• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.20 no.4
• /
• pp.1-6
• /
• 2012

The accurate information of mass properties is required for the precise control of the spacecraft. The mass properties, mass and inertia, are changeable by some reasons such as consumption of propellant, deployment of solar panel, sloshing, environmental effect, etc. The gyro-based attitude data including noise and bias reduces the control accuracy so it needs to be compensated for improvement. This paper introduces a real-time inertia estimation method for the attitude determination of STSAT-3, Korea Science Technology Satellite. In this method we first filter the gyro noise with the Extended Kalman Filter(EKF), and then estimate the moment of inertia by using the filtered data from the EKF based on the Recursive Least Square(RLS).

• Journal of Institute of Control, Robotics and Systems
• /
• v.11 no.12
• /
• pp.1045-1050
• /
• 2005

This paper describes a design experience of a low-cost 6 DOF spatial tracker system where relative low accuracy and relatively long ranges, wireless communication will be achieved by means of low cost accelerometers and gyros with contemporary microprocessor. However, there are two key problems; one is the bias drift problem and the other is that single or double integration of acceleration signal suffers not only from noise but also from nonlinear effects caused by gravity. To be specific, beginning and stopping of hand motions needs to be accurately detected to initiate and terminate integration process to get position and pose of the hand from accelerometer and gyro signals, since errors due to noise and/or hand-shaking motions accumulated by integration processes. Several experimental results are shown to validate our proposed algorithms.

• Journal of Institute of Control, Robotics and Systems
• /
• v.7 no.8
• /
• pp.697-702
• /
• 2001

The ring laser gyro(RLG) has been used extensively in strapdown inertial navigation system(SDINS) because of the apparent of having wide dynamic range, digital output and high accuracy. The dithered RLG system has dynamic motion at sensor level, caused by the dithering motion to overcome the lock-in threshold. In this case, an attitude error is produced by not only the true coning of the vehicle motion but also the pseudo coning of the sensor motion. This paper describes the definition of the multi-frequency coning motion and its noncommutativity error to reject the pseudo coning error produced by the sensor motion such as the dithered RLG. The simulation results are presented to minimize the multi-frequency coning error.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.7
• /
• pp.871-877
• /
• 2018

In this paper, we propose a triple nested PID control scheme for stable hovering of a quadrotor and propose a complementary filter based sensor fusion technique to improve the performance of attitude, altitude and velocity measurement. The triple nested controller has a structure in which a double nested attitude controller that has the angular velocity PD controller in inner loop and the angular PI controller in outer loop, is nested in a velocity control loop to enable stable hovering even in the case of disturbance. We also propose a sensor fusion technique by applying a complementary filter in order to reduce the noise and drift error included in the acceleration and gyro sensor and to measure the velocity by fusing image, gyro, and acceleration sensor. In order to verity the performance, we applied the proposed control and measurement scheme to hovering control of quadrotor.

• Journal of the Korean Society for Precision Engineering
• /
• v.18 no.4
• /
• pp.190-196
• /
• 2001

The naval vessel must moves rolling, pitching, yawing by wave when it runs in ocean. Some narrow beam antenna needed position compensation by stabilizer or gimbal for best performance. This paper presents the precision position control for heavy weight(130kg) in roll and pitch direction. Generally it's called for gimbal. This gimbal uses P-I controller, and it's driven by linear actuator and servo motor. This gimbal gets ship's gyro signal and synchro, which have the absolute angle value. Some other similar equipments are driven by huge hydraulic power, but this gimbal is driven by small servo motor. This control loop gets the following procedure repeatedly; reading ship gyro and gimbal synchro, calculating compensated error and control output, driving motor and actuator The performance of gimbal system was satisfied.

• Journal of Advanced Navigation Technology
• /
• v.4 no.2
• /
• pp.132-142
• /
• 2000

This paper includes a study on the performance analysis of SDINS by a simulator using Matlab/Simulink. The performance model is considered gravity and Coriolis force, and a barometer is included to damp down diversity of a perpendicular axis error. Using the simulator, the performance included gyro sensor errors was analyzed in various maneuvering patterns. Also, the performance is virtually presented for the variation of error parameters of gyro and accelerometer under GUI.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.2 no.S1
• /
• pp.89-109
• /
• 1996

The main information for a marine navigation is ship's bearing obtained from Gyro, Gyrocompass, Magneticcompass and electronic navigation systems such as LORAN, OMEGA and GPS. However, some of these systems have a disadvantage or restricted conditon involved critical problems in a war-ship and weapon system. In the work, we have done the basic resrarch, analysis of error pattern for GPS, for the development of the ship's seondary bearing sensor (GPS-Compass) to provide the back-up system of Gyro/Gyrocompass and a substitution way of Magneticcompass.

• The Journal of Korea Robotics Society
• /
• v.4 no.4
• /
• pp.289-297
• /
• 2009

This paper presents the development and control of a two wheeled car-like mobile robot using balancing mechanism whose heading control is done by turning the handle. The mobile inverted pendulum is a combined system of a mobile robot and an inverted pendulum system. A sensor fusion technique of low cost sensors such as a gyro sensor and a tilt sensor to measure the balancing angle of the inverted pendulum robot system accurately is implemented. Experimental studies of the trajectory following control task has been conducted by command of steering wheel while balancing.

• Journal of Advanced Navigation Technology
• /
• v.7 no.2
• /
• pp.156-161
• /
• 2003

In this study, a hybrid navigation system with a low-cost GPS Receiver plus Gyro and Odometer is developed and tested. This hybrid navigation system adopted a modified coupling method which can be distinguished from tightly coupled method or loosely coupled method, so that GPS receivers or Gyros or Odometers can be chosen arbitrary. Comparing to the existing hybrid navigation system, the test results show that this navigation system enhances the accuracy and is robust against the multipath error. It is also proven that this system has an advantage of acquiring GIS data for post processing.

• International Journal of Aeronautical and Space Sciences
• /
• v.15 no.3
• /
• pp.293-301
• /
• 2014

We present a study of vertical dynamics control of an electrostatically levitated gyro-accelerometer considering the wobbling effect and propose a tilt stabilization method with newly introduced control electrodes. Typically, a rotor in a vacuum rotates at high velocity, which may create a drift rate and lead to displacement instability due to the tilt angle of the rotor. To analyze this, first we set up a vertical dynamic equation and determined simulation results regarding displacement control. After deriving an equation for drift dynamics, we analyzed the drift rate of the rotor and the wobbling effect for displacement control quantitatively. Then, we designed new sub-electrodes for moment control that will decrease the drift amplitude of wobbling dynamics. Finally, a simulation study demonstrated that the vertical displacement control with the wobbling compensation electrodes mitigated the rotor's drift rate, showing the effectiveness of the newly proposed control electrodes.