• Metals and materials international
• /
• v.24 no.6
• /
• pp.1386-1393
• /
• 2018

The solubility of $TiO_2$ in $NaF-CaF_2-BaF_2$ ternary eutectic melts was investigated at the temperature range of $1025-1150^{\circ}C$. The least-squares equation was obtained from the relationship between the reciprocal temperature and the natural logarithm of the titanium concentration in the melts saturated with $TiO_2$. The corresponding partial molar enthalpy of dissolution of $TiO_2$ was found to be 188 kJ/mol. The titanium saturation concentration was 3.73 wt% at $1100^{\circ}C$. From the titanium concentration change with the added amount of $TiO_2$ at different holding time after a final stirring, it was found that not only complete dissolution of $TiO_2$ but also enough sedimentation of excessive $TiO_2$ should be guaranteed to obtain more reliable solubility data. The holding time of 10 h was found to be enough for the excessive $TiO_2$ particles to settle down in our experimental conditions. It is noteworthy that in case of adding $TiO_2$ in excess of its solubility, the $Ba_{1.12}(Ti_8O_{16})$ phase was observed at the lower and bottom of the solidified salt ingots.

• Journal of Magnetics
• /
• v.14 no.2
• /
• pp.80-85
• /
• 2009

The mineral dissolution sensor system using GMR-SV and glass/Mg(200 nm) was prepared and characterized. The magnetic field sensitivity of GMR-SV to microscopic magnetic variation was about 0.8%/Oe. The change that occurs when Mg-film dissolves in water, the solubility of water, which is one of the basic properties of mineral water, was sensed by measuring the subtle variation of an electric current. In the case of edible water with Mg mineral added, bubbles were generated on the surface of the Mg film in the first 45 minutes, and the number of drops that were dissolved more rapidly than with the tap and DI waters later reduced to zero. For the edible water samples that each had different mineral Mg concentrations, the Mg solubility speed significantly differed. After injecting Mg film into the edible water, the magnetoresistance of the output GMR-SV signal decreased from a maximum of $45.4\;{\Omega}$ to a minimum of $43.6\;{\Omega}$. The measurement time was within 1 min, giving the rate of change ${\Delta}R/{\Delta}t=0.18\;{\Omega}/s$. This measurement system can be applied to develop a mineral Mg solubility GMR-SV sensor that can be used to sense the change from edible water to reduced alkali.

• Restorative Dentistry and Endodontics
• /
• v.35 no.5
• /
• pp.344-352
• /
• 2010

Objectives: The purpose of this study was to determine the setting time, compressive strength, solubility, and pH of mineral trioxide aggregate (MTA) mixed with glass ionomer cement (GIC) and to compare these properties with those of MTA, GIC, IRM, and SuperEBA. Materials and Methods: Setting time, compressive strength, and solubility were determined according to the ISO 9917 or 6876 method. The pH of the test materials was determined using a pH meter with specified electrode for solid specimen. Results: The setting time of MTA mixed with GIC was significantly shorter than that of MTA. Compressive strength of MTA mixed with GIC was significantly lower than that of other materials at all time points for 7 days. Solubility of 1 : 1 and 2 : 1 specimen from MTA mixed with GIC was significantly higher than that of other materials. Solubility of 1 : 2 specimen was similar to that of MTA. The pH of MTA mixed with GIC was 2-4 immediately after mixing and increased to 5-7 after 1 day. Conclusions: The setting time of MTA mixed with GIC was improved compared with MTA. However, other properties such as compressive strength and pH proved to be inferior to those of MTA. To be clinically feasible, further investigation is necessary to find the proper mixing ratio in order to improve the drawbacks of MTA without impairing the pre-existing advantages and to assess the biocompatibility.

• Journal of the Korean earth science society
• /
• v.25 no.1
• /
• pp.39-47
• /
• 2004

In the FMAS system the effect of iron on alumina solubility in orthopyroxene has been determined by experiments with crystalline starting mixtures of garnet and orthopyroxene of known initial compositions at 20 kb, 975$^{\circ}C$ and 25 kb, 1,200$^{\circ}C$. These data have been modeled to develop a thermodynamic method for the calculation of Al$_{2}$O$_{3}$ in orthopyroxene as a function of P, T and composition. The direct application of the alumina solubility data in the MAS system to natural assemblages could lead to significant overestimation of pressure, probably by about 5kb for the relatively common garnet-lherzolites with abot 25 mol per cent Ca + Fe$^{2+}$ in garnet and about 1 wt. per cent Al$_{2}$O$_{3}$ in orthopyroxene since the effect of Fe is similar to that of Ca and Cr$^{3+}$in reducing the alumina solubility in orthopyroxene in equilibrum with garnet relative to that in the MAS system.

• Asian-Australasian Journal of Animal Sciences
• /
• v.12 no.8
• /
• pp.1277-1284
• /
• 1999

Eight feeds and their residues left after washing with tap water (water residue) or incubation in the rumen (rumen residues) were treated with hydrochloric acid, neutral detergent solution without EDTA (NDS) or both, and the release or sorption of minerals (Ca, Mg, P, Na, K, Cu and Zn) assessed. Six of the feeds were from Sri Lanka (Panicum maximum ecotype Guinea A, Glyricidia maculate, Artocarpus heterophyllus (jak leaves), untreated and urea-treated rice straw, and rice bran) and two from the Netherlands (maize silage and wheat straw). The initial concentration of mineral elements, the concentration of neutral detergent fibre (NDF) and the type of feed significantly influenced (p<0.01). The proportion of the mineral elements released or sorbed. In general, feeds with high NDF content (straws and guinea grass) sorbed Ca from tap water, or released less in the rumen, and within these feeds the extent of sorption varied with source of fibre. Acid or NDS treatment removed little of the sorbed Ca, but they removed much of the Mg from both water and rumen residues. Fibres of wheat straw and jak leaves showed an affinity for Mg in the rumen. All feeds and their water and rumen residues sorbed P and Na from NDS, and the extent of sorption varied with the initial concentrations of these elements and with the type of fibre. Acid treatment removed part of the sorbed Na, but not the P. The solubility of K was not affected by the content of NDF, the type of fibre or the initial concentration of K. All feeds and their residues, except for the rumen residues of rice bran sorbed Cu from tap water and in the rumen. The recovery of Cu in rumen residues declined from 353% to 147% after NDS treatment, and with some feeds (glyricidia and jak leaves) the recovery was below 100%. Acid treatment removed part of the Zn sorbed by the water and rumen residues, but the capacity of residues to retain Zn varied with the type of feed.

• Asian-Australasian Journal of Animal Sciences
• /
• v.2 no.4
• /
• pp.583-590
• /
• 1989

Increasing levels of ammonia-N in the rumen fluid used for in vitro incubation were achieved by supplementation of the ration of the donor cows with urea and by addition of urea either with or without glucose to the rumen fluid after collection. The ration of the donor animals consisted of wheat straw (80%) and maize silage (20%). During the second half of the experiment the basal ration was supplemented with a mineral mixture. Wheat straw, Guinea grass and two rice straw varieties were incubated with the various kinds of rumen fluid. Parameters studied were: solubility, apparent organic matter disappearance after 48 hours of incubation ($OMD_{48}$), rate of organic matter degradation from 0 to 24 hours of incubation ($k_1$) and from 24 to 95 hours ($k_2$). The concentration of ammonia-N in the rumen fluid at which 95% of the maximal $OMD_{48}$ and k1 were reached (88.2 and 100.0 mg/l) were independent of the feed. With regard to the $k_2$ the required ammonia-N concentration to reach 95% of the maximal $k_2$ differed per feed. Mineral supplementation increased the OMD48 and $k_1$, but not the solubility and $k_2$. Glucose addition in combination with urea had no beneficial effect compared to urea supplementation alone.

• Resources Recycling
• /
• v.29 no.4
• /
• pp.58-66
• /
• 2020

Carbonation (step I) and cryo-crystallization (crystallization at low temperature) (step II) were performed to synthesize Na compounds from sodium concentrated solution. In the step 1, the solubility and pH of carbon dioxide (95 wt.%) affecting carbonation could be changed by the variation of reaction temperature. The step II was performed at 2 ℃ after carbonation. The injection of carbon dioxide was carried out twice for the stable production and the saturated solubility of carbonate ions in solution. Firstly, we tried to inject CO₂ for controlling the solubility of CO₂ by changing the reaction temperature from 35 ℃ to 10 ℃, and the second injection was aimed at 10 ℃ for inducing nucleation of Na compound through carbonation after NaCl solution addition. In the cryo-crystallization step, the crystal growth of Na compounds could be induced by slowing the carbonation rate through reaction temperature change from 10 ℃ to 2 ℃. In this study, the effect on NaOH concentration was examined and the purity of Na compound was increased when 2M NaOH was used. In addition, the synthesized Na compounds were mostly rod-shaped and consisted of sodium carbonate or sodium carbonate with monohydrate.

• Asian-Australasian Journal of Animal Sciences
• /
• v.29 no.11
• /
• pp.1608-1615
• /
• 2016

This study was conducted to determine the solubility of copper (Cu) in two sources of copper(II) sulfate ($CuSO_4$) including monohydrate and pentahydrate and three sources of dicopper chloride trihydroxide (dCCTH) including ${\alpha}$-form (dCCTH-${\alpha}$), ${\beta}$-form (dCCTH-${\beta}$), and a mixture of ${\alpha}$- and ${\beta}$-form (dCCTH-${\alpha}{\beta}$) at different pH and a 3-step in vitro digestion assay for pigs. In Exp. 1, Cu sources were incubated in water-based buffers at pH 2.0, 3.0, 4.8, and 6.8 for 4 h using a shaking incubator at $39^{\circ}C$. The $CuSO_4$ sources were completely dissolved within 15 min except at pH 6.8. The solubility of Cu in dCCTH-${\alpha}$ was greater (p<0.05) than dCCTH-${\beta}$ but was not different from dCCTH-${\alpha}{\beta}$ during 3-h incubation at pH 2.0 and during 2-h incubation at pH 3.0. At pH 4.8, there were no significant differences in solubility of Cu in dCCTH sources. Copper in dCCTH sources were non-soluble at pH 6.8. In Exp. 2, the solubility of Cu was determined during the 3-step in vitro digestion assay for pigs. All sources of Cu were completely dissolved in step 1 which simulated digestion in the stomach. In Exp. 3, the solubility of Cu in experimental diets including a control diet and diets containing 250 mg/kg of additional Cu from five Cu sources was determined during the in vitro digestion assay. The solubility of Cu in diets containing additional Cu sources were greater (p<0.05) than the control diet in step 1. In conclusion, the solubility of Cu was influenced by pH of digesta but was not different among sources based on the in vitro digestion assay.

• Resources Recycling
• /
• v.30 no.6
• /
• pp.3-11
• /
• 2021

In this study, the effect of the solubility of ammonium metavanadate and the decomposition ratio of ammonium ions on a precipitation reaction-the precipitation of ammonium metavanadate by adding ammonium chloride to a sodium vanadate solution-was investigated. As the precipitation temperature and pH increased, the decomposition ratio of ammonium ions increased, and the decomposition ratio was greater than 81% at 45 ℃ and pH 9.3. This was approximately four times higher than that at pH 8. The result of the precipitation reaction, in view of these two factors that significantly influence the precipitation reaction, was that the precipitation yield increased as the temperature increased. However, the effect of temperature was not significant above 35 ℃. A kinetic study of the precipitation reaction revealed that the activation energy of the reaction was 42.3 kJ/mol. Therefore, considering the solubility of ammonium metavanadate, the lower the temperature, the better the vanadium recovery yield. Additionally, considering the decomposition of ammonium ions, the lower the pH of the aqueous solution, the more advantageous. However, at pH 8 or less, sodium polyvanadate is precipitated and the purity of vanadium oxide may reduce.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.253-260
• /
• 2002

Chemical weathering processes related with mineralogical characters and ground water condition are very essential engineering problems in soluble rock masses. Detailed geological mapping were performed and 8 samples were collected from the 2 formations including various rock faces to deduce the possibility of the limestone cavity formation and their mechanism. Petrological descriptions and various petro-mineralogical experiments such as XRD analysis, clay mineral analysis, absorptivity test, impurity analysis were conducted to evaluate the cavity making processes. Laboratory solubility test for rock specimen were also carried out under the strong acid (pH=1) condition. From the experimental data and geological mapping data, it is found that the formation of limestone cavities in limestones are strongly related with geological structures such as beddings, cleavages and the contents of impurities rather than CaCO$_3$contents. In case of dolomites, rock textures, grain size, amounts and types of clay minerals as well as geological structures are major controlling factors of cavity forming processes