• Proceedings of the KSME Conference
• /
• 2004.11a
• /
• pp.1166-1171
• /
• 2004

The combustion instability acts as a serious obstacle for the lean premixed combustion of gas turbine and even causes the fatal damage to the combustor and whole system. In this experiment, the pressure fluctuation is highly related to the stabilizing position of flame and fuel injection location. The fuel injection location is connected with the convection time of the fresh mixture, which is important time scale to refresh the mixtures near the flame stabilization location. The flame is extremely unstable when the alternative stabilization occurs and bulk mode frequency (${\sim}10Hz$) of pressure fluctuation is observed in this condition. It was found that the convection time scale of the fresh reactant coincided with the time scale of the bulk mode fluctuation. Hence this phenomenon results from the local equivalence ratio change caused by the pressure fluctuation induced by thermo-acoustic effects.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.5
• /
• pp.400-408
• /
• 2003

This paper investigates the vibration characteristics of steam generator (SG) U-tubes with defect. The operating SG shell-side flow field conditions for determining the fluidelastic instability parameters such as added mass are obtained from three-dimensional SG flow calculation. Modal analyses are performed for the U-tubes either with axial or circumferential flaw with different sizes. Special emphases are on the effects of flaw orientation and size on the modal and instability characteristics of tubes, which are expressed in terms of the natural frequency, corresponding mode shape and stability ratio. Also, addressed is the effect of the internal pressure on the vibration characteristics of the tube.

• Journal of Korean Association for Spatial Structures
• /
• v.20 no.2
• /
• pp.77-85
• /
• 2020

This paper examined the dynamic instability of a shallow arch according to the response characteristics when nearing critical loads. The frequency changing feathers of the time-domain increasing the loads are analyzed using Fast Fourier Transformation (FFT), while the response signal around the critical loads are analyzed using Hilbert-Huang Transformation (HHT). This study reveals that the models with an arch shape of h = 3 or higher exhibit buckling, which is very sensitive to the asymmetric initial conditions. Also, the critical buckling load increases as the shape increases, with its feather varying depending on the asymmetric initial conditions. Decomposition results show the decrease in predominant frequency before the threshold as the load increases, and the predominant period doubles at the critical level. In the vicinity of the critical level, sections rapidly manifest the displacement increase, with the changes in Instantaneous Frequency (IF) and Instant Energy (IE) becoming apparent.

• 한국연소학회:학술대회논문집
• /
• 2000.12a
• /
• pp.92-100
• /
• 2000

One method to analyse acoustic modes is proposed to predict the characteristics of acoustic instability in liquid rocket engine. It is based on the similarity between transverse acoustic modes and adopts two-dimensional axisymmetric geometry. Using this method, the first tangential mode in the prototype combustor can be analysed through the analysis of the first radial mode in the model combustor with doubled chamber diameter. Sample numerical calculation is demonstrated applying this method to sample rocket engine and thereby acoustic instabilities of the engine are investigated. The present results show a good agreement with the previous findings. The numerical analysis based on the proposed method is cost-effective and serves as the first approximation to the true solution.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 1995.10a
• /
• pp.185-190
• /
• 1995

In recent years, many researcher have been interested in the stability of a thin beam. Among them, Pai and Nayfeh[1] had investigated the nonplanar motion of the cantilever beam under lateral base excitation and chaotic motion, but this study is associated with internal resonance, i.e. one to one resonance. Also Cusumano[2] had made an experiment on a thin beam, called Elastica, under bending loads. In this experiment, he had shown that there exists out-of-plane motion, involving the bending and the torsional mode. Pak et al.[3] verified the validity of Cusumano's experimental works theoretically and defined the existence of Non-Local Mode(NLM), which is came out due to the instability of torsional mode and the corresponding aspect of motions by using the Normal Modes. Lee[4] studied on a thin beam under bending loads and investigated the routes to chaos by using forcing amplitude as a control parameter. In this paper, we are interested in the motion of a thin beam under torsional loads. Here the form of force based on the natural forcing function is used. Consequently, it is found that small torsional loads result in instability and in case that the forcing amplitude is increasing gradually, the motion appears in the form of dynamic double potential well, finally leads to complex motion. This phenomenon is investigated through the poincare map and time response. We also check that Harmonic Balance Method(H.B.M.) is a suitable tool to calculate the bifurcated modes.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2012.05a
• /
• pp.76-80
• /
• 2012

Uni-element preburners using a oxidizer-rich triplex injector have been designed and tested. During combustion tests 1L mode high-frequency instability of 1100 Hz and low-frequency instability of 100 Hz were observed. High-frequency instability has been suppressed by reducing chamber diameter and applying turbulent rings in combustion chamber. Recently, research to reduce low-frequency instability is in progress.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.59-60
• /
• 2017

Combustion instability of gas turbine is performed by adopting dynamic mode decomposition (DMD). The unstable frequencies are calculated and compared with FFT results. The damping coefficient derived from the DMD technique and FFT results were compared and analyzed. OH radical is measured by experimental work and fluctuation field is extracted and FTF was calculated at various points with DMD. The gains of FTF are changed depending on the extraction position of the heat release fluctuation field.

• Proceedings of the KSME Conference
• /
• 2001.06b
• /
• pp.283-288
• /
• 2001

This study provides analytical evaluation of the Dual-Ann Work Module. The current hydraulic system was modeled using the HyPneu and analyzed to find the cause of the instability. The cause of the instability was determined to be primarily an interacting involving the pilot operated check valves and the counterbalance valves for fail safe mode of operation. A new design concept was developed to eliminate the potential for unstable operation while adequately meeting the need for a fail-safe feature.

• 한국연소학회:학술대회논문집
• /
• 2015.12a
• /
• pp.115-116
• /
• 2015

In the present approach, the flame-acoustics interaction is represented by FDF (Flame Describing Function) which is a important source term in the Helmholtz' equation. In this study, the combustion instability is analyzed by the forced mode strategy with the measured FDF. Numerical results indicate that the present approach reasonably well predicts the essential features of the combustion instability characteristics in the lean premixed combustor under the gas-turbine like environment.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.15 no.4
• /
• pp.48-56
• /
• 2011

A Possibility of combustion instability on longitudinal mode has a high level at large scale of L/D. Solid propellant has a metal particle and a grain of control to pressure oscillation. Solid rocket motor in slotted-tube grain controls pressure oscillation of longitudinal mode. Slotted-tube grain restrains longitudinal 1st pressure oscillation. But cavity volume of aft. insulation ablation amplifies 2nd pressure o scillation by vortext shedding. A study has suppressed combustion instability and vortex shedding by modified 4 slotted tube solid rocket motor design.