• Journal of Wetlands Research
• /
• v.10 no.1
• /
• pp.59-68
• /
• 2008

Three phases of development in construction projects (i.e. pre-development, construction and post construction) diversely effect the environment, hydraulics and ecosystem. Currently, the domestic environmental policy is in control of the various environmental hazards produced after completion of development operations. Nevertheless, with the enforcement of water pollution total amount management system, improving the water quality; also the water and ecosystem preservation law recommends enforcing the sediment management for development operations in order to lessen the negative impacts to the environment. Recently, the country is experiencing difficulties in various development project locations due to insufficiency of interpreting the fundamental data for sediment loss and miscalculation of soil loss unit loads of sediment. This research utilizes data from 2000 to 2005 discussing a total of 1,036 environment impact assessment projects gathered from various ministries and offices namely Ministry of Environment (MOE), Ministry of Agriculture, the Office of Forestry, and Ministry of Construction and Transportation. Moreover, quantity of sediment from high land agriculture reports involving contaminant discharge characteristic investigation previously did concerning old land agriculture and So-Yang lake non-point pollution source management area as well as management measured data from MOE. The findings of this study reveal that the highest soil loss rate occurred from mountain district for pre-development and post construction and sports facility during construction.

• Korean Journal of Environmental Agriculture
• /
• v.18 no.1
• /
• pp.70-76
• /
• 1999

Since high concentrations of N, P, and organic C cause the excessive eutrophication in water systems, the control of nutrient export from agricultural nonpoint sources has become important. This study was conducted to estimate discharges of N, P, and organic C from a small agricultural watershed of the upper Imgo stream in Youngchun, Kyongbuk. Of the total area(1.420ha), 25% was agricultural land including paddy, upland and orchards and most of the remainder was forest. The resident population in the watershed was 194 in 80 households and relatively small numbers of livestocks including cow were raised. Mean concentrations of nutrients in the stream water were 4.95, 0.80, 6.72, 0.07 and 2.52mg/L for $NO_3-N$, $NH_4-N$, Total N, Total P and COD respectively. Annual discharges in 1997 were 28,991kg of $NO_3-N$. 3,010kg of $NH_4-N$, 37,006kg of Total N. 590kg of Total P, and 29,138kg of COD. There was a strong positive relationship between stream flow and precipitation, and also most of the nutrient discharges occurred in the rainy season (May to August). Since there was no any other industries in the watershed, agricultural practices and sewage from the resident households, forest runoff and livestock wastes were the major sources of NPS discharges. A combination of management options, including management of soil erosion and fertilizer application, could lead to reductions in nutrient exports.

• The Journal of Engineering Geology
• /
• v.20 no.3
• /
• pp.257-269
• /
• 2010

We analyzed patent trends regarding stabilization technology for steep slope hazards, focusing on patents applied for and registered in Korea, the USA, Japan, and Europe. The technology was classified into four groups at the second classification step: prediction techniques, instrumentation techniques, countermeasure/reinforcement/mitigation techniques, and laboratory tests. A total of 2,134 patents were selected for the final effective analysis. As a result of portfolio analysis using the correlation between the number of patents and the applicant for each patent, the Korean and USA situations were classified as belonging to the developing period, and the Japanese and European situations were classified as belonging to the ebbing period. In particular, patent activity in Korea has been enlivened by government-led research. As a result of technology analysis at the second classification step, prediction techniques arising from Japan are evaluated as a competitive power technique, and laboratory tests arising from the USA are evaluated as a competitive power technique. However, prediction techniques and laboratory tests arising from Korea are evaluated as a blank technique. According to the prediction results regarding future research and developments, a new finite element analysis method and a numerical model should be established as part of prediction techniques, as well as sensors, and hazard prediction should be developed by integrating information and equipment using IT technology as part of instrumentation techniques. In addition, improvements to existing structures for erosion control and the development of new slope-reinforcement methods are required as part of countermeasure/reinforcement/mitigation techniques, and new laboratory apparatus and methods with an optimizing structure should be developed as part of laboratory tests.

• Ecology and Resilient Infrastructure
• /
• v.2 no.4
• /
• pp.305-310
• /
• 2015

In 2014, the city of Seoul revised the ordinance regarding water-cycle restoration in the Seoul Metropolitan areas by incorporating the 'Low Impact Development (LID)' policy. The new ordinance plan will utilize 630 mm or almost 45 to 50% of annual rainfall until 2050 by means of providing a rainwater management system consisting of infiltration, retention and vegetation. The LID is believed to be the key to achieving the target requirements, specifically in development projects. This research was performed to evaluate the stormwater runoff and pollutant reduction performance of three different LID facilities (water circulation facilities) including an infiltration inlet, bioretention swale, and permeable pavement constructed in Seoul City. Results show that among the water circulation facilities, the permeable pavement achieved the highest runoff reduction as it was able to entirely capture and infiltrate the runoff to the ground. However, in order to attain a long-term performance it is necessary to manage the accumulated sediment and trapped pollutants in the landscape areas through other water circulation techniques such as through soil erosion control. In terms of pollutant reduction capability, the infiltration inlet performed well since it was applied in highly polluted areas. The bioretention facility integrating the physico-chemical and biological mechanisms of soil, microorganisms and plants were able to also achieve a high runoff and pollutant reduction. The water circulation facilities provided not only benefits for water circulation but also various other benefits such as pollutant reduction, ecological restoration, and aesthetic functions.

• Journal of Environmental Impact Assessment
• /
• v.27 no.5
• /
• pp.417-430
• /
• 2018

Identification and mangement of ecosystem service hotspots are necessary to set environmental policies that include concepts of ecosystem service. Assessment and mapping of ecosystem service hotspot referring areas with high amount of ecosystem services provide essential information to manage ecosystem services effectively. Assessment of hotspots based on regional environmental stakeholders' perception is an useful approach to identify priority areas where management practices are required. This study estimated weights on regulating ecosystem services from regional environmental stakeholders' surveys in Ansan, and then, identified regulating service hotspots with weights. The result indicated that regulating services are, in order of importance, water quality, air quality, erosion, and climate control. The north-eastern forest of Ansan was mainly revealed as an ecosystem service hotspot. Ecosystem service hotspots were spatially distributed similarly regardless of environmental stakeholders' weights. Identification of ecosystem service hotspot with environmental stakeholders' perception can be applied in decision-support tools for ecosystem service management.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.1
• /
• pp.644-653
• /
• 2018

Landslides occur frequently due to the effects of heavy rainfall and typhoons caused by climate change. Erosion control measures are needed to effectively prevent landslide damage. In order to improve their efficiency, it is necessary to quantitatively measure the sediment discharge from the mountain stream. In this study, a load cell sensor was installed in a mountain stream and the measured values were compared according to the applicability and load test type in the mountain stream. The result of the load test showed that the effect of the loading type (load test 1, 2) was low at average (loadings) of 0.4kgf and 0.6kgf at sites 1 and 2, respectively. The load factor was also derived by regression analysis to increase the accuracy of the measured values. According to the results of the load factor (normalized) to the load-cell measurement value, the output value increased by 14.8% and 24.6% in sites 1 and 2, respectively, and was calculated to be similar to the reference value. The load cell sensor enabled us to quantitatively estimate the amount of sediment discharge in the mountain stream through time series analysis with the water level and rainfall information. If the monitoring is carried out for a long time, it can be used to find the sediment discharge mechanism for the mountain stream. In addition, applying sensors such as load-cells to a mountain stream is expected to contribute to the development of related industries, such as the manufacturing of measurement sensors.

• Polymer(Korea)
• /
• v.37 no.3
• /
• pp.347-355
• /
• 2013

In this study, the porous cellulose hydrogel as a carrier to enhance the skin delivery of quercetin and its glycoside, rutin known as flavonoid antioxidants was prepared and its properties were investigated. The optimum cellulose hydrogel for quercetin and rutin was made by the reaction of 2 wt% cellulose with 12% ECH. In the release test of the hydrogel containing the flavonoids, the release of quercetin was diffusion-controlled at $10{\sim}500{\mu}M$, but rutin was released by the erosion of hydrogel system at $10{\sim}50{\mu}M$. Both the encapsulation efficiency and release amount of rutin in hydrogel were higher than quercetin. However, in skin permeation experiment using Franz diffusion cell, quercetin showed higher skin permeation capacity than rutin. The hydrogel containing flavonoids showed remarkable transdermal permeation than the control group. These results suggest that porous cellulose hydrogel is potential drug delivery system to enhance transdermal permeation of water-insoluble flavonoid antioxidants.

• Journal of Korean Society of Forest Science
• /
• v.61 no.1
• /
• pp.69-79
• /
• 1983

To develope the fundamental models suitable for slope stabilization and scenic effect improvement of the roadside slopes, this study has continuously been conducted for last about 10 years through the field survey and observations on the roadside slopes of 100 plots located in the Capital region. The results obtained could be summarized as follows: 1) In general, due to unsuitable treatments and constructions to the man-made bare slope characteristics of the roadsides, the treatment aims for stabilizing and improving the scenic beauty of the slopes have not been successfully reached in the surveyed regions. 2) Particularly, because of insufficiency of the follow-up maintenance techniques to the roadside slopes treated, denudations of slope scenery established as well as the withering of the vegetation planted have been accelerated for the most part of the slopes treated. 3) 6 fundamental models for the roadside slope treatments have been developed and could be edaptable to the nation-wide purposes. The fundamental models are the model of forest scenery match plantation, roadside scenery establishment, denuded land rehabilitation, rock slope greenification, absolute stabilization, and environmental plantation belt establishment, respectively.

• Journal of the Korean Geographical Society
• /
• v.42 no.4
• /
• pp.506-525
• /
• 2007

Incision into bedrock channel is the primary control of landform evolution, but research into bedrock incision process stagnated for long time. Due to the scaling problem of the application of results from flume studies to bedrock channel, there is a strong need to simulate the bedrock incision process with more realistic models. As a part of investigation into controls of bedrock channel incision, three-dimensional changes of rock surface with abrasion was investigated with physical modelling. 18 rock plates were abraded with various sediment particle size and sediment load and abraded surfaces of the plates were scanned with high resolution 3-D scanner. To identify the spatial pattern of erosion of the rock plates, various methods were used. There was no synthetic or holistic method that showed all features of bedrock plate produced by abrasion, so each plate was analyzed using some available methods. Contour maps, shaded relief maps and profiles show that abrasion concentrated on the centre of plate (cross profile) and upstream and downstream edges (longitudinal profile) and eroded area extended inwards. It also found that the cracks and boundaries of forming materials easily eroded than other parts. Changing patterns of surface roughness were investigated with profiles, regression analysis and spectral analysis. Majority of plates showed decrease in small-scale roughness, but it depends on microstructures of the plates rather than general hardness or other factors. SEM inspection results supported this idea.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.35 no.1
• /
• pp.1-10
• /
• 2008

The purpose of this study was to develop the wireless pH telemetry lasting longer than 24 hours in the mouth to overcome the limits of conventional wire telemetry previously used for salivary and plaque pH measurement, and to assess its effectiveness. We developed a wireless pH telemeter which can measure and store the pH profile data during more than 24 hours. It was composed of intraoral part; pH sensor of antimony electrode, battery and microprocessor for data storage, and extraoral part; control/data receiver and data analyzing software which was newly made for this device. After inspecting wireless electrode for accurate measurement, it was attached to the removable intraoral appliance and delivered to the volunteer who was told to wear except brushing time, retrieved after 24 hours and finally the pH profile data was extracted and analyzed. When compared with conventional wire telemetry, this device showed similar results and induced less discomfort to examinees. The data showed pH changes at same time when examinees ate various scheduled foods and beverages. With this method it became possible to accurately measure pH changes within mouth for long time in accordance with individual's lifestyle, definitely reducing the discomfort inflicted to the examinees' life.