• Journal of Astronomy and Space Sciences
• /
• v.26 no.1
• /
• pp.59-74
• /
• 2009

Relative navigation system is presented using GPS measurements from a single-channel global positioning system (GPS) simulator. The objective of this study is to provide the real-time inter-satellite relative positions as well as absolute positions for two formation flying satellites in low earth orbit. To improve the navigation performance, the absolute states are estimated using ion-free GRAPHIC (group and phase ionospheric correction) pseudo-ranges and the relative states are determined using double differential carrier-phase data and singled-differential C/A code data based on the extended Kalman filter and the unscented Kalman filter. Furthermore, pseudo-relative dynamic model and modified relative measurement model are developed. This modified EKF method prevents non-linearity of the measurement model from degrading precision by applying linearization about absolute navigation solutions not about the priori estimates. The LAMBDA method also has been used to improve the relative navigation performance by fixing ambiguities to integers for precise relative navigation. The software-based simulation has been performed and the steady state accuracies of 1 m and 6 mm ($1{\sigma}$ of 3-dimensional difference errors) are achieved for the absolute and relative navigation using EKF for a short baseline leader/follower formation. In addition, the navigation performances are compared for the EKF and the UKF for 10 hours simulation, and relative position errors are mm-level for the two filters showing the similar trends.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.6
• /
• pp.234-238
• /
• 2005

Effects of plasma composition, ion flux and ion energy on the etch rate, surface morphology and near surface stoichiometry of a single crystalline $La_3Ga_5SiO_{14}$ wafer have been examined in $Cl_2/Ar$ inductively coupled plasma (ICP) discharges. Maximum etch rate ${\sim}1600{\AA}/min$ was achieved either at relatively high source power $({\sim}1000W)$ or high $Cl_2$ content conditions in $Cl_2/Ar$ discharges. The etched surfaces showed similar or better RMS roughness values than those of the unetched control sample and the near surface stoichiometry was found not to be affected by ICP etching.

• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.3
• /
• pp.179-187
• /
• 2009

This paper describes the field evaluation of a sampling and analytical method for the quantity of airborne hexavalent chromium ($Cr^{6+}$) in the industrial areas, such as Sihwa and Banwol. Ambient measurements were performed by using the cellulose filter during the four seasons (October 2006 to June 2007). The determination of hexavalent chromium was carried out by ion chromatography. Performance validations, including method detection limit, relative standard deviation, and recovery percent, were also investigated. The mean concentrations of $Cr^{6+}$ in Sihwa and Banwol were 0.767 and 0.796 $ng/m^3$, respectively, which are similar to those of other foreign industrial areas. The seasonal variations of $Cr^{6+}$ levels were not quite different, which implies that the chromium was continuously emitted from the industrial sources throughout the year. The concentration variations between total chromium and $Cr^{6+}$ have also shown the similar pattern, suggesting that these components originate from the same sources. The concentration of $Cr^{6+}$ was found to be 0.7 to 2.4% of the total chromium. From these results, the approach using the cellulose filter may be suitable to collect $Cr^{6+}$ in the ambient air.

• Membrane and Water Treatment
• /
• v.11 no.1
• /
• pp.1-10
• /
• 2020

An understanding of particle-particle interactions in filtration requires studying the detachment as well as the attachment of nanoparticles. Nanoparticles captured in a granular media filter can be released by changing the physicochemical factors. In this study, the detachment of captured silver nanoparticles (AgNPs) in granular media filtration was examined under different ionic strengths, ion type, and the presence or absence of natural organic matter (NOM). Filtration velocity and ionic strength were chosen as the physical and chemical factors to cause the detachment. Increasing filtration velocity caused a negligible amount of AgNP detachment. On the other hand, lowering ionic strength showed different release amounts depending on the background ions, implying a population of loosely captured particles inside the filter bed. Overall detachment was affected by ionic strength and ion type, and to a lesser degree by NOM coating which resulted in slightly more detachment (in otherwise identical conditions) than in the absence of that coating, possibly by steric effects. The secondary energy minimum with Na ions was deeper and wider than with Ca ions, probably due to the lack of complexation with citrate and charge neutralization that would be caused by Ca ions. This result implies that the change in chemical force by reducing ionic strength of Na ions could significantly enhance the detachment compared to that caused by a change in physical force, due to a weak electrostatic deposition between nanoparticles and filter media. A modification of the 1-D filtration model to incorporate a detachment term showed good agreement with experimental data; estimating the detachment coefficients for that model suggested that the detachment rate could be similar regardless of the amount of previously captured AgNPs.

• Progress in Medical Physics
• /
• v.9 no.2
• /
• pp.105-113
• /
• 1998

Accurate radiation dosimetric characters is very important to determine of dose to a radiotherapeutic patient. Medical linear accelerators have been developed not only its new quality of convenient operation but also electric moderation. It is reliable to measure more detail physical parameter that linac's internal ability. Typically, radiation dosimetric tool is classified ionization chamber, film, thermoluminescence dosimeter, etc. Nowaday, Electronic Portal Imaging Device is smeared in radiation field to verification of treatment region. EPID's image was focused that using both on-line image verification and absolutely minimum absorbed dose during radiotherapy. So, Electronic Portal Imaging was tested for quality evaluation of medical linear accelerator had its pure conditional flash. This study has performed symmetry, Light/Radiation field congruence, and energy check, geometry difference on wedge filter using a liquid filled ion chamber (EPID). Prior to irradiated on EPID, high energy photon beam is checked with ion chamber. Using these results more convenient dosimetric method is accomplished by EPID that taken digital image. Medical image is acquired with EPID too. Therefore, EPID can be analyzed by numerical information for what want to see or get more knowledge for natural human condition.

• Journal of Korean Society on Water Environment
• /
• v.18 no.3
• /
• pp.253-260
• /
• 2002

The purpose of this research was to describe the mechanisms and prevention of initial degradation in turbidity of the sand filter effluent. The method used was by adding a coagulant (PAC) to the sand filter after backwashing as a means of reducing turbidity. It was found that adding 80 mg/L of PAC solution to the sand filter was very effective in improving the initial effluent turbidity. A turbidity removal efficiency of 99 % was observed in the initial term period as compared to a 70% efficiency without PAC addition. The PAC solution added to the sand filter resulted in high aluminum concentration at the upper layer as compared with the bottom layer of the sand filter column. A change in the zeta potential to a strong positive-ions at upper layer was observed at this time but only a small change was obtained at the bottom. This result showed that the zeta potential of the sand was changed to positive with PAC coating. The effect of pH on zeta potential with PAC addition was also investigated. Zeta potential was greatly changed to positive-ion at pH 4~6. A series of experiments was then conducted in this study to optimize the pH of the PAC solution to be added to the sand filter after backwashing. The removal efficiency of turbidity was found to be highest at pH 5. This result suggested that hydrolyzed aluminium species attached to the surface of the sand enhanced the removal of turbidity of the effluent.

• Applied Biological Chemistry
• /
• v.12
• /
• pp.25-31
• /
• 1969

The characteristics of crude enzyme produced from Trichoderma viride($O_2-1$) which isolated from half spoiled Locust acacia wood (Robinia Pseudacacia Linne) were examined in this paper. The results obtained were summarized as follows: 1) As a results of enzymatic action on several cellulose substrate it was found that there were some sorts of cellulase in crude enzyme. 2) The activity of C.M.C. ase and ${\beta}-glucosidase$ were decreased in accordance with increasing concentration of substrate, and filter paper saccharifying enzyme relatively increased in accordance with increasing concentration of substrate and enzyme in couse of time. 3) The optimal pH of each enzyme was 5.0 and the range of stability on pH generally from 3 to 6. 4) In disintegrating activity on filter paper, in decomposing activity on C.M.C. and $p-nitrophenyl-{\beta}-D-glucoside$, and in saccharifying activity on filter paper, the optimal temperatures were $50^{\circ}C.,\;60^{\circ}C,\;and\;65^{\circ}C$. 5) The order of stability on temperature was as follow; saccharifying activity on filter paper decomposing activity on C.M.C. disintegrating activity on filter paper>decomposing activity on $p-nitrophenyl-{\beta}-D-glucoside$. 6) The activity of the enzymes was inhibited with mercuric and silver ion, and activated with potassium.

• Journal of the Korean Vacuum Society
• /
• v.17 no.4
• /
• pp.262-269
• /
• 2008

The residual gas analyzer (RGA) is employed for the process control of a vacuum system by measuring residual gases in it. This review paper introduces operating principles of the RGA and problems that can be encountered during use, together with their possible solutions.

• Bulletin of the Korean Chemical Society
• /
• v.10 no.6
• /
• pp.524-529
• /
• 1989

A glow discharge mass spectrometric(GDMS) analytical method was developed for direct analysis of impurities in solids. Ions extracted from a glow discharge ion source with a sample as a cathode were analyzed by a quadrupole mass filter. Ion extractions were carried out through differentially-pumped orifices biased to positive and negative potentials. Operating parameters of the glow discharge source such as discharge current, orifice-to-cathode distance, energy analyzer setting and bias voltages have been optimized. The developed GDMS was applied to the analysis of KSS copper-base alloy standards certified by Korea Standards Research Institute(KSRI). In the analysis, the reproducibility and the detection limits were estimated to be about 2.5% RSD, and in the low ppm range, respectively.

• Korean Journal of Food Science and Technology
• /
• v.15 no.2
• /
• pp.133-134
• /
• 1983

Some metallic ions such as copper, manganese, iron, zinc and cadmium in ginseng extract, originated from white ginseng, were determined by atomic absorption spectrophotometry. The extracts were prepared with water, 35% ethanol, 50% ethanol or 75% ethanol solution followed by filtration or centrifugation. Greater amounts of metallic ions were found in the solution filtrated by filter paper (Toyo No. 5A) or by filter cloth than in that of centrifugation. The residual amount of metallic ions in the extract decreased with increasing concentration of ethanol. The percentages of each metallic ion in ginseng extracts on the basis of original amount of metallic ions were as follows: Cu, 10.4-31.9%, Fe,5.1-19.0%, Mn,3.0-12.2% Zn,7.4-12.0%, Cd,5.9-11.8%.