• Proceedings of the KIPE Conference
• /
• 2019.07a
• /
• pp.50-52
• /
• 2019

Dynamic resistance equalization is a viable technique to balance SOC of cells in a parallel-connected battery configuration due to high equalization performance, simplicity and low-cost. However, an inappropriate design of the equalization resistor can degrade the equalization performance and increase the power loss. This paper proposes an optimization process to design the equalization resistors to minimize power loss and equalization error. The simulation results show that the optimally designed resistor significantly enhance the performance in comparison with the conventional fixed-resistor equalization.

• Journal of Power Electronics
• /
• v.15 no.3
• /
• pp.775-785
• /
• 2015

Many equalization circuits have been proposed to improve pack performance and reduce imbalance. Although bidirectional equalization topologies are promising in these methods, pre-equalization global equalization strategy is lacking. This study proposes a novel state-of-charge (SoC) equalization algorithm for bidirectional equalizer based on particle swarm optimization (PSO), which is employed to find optimal equalization time and steps. The working principle of bidirectional equalization topologies is analyzed, and the reason behind the application of SoC as a balancing criterion is explained. To verify the performance of the proposed algorithm, a pack with 12 LiFePO4 batteries is applied in the experiment. Results show that the maximum SoC gap is within 2% after equalization, and the available pack capacity is enhanced by 13.2%. Furthermore, a comparison between previously used methods and the proposed PSO equalization algorithm is presented. Experimental tests are performed, and results show that the proposed PSO equalization algorithm requires fewer steps and is superior to traditional methods in terms of equalization time, energy loss, and balancing performance.

• Proceedings of the KIEE Conference
• /
• 1998.11b
• /
• pp.624-626
• /
• 1998

Adaptive channel equalization accomplished without resorting to a training sequence is known as blind equalization. In this paper, we present a auto-switching blind, equalization for 8-VSB HDTV receiver. The scheme operate in two mode : blind equalization mode and decision-directed equalization mode. This proposed scheme changes from the blind equalization mode at high error levels to the decision-directed equalization mode at lower error levels smoothly and automatically. Manual switch from the blind equalization mode to the decision-directed mode is not necessary.

• Journal of information and communication convergence engineering
• /
• v.8 no.2
• /
• pp.136-139
• /
• 2010

We derived Stop-and-go normalized DD, dual-mode normalized Sato, dual-mode NCMA blind equalization algorithm for complex data in this research. And then, the convergence characteristics of the proposed SG-NDD, dual-mode NSato blind equalization algorithms are compared with those of SG-DD, dual-mode Sato algorithms. In general, the normalized blind equalization algorithms have better convergence characteristics than the conventional algorithms.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.7 no.3 s.18
• /
• pp.101-109
• /
• 2004

Image enhancement for Infrared imaging system is mainly based on the global histogram equalization. The global histogram equalization(GHE) is a method in which each pixel is equalized by using a whole histogram of an image. GHE is speedy and effective for real-time imaging system but its method fails to enhance the fine details. On the other hand, the basic local histogram equalization(LHE) method uses sliding a window and. the pixels under the window region are equalized over the whole output dynamic range. The LHE is adequate to enhance the fine details. But this method is computationally slow and noises are over-enhanced. So various local histogram equalization methods have been already presented to overcome these problems of LHE. In this paper, a new regional dynamic range histogram equalization (RDRHE) is presented. RDRHE improves the equalization quality while reducing the computational burden.

• Journal of Communications and Networks
• /
• v.18 no.3
• /
• pp.333-339
• /
• 2016

A multi-stage turbo equalization scheme based on the bit-level combining (BLC) is proposed for multiple-input multiple-output (MIMO) systems with hybrid automatic repeat request (HARQ). In the proposed multi-stage turbo equalization scheme, the minimum mean-square-error equalizer at each iteration calculates the extrinsic log-likelihood ratios for the transmitted bits in a subpacket and the subpackets are sequentially replaced at each iteration according to the HARQ rounds of received subpackets. Therefore, a number of iterations are executed for different subpackets received at several HARQ rounds, and the transmitted bits received at the previous HARQ rounds as well as the current HARQ round can be estimated from the combined information up to the current HARQ round. In addition, the proposed multi-stage turbo equalization scheme has the same computational complexity as the conventional bit-level combining based turbo equalization scheme. Simulation results show that the proposed multi-stage turbo equalization scheme outperforms the conventional BLC based turbo equalization scheme for MIMO systems with HARQ.

• Journal of the Optical Society of Korea
• /
• v.7 no.3
• /
• pp.202-206
• /
• 2003

In this paper, minimum mean-squared-error(MMSE) and blind equalization schemes were employed to improve bit-error-rate(BER) and to reduce inter-symbol interference(ISI) generated during storage and retrieval processes of two-dimensional data in a digital holographic data storage system. We explained methods for designing and applying MMSE and blind equalization to improve BER in a digital holographic data storage system. From experimental evaluations, we compared the BER performances of MMSE and blind equalization and we showed that the BER performances of MMSE and blind equalization were improved significantly compared with those before equalization.

• Journal of Korea Multimedia Society
• /
• v.20 no.2
• /
• pp.188-195
• /
• 2017

The paper presents a histogram equalization method using the edge information of an image to be processed. The basic idea of this method is to carry out histogram equalization with edge information, which is important and essential for object conformation. In the proposed method, the edge information is used to generate histogram for the equalization process. It is found to be effective to suppress the histogram spikes that cause quantum jumps in mapping function for the equalization process. The proposed method is tested for randomly selected 30 images and compared to conventional approaches with a quantitative measure to check it preserves the structural similarity. Experimental results show that the proposed method has better performance and no artifacts caused by histogram spikes.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.123-124
• /
• 2006

This paper investigates an efficient pre-equalization technique that can be applied on the up-link of a time division duplex (TDD) orthogonal frequency division multiplexing (OFDM) systems. This technique provides the spectral efficiency by omitting the usage of training sequences on the up-link. In this paper, the performance of a variety of pre-equalization techniques is analyzed and simulations are performed by applying power efficient pre-equalization algorithms with phase and amplitude & phase pre-equalization in the Rayleigh fading channel.

• Proceedings of the KIPE Conference
• /
• 2007.07a
• /
• pp.350-352
• /
• 2007

Modularized charge equalization converter for HEV lithium-ion battery cells is proposed in this paper, in which intra-module and inter-module charge equalization can be achieved at the same time. For intra-module charge equalization, the conventional flyback DC/DC converters of low power and small size are employed, in which all of the primary sides are coupled in parallel for selective charge of the specific under charged cell within the module. For inter-module charge equalization, the flyback DC/DC converters are also added, in which all the secondary windings are electrically linked in parallel for automatic charge balancing among the modules. An engineering sample of forty cells hiring the proposed cell balancing scheme is implemented and its experimental result shows that the proposed modularized charge equalization circuit has good cell balancing performance.