• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2021년도 봄 학술논문 발표대회
• /
• pp.78-79
• /
• 2021

This study compared and analyzed the fluidity and compressive strength characteristics of mortar using ferronikel slag powder and mixed slag fine aggregate as part of the study to reduce environmental load and increase recycling rate of industrial by-products.

• 콘크리트학회논문집
• /
• 제13권6호
• /
• pp.561-567
• /
• 2001

석산에서 부순잔골재를 생산시에는 다량의 슬러지 미립분이 배출되고 있다. 그러나, 실무현장에서는 슬러지의 일부를 매립용등에 제한적으로 사용할 뿐, 대부분은 방치되거나 무분별하게 버려지고 있어 막대한 경제적 손실과 환경오염 문제를 유발시키고 있다. 따라서 본 연구에서는 석산폐기물인 슬러지를 공장제품용 시멘트 모르타르 제조에 골재대체용 충전재로 활용하기 위하여, 골재 종류 및 모르타르 배합비 등에 미립분 혼입률을 변화시켜 시멘트 모르타르의 강도 및 흡수 특성을 검토하였다. 연구결과, 시멘트 모르타르 제품을 제조할 때 슬러지를 골재에 10% 정도 대체하여 혼입하게 되면 기존의 시멘트 모르타르 제품보다 향상된 품질의 제품이 생산될 수 있는 것이 확인되었다.

• Advances in concrete construction
• /
• 제8권4호
• /
• pp.305-309
• /
• 2019

Pervious concrete pavements are the need of the day to avoid urban flooding and to facilitate ground water recharge. However, the strength of pervious or porous concrete is considerably less compared to conventional concrete. In this experimental investigation, an effort is made to improve the strength of pervious concrete by adopting fibres and a small amount of fine aggregate. A porous concrete with cement to aggregate ratio of 1:5 and a water-powder ratio of 0.4 is adopted. 30% of the cement is replaced by cementitious material ground granulated blast furnace slag (GGBS) for better strength and workability. Recron fibres at a dosage of 0.5, 1.0 and 1.5% by weight of cement were included to improve the impact strength. Since concrete pavements are subjected to impact loads, the impact strength was also calculated by "Drop ball method" in addition to compressive strength. The effect of fine aggregate and recron fibres on workability, porosity, compressive and impact strength was studied. The investigations have shown that 20% inclusion of fine aggregate and 1.5% recron fibres by weight of cement give better strength with an acceptable range of porosity.

• 한국분말재료학회지
• /
• 제26권6호
• /
• pp.493-501
• /
• 2019

In this work, ultra-fine calcium oxide (CaO) powder derived from eggshells is used as the starting material to synthesize mineral trioxide aggregate (MTA). The prepared CaO powder is confirmed to have an average particle size of 500 nm. MTAs are synthesized with three types of fine CaO-based powders, namely, tricalcium silicate (C3S), dicalcium silicate (C2S), and tricalcium aluminate (C3A). The synthesis behavior of C3S, C2S and C3A with ultra-fine CaO powder and the effects of C₃A content and curing time on the properties of MTA are investigated. The characteristics of the synthesized MTA powders are examined by X-ray diffraction (XRD), field emission-scanning electron microscope (FE-SEM), and a universal testing machine (UTM). The microstructure and compressive strength characteristics of the synthesized MTA powders are strongly dependent on the C3A wt.% and curing time. Furthermore, MTA with 5 wt.% C3A is found to increase the compressive strength and shorten the curing time.

• 한국건축시공학회지
• /
• 제14권1호
• /
• pp.54-60
• /
• 2014

The purpose of this study is to examine whether cementitious powder separated from waste concrete can be used as an alternative raw material to limestone and reduce the usage of natural resource (limestone) and $CO_2$ emission based on recycling cementitious powder from waste concrete. Experiments actually analyzed the chemical composition of cementitious powder and performed hyperthermia analysis, measurement of free CaO and XRD analysis to measure the degree of recovery of hydration in the model of cementitious powder manufactured based on chemical composition. These were performed in each cementitious powder model at different calcination temperatures such as $900^{\circ}C$, $1200^{\circ}C$, $1300^{\circ}C$, $1400^{\circ}C$ and $1450^{\circ}C$. Through the experiments, it was found that the recovery of hydration was at a level which can be used as the alternative raw material for limestone, but the replacement ratio was directly affected by the degree of mixing of fine aggregate in less than $150{\mu}m$, which cannot be separated from cementitious powder. It was shown that there was no difference in the production of compounds involved in hydration at calcination temperatures of $1200^{\circ}C$ or higher. Therefore, to pursue the replacement of limestone and reduction of greenhouse gas by recycling cementitious powder, the development of technology to efficiently separate aggregate fine powder is required.

• 한국건설순환자원학회논문집
• /
• 제6권1호
• /
• pp.88-94
• /
• 2011

순환골재를 제조하기 위해서는 반복적으로 파쇄해야 하기 때문에 미립분의 발생량이 증가하게 된다. 기존에는 이 분말을 순환골재에 포함하여 배출하였으나, 고품질 순환골재의 경우에는 골재의 품질을 저하시키게 되므로 별도로 분리하여야 한다. 또한, 폐콘크리트의 완전한 리사이클링 이라는 측면에서도 미립분의 용도를 개발하는 것은 매우 중요하다. 본 연구에서는 고압으로 압출하고 고온고압 양생에 의해 산화칼슘과 산화규소의 수화반응을 유도하여 강도를 발현하는 시멘트 압출패널을 대상으로 규사분말의 대체재로서 폐콘크리트 분말을 적용하는 연구를 수행하였으며, 그 결과는 다음과 같다. 1) 폐콘크리트 분말은 $SiO_2$, CaO를 주성분으로 하고 환경에 유해한 성분을 포함하고 있지 않으며, 밀도는 콘크리트보다 약간 높은 $2.45g/cm^3$, 분말의 평균 입경은 $13{\sim}141{\mu}m$로 배출되는 장소에 따라서 다소 차이가 있는 것으로 나타났다. 2) 폐콘크리트 분말을 배출되는 장소에 따라 강도를 검토한 결과 분말의 평균사이즈가 작은 경우의 강도가 높게 나타나고 있어 분말의 크기가 강도에 미치는 주요 요인인 것을 확인하였다. 3) 평균크기 $13{\mu}m$로 크기가 가장 작은 백필터 집진분말을 이용하여 규사분말의 50~100%를 대체하여 실험한 결과 대체율의 증가에 따라 강도가 저하하고 있으나 KS 기준을 만족하는 경우도 있어 폐콘크리트 미립분을 수열반응에 의해 제조하는 시멘트 압출패널의 실리카질 재료로 활용하는 것이 가능함을 확인하였다.

• 한국결정성장학회지
• /
• 제27권3호
• /
• pp.115-121
• /
• 2017

콘크리트는 열화요인에 의해 철근콘크리트구조물의 철근부식, 균열발생 및 구조내력저하 등 성능저하현상이 사회적 문제점으로 대두되고 있다. 특히 해수, 지하수 또는 오 폐수처리시설 및 하수도 등에 건설되는 콘크리트 구조물은 산 및 황산염에 의한 화학적 침식을 받는 경우 내구성이 크게 저하되어 대책이 필요하다. 따라서 본 연구는 폐유리 미분말과 메타카올린을 사용하여 강모래와 슬래그 잔골재를 비교하여 내황산염성 실험을 진행하였다. 평가 결과 강모래보다 슬래그 잔골재가 내황산염성이 우수하였으며, 폐유리 미분말은 3 % 치환에서 가장 우수한 성능을 발현하였다.

• 한국농공학회논문집
• /
• 제50권5호
• /
• pp.19-27
• /
• 2008

This study was performed to evaluate the compressive strength and acid-resistant of polymer concrete using redispersible polymer powder(RPP) and blast furnace slag powder(BSP). Material used were ordinary portlant cement, recycled coarse aggregate, natural fine aggregate, redispersible polymer powder and blast furnace slag powder. The main experimental variables were the substitution ratio of redispersible polymer powder and blast furnace slag powder, when the substitution ratios of RPP were 0, 1, 2, 3, 4, 5 and 6%, and those of BSP were 10%. The compressive strength and acid-resistant of polymer concrete using RPP and BSP were compared with those of ordinary concrete(Basis). When the substitution ratio of RPP was 1%, at age of 28 days, the compressive strength were more higher than those of Basis by 24%, and it was decreased with increasing the RPP content, respectively. Also, the water absorption ratio was decreased with increasing the RPP content. But, the acid-resistant was improved with increasing the RPP content.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1998년도 봄 학술발표회 논문집(I)
• /
• pp.111-116
• /
• 1998

This studies regarding development of product system on artificial aggregate using of Paper Sludge Ah that waste production at paper-making mill, expecially this paper describes development of product system using centrifugal mixer plant. The skills of this product system on artificial aggregate using of Ash can be spread Fly-Ash, powder and fine aggregate(under 5mm) of waste concrete reuse.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1997년도 가을 학술발표회 논문집
• /
• pp.69-75
• /
• 1997

This studies regarding deveolpment of product system on artificial aggregate using of Paper Sludge Ash that waste production at paper-making mill. Expecially this paper discribes development of product system using centrifugal mixer plant. The skills of this product system on artificial aggregate using of Ash can be spread Fly-Ash, powder and fine aggregate (under 5mm) of waste concrete reuse.