• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.10C
• /
• pp.992-998
• /
• 2005

In this paper, An Ultra Fast Acquisition Algorithm of low transmission rate ultra-wideband(UWB) systems for car positioning and traffic light controling is proposed. Since the acquisition algorithms for CDMA system are not fast enough to access the low transmission rate UWB systems, the new ultra fast acquisition scheme which can be implemented with low cost and simplified circuit is required. The proposed algorithm adopted the Recurrent Sequential Estimation scheme and trinomial M-sequence. Therefore, The proposed scheme can reduce the average acquisition time in $1\~3{\mu}sec$ with simple circuit, even for the UWB systems which use long pseudo-noise(PN) sequence and transmit low power below the FCC EIRP emission limits. The simulation results for the average acquisition time of the proposed scheme are compared with the ones of the existing acquisition schemes.

• Proceedings of the KOSOMBE Conference
• /
• v.1993 no.05
• /
• pp.129-131
• /
• 1993

A transcutaneoos information transmission system using transmitted infrared light for an implantable total artificial heart(TAH) an developed and the performance of the system was tested. In an in vitro test, transmittance of the developed system was measured through various thicknesses of pig shins. In an in vivo test, a loopback test using a personal computer was performed to determine the error rate and an experiment using a mock system was taken. In this experiment, within acceptable lateral and vertical displacements, the error rate of at least 3.8E-6 was guaranteed. Monitoring signals from the internal controller(Intel 87C196) of the mock system were successfully transmitted to the external controller(IBM PC) and the operating commands from the external controller were successfully conducted by the mock system. Communication was done in half duplex mode according to RS-232 protocol at the speed of 4800 bps.

• Journal of Institute of Control, Robotics and Systems
• /
• v.16 no.1
• /
• pp.12-17
• /
• 2010

The oil tanker ship over 150GRT must equip oil content meter which satisfy requirements of revised MARPOL 73/78. Online measurement of oil content in complex samples is required to have fast response, continuous measurement, and satisfaction of ${\pm}10ppm$ or ${\pm}10%$ error in this field. The research of this paper is to develop oil content measurement system using analysis of light transmission and scattering among turbidity measurement methods. Light transmission and scattering are analytical methods commonly used in instrumentation for online turbidity measurement of oil in water. Gasoline is experimented as a sample and the oil content approximately ranged from 14ppm to 600ppm. TSK Fuzzy Model may be suitable to associate variously derived spectral signals with specific content of oil having various interfering factors. Proposed Parallel TSK Fuzzy Model is reasonably used to classify oil content in comparison with other models. Those measurement methods would be effectively applied and commercialized to oil content meter that is key components of oil discharge monitoring control equipment.

• Korean Journal of Optics and Photonics
• /
• v.20 no.5
• /
• pp.288-293
• /
• 2009

Polarization characteristics of a composite film composed of two optically anisotropic films are analyzed. The procedure to determine the effective optics axis and the equivalent retardation of the composite film is suggested in conjuction with the related ellipsometric expressions. The explicit expressions of the effective optic axis and the equivalent retardation of a non-uniform anisotropic film are derived when all optic axes are parallel. Those expressions of the composite film where optic axes of two constituting anisotropic films are not parallel are also derived. Dependence of those expressions on the polarization state of the incident light or the azimuth angle of the linearly polarized light and their limit when applied to practical use are discussed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.3
• /
• pp.478-490
• /
• 2015

Abundant data has been generated over the internet as the arrival of information age. To share the information, Wired, wireless network are required to transmit the data. Especially, In the wireless network which is using mobile device based on battery, energy consumption is growing due to uploading, downloading the abundant data on mobile device. In order to solve the problem, This paper addresses the protocol of the modified TCP congestion control that is being used for the most network protocol to save energy.

• Korean Institute of Interior Design Journal
• /
• v.26 no.4
• /
• pp.30-41
• /
• 2017

Sunlight is perceived by human beings first through the epidermis to space, and is a non - material medium that provides physical awareness of space, diversified expression of spaces, and plenty experience. The purpose of this study is to investigate the characteristics of active building skin based on the inflow of natural light required by humans, looked through among the works of Jacques Herzog & Pierre de Meuron, which show the characteristics of active building skin, TEA(Tenerife Espacio de las Artes, 2008), Messe Basel New Hall (2013) and Elbphilharmonie (2016). First, the interaction between Sunlight and space is divided into spatial characteristics and sensitivities according to their concepts, properties, and characteristics. The characteristics of active skin by light are classified into a physical approach and a constructive approach. Second, (El Croquis 152/153) and analyzed the images, detail drawings, and elevations, and simulated them in 3D to express the relationship between light and active building skin. Third, the changes of light intensity, light color, and distribution of light according to the time of light entering and the skin are determined from 6:00 am to 6:00 pm. Fourth, the images taken from January 30th to February 7th, 2017 on the site were compared with the computer simulated images, and the relationship between active skin and light was compared. This study is to recognize the existence and necessity of light required for human being through the activated epidermis differentiated from the limited or closed epidermis focused on information transmission, I would like to emphasize that I would like to take a step closer to the necessity and possibility of new attempts and developments so that I can feel the various experiential spaces by.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2017.05a
• /
• pp.741-743
• /
• 2017

The visible light communication is a communication method of outputting binary data based on the illumination threshold value at the light receiving diode of the receiving unit, when the LED of the transmitting unit transmits light. However, separate receiver is necessary to receive the optical signal, there is a problem that a device not equipped with such a receiver can not utilize visible light communication. To solve this problem, this paper proposes a portable visible light receiver applicable to devices using USB OTG. Implemented portable visible light receiver converts the binary data received from the LED into a character string of ASCII code and transmits it to another device. Through data transmission experiments using smart phone confirmed that it is possible to transmit ASCII codes in the proposed method.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.176-177
• /
• 2013

Surface plasmon polaritons (SPPs) have attracted the attention of scientists and engineers involved in a wide area of research, microscopy, diagnostics and sensing. SPPs are waves that propagate along the surface of a conductor, usually metals. These are essentially light waves that are trapped on the surface because of their interaction with the free electrons of conductor. In this interaction, the free electrons respond collectively by oscillating in resonance with the light wave. The resonant interaction between the surface charge oscillation and the electromagnetic field of the light constitutes the SPPs and gives rise to its unique properties. In this papers, we studied theoretical and experimental extraordinary transmittance (T) and reflectance (R) of 2 dimensional metal hole array (2D-MHA) on GaAs in consideration of the diffraction orders. The 2d-MHAs was fabricated using ultra-violet photolithography, electron-beam evaporation and standard lift-off process with pitches ranging from 1.8 to $3.2{\mu}m$ and diameter of half of pitch, and was deposited 5-nm thick layer of titanium (Ti) as an adhesion layer and 50-nm thick layer of gold (Au) on the semiinsulating GaAs substrate. We employed both the commercial software (CST Microwave Studio: Computer Simulation Technology GmbH, Darmstadt, Germany) based on a finite integration technique (FIT) and a rigorous coupled wave analysis (RCWA) to calculate transmittance and reflectance. The transmittance was measured at a normal incident, and the reflectance was measured at variable incident angle of range between $30^{\circ}{\sim}80^{\circ}$ with a Nicolet Fourier transmission infrared (FTIR) spectrometer with a KBr beam splitter and a MCT detector. For MHAs of pitch (P), the peaks ${\lambda}$ max in the normal incidence transmittance spectra can be indentified approximately from SP dispersion relation, that is frequency-dependent SP wave vector (ksp). Shown in Fig. 1 is the transmission of P=2.2 um sample at normal incidence. We attribute the observation to be a result of FTIR system may be able to collect the transmitted light with higher diffraction order than 0th order. This is confirmed by calculations: for the MHAs, diffraction efficiency in (0, 0) diffracted orders is lower than in the (${\pm}x$, ${\pm}y$) diffracted orders. To further investigate the result, we calculated the angular dependent transmission of P=2.2 um sample (Fig. 2). The incident angle varies from 30o to 70o with a 10o increment. We also found the splitting character on reflectance measurement. The splitting effect is considered a results of SPPs assisted diffraction process by oblique incidence.

• Journal of Korean Ophthalmic Optics Society
• /
• v.17 no.1
• /
• pp.83-89
• /
• 2012

Purpose: This article was to study the optical and surface properties of soft contact lenses (SCL) exposed to eye make-ups. Methods: Rates of the light transmission of etafilcon A (HEMA based hydrogel lens) and lotrafilcon B (silicone based hydrogel lens) exposed to four different cosmetics over time were investigated. After cleansed with multi-purpose solution (MPS), rates of the light transmission and surface change of lens that were exposed to the cosmetics for 7 consecutive days were analyzed. Results: Visible light transmissions of all lenses exposed to cosmetics decreased to 93.35% (HEMA based hydrogel lens) and 90% (silicone based hydrogel lens) compared with those of the fresh SCLs, such as 97.8% and 96.4%, respectively. It was found that cosmetic residues from powder eye shadow and mascara attached to the lenses were not removed completely when cleansed with MPS. Especially with silicone based hydrogel lens, we found a decrease in visible light transmission of the lens and noticeable particles on lens surface imaged by SEM. Conclusions: Depending on types of eye make-ups and contact lens materials, make-ups were not completely eliminated with current cleansing methods and that caused a decrease in optical property and a change in surface property of the lenses.

• Journal of the Korean Ceramic Society
• /
• v.41 no.3
• /
• pp.221-228
• /
• 2004

Basic properties of artificial lightweight aggregate by using waste dusts and strength properties of LWA concrete were studied. Bulk specific gravity and water absorption of artificial lightweight aggregates varied from 1.4 to 1.7 and 13 to 16%, respectively. Crushing ratio of artificial lightweight aggregate was above 10% higher than that of crushed stone or gravel. As a result of TCLP leaching test, the leaching amount of tested heavy metal element was below the leaching standard of hazardous material. Slump, compressive strength and stress-strain properties of LWA concrete made of artificial lightweight aggregate were tested. Concrete samples derived from LWA substitution ratio of 30 vol% and W/C ratio of 45 wt% showed the best properties overall. Thermal insulation and sound insulation characteristics of light weight concrete panel with the optimum concrete proportion were tested. Average overall heat transmission of 3.293W/㎡$^{\circ}C$ was observed. It was higher by about 15% than those of normal concrete made by crushed stone. Sound transmission loss of 50.9 ㏈ in frequency of 500 ㎐ was observed. It was higher by about 13% than standard transmission loss.