• The Journal of Engineering Geology
• /
• v.31 no.2
• /
• pp.149-163
• /
• 2021

Damage characteristics of granite, marble and sandstone whose properties were different were investigated by uniaxial compression test and cyclic loading-unloading test. Strength, elastic constants and damage threshold stresses were measured by uniaxial compression test and were compared with those measured by cyclic loading-unloading test. Average rock strengths measured by cyclic loading-unloading test were either lower than or similar with those measured by uniaxial compression test. Rocks with high strength and low porosity were more sensitive to fatigue than that with low strength and high porosity. Although permanent strains caused by cyclic loading-unloading were different according to rock types, they could be good indicators representing damage characteristics of rock. Damage threshold stress of granite and marble might be measured from stress-permanent strain curves. Acoustic emissions were measured during both tests and felicity ratios which represented damage characteristics of rocks were calculated. Felicity ratio of sandstone which was weak in strength and highly porous could not be calculated because of very few measurements of acoustic emissions. On the other hand, damage threshold could be predicted from felicity ratios of granite and marble which were brittle and low in porosity. The deformation behaviors and damage characteristics of rock mass could be investigated if additional tests for various rock types were performed.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.6
• /
• pp.45-55
• /
• 2008

CFRD (Concrete Faced Rockfill Dam) has been world-widely constructed due to a lot of advantages which it has compared with rockfill dam and recently, sand/gravel materials, Instead of crushed rock materials, are also utilized as a main rockfill material to overcome geological and environmental problems. In Korea, two dams using sand/gravel materials as a main fill material were designed and are being constructed. In this research, the strength and deformation characteristics of the rockfill and sand/gravel materials taken from 2 dam sites were tested by using a laboratory large triaxial testing equipment for a total of 7 cases. From the results of large triaxial and compaction tests, it was observed that two kinds of materials show a little different compaction, shear strenght and deformation characteristics. It could be expected that the shear strength of sand/gravel material was not disadvantageous compared with that of rockfill materials, however, there was some difference between two materials with respect to behavior characteristics. On the other hand, smaller displacements were observed from numerical analysis based on the data from a large triaxial test when the sand/gravel is used as a main fill material compared with the case when the crushed rock material is used as a main fill material. Finally, in spite of a little different shear strength and behavior characteristic between two materials, it was concluded that it will not lead to a significant problem when the sand/gravel material is used as a main rockfill material.

• 한국체육학회지인문사회과학편
• /
• v.57 no.6
• /
• pp.263-272
• /
• 2018

This study examined the association of gait variability and physical fitness with frailty status in older women. In a cross-sectional design, 168 elderly women, aged 65 years and older (75.07±5.40 years), measured body composition, gait parameters gait variability, physical fitness variables, MMSE-DS and CES-D. Subjects were classified as robust, pre-frail, and frailty based on the Fried et al.(2001) criteria for frailty weight loss, exhaustion, low hand-grip strength, low gait speed, and physical inactivity. Logistic regression analyses were used to determine the odds ratio (ORs) and 95% confidence interval (CI) of frailty status for having gait variability and physical fitness levels. Compared to the robust group (OR=1), the frailty group had significantly higher ORs of having terminal double limb stance (OR=1.48, 95% CI=0.10-2.21, p=.049), step cadence (OR=2.06, 95%CI=1.20-3.43, p=.009) variability, and significantly lower ORs of having upper-strength (OR=0.49, 95%CI=0.31-0.77, p=.002) even after adjusting for age, education, comorbidity, K-IADL, MMSE-KC and CES-D score. The finding of this study suggested that terminal double limb stance, step cadence and upper body muscular strength were independent predictors of frailty.

• Journal of the Korean Society for Heat Treatment
• /
• v.29 no.1
• /
• pp.15-23
• /
• 2016

The effects of austenitizing temperature and cooling rate on precipitation behavior and tensile properties were investigated in an Mn-Mo-Nb-V pressure vessel steel. During austenitizing, it was shown that the austenite coarsening was somewhat suppressed by undissolved NbC. After cooling from austenitizing, the microstructure of all the steels mainly consisted of upper bainite. However, the steel comprised a little lower bainite and martensite in the case of aqua oil quenching from $1000^{\circ}C$, which would be due to increased hardenability by partly dissolved Nb and comparatively large austenite grains. The average size of NbC in austenite at higher temperature was analyzed to be smaller than that at lower temperature because of the more dissolution. It was found that the NbC did not grow much during fast cooling from austenitizing. Meanwhile, the NbC grew much during slow cooling, probably due to wide temperature range of cooling and sufficiently long time for NbC to grow. It was conjectured the V precipitates newly formed and/or grew during cooling from austenitizing and during tempering. On the other hand, the formation of NbC was almost completed before tempering and little more precipitated during tempering. Among the tempered steels, the steel which was fast cooled from $1000^{\circ}C$ showed the highest tensile strength, which seemed to come from the microstructure of fine upper bainite and some low temperature phases as well as the comparatively fine NbC precipitates.

• Journal of the Korean Geotechnical Society
• /
• v.31 no.1
• /
• pp.53-64
• /
• 2015

This study presents the experimental results of pervious blocks subjected to a series of unique inflow conditions in urban area. The measured properties include the strength, permeability, drainage capacity and runoff, and evaporation for blocks made of two different size of aggregates. Results revealed that the strength satisfies the Korean Standard regardless of aggregate size whereas the immediate runoff occurred for the block with small size aggregate. On the other hand, the block with large aggregates allowed the drainage upon the initial inflow condition, which became hampered to induce the runoff by subsequent inflow. It was attributed to the fact that the capillary water often served as the hydraulic barrier in partially saturated condition. The salient observation indicated that the runoff highly depended on the evaporation and pre-wetting condition as well as the porosity and pore connectivity. The bilinear evaporate rate that makes the degree of saturation vary also had great influence on deterining the time-dependent runoff.

• Food Science of Animal Resources
• /
• v.37 no.2
• /
• pp.162-167
• /
• 2017

Functional and nutritional soluble proteins can be recovered from surimi (and surimi-like material) processing wastewater, reducing environmental problems and the cost of an irresponsible waste disposal. Recovered proteins may be added back at a low percentage to surimi products. The aim of this work was to evaluate the effect of the addition of soluble recovered proteins (RP), obtained from mechanically separated chicken meat surimi-like material (MSCM-SLM) processing wastewater by acidic pH-shifting, on the composition and texture of RP-MSCM-SLM, with RP contents of 0, 10, 20 and 30% (w/w) in the mixture. For that, proximate composition and gel properties were evaluated. The fat content of the MSCM-SLM was significantly reduced to 11.98% and protein increased to 83.64% (dry basis) after three washing cycles. The addition of 30% RP in the MSCM-SLM significantly augmented the protein content to 93.45% and reduced fat content from to 2.78%. On the other hand, the addition of RP was responsible for a drastic decrease in texture parameters, reaching 252.36 g, 185.23 g.cm, and 6.97 N for breaking force, gel strength and cutting strength, respectively, when 30% of RP was included in the MSCM-SLM. It was concluded that the obtained intermediary product (RP-MSCM-SLM) is a good option to applications in processed meat products where high texture parameters are dispensable, e.g., emulsified inlaid frankfurter-type sausages, but high protein content and low fat content desired.

• Applied Chemistry for Engineering
• /
• v.27 no.4
• /
• pp.380-385
• /
• 2016

Nanocelluloses, mainly cellulose nanofibrils (CNF) and cellulose nanocrystals (CNC, i.e., defect-free, rod-like crystalline residues after acid hydrolysis of fibers), have been the subject of recent interest. Due to the presence of hydroxyl groups on the surface of nanocelluloses, their surfaces are reactive, making them suitable candidates for reinforcing materials for manufacturing polymer composites. In this study, CNF was used as a reinforcing material for manufacturing cement composites. CNF was prepared by TEMPO (2,2,6,6,-tetramethyl piperidine-1-oxyl radical) oxidation procedure combined with extensive homogenization and ultrasonication. Transmission electron microscopy (TEM) analysis of the suspension showed the width of CNF between 10 and 15 nm. The compressive strength of cement composites containing 0.5% CNF was comparable to that of conventional cement composites. On the other hand, the tensile and flexural strength were improved by 49.7% and 38.8%, respectively, compared to those of conventional cement composites. Also, at an ambient condition, the degree of self-shrinkage reduction reached to 18.9% in one day, followed by 5.9% in 28 days after molding.

• Archives of Reconstructive Microsurgery
• /
• v.21 no.1
• /
• pp.1-7
• /
• 2012

Purpose: This retrospective study was to determine the functional results of patients who were amputated of their fingertip between patients who were treated with replantation and patients who were treated with thenar flap. Materials and Methods: From 2004 to 2007, we identified and operated 159 patients who were diagnosed with fingertip amputations. Of 159 patients, Eighty-two patients were treated by replantation (67 in men and 14 in women) and the mean age at the operation was 41 years (range, 15-68 years). Seventy-nine patients was treated with thenar flap(54 in men and 25 in women) and the mean age at the operation was 43 years(range, 21-70 years). We compared variables between two groups including, age, gender, diagnosis, duration of hospital admission, grip strength, two-point discrimination, Semmes Weinstein monofilament test, active range of motion (ROM) of the proximal and distal interphalangeal (PIP and DIP) joint, pain (or tenderness), paresthesia, cold intolerance, the Disabilities of the Arm, Shoulder, and Hand (DASH) questionnaire, and finger for activities of daily living (ADLs). Results: The duration of admission was longer in Replantation group than in Thenar flap group(p=0.001). However, the grip strength (p=0.003) and Semmes Weinstein monofilament test (p=0.029) in the Replanation group were statistically superior to the Thenar flap group. The average DASH disability (p=0.003)/symptom score (p=0.007) and ADLs (p<0.001) in the Replantation group was statistically better. In addition, cold intoleranace test of Thenar flap group is worse than the Replantation group. Conclusion: This study demonstrate that fingertip replantation have demonstrated not only to obtain the best appearance but also to gain better functional outcome. However, it is impossible to perform replatation, the thenar flap can be limited alternative method for fingertip amputation in aspect of preservation of range of motion and hospitalization time.

• Journal of Society of Preventive Korean Medicine
• /
• v.18 no.2
• /
• pp.115-123
• /
• 2014

Objective : The objective of this study is to develop a Qigong exercise program to reinforce musculoskeletal system of seniors appropriate for physical strength and conditions of seniors aged 65 years or above based on health Qigong exercise of oriental medicine. Method : Qigong exercise motions that can improve strength, muscular endurance, flexibility, and cardiovascular endurance of seniors were developed by primarily performing literature review of Qigong experts on the fields like oriental medicine, Qigong exercise, physical education and health science and secondarily using motion training for increased validity of motions. Results : The Qigong exercise program for musculoskeletal system of seniors was designed with 12 motions repeated 8 times and 20 minutes per session, including shoulder exercises (alternate turning of left and right shoulders, turning both arms back and forth, holding and lifting elbow to put it aside), waist exercises (wrapping the head with hands to bow, twisting waist while looking at the tip of hand, large spinning of ball, putting hands together to pull back), and knee exercises (going up a down while lifting a rock, balancing the body while lifting a knee, lifting and spreading knees while drawing circle with arms, raising both arms to the side while lifting heels, breathing). Conclusion : Once the effects of Qigong exercise for musculoskeletal system of seniors developed in this study are tested, the program is expected to contribute to development of Qigong exercise, a core part of oriental medicine health improvement project.

• International Journal of Highway Engineering
• /
• v.12 no.4
• /
• pp.203-209
• /
• 2010

The base asphalt mixtures that used the waste recycle asphalt correcting from the four different overlay construction sites in Seoul city were made using the foamed asphalt method. The sample mixtures were made in different ratio of the recycle asphalt and new asphalt material and the performance of the mixtures of the different ratio was investigated in the laboratory. The laboratory tests includes the Marshall test, the indirect tensile test, the resilient modulus test, the creep test and the wheel tracking test. The test of the recycle foamed asphalt mixtures(RFA) were compared with the those of the recycle hot mix asphalt(RHA) mixtures. The performance of the RFA is comparable to that of the RHA. On the other hand, the indirect tensile strength of the RFA in dry condition is lower than that of RHA and the indirect tensile strength of the RFA in wet condition is much lower than that of the RHA.