• Journal of the Korean Society of Propulsion Engineers
• /
• v.25 no.1
• /
• pp.1-11
• /
• 2021

POGO is a dynamic axial instability phenomenon that occurs in liquid-propelled rockets. As the natural frequencies of the fuselage and those of the propellant supply system become closer, the entire system will become unstable. To predict POGO, the propellant (oxidant and fuel) tank in the first stage is modeled as a shell element, and the remaining components, the engine and the upper part, are modeled as mass-spring, and structural analysis is performed. The transmission line model is used to predict the pressure and flow perturbation of the propellant supply system. In this paper, the closed-loop transfer function is constructed by integrating the fuselage structure and fluid modeling as described above. The pogo suppressor consists of a branch pipe and an accumulator that absorbs pressure fluctuations in a passive manner and is located in the middle of the propellant supply system. The design parameters for its design optimization to suppress the decay phenomenon are set as the diameter, length of the branch pipe, and accumulator. Multiple-objective function optimization is performed by setting the energy minimization of the closed loop transfer function in terms of to the mass of the pogo suppressor and that of the propellant as the objective function.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.3 no.1 s.4
• /
• pp.85-96
• /
• 2004

The study begin with a basic concept, if the occupancy length of vehicle detector is directly proportional to the delay of vehicle. That is, it analogize vehicle's delay of a occupancy time. The results of a study was far superior in the estimation of a queue length. It is a very good points the operator is not necessary to optimize s1, s2, Thdoc. Thdoc(critical congestion degree) replaced 0.7 with 0.2 - 0.3. But, if vehicles have been experience in delay was not occupy vehicle detector, the study is in existence some problems. In conclusion, it is necessary that stretch queue detector or install paired queue detector. Also I want to be made steady progress a following study relation to this study, because it is required traffic signal control on congestion.

• The Plant Pathology Journal
• /
• v.20 no.3
• /
• pp.212-219
• /
• 2004

Three isolates of Cucumber mosaic virus (CMV) from lily plants showing mosaic and distortion symptoms were detected by reverse-transcriptase polymerase chain reaction (RT-PCR) using primers specific to Cucumovirus genus namely, LK-CMV, LK4-CMV, and LKS-CMV. Restriction enzymes patterns of the RT-PCR products revealed that the lily isolates belonged to subgroup IA of CMV. In terms of biological properties, the lily isolates have highly similar but distinct pathogenicity as reported in other lily strains and ordinary strains of CMV. To characterize the molecular properties, cDNAs containing coat protein (CP) gene and 3' non-coding region (NCR) of RNA3 for the isolates were cloned and their nucleotide sequences were determined. The CP similarity (218 amino acids) was highly homologous (>97％) with that of subgroup I CMV strains. However, an additional 20-nulcleotide long segment was only present in 3' NCR of lily isolates, which form an additional stem-loop RNA structure. By using chimeric construct exchange cDNA containing 3'NCR of LK-CMV into the full-length cDNA clone of RNA3 of Fny-CMV, this additional segment may prove to be significant in the identification and fitness of the virus in lily plants. The pathology of zucchini squash infected by F1F2L3-CMV, a pseudorecombinant virus was showed to change drastically the severe mosaic and stunting symptom into a mild chlorotic spot on systemic leave, compared with Fny-CMV. To delimit the sequence of RNA3 affected the pathology, various RNA3 chimeras were constructed between two strains of CMV. The symptom determinants of F1F2L3-CMV were mapped to the positions amino acid 234, 239, and 250 in 3a movement protein (MP). RNA3 chimeras changed the sequences encoding three amino acids were resulted in alteration of systemic symptom.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.10
• /
• pp.1908-1914
• /
• 1992

A significant drag reduction in the turbulent flow of CWM(coal Water Mixture) adding minute amounts of high molecular weight polymer additives has been obtained and it was compared with pure CWM.However, the rate of drag reduction could come down with flow time, which is caused by polymer degradation, The rate of drag reduction and polymer degradation is affected by polymer type, concentration, molecular weight, and flow velocity. In the present investigation, these important parameters were evaluated for their influences on polymer degradation in order to find out stable conditions for CWM transportation with time. It was necessary to determine the more effective type of polymer additives to guarantee the optimum conditions for CWM transport. Experiments were undertaken with a test section of pipe diameter 9.8mm and pipe length 3500mm(L/D=357) in a closed loop, and polyacrylamide and polyetylene oxide were utilized as polymer additives. The tests were carried out under the conditions of 200, 400, 700ppm of polymer concentrations. CWM concentrations utilized were 5% and 10% with flow velocities of 4.9m/s and 6.1m/s. Experimental data show that polyehylene oxide degraded faster than polyacrylamide in CWM transport, and polyacryamide is considered to be a more effective candidate as additive for long time-CWM transport. Polymer degradation is also found to be more likely at lower polymer concentrations, at higher flow velocities, and higher CWM concentrations.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.4
• /
• pp.636-644
• /
• 2009

This paper presents a compact, low insertion loss, sharp rejection and wide band microstrip band pass filter that is composed rectangular loop resonator and step-impedance-open-stub(SIOS) for wireless data communication. The SIOS can be reduce length about 30% more than general $0.25{\lambda}$ stub. And the stub can the advantage of tuning impedance magnitude. In order to demonstrate agrement of this paper prove, the optimized wide band pass filters are realized and experimented. A transmission line model used to calculate the frequency response of the new filters shows good agreement with measurements. The filter has 3dB fractional bandwith of 52.5%(3.267GHz), an insertion loss of better than 0.33dB from 4.587GHz to 7.854GHz, and two rejection of greater than 30dB within 221MHz$(4.366GHz{\sim}4.587GHz)$ at low frequency band, 181MHz$(7.854GHz{\sim}8.035GHz)$ at high frequency band. Maximum rejection characteristics of the filter are -54dB at low frequency and -60dB at high frequency.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.4
• /
• pp.1527-1530
• /
• 2014

Background: Time to colposcopy (TC) after abnormal Pap smears was evaluated for influence on cytohistologic correlation (CHC). Materials and Methods: This retrospective study assessed the correlation between TC and CHC of women who had abnormal Pap smears. Colposcopic chart review included participants from 2010-2013 who attended a colposcopic clinic, Thammasat University Hospital, Thailand. Results: Four hundred and sixty cases who had abnormal Pap smears were recruited. Pap reports were atypical smears with low grade squamous intraepithelial lesion (SIL), high grade SIL and cancer at 339, 114 and 7 cases, respectively. One hundred and twenty four patients underwent loop electrosurgical excision procedure (LEEP). A half of the cases were colposcopically examined within 1-2 months after abnormal Pap collection. CHC was 88 percent and not affected at all by TC. Subjects who attended cervical cancer screening from affiliated health providers had shorter TC than those screened in our tertiary hospital. Conclusions: Time to colposcopy with abnormal Pap smears conducted at Thammasat University Hospital had a highest frequency of 42 days, in line with the literature. Length of TC does not affect the correlation between Pap and histopathologic reports. A longer waiting period for colposcopy did not alter progression or regression of the disease.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.12
• /
• pp.87-94
• /
• 2003

In this paper, we propose an IFFT/FFT design method to minimize quantization error in IEEE 802.11a WLAN. In the proposed algorithm, the twiddle coefficient of IFFT/FFT processor is manipulated by the statistics distribution of the input data at each stage. We applies this algorithm to radix-2/$^2$ SDF architecture. Both IFFT and FFT processor shares the circuit blocks cause to the symmetric architecture. The maximum quantization error with the 10 bits length of the input and output data is 0.0021 in IFFT and FFT that has a self-loop structure with the proposed method. As a result, the proposed architecture saves 3bits for the data to keep the same resolution compared with the conventional method.

• Journal of Energy Engineering
• /
• v.19 no.4
• /
• pp.234-239
• /
• 2010

Heat transfer characteristics were experimentally investigated for ice slurry which was made from 6.5% ethylene glycol-water solution flowing in the circular pipe. The test section was made of a copper tube of 13.84 mm inner diameter and 1,500 mm length. The ice slurry was heated by passing hot water through an annulus surrounding the test section. The ice packing factor(IPF) and the mass flux of the experiments were varied from 0 to 25% and from 1,000 to 3,000 kg/$m^2s$ respectively at a fixed hot water temperature and flow rate. The measured heat transfer rates increase with the mass flow rate and IPF; however the effect of IPF appears to be minor at high mass flow rate. At the low mass flow rate condition, a sharp increases in the heat transfer coefficient was observed when the IPF was above 15 ~ 20%. And finally the measured heat transfer coefficients were compared with those calculated from the correlations.

• Molecules and Cells
• /
• v.42 no.12
• /
• pp.850-857
• /
• 2019

The Gram-negative opportunistic pathogen, Pseudomonas aeruginosa, has multiple multidrug efflux pumps. MexT, a LysR-type transcriptional regulator, functions as a transcriptional activator of the MexEF-OprN efflux system. MexT consists of an N-terminal DNA-binding domain and a C-terminal regulatory domain (RD). Little is known regarding MexT ligands and its mechanism of activation. We elucidated the crystal structure of the MexT RD at 2.0 Å resolution. The structure comprised two protomer chains in a dimeric arrangement. MexT possessed an arginine-rich region and a hydrophobic patch lined by a variable loop, both of which are putative ligand-binding sites. The three-dimensional structure of MexT provided clues to the interacting ligand structure. A DNase I footprinting assay of full-length MexT identified two MexT-binding sequence in the mexEF-oprN promoter. Our findings enhance the understanding of the regulation of MexT-dependent activation of efflux pumps.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.5
• /
• pp.57-63
• /
• 2006

This paper deals with the physical properties and statistical analysis of waveform parameters of electric and magnetic folds radiated from lightning return strokes. The lightning electric and magnetic fields were detected by an plate-type electric field sensor and a loop-type magnetic field sensor respectively, and they were recorded by a data acquisition system having a resolution of 12bits, a sampling rate of 10[MS/s] and recording length of 10[ms]. As a result, a little difference between the parameters of electric and magnetic fields for positive and negative polarities was observed. The rise times of electric and magnetic fields were within the range of less than $13[{\mu}s]$ and the average values for positive and negative polarities were $4.1[{\mu}s]\;and\;4.2[{\mu}s]$, respectively. The average values of the zero-to zero crossing times were $65.2[{\mu}s]\;and\;67.0[{\mu}s]$, and the average depths of the dip to opposite polarity were 38.0[%] and 40.3[%], for positive and negative polarities, respectively.