• Design & Manufacturing
• /
• 제14권4호
• /
• pp.40-45
• /
• 2020

In a vehicle-to-vehicle accident, the impact posture, braking status, final stopping position, collision point and collision speed are important factors for accident reconstruction. In particular, the speed of collision is the most important issue. In this study, the collision speed and the final stopping position in the tunnel were estimated using PC-CRASH, a vehicle crash analysis program used for traffic accident analysis, and the final stopping position of the simulation and the final stopping position of the traffic accident report were compared. When the Pride speed was 0km/h or 30km/h and the Sorento speed was 100m/h, the simulation results and reports matched the final stopping positions and posture of the two vehicles. As a result of the simulation, it can be estimated that Pride was collided in an almost stationary state.

• 한국안전학회지
• /
• 제15권1호
• /
• pp.53-58
• /
• 2000

In a car accident in Kyongju, each of the two occupants insisted that he was not driving the car. The accident was investigated to determine who the driver is through careful review of the collision report, the statements of accident and witness, photographs taken at the scene, and the expert report of the National Institute of Scientific Investigation. The accident was reconstructed based on the physical principles, injuries of occupants, damages of the involved vehicles and their final stops. A mistake was found in the expert report.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 합동 추계학술대회 논문집 정보 및 제어부문
• /
• pp.209-211
• /
• 2001

The core in developing the transformer-operated 3 phase solid state meter is to design a single chip IC, that incorporates all the necessary features required for development of the 3 phase solid state meter. Using this technology, the solid state meter can be mass produced at lower cost and higher quality. This report deals with the performance of the prototype FPGA board, which is the final step before actual IC fabrication in fabrication LAB. All the features of FPGA board, shown in this report will be included in the final ASIC IC product.

• 복식문화연구
• /
• 제16권2호
• /
• pp.205-218
• /
• 2008

This study was to develop a fashion internship pragmatic program for college students. Preceded researches were reviewed and some case studies were used for this study. The results of this study were as follows : Pragmatistic program has 6 steps such as preperation, introduction, selection, operation, reputation, management. pre-internship schedule, resume and self-introduction form, preparing for the interview and details, how to write a follow up letter after the interview, advise during the intern period, 7 contents that you should include in the final report, Presentation Strategy, SWOT analysis table were included in this study. So this study would be helpful for the college students who are searching for internships and jobs.

• 대한치과보철학회지
• /
• 제62권1호
• /
• pp.38-46
• /
• 2024

편악 무치악 환자에서 완전 고정성 임플란트 보철 치료를 위해 다수의 임플란트를 식립할 때에는 악궁의 해부학적 구조, 대합치의 상태, 교합 평면 등을 고려한 최종 보철물 형태를 미리 결정해야 한다. 이 때 임시 보철물의 형태 및 교합 정보는 최종 보철물의 디자인에 유용하게 활용될 수 있다. 본 증례에서는 구강 스캐닝 디지털 워크플로우를 통해 무치악 스캔 데이터와 임시 보철물의 스캔 데이터를 중첩하였으며, 이를 통해 임시 보철물의 정보를 최종 보철물의 디자인에 반영하였다. 또한 구강 스캔을 통해 임시 의치 정보를 획득하여 임플란트의 위치와 각도를 계획하고, 수술 가이드를 사용하여 사전에 계획한 3차원적 위치에 임플란트를 식립하였다. 본 증례에서는 이와 같이 디지털 기술을 활용하여 심미적, 기능적으로 만족할 만한 임상적 결과를 얻었기에 이를 보고하는 바이다.

• 자원환경지질
• /
• 제9권1호
• /
• pp.1-11
• /
• 1976

It is believed that geological survey, drilling and geophysical survey which was carried out on Tertiary deposits in Pohang is a valuable but through the studying of many Tertiary sediments in Japan discovered many questions on analysis of final report prepared by National geological survey. The main reason is: 1. The seismic sound velocity which have regulated in the final report prepared by geological survey for Tertiary deposits in Pohang was 1,500-2,000m/sec in spite of oil bearing sediments of same age in Japan are 2,000-3,800m/sec. These may means the requirement of reconsideration of seismic velocity for Tertiary deposits in Pohang and required to have a dipper drilling. 2. Stratigraphically, geophysically, and paleontologically, the Tertiary deposits in Pahang land area is similar with that of Nishiyama-Hunakawa formations of Akita oil field in Japan. Nishiyama-Hunakawa formation is the main oil bearing formation in Japan. 3. Those valcanic rock including andestitic rock and liparitic rock which have extensively distributed over either at land area or at sea bottom, assumed by geological survey as the base of Tertiary sediments. But in case of Japan many oil bearing deposits are in over laid by these kind of volcanic rock. Therefore a possible of same condition with Japan is presumable on Tertiary sediments in Pohang. 4. It is believed that the Tertiary sediments of land area in Pohang is the extension of offshore basin but is wandering that the final report submitted by geologic survey have not remain any word on report of ECAFE discribed so much problematics as followed: A. Although it was assumed that no great thickness exceeding 1,000 meters, or major structures would be encountered in the Tertiary offshore sequence, it was hoped that shallow hydrocarbon deposits might be found, because these sediment are lithologically similar to those of the same age in the producing area of the northwest Honshu region of Japan where hydrocarbon are extracted from depths of only 500 to 600 meters. B. Four possible hydrocarbon trap conditions are represented in the survey area: anticlinal folds, faults, pinch outs, along the igneous basement and lateral facies changes. C. Most of the prime possible reservoir area are beyond the 50 meter water depth mark, except for the structures in Yonil Bay. D. Despite the shallowness of the offshore basin, sufficient trap condition exist in the area to warrant further exploration for hydrocarbon. 5. All of the problems mentioned above have gave us a strong reasons to have us hesitating to make a final conclusion on Tertiary problems in Pohang, before to have a drill to a depth to 3,000 meters or more whatever it is the Tertiary or a Mesozoics below 1,000 meters.

• 대한치과의사협회지
• /
• 제36권11호통권354호
• /
• pp.794-799
• /
• 1998

Many references report that abnormal diastema except temporary diastema existing in mixed dentition period is caused by maxilary heavy labial frenum, malocclusion, progressive periodontal disease, and loss of posterior teeth. We can diagnose patient as diastema caused by periodontal disease, especially, in case of accompanying progressively destructed anterior maxillary alveolar bone defect, and interseptal bone defect. We report Multiple disciplinary approach for diastema associated with periodontal disease. Periodontal treatment(Guided Tissue -Regeneration, alveoloplasty, bone graft), or thodontic treatment (space closure, redistribution), and the final proshodontic restoration for retention were used.

• Toxicological Research
• /
• 제27권3호
• /
• pp.133-135
• /
• 2011

The FDA guidance focuses on the use of the NOAEL to establish the maximum recommended starting dose. The majority of NOAEL has been described inaccurately or incompletely in final reports for 90-days repeated dose toxicity test based on GLP (good laboratory practice) regulation. This is the most serious one of reasons for why most pharmaceutical companies targeting global markets have disregarded the final report produced from GLP facilities in Korea. The problems in deciding NOAEL reflected in the final reports are mainly due to the followings; 1) Inaccurate description or use of NOEL, NOAEL and LOAEL, 2) Insufficient and inappropriate interpretations in findings from toxicity test. This paper is intended to provide the insight into distinguishing NOAEL from NOEL and LOAEL, and into classifying findings from toxicity test. Here, the three step method is newly suggested by applying the weight-based classification to the NOEL, NOAEL and LOAEL based on the findings.

• 한국도서관정보학회지
• /
• 제51권4호
• /
• pp.211-230
• /
• 2020

본 연구는 국가연구개발사업 성과로 발생한 최종보고서 기재항목 기준을 마련하여 데이터베이스 품질 향상과 관리 효율성 제고에 기여하고자 한다. 이를 위하여 과학기술정보통신부의 49개 산하기관에서 제출한 최종보고서를 수집하고 기관별 샘플을 선정하였다. 과학기술기본법 시행규칙의 최종보고서·요약서 서식과 대조하여 구성요소와 기재항목을 정립하고, 국가연구개발정보표준과 연계현황을 분석하여 최종보고서의 고유항목을 도출하였다. 기재항목은 중요도에 따라서 주요, 선택으로 구분하고 기재항목의 기입 위치를 제안하였다. 이와 같이 최종보고서 기재항목의 표준화가 진행되면, 데이터베이스 구축 시 메타데이터 추출 자동화와 보고서 메타데이터의 품질 향상을 기대해볼 수 있다.

• Journal of Periodontal and Implant Science
• /
• 제25권1호
• /
• pp.111-120
• /
• 1995

This case report presents two maxillary anterior cases for clinical crown lengthening by forced eruption. In the first case, clinical crown of maxillary right lateral incisor was almost lost by fracture. Forced eruption using intracoronal splint and elastic thread accomplished vertical root movement successfully. Then, post & core was inserted and final restoration was harmonious with adjacent teeth. In the second case, the crown portion of maxillary right central incisor was almost mutilated by secondary caries. Forced eruption using removable Hawley appliance and elastic accomplished vertical root movement successfully. Then, post & core was inserted and final restoration was placed. In conclusion, clinical crown lengthening by vertical root movement can be accomplished by a simple appliance without any sacrifice of periodontal support in selected patients. A clinical crown so created can be restored to adequate function and arch integrity without compromising adjacent teeth. Therefore, forced eruption is preferred in the anterior region of the dentition where esthetics is of major concern.