• Journal of Environmental Science International
• /
• v.15 no.3
• /
• pp.211-219
• /
• 2006

An experimental study on the removal of VOCs gas using a biomembrane reactor were carried out at various inlet gas concentration, specific loading rate, retention time and gas flow rate of volume. The variations of efficiency and various parameters, which are relevant to gas removal, with mixing of soluble gas and without have been discussed. More than 95% of the toluene and methanol present in the feed was successfully removed in each study. The elimination of methanol with mixture of soluble compound of about 300 mg/h corresponds to a portion of 21% if there is a feed stream of 1400 mg/h. On the contrary the maximum efficiency of about 72% of toluene was reached. This is to be rated as a treatment of sorption that the limiting factor of the dismantling speed could be represented by this difficult degradable component. Nevertheless the elimination capacities for this reactor for toluene were on a very high level. For substances which show a very high solubility in silicon rubber an advantage of a bio membrane is clearly shown. Therefore a similarly good result is expected for n-hexane, because of its relatively good permeability which was distinguished during permeation experiments.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.2
• /
• pp.185-189
• /
• 2004

Methanol dehydration to dimethyl ether (DME) has been investigated over ZSM-5 zeolites and compared with that of ${\gamma}-Al_2O_3$. Although the catalytic activity was decreased with an increase in silica/alumina ratio, the DME selectivity increased. H-ZSM-5 and NaH-ZSM-5 zeolites were more active for conversion of methanol to DME than ${\gamma}-Al_2O_3$. $Na^+$ ion-exchanged H-ZSM-5 (NaH-ZSM-5) shows higher DME selectivity than H-ZSM-5 due to the selective removal of strong acid sites.

• Analytical Science and Technology
• /
• v.6 no.3
• /
• pp.283-288
• /
• 1993

The solvent extraction and clean up processes for the gas chromatographic determination of muarimol pesticide residues in apples were investigated and examined the changes of residual concentration with the passage of time. The extracted pesticide with methanol were partitioned with dichloromethane after adding sodium chloride solution. The separated solutions were concentrated and transfered to the alumina column for clean up, and eluated with 1-chlorobutane : methanol solution. As a results their recovering for 0.200 and 1.00ppm muarimol spiked on apples have shown 79~95%. Residual amounts of nuarimol in apple was 0.0830ppm when the fungicide was treated eight times until 3 days before its harvest. It seems to be safely used when nuarimol is treated six times until 7 days before harvest of apple.

• Applied Chemistry for Engineering
• /
• v.35 no.5
• /
• pp.410-417
• /
• 2024

Steel mill gases, including coke oven gas (COG), blast furnace gas (BFG), and Linz-Donawitz gas (LDG), are mainly used as fuels within steel plants, resulting in substantial CO₂ emissions. This combustion process accounts for 10% of South Korea's total CO₂ emissions. These off-gases, rich in CO, CH₄, and hydrogen, have the potential to be converted into valuable chemicals through catalytic processes, thereby reducing CO₂ emissions and increasing their economic value. This study investigates the conversion of steel mill gases into methanol, an important platform chemical and cleaner transportation fuel. By using COG and LDG as sources of CO and H₂, respectively, a novel process was developed. In this process, H₂-rich COG from a simple single-step membrane separation and raw LDG are converted into methanol with high selectivity using a Cu-Zn-Al catalyst. The study identified the optimal gas compositions for methanol production through experimental results, demonstrating efficient methanol synthesis from various compositions of LDG, COG, pure hydrogen, and H₂-rich COG. This innovative approach not only aims to reduce specific CO₂ emissions from steel plants but also enhances the economic value of the byproduct gases. Thus, the study provides a sustainable and economically advantageous solution for the steel industry.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.10 no.4
• /
• pp.43-50
• /
• 2002

In the present study, reduction of harmful exhaust gas in a diesel engine using stratified injection system of dual fuel (diesel fuel and methanol) was tried. The nozzle and fuel injection pump of conventional injection system were remodeled to inject dual fuel in order from the same injector. The quantity of each fuel was controlled by micrometers, which were mounted at rack of injection pumps. The injection ratio of dual fuel was certificated by volumetric ratio in injection quantity test. Cylinder pressure and exhaust gas were measured and analyzed under various supply condition of duel fuel. We confirmed that combustion of dual fuel was performed successful1y by using modified injection system in a D.I. diesel. Soot and NOx are simultaneously reduced by stratified injection without large deterioration of thermal efficiency, but THC and CO are relatively increased.

• Journal of the Korean Society for Heat Treatment
• /
• v.24 no.2
• /
• pp.87-91
• /
• 2011

Single layer Sn doped $In_2O_3$ (ITO) films and ITO 50 nm / Au 10 nm / ITO 40 nm (IAI) multilayer films were prepared with electron beam assisted magnetron sputtering on glass substrates. The effects of the Au interlayer, post-deposition atmosphere annealing and intense electron irradiation on the methanol gas sensitivity were investigated at room temperature. As deposited ITO films did not show any diffraction peaks in the XRD pattern, while the IAI films showed the diffraction peak for $In_2O_3$ (400). In this study, the gas sensitivity of ITO and IAI films increased proportionally with the methanol vapor concentration and an intense electron beam irradiated IAI film shows the higher sensitivity than the others film. From the XRD pattern, it is supposed that increased crystallization promotes the gas sensitivity. This approach is promising in gaining improvement in the performance of IAI gas sensors used for the detection of methanol vapor at room temperature.

• Journal of Microbiology and Biotechnology
• /
• v.25 no.3
• /
• pp.375-380
• /
• 2015

Recently, methane has attracted much attention as an alternative carbon feedstock since it is the major component of abundant shale and natural gas. In this work, we produced methanol from methane using whole cells of Methylosinus trichosporium OB3b as the biocatalyst. M. trichosporium OB3b was cultured on NMS medium with a supply of 7:3 air/methane ratio at 30℃. The optimal concentrations of various methanol dehydrogenase inhibitors such as potassium phosphate and EDTA were determined to be 100 and 0.5 mM, respectively, for an efficient production of methanol. Sodium formate (40 mM) as a reducing power source was added to enhance the conversion efficiency. A productivity of 49.0 mg/l·h, titer of 0.393 g methanol/l, and conversion of 73.8% (mol methanol/mol methane) were obtained under the optimized batch condition.

• Journal of Astronomy and Space Sciences
• /
• v.28 no.1
• /
• pp.13-16
• /
• 2011

The $CH_3OH$ $4_2-5_1$ E transition was observed toward the Sgr B2 region, including the Principal Cloud and its surroundings. This methanol transition shows an extended emission along the 2'N cloud, which is believed to be colliding with the Principal Cloud and may trigger the massive star formation in this cloud. This extended methanol emission may also suggest that the 2'N cloud is under shocks. We derive total methanol column density $N(CH_3OH)\;=\;2.9{\pm}0.3{\times}10^{14}\;cm^{-2}$ toward the peak position of the extended emission. The fractional abundance of methanol is about 10.9, relative to the estimated total $H_2$ abundance, which is similar to the methanol abundances in quiet gas phase.

• Journal of the Korean Society of Safety
• /
• v.23 no.6
• /
• pp.76-83
• /
• 2008

In the course of increasing in human and material damage caused by fire, it is an important research field to develop clean extinguishing agent which does no harm to global environment as well as has a good extinguishing efficiency. This research is a basic step to develop a new clean extinguishing agent. In order to get a satisfactory result, we tested fire extinguishing ability using nitrogen and Novec mixtures gas which are inert gas and new clean extinguishing agent. We used Cup Burner Test made by international standard ISO-14520 regulations of gaseous extinguishing agent ability test, and the fuels used in the test are n-heptane, methanol, ethanol, iso-propanol and 1-butanol. The experimental results of flame extinguishing concentration are n-heptane 6.54%, methanol 8.47%, ethanol 6.98%, isopropanol 6.10% and butanol 6.54% by pure Novec agent. So the finding is that a new clean agent, Novec has an efficient extinguishing ability in a state of gas. Also, in a test as to mixtures gas of nitrogen and Novec, it has a good result for minimum oxygen concentration is under 16%.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.30 no.2
• /
• pp.239-251
• /
• 2024

In this study, a hydrogen fuel cell process based on methanol was developed to reduce greenhouse gas emissions. In Case1, the methanol fuel engine system was designed to investigate the emission of exhaust gas when methanol was supplied as fuel instead of gasoline to the engine. In Case2, a hydrogen fuel cell system was designed by adding a methanol reforming system to Case1. This hybrid system produced gray hydrogen and combined the output of the engine and fuel cell to drive the ship. However, gray hydrogen emits carbon in the process of producing hydrogen. To address this problem, a carbon capture and utilization (CCU) system was added to Case3. The CO2 of the flue gas discharged from Case2 was synthesized with gray hydrogen to produce blue methanol. The results of the case studies revealed that the optimal operating conditions were 220 ℃, 500 kPa, SCR = 1.0, and flow ratio = 0.7. The system of Case3 reduced carbon emissions by 42% compared with that Case1. Thus, the hybrid system of Case3 could considerably reduce the ship's CO2 emissions.