samples were collected from Jeolla province. Moisture content of each sample was adjusted to 14% and 20%, respectively, then stored in two warehouses where temperature was controlled differently: one controlled below $12^{\circ}C$, and the other with no control. While monitoring temperature and relative humidity of warehouses hourly, grain moisture content, Fusarium occurrence, and mycotoxin level was analyzed at 1, 3, 6, and 12 month after storage. The average monthly temperature and relative humidity ranged $3{\sim}29^{\circ}C$, and 58~70% in warehouse without temperature control, whereas $3{\sim}13^{\circ}C$ and 62~74% in warehouse controlled below $12^{\circ}C$. Grain moisture content of the samples decreased in both warehouses except 14% samples which increased in the warehouse with temperature control. Fusarium frequency of the contaminated grains decreased continuously in the warehouse without temperature control. But in the warehouse below $12^{\circ}C$, Fusarium decreasing rate was slower because of high grain moisture content. In most samples, nivalenol was detected more in the warehouse without temperature control after 12 month but there was little difference after 1, 3, and 6 month. Therefore, it will be efficient to store hulled barley in the warehouse controlled below $12^{\circ}C$ to reduce Fusarium contamination when the barley is not dried properly. In addition, when storage period exceeds 12 month, it is recommended to store hulled barley in a warehouse controlled below $12^{\circ}C$ to reduce nivalenol contamination.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2014.05a
• /
• pp.212-213
• /
• 2014

In case of fire spray protection sheath, fire resisting capacity is assessed for each material and installation method according to fire-resistive construction recognition. This study reviews effects of the percentage of water content that exist in fire spray protection sheath during the assess process of fire resisting capacity on fire resisting capacity, and changes of the percentage of water content according to temperature conditions. As a result of exams, as curing temperature is higher and thickness of specimen is thinner, decrease of the percentage of water content becomes significant.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.11a
• /
• pp.545-548
• /
• 2003

The purpose of this study is measures vulcanization properties of matter by time of room temperature vulcanization synthetic rubber sheet and the evaluation adhesive properties tested by concrete surface moisture. Also, Its estimated reaction mechanism and adhesion performance between protection mortar and waterproofing layer. The results showed that vulcanization progressed in room temperature and adhesion intensity increased regardless of moisture condition.

• Journal of the Korean Wood Science and Technology
• /
• v.52 no.1
• /
• pp.70-86
• /
• 2024

Termites are a serious threat to wood-based products in Indonesia. This study investigated the termite resistant property of glulam made from polystyrene-modified wood. Three tropical fast-growing wood species, namely mangium (Acacia mangium), manii (Maesopsis eminii), and rubberwood (Hevea brasiliensis), were prepared for flat-sawn laminae. After getting air-dried condition, the laminae were impregnated with polystyrene using potassium peroxydisulphate as a catalyst followed by polymerization at 80℃. Polystyrene-impregnated and control glued-laminated lumbers (glulams) were manufactured, and solid wood was provided. Three wood species and three wood products with six replicates were exposed in a field in Bogor, Indonesia, for four months, and before the tests, their density and moisture content were measured. At the end of the field tests, the weight loss and protection levels of each test sample were determined. A completely randomized factorial design was used for data analysis. The weight percentage gains for mangium, manii, and rubberwood were 22.30%, 18.22%, and 10.44%, respectively. The results showed that manii belonged to low-density wood, whereas the other two woods were medium-density wood, and the moisture content was the ambient moisture content, typical of the Bogor area. Regarding weight loss and protection level, mangium was the most durable against subterranean termite attacks, followed by rubberwood and manii. Among the wood products, the polystyrene-impregnated glulam presented the highest durability, followed by the control glulam and solid wood. Therefore, mangium and rubberwood polystyrene-impregnated glulams are recommended for future product development.

• Journal of Convergence for Information Technology
• /
• v.12 no.3
• /
• pp.236-243
• /
• 2022

This study attempted to find the optimum amount of manuka extract ingredient with hair treatments in different manuka extract contents and examine its bleached hair protection effects. For this, the tensile strength and moisture level of the damaged hair were measured. In addition, hair conditions were analyzed, using SEM and FE-SEM. In terms of protection of bleached hair, all experimental groups (M1, M2, M3) were more effective than the control group (no manuka extract added) in tensile strength, moisture level, hair thickness and cuticle conditions. In particular, 'M3 (3% manuka extract)' revealed the largest hair protection effects. The above results confirm that Manuka extract-added hair treatments would be useful in protecting damaged hair as well as scalp as a cosmetic material. It is anticipated that there would be further studies on diverse chemical treatments with a much wider variety of samples.