• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.618-621
• /
• 1999

With the advent of the high-speed microprocessor and DSP, the possibility of executing a control strategy in digital domain has become a reality. By the use of the DSP and microprocessor controller, many high power drive system may be enhanced resulting in the improved robustness to EMI, the ability to communicate the operating conditions and the ease of adjusting the control parameters. But, the digital controller using DSP or microprocessor is not applied in the high frequency switching power supplies, especially full bridge DC/DC converter. So, this paper presents the method and realization of designing a digital-to-phase shift PWM circuit for full digital controlled full bridge DC/DC converter with zero voltage switching. The operating principles, simulation and experimental results will be presented.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 하계학술대회 논문집 B
• /
• pp.833-836
• /
• 1993

A flyback type power converter circuit for switched reluctance motor drives is presented. In this converter circuit, the energy extracted from an off going phase is stored in an additional capacitor. The energy stored is used to either be returned to the source frequently or energize the conducting phase during the conduction interval through the transformer. The additional switch to pass the energy stored in the capacitor to the source or the conducting phase is switched under a relatively low voltage condition. Its switching frequency is relatively high so that the size of the transformer can be reduced. The design guideline for the capacitor and the transformer is described. The effectiveness of the presented converter circuit is compared to other circuits through the analysis and experiment.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1988년도 추계학술대회 논문집 학회본부
• /
• pp.283-286
• /
• 1988

This paper describes the PWM cycloconverter which can provide step-up ac-ac direct conversion in a wide output frequency range. With input reactor and output capacitor. the input and output ports are exchanged. And sine PWM scheme is applied to the converter. To analyze the converter operation the state equations are derived using dq transformation. Simulated results show that both the output voltage and frequency can be controlled by adjusting the modulating functions.

• 한국지능시스템학회:학술대회논문집
• /
• 한국퍼지및지능시스템학회 2007년도 춘계학술대회 학술발표 논문집 제17권 제1호
• /
• pp.469-472
• /
• 2007

최근 많은 광대역 유무선 통신 응용분야에서 OFDM(Orthogonal Frequency Division Multiplexing) 방식을 표준기술로 채택하고 있다 OFDM 방식의 고속 무선 데이터 통신를 위한 FFT 프로세서는 일반적으로 DSP(Digital Signal Processing)로 구현되었으나, 큰 전력 소비를 필요로 한다. OFDM의 단점인 전력문제를 보안하기 위해서 Current-mode FFT LSI가 제안되었다. 본 논문에서는 Current-mode FFT LSI의 구현을 위한 저전력 IVC를 설계하였다. 설계된 IVC는 FFT Block의 출력이 $13.65{\mu}A$ 이상일 때에 3V 이상의 전압을 출력하고, FFT Block의 출력이 $0.15{\mu}A$ 이하일 때에 0.5V 이하의 전압을 출력한다. 그리고 IVC의 총 소모전력은 약 1.65mW이다. $0.35{\mu}A$ 공정에서의 저전력 IVC를 설계함으로서, $0.35{\mu}A$ 공정에서의 Current-mode FFT LSI의 설계가 가능해졌다. 저전력 OFDM 통신용 Current-mode FFT LSI는 무선통신의 발전에 기여할 것으로 전망한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.256-260
• /
• 2001

This paper presents boost and buck and buck-boost DC-DC converter circuit topologies of high-frequency soft switching transition PWM chopper type DC-DC high power converters with a single auxiliary passive resonant snubber. In the proposed boost power converter circuits operating under a principle of ZCS turn-on and ZVS turn-off commutation schemes, the capacitor and inductor in the auxiliary passive resonant circuit works as the loss less resonant snubber. In addition to this, the switching voltage and current peak stresses as well as EMI and RFI noises can be basically reduced by this single passive resonant snubber. Moreover, it is proved that converter circuit topologies with a passive resonant snubber are capable of solving some problems of the conventional hard switching PWM processing based on high-ferquency pulse modulation operation principle. The simulation results of this converter are discussed as compared with the experimental ones. The effectiveness of this power converter with a single passive resonant snubber is verified by the 5kW experimental breadboad set up.

• Journal of Power Electronics
• /
• 제14권3호
• /
• pp.580-591
• /
• 2014

This paper concerns a three-phase self-excited induction generator used for autonomous power generation. It presents a robust control strategy which makes it possible to maintain the frequency quasi constant during the voltage regulation without any control loop on this variable. This strategy, which also prevents the machine disengagement, uses as power converter a simple dimmer. The obtained theoretical and/or numerical results are validated on a laboratory test bench that allows the analysis of this control law effectiveness.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제53권10호
• /
• pp.610-617
• /
• 2004

This paper presents a novel high frequency generating circuit integrated chopper-inverter using ZVS with high power-factor. The proposed topology is integrated half-bridge boost rectifier as power factor corrector(PFC) and half-bridge high frequency resonant inverter into a single-stage. The input stage of the half-bridge boost rectifier works in discontinuous conduction mode(DCM) with constant duty cycle and variable switching frequency. So that a boost converter makes the line current follow naturally the sinusoidal line voltage waveform. Simulation results have demonstrated the feasibility of the proposed high frequency resonant inverter. Characteristics values based on characteristics analysis through circuit analysis is given as basis data in design procedure. Also, experimental results are presented to verify theoretical discussion. This proposed inverter will be able to be practically used as a power supply in various fields as induction heating applications. fluorescent lamp and DC-DC converter etc.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.193-197
• /
• 2001

This paper presents a novel circuit topology of the double two-switch forward type high frequency transformer linked soft-switching PWM DC-DC power converter with tapped inductor filters that can operate under a condition of the low peak voltage stress across the power semiconductor devices and lowered peak current stress through the transformer for some high power applications. This circuit topology of an interleaved two-switch forward soft-switching power converter is proposed in the order to minimize an idle circulating current due to the tapped inductor filter without of any additional active auxiliary resonant-assisted snubber circuits, such as active resonant DC link snubbers and AC link snubbers, active resonant commutation leg link snubbers. The unique advantages of this power converter are less power circuit components and power semiconductor devices, constant frequency PWM scheme, cost effective configuration and wider soft-switching PWM operation range under PWM power regulations load variations. The practical effectiveness of the proposed soft-switching converter circuit topology is tested by simulations and is proved by experimental results received from the 500W-100kHz breadboard setup.

• 전기전자학회논문지
• /
• 제18권1호
• /
• pp.119-127
• /
• 2014

본 논문에서는 MEMS(Micro Electro Mechanical System) 가속도센서를 위한 CMOS readout 회로를 설계하였다. 설계된 CMOS readout 회로는 MEMS 가속도 센서, 커패시턴스-전압 변환기(CVC), 그리고 2차 스위치드 커패시터 ${\Sigma}{\Delta}$ 변조기로 구성된다. 이들 회로에는 저주파 잡음과 오프셋을 감소시키기 위한 correlated-double-sampling(CDS)와 chopper-stabilization(CHS) 기법이 적용되었다. 설계 결과 CVC는 150mV/g의 민감도와 0.15%의 비선형성을 갖는다. 설계된 ${\Sigma}{\Delta}$ 변조기는 입력전압 진폭이 100mV가 증가할 때, 출력의 듀티 싸이클은 10%씩 증가하며, 0.45%의 비선형성을 갖는다. 전체 회로의 민감도는 150mV/g이며, 전력소모는 5.6mW이다. 제안된 회로는 CMOS 0.35um 공정을 이용하여 설계하였고, 공급 전압은 3.3V이며, 동작 주파수는 2MHz이다. 설계된 칩의 크기는 PAD를 포함하여 $0.96mm{\times}0.85mm$이다.

• 전력전자학회논문지
• /
• 제10권6호
• /
• pp.592-597
• /
• 2005

푸시 풀 포워드 컨버터는 넓은 입력범위에서 저전압 대전류 특성이 좋고 싱글 EI-EE 코어에 출력 인덕터와 변압기 그리고 입력 필터 등 모든 자성소자들을 포함시킴으로써 집적화할 수 있다. 회로의 여러 변수들에 대한 효율 비교를 통해서 집적화된 싱글 코어 푸시 풀 포워드 컨버터에 대해 고찰하였다. 푸시 풀 포워드 컨버터의 변압기는 Nicera사의 5M FEE 18/8/10C와 NC-2H FEI32/8/10C 코어를 이용하였다. 컨버터의 정격은 입력 전압 $36\~72V$이며 출력은 3.3V, 30A이다. NC-2H FEI32/8/10C코어를 사용하였을 경우 스위칭 주파수가 200kHz이고 부하가 11A일 때 $83.5\%$의 최고 효율이 측정되었다. 전부하(full load)시의 효율은 $76.4\%$, 반부하(half load)일 경우에는 $82.95\%$의 효율이 각각 측정 됐다.