• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.31 no.1
• /
• pp.37-42
• /
• 2021

The effect of chemical composition on the structural and thermal properties of TiZrN thin films was studied. As the Zr fraction in the deposited TixZr1-xN (x = 0.87, 0.82, 0.7, 0.6, and 0.28) increased, microstructural changes consisted of reduction in the grain size and a gradual transition from columnar structure to granular structure were observed. In addition, it was also confirmed that a gradual crystal phase transition from TiN to TiZrN has occurred as the Zr fraction increased up to 0.4. After heat treatment at 900℃, Ti0.82Zr0.18N and Ti0.7Zr0.3N layers were converted to a form in which rutile phase TiO2 and TiZrO4 oxides coexist, while Ti0.6Zr0.4N layer was converted to TiZrO4 oxide. Among the five compositions of TiZrN films, the Ti0.6Zr0.4N showed the best high temperature stability and produced a significant enhancement in the thermal oxidation resistance of Inconel 617 through suppressing the surface diffusion of Cr caused by thermal oxidation of the Inconel 617 substrate.

• Journal of Life Science
• /
• v.31 no.2
• /
• pp.115-125
• /
• 2021

Calcium-dependent protein kinases (CDPKs) are known to be involved in regulating plant responses to abiotic stresses such as salinity, cold temperature and dehydration,. Although CDPKs constitute a large multigene family consisting of 31 genes in rice, only a few rice CDPKs' functions have been identified. Therefore, in order to elucidate the functions of OsCPK11 in rice, this study was intended to focus on the expression pattern analysis of OsCPK11 in wild type and ND0001 oscpk11 mutant plants under these abiotic stresses. For the salt, cold and drought stress treatment, seedlings were exposed to 200 mM NaCl, 4℃ and 20% PEG 6,000, respectively. RT-PCR and quantitative real-time PCR were performed to determine the expression patterns of OsCPK11 in wild type and ND0001 mutant plants. RT-PCR results showed that OsCPK11 transcripts in the wild type and heterozygous mutant were detected, but not in the homozygous mutant. Real-time PCR results showed that relative expression of OsCPK11 of wild type plants was increased and reached to the highest level at 24 hr, at 6 hr and at 24 hr under salt, cold and drought stress conditions, respectively. Relative expression of OsCPK11 of ND0001 homozygous plant was significantly reduced compared to that of wild type. These results suggested that oscpk11 homozygous mutant knocks out OsCPK11 and OsCPK11 might be involved in salt, cold and drought stress signaling by regulating its gene expression.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.9 no.1
• /
• pp.26-32
• /
• 2021

Powder type sericite has been actively researched in the area of chemistry and mineralogy in terms of waste recycling. It is a material that can be obtained relatively inexpensively with a low thermal conductivity like general mica, so in order to improve the thermal conductivity of the mortar, powder type sericite was used in this work. Compressive strengths of mortar before and after high temperature exposure were compared and evaluated to determine the fire resistance of mortar with powder type sericite. According to the experimental results, it was found that the compressive strength decreased when powder type sericite was replaced with cement, but the decrease in compressive strength with the increasing amount of powder type sericite was insignificant. When powder type sericite was incorporated, the thermal conductivity decreased, and the residual strengths of the mortar specimens which were heat treated at 600℃, 900℃, and 1,200℃ were higher than that of plain mortar. From the comprehensive evaluation of the experimental results, it can be concluded that the powder type sericite has the potential to be used as a refractory material for cement composites.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.1
• /
• pp.153-160
• /
• 2021

Nitrous oxide is a global warming substance and is known as the main cause of the destruction of the ozone layer because its global warming effect is 310 times stronger than carbon dioxide, and it takes 120 years to decompose. Therefore, in this study, we investigated the characteristics of NOx emission from N2O reduction by thermal decomposition of N2O. Bunsen premixed flames were adopted as a heat source to form a high-temperature flow field, and the experimental variables were nozzle exit velocity, co-axial velocity, and N2O dilution rate. NO production rates increased with increasing N2O dilution rates, regardless of nozzle exit velocities and co-axial flow rates. For N2O, large quantities were emitted from a stable premixed flame with suppressed combustion instability (Kelvin Helmholtz instability) because the thermal decomposition time is not sufficient with the relatively short residence time of N2O near the flame surface. Thus, to improve the reduction efficiency of N2O, it is considered effective to increase the residence time of N2O by selecting the nozzle exit velocities, where K-H instability is generated and formed a flow structure of toroidal vortex near the flame surface.

• Korean Journal of Ecology and Environment
• /
• v.54 no.4
• /
• pp.334-345
• /
• 2021

The present study investigated the effect of global warming on germination and initial growth across six deciduous oak species (Quercus mongolica, Q. variabilis, Q. serrata, Q. dentata, Q. aliena, and Q. acutissima), which are the dominant tree species in Korea forest ecosystems. Seeds were sown in climate change treatments, with temperatures higher than those of the control (approximately 3.0℃ higher), and CO₂ concentrations higher than those of the control (approximately 2-fold higher). Initial growth in each species was measured every two weeks. Initial growth was more rapid in all oak species at the time of root and shoot emergence under high temperature and CO₂ treatments than in the control group. Leaf emergence in Q. mongolica, Q. variabilis, and Q. serrata occurred earlier under the climate change treatments than under the control. Root length increased significantly in Q. mongolica, Q. variabilis, and Q. dentata under the climate change treatments when compared to under the control. However, Q. aliena and Q. serrata exhibited a contrasting trends, and no significant difference was observed between the species and Q. acutissima. Shoot length increased significantly in Q. aliena under climate change treatments when compared to under the control but decreased in Q. aliena. In addition, no significant difference was observed in shoot length among Q. mongolica, Q. dentata, and Q. acutissima. The results showed that climate change treatments facilitated early growth, rapid emergence from the ground, leaf development, and enhanced belowground growth in Q. mongolica. Conversely, Q. aliena exhibited the lowest aboveground and belowground growth under climate change treatments when compared to other oak species. Climate change treatments had the least impact on Q. acutissima considering the insignificant differences observed in initial growth rates under climate change treatment.

• Journal of the Microelectronics and Packaging Society
• /
• v.28 no.4
• /
• pp.85-89
• /
• 2021

AlGaN-based UV-C light-emitting diodes (LEDs) were applied for p-type activation by electrochemical potentiostatic activation (EPA). The p-type activation efficiency was increased by removing hydrogen atoms through EPA treatment using a neutral Mg-H complex that causes high resistance and low conductivity. A neutral Mg-H complex is decomposed into Mg^- and H⁺ depending on the key parameters of solution, voltage, and time. The improved hole carrier concentration was confirmed by secondary ion mass spectroscopy (SIMS) analysis. This mechanism eventually improved the internal quantum efficiency (IQE), the light extraction efficiency, the leakage current value in the reverse current region, and junction temperature, resulting in better UV-C LED lifetime. For systematic analysis, SIMS, Etamax IQE system, integrating sphere, and current-voltage measurement system were used, and the results were compared with the existing N₂-annealing method.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.32 no.2
• /
• pp.55-60
• /
• 2022

In this study, a heat treatment experiment was conducted to select a new melt composition that can easily control the unintentionally doped nitrogen (N-UID) without degrading the SiC single crystal quality during TSSG process. The experiment was carried out for about 2 hours at a temperature of 1900℃ under Ar atmosphere. The used melt composition is based on either Si-Ti 10 at% or Si-Cr 30 at%, and also Co or Sc transition metals, which are effective for carbon solubility, were added at 3 at%, respectively. After the experiment, the crucible was cross-sectionally cut, and evaluated the Si-C reaction layer on the crucible-melt interface. As a result, with Sc addition, Si-C reaction layers uniformly occurred with a Si-infiltrated layer (~550 ㎛) and a SiC interlayer (~23 ㎛). This result represented that the addition of Sc is an effective transition metal with high carbon solubility and can feed carbon sources into the melt homogeneously. In addition, Sc is well known to have low reactivity energy with nitrogen compared to other transition metals. Therefore, we expect that both growth rate and Nitrogen UID can be controlled by Si-Sc based melt in the TSSG process.

• Journal of Conservation Science
• /
• v.38 no.3
• /
• pp.217-233
• /
• 2022

The remains found in Geumcheok-ri, Gyeongju are located in close proximity to the Ancient Tombs in Geumcheok-ri, Gyeongju (Historic Site) which were built between the late 5th and early 6th centuries, and these tombs are known to belong to the powerful rulers of that area. Using metallurgical techniques, this study was conducted on the iron objects obtained from the excavated remains in Geumcheok-ri, Gyeongju which are presumed to have a close relation to the nearby ruins that played an important role in the growth of Silla. To identify differences in manufacturing techniques based on the purpose of the iron objects, eight objects were selected after classifying them by use and the microstructure and non-metallic inclusions were investigated. The analyses results confirmed that the manufacturing process involved forging iron with a high or low carbon content to produce a particular shape, and that the carburization process was applied to iron post forging a shape to increase its strength when necessary. The mechanical properties were improved by selectively applying the steelmaking method and the heat treatment technique considering the functions of the parts, and the low temperature reduction was applied to the smelting process. Furthermore, in comparison with the iron objects excavated from the remains located in the center of Gyeongju and its outskirts, it is confirmed that there is similarity in the smelting and manufacturing techniques between these objects.

• Journal of the Korean Society of International Agriculture
• /
• v.23 no.5
• /
• pp.497-502
• /
• 2011

Broccoli is considered as one of the functional foods to offer a hearty supply of the nutrient-rich vegetable in the world. Broccoli contains high level of phytochemicals, and that is selected as one of the top 10 vegetables for human health promotion. Especially, glucosinolates and flavonoids are well known as anti free oxygen radicals in vegetables and fruits. In Korea, broccoli consumption has increased to well known on the health-beneficial vegetables since 2000. However, broccoli has many problems of postharvest management since the quality of harvested heads quickly declines. Major problems are the floret yellowing, wilting, off-odor, and decay. The multiple postharvest applications improve broccoli quality and cold treatment including pre-cooling extends on the shelf-life with circumstance of optimum storage which is 0℃ temperature and a range of 95-100% relative humidity. Controlled atmosphere or modified atmosphere packaging can be used as supplemental treatments to extend postharvest life. 1-2% O₂ + 5-10% CO₂ is currently recommended for broccoli. Postharvest management is important for broccoli because price fluctuations depend on harvest time and quality. In this study, we tried to review physiological change of broccoli after the harvest, storage method, and various techniques to optimize quality during distribution.

• Food Science and Preservation
• /
• v.30 no.1
• /
• pp.122-131
• /
• 2023

Persimmon peels are mostly discared as a by-product of dried persimmon manufacturing, but effective use is required as it contains various functional constituents. This study covers the preparation of carotenoid-enriched oil by ultrasound treatment of persimmon peel in soybean oil solvent, and the investigation of its physicochemical characteristics. Using the Box-Behnken design and response surface methodology, the optimal extraction conditions (temperature, 62℃; time, 32 min; and persimmon peel to oil ratio, 1:3.1) were determined based on the carotenoid concentration of the extract. The physicochemical characteristics of the extract obtained under optimal conditions and the untreated soybean oil (control) were compared. The total carotenoid content of the extract increased. The carotenoid-enriched soybean oils had a lighter color than the controls, but with high redness and yellowness values. The effect of sonication and a component of the persimmon peel on the oxidation and heating stability of soybean oil was weak. The viscosity and activation energy of carotenoid-enriched soybean oil were slightly higher than those of the control. Thus, it was possible to prepare yellow-red carotenoid-enriched soybean oil by applying ultrasonic-soybean oil solvent extraction to persimmon peel. The oil is expected to be useful as an additive as well as a substitute for general edible oils.