• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2003년도 Proceedings of ACRS 2003 ISRS
• /
• pp.82-84
• /
• 2003

Watershed boundaries and flow paths within the watershed are the most important factors required in watershed analysis. Most often the derivation of watershed boundaries and stream network and flow paths is based on topographical maps but spatial variation of flow direction is not clearly understandable using this method. Water resources projects currently use 1: 50, 000-scale ground survey or aerial photography-based topographical maps to derive watershed boundary and stream network. In basins, where these maps are not available or not accessible it creates a real barrier to watershed geo-spatial analysis. Such situations require the use of global datasets, like GTOPO30. Global data sets like ETOPO5, GTOPO30 are the only data sets, which can be used to derive basin boundaries and stream network and other terrain variations like slope aspects and flow direction and flow accumulation of the watershed in the absence of topographic maps. Approximately 1-km grid-based GTOPO 30 data sets can derive better outputs for larger basins, but they fail in flat areas like the Karkheh basin in Iran and the Amudarya in Uzbekistan. A new window in geo-spatial hydrology has opened after the launching of the space-borne satellite stereo pair of the Terra ASTER sensor. ASTER data sets are available at very low cost for most areas of the world and global coverage is expected within the next four years. The DEM generated from ASTER data has a reasonably good accuracy, which can be used effectively for hydrology application, even in small basins. This paper demonstrates the use of stereo pairs in the generation of ASTER DEMs, the application of ASTER DEM for watershed boundary delineation, sub-watershed delineation and explores the possibility of understanding the drainage flow paths in irrigation command areas. All the ASTER derived products were compared with GTOPO and 1:50,000-based topographic map products and this comparison showed that ASTER stereo pairs can derive very good data sets for all the basins with good spatial variation, which are equal in quality to 1:50,000 scale maps-based products.

• 한국전기전자재료학회논문지
• /
• 제11권11호
• /
• pp.996-1000
• /
• 1998

This paper describes the characteristics of Pt microheater using aluminum oxide films as medium layer and its application to flow sensors. Pt microheater have heating temperature of $390^{\circ}C$ at heating power of 1.2 W. Output voltages of flow sensors which were fabricated by integrating sensing-part with heating-part increase as gas flow rate and its conductivity increase. At $O_2$ flow rate of 2000 sccm, heating power of 0.8 W, output voltage of flow sensor is 101 mV under bridge-applied voltage of 5 V.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 추계학술대회 논문집 학회본부
• /
• pp.609-611
• /
• 1997

Pt thin films flow sensors were fabricated by using aluminum oxide films as medium layer and their characteristics were investigated after annealing at $600^{\circ}C$ for 60min. Aluminum oxide improved adhesion of Pt thin films to $SiO_2$ layer without any chemical reactions to Pt thin films under high annealing temperatures. Output voltages increased as gas flow rate and gas conductivity increased because heat loss of heater, which was integrated with a sensing resistor in the flow sensor, increased. Output voltage of flow sensor fabricated on membrane structure was 101mV at $O_2$ flow rate of 2000sccm, heating power of 0.8W while flow sensor fabricated on Si substrate without membrane had output voltage of 78mV under the same conditions.

• 대한교통학회지
• /
• 제28권3호
• /
• pp.157-167
• /
• 2010

교통량, 속도, 밀도의 3가지 교통류 지표 중 밀도는 혼잡을 잘 나타내는 지표이다. 밀도를 측정하는 방안은 직접적으로 수집하는 방안과 수집자료를 활용하여 간접적으로 수집하는 방안이 있다. 직접적인 측정법은 대상구간의 교통류를 항공기나 고층건물에서 촬영하여 밀도를 직접적으로 구하는 것이나, 기상과 도로조건 및 비용상의 문제로 인하여 광범위한 사용에는 한계가 있다. 본 논문에서는 두 개의 지점검지기를 이용하여 밀도를 측정할 수 있는 방법을 제시하였다. 또한, 순간밀도, 평균밀도, 측정간격이라는 개념을 정리하고 가상시뮬레이션(Paramics Application Programming Interface) 기능을 활용하여 자료를 생성한 후 측정간격이 도로조건(측정구간길이별, 차로별, 서비수준별)별로 구간밀도정확도에 미치는 영향을 분석하였다.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2003년도 춘계학술발표강연 및 논문개요집
• /
• pp.137-137
• /
• 2003

Conducting PPy/PVA composite and pure PPy gas sensors were prepared by in-situ vaporstate polymerization method in a vaporization chamber under N2 condition, by exposing the pre-coated electrode with PVA/FeC13 to distilled pyrrole monomer. The various electrical sensing behaviors of both types of sensors were systematically investigated by a flow measuring system including mass flow controller (MFC) and bubbling bottle. The FT-Raman spectroscopy of vapor state polymerized PPy was identical to that of chemically polymerized PPy, confirming the same chemical structure. Both types of sensors had positive sensitivity when exposed to methanol gas. The sensitivity varied linearly with gas concentration in the range of 50ppm to 1059ppm. The detection limit of PPy/PVA sensor was believed to be as low as 10ppm. The sensitivity of PPy/PVA composite sensor was higher than that of pure PPy sensor. Both the response time and recovery time of PPy/PVA composite sensors were longer than those of pure PPy sensors. The thickness of the sensing film affected the sensitivity this way that the sensor having thinner film had higher sensitivity, indicating that the resistance of polymer film involved in the sensing behavior was bulk resistance rather than surface resistance. The reproducibility of PPy/PVA composite sensor was excellent during eight on-off cycles by switching between N2 and 3000ppm methanol gas. The sensitivity of PPy/PVA composite sensor was only maintained for two weeks, while the sensitivity of pure PPy sensor was maintained over two months.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집B
• /
• pp.377-382
• /
• 2001

A suboptimal control law in turbulent pipe flow is derived and tested. Two sensing variables ${\partial}p/{\partial}{\theta}\;|_w\;and\;{\partial}{\upsilon}_{\theta}/{\partial}r\;|_w$ are applied with two actuations ${\phi}_{\theta}$ and ${\phi}_r$. To test the suboptimal control law, direct numerical simulations of turbulent pipe flow at $Re_r=150$ are performed. When the control law is applied, a $13{\sim}23%$ drag reduction is achieved. The most effective drag reduction is made at the pair of ${\partial}{\upsilon}_{\theta}/{\partial}r\;|_w$ and ${\theta}_r$. An impenetrable virtual wall concept is useful for analyzing the near-wall suction and blowing. The virtual wall concept is useful for analyzing the near-wall behavior of the controlled flow. Comparison of the present suboptimal control with that of turbulent channel flow reveals that the curvature effect is insignificant.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2003년도 Proceedings of ACRS 2003 ISRS
• /
• pp.372-374
• /
• 2003

The optical flow theory can be utilized for automatically tracking and positioning homologous points in digital video (DV) image sequences. In this paper, the Lucas-Kanade optical flow estimation (LKOFE) method and the normalized cross-correlation (NCC) method are compared and analyzed using the DV image sequences acquired by our SONY DCRPC115 DV camera. Thus, an improved optical flow estimation procedure, called 'Iterated Optical Flow Estimation (IOFE)', is presented. Our test results show that the trackable range of 3${\sim}$4 pixels in the LKOFE procedure can be apparently enlarged to 30 pixels in the IOFE.

• 국제학술발표논문집
• /
• The 3th International Conference on Construction Engineering and Project Management
• /
• pp.1359-1363
• /
• 2009

The object of this research is to develop a simulation system for earthmoving operations in consideration of the impact of congestion in-between equipment and existing traffic flow around the site. The congestion in-between equipment and traffic flow affect work productivity. The conventional discrete event simulation, however, has limitations in simulating the flow of construction equipment. To consider the impact of congestion in-between equipment and existing traffic flow, in this paper, a multi-agent based simulation model that can realize characteristics of truck behavior more accurately to consider the impact of congestion was proposed. In this simulation model, multiple agents can identify environmental changes and adapt themselves to the new environment. This modeling approach is a better choice for this problem since it describes behavioral characteristics of each agent by sensing changes in dynamic surroundings. This study suggests a detailed system design of the multi-agent based simulation system.

• 한국수자원학회논문집
• /
• 제35권6호
• /
• pp.807-816
• /
• 2002

본 연구에서는 댐 건설에 따른 댐 하류 유황의 변화에 대해 살펴보고자 하였다. 이를 위해 대청댐이 위치해 있는 금강유역을 대상으로 하였으며, 댄 건설 전후의 인공위성 영상자료를 분석해서 댐 하류 수표면의 변화를 평가하였고, 유황변화에 대한 분석을 위해서는 대청댐 하류에 위치한 공주 수위관측소의 자료를 이용해서 댐의 건설에 따른 하류 유황변화를 분석을 실시하고 그 영향을 평가하였다. 또한, 댐의 홍수조절에 따른 홍수량 규모의 변화를 살펴보기 위해 대청댐 하류의 공주와 규암지점의 연 초과치 계열에 대한 빈도해석을 실시하고 그 변화를 분석하였다. 이를 통해 댐이 하류하천의 유황을 개선하고 일정하게 유지해서 안정적인 수자원 공급을 가능하게 해주는 역할과 첨두유량의 감소로 홍수피해를 저감시켜주는 역할을 동시에 담당하고 있음을 알 수 있었으며, 수자원의 관리 및 이용측면에서 이·치수에 기여하는 댐의 긍정적인 효과를 다시 한번 확인할 수 있었다.

• 산업기술연구
• /
• 제22권A호
• /
• pp.89-94
• /
• 2002

In this paper, a Exhaust Flow Controller (EFC) technology for uniform application of film coater and developer device is introduced that spread and remove photo resister at semiconductor manufacturing process. Because developed EFC device uses differential pressure sensing method as a differential flow meter and embodied smart A/D conversion by using a one chip microprocessor and devised by feedback Servo control, It has shown excellent performance and stability evaluation, as maximum 2000L/min flow, capability of installation to actual semiconductor equipment.