• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11b
• /
• pp.332-336
• /
• 2001

In this study, the reaction at UBM(Under Bump Metallurgy) and solder interface was investigated. The UBM employed in conventional optical packages, Au/Pt/Ti layer, were found to dissolve into molten Au-Sn eutectic solder during reflow soldering. Therefore, the reaction with different diffusion barrier layer such as Fe, Co, Ni were investigated to replace the conventional Pt layer. The reaction behavior was investigated by reflowing the solder on the pad of the metals defined by Cr layer for 1, 2, 3, 4, and 5 minutes at $330^{\circ}C$. Among the metals, Co was found to be most suitable for the diffusion barrier layer as the wettability with the solder was reasonable and the reaction rate of intermetallic formation at the interface is relatively slow.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.332-336
• /
• 2001

In this study, the reaction at UBM(Under Bump Metallurgy) and solder interface was investigated. The UBM employed in conventional optical packages, Au/Pt/Ti layer, were found to dissolve into molten Au-Sn eutectic solder during reflow soldering. Therefore, the reaction with different diffusion barrier layer such as Fe, Co, Ni were investigated to replace the conventional R layer. The reaction behavior was investigated by reflowing the solder on the pad of the metals defined by Cr layer for 1, 2, 3, 4, and 5 minutes at 330$^{\circ}C$. Among the metals, Co was found to be most suitable for the diffusion barrier layer as the wettability with the solder was reasonable and the reaction rate of intermetallic formation at the interface is relatively slow.

• 한국연소학회:학술대회논문집
• /
• 1999.10a
• /
• pp.11-20
• /
• 1999

Acoustic pressure response and NO formation of hydrogen-air diffusion flames at various pressures are numerically studied by employing counterflow diffusion flame as a model flame let in turbulent flames in combustion chambers. The numerical results show that extinction strain rate increases linearly with pressure and then decreases, and increases again at high pressures. Thus, flames are classified into three pressure regimes. Such non-monotonic behavior is caused by the change in chemical kinetic behavior as pressure rises. Acoustic pressure response in each regime is investigated based on the Rayleigh criterion. At low pressures, pressure-rise causes the increase in flame temperature and chain branching/recombination reaction rates, resulting in increased heat release. Therefore, amplification in pressure oscillation is predicted. Similar phenomena are predicted at high pressures. At moderate pressures, weak amplification is predicted. Emission index of NO shows similar behaviors as to the peak-temperature variation with pressure.

• Journal of the Korean institute of surface engineering
• /
• v.15 no.3
• /
• pp.146-151
• /
• 1982

The electrochemical reaction behavior of nickel electrode of the nickel-cadium battery system in potassium hydroxide solution has been studied by cyclic voltammetry, controlled potential electrolysis and X-ray diffraction method. It has been found that the reaction mechanism of positive nickel electrode for charging was assumed to be proten transfer step with a rate controlling diffusion process and char-ging state of positive electrode was amorphous $\beta$-NiOOH.

• Polymer(Korea)
• /
• v.27 no.5
• /
• pp.421-428
• /
• 2003

The kinetics of photoinitiated polymerization of reactive oligomer methacrylates and oligomer methacrylate/SBS blends have been studied to characterize the diffusion-controlled reaction using Fourier Transform Infrared Spectroscopy-Attenuated Total Reflectance (ATR-FTIR). The polymerization rates of reactive oligomer methacrylates and oligomer methacrylate/SBS blends were autocatalytic in nature at the initial stage and then a retardation of the reaction conversion occurred gradually as the polymer matrix became vitrified, and finally the reaction became diffusion controlled. Photopolymerization behavior of methacrylate/SBS blends was well predicted using the diffusion-controlled reaction model. N-Vinyl-2-pyrrolidinone (NVP) as a reactive solvent was used to incorporate SBS into methacrylate to form semi-IPN via photopolymerization. Due to the high reactivity of NVP, polymerization rate increased with the increase of NVP content. As the content of NVP-SBS in the blends increased up to 10 phr, the reaction conversion maintained almost constant. But above 20 phr of NVP-SBS in the blends, the reaction conversion gradually decreased since the increase of viscosity affected on the photopolymerization rate. The semi-IPN films of methacrylate/SBS blends were transparent at room temperature as well as at increased temperature and were able to be applied to surface coating.

• Korean Journal of Mathematics
• /
• v.4 no.1
• /
• pp.39-43
• /
• 1996

Large-time asymptotic behavior of the solutions of interacting population reaction-diffusion systems are considered. Polynomial stability was proved.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.5 no.2
• /
• pp.122-128
• /
• 1995

Sintered bodies were prepared from ${\alpha} - Al_2O_3/SiO_2$ composite powders which each alumina particles were surrounded by silica particles and investigated the mullitization behavior on the process of reaction - sintering. Mullitized reaction was started by formation of amorphous aluminosilicate inter - layer and proceeded by diffusion of alumina through this inter-layer. The growth of mullite was happened along the surface of alumina and controlled by the rate of diffusion.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1995.10a
• /
• pp.43-44
• /
• 1995

The diffusion behavior of liquid into polymer has been described by Fick's law, but the departure from Fickian diffusion is frequently found. In this study, 'noble' expressions for the rates of relaxation and sorption are introduced to eliminate these limitations. The ralaxation-sorption coupled mechanism model are based on the possibility of contacting liquid molecule and the active site which has the numerical concept of free volume. The concept has an analogy of reaction rate expressed by the possibility of collision with molecules and used in adsorption and reactive extraction etc. The new model simulated by Rungc-Kutta method for initial-value problem and Fickian diffusion is caompared with experimental data. The results show that the ralaxation-sorption coupled mechanism is able to account well for Fickian and non-Fickian sorption behavior including sigmoid and two-stage. In addition, this model has a chance of expansion to multi-component sorption with ease.

• Journal of applied mathematics & informatics
• /
• v.16 no.1_2
• /
• pp.69-78
• /
• 2004

This paper treats the conditions for the existence of rotating wave solutions of a system modelling the behavior of students in graduate programs at neighbouring universities near each other which is a modified form of the model proposed by Scheurle and Seydel. We assume that both types of individuals are continuously distributed throughout a bounded two-dimension spatial domain of two types (circle and annulus), across whose boundaries there is no migration, and which simultaneously undergo simple (Fickian) diffusion. We will show that at a critical value of a system-parameter bifurcation takes place: a rotating wave solution arises.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.4
• /
• pp.907-912
• /
• 2009

Complex breakup behavior in the revival wave has been observed in the Belousov-Zhabotinsky(BZ) reaction system containing 1,4-cyclohexanedione (1,4-CHD) in the dish divided into two compartments with a sliding window. A same reaction mixture is poured into the two compartments individually with time difference. Wave propagation exhibited different behavior in the revival wave of the reaction system. This was largely dependent on the progress time prior to the pouring into each compartment and on the gap between the times of pouring into the two compartments. The revival wave in the reaction system is induced spontaneously as a new wave train with a long time lag after the disappearance of the initially induced wave. A thoroughgoing study of the chaotic breakup of propagating chemical wave train was to be possible since the revival wave has a longer wavelength, clearer wave-train patterns, and longer duration period.