• Journal of Conservation Science
• /
• v.27 no.3
• /
• pp.301-312
• /
• 2011

Epoxy resin has superior durability and adhesive strength and proper physical strength so that it is used to diversity materials for multi-purposes. However epoxy resin is hardly removed after hardening specially once it is applied to artefacts, it is difficult to remove them under re-conservation. This paper is an experimental study on removing epoxy resin applied to iron objects using Nd:YAG laser cleaning system. Tests conducted in this study investigated how increasing laser energy and pulses would give effect on samples. The samples were prepared in a way that epoxy resin, itself pure and one which was mixed with pigment and they were applied to iron coupons and corroded iron coupons respectively. As a result of experiment, pure epoxy resin applied to corroded iron coupons was ablated at high laser energy but epoxy resin applied to iron coupons and mixing with pigment were not ablated but discolored and bubbled due to laser-induced heat generation. Results of FT-IR showed no component alteration of shifted resins and no residues on the surfaces ablated by laser irradiation. From SEM-EDS for removed surfaces, the debris from epoxy resin and melting iron was observed. Therefore, this study demonstrated the possibilities and limitations for laser cleaning to remove epoxy resin from iron objects.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.2 no.2
• /
• pp.155-160
• /
• 1969

The soil textures and chemical compositions of Tapes Philippinarum beds were investigated in order to estimate the grade of the habitat soil of T. Philippinarum for the improvement of natural tidal flats. The coefficients of correlation between tile percentages of debris, coarse sand, fine sand, silt, and clay of the habitat soil, and the population density of T. Philippinarum were 0.78, 0.73, -0.42, -0.68, and -0.51 respectively. And the optimum levels of same were above $13.5\%,\;above\;23.0\%\;below\;41.5\%,\;below\;10.0\%$, and below $6.8\%$ respectively The $SiO_2\;Al_2O_3+Fe_2O_3$ ratio of the soil of T. Philippinarum beds showed the range of 5.09 to 5.60. The levels of soil pH, water holding capacity, organic matter, total nitrogen, available phosphorus, exchangeable magnesium were 6.15-6.60, $4.26-6.86\%$, $0.40-1.10\%$ 14.0-27.0 ppm, $0.041-0.394\%,\;and\;0.009-0.132\%$ respectively.

• Journal of Chest Surgery
• /
• v.36 no.8
• /
• pp.630-632
• /
• 2003

In off-pump coronary artery bypass grafting (CABG), multiple proximal anastomosis may increase the risk of cerebral embolism (air, debris) and aortic injury (dissection, pseudoaneurysm). Radial artery (RA) has no intraluminal valve such as saphenous vein. We applied Cabrol technique using aortic root replacement for proximal anastomosis in off-pump CABG. Cabrol technique using RA graft can reduce numbers of proximal anastomosis and reduce number of aortic manipulation in off-pump CABG. We report a Cabrol technique for proximal anastomosis in off-pump CABG with RA graft.

• Korean Journal of Ecology and Environment
• /
• v.33 no.3 s.91
• /
• pp.295-303
• /
• 2000

The water clarification efficiency was examined in a shallow wetland where dense vegetation was formed naturally in an abandoned paddy field. And, also two enclosure experiments were carried out to measure the effects of materials exchange between sediment and the overlying water with the existence of vegetation and accumulated litter. The hydraulic retention time of wetland was regulated in 1.2 day. The removal rates of SS (56%) and $NO_3-N$ (61%) were high, considering its short retention time. However, removal efficiencies of VSS (28%), COD (14%), DOC (1%),and TP (0.2%) were relatively lower. This low removal efficiencies were thought to be due to the release of dissolved form of organic matter and phosphorus from the sediment. Most of constituents except nitrate were higher in the enclosure at the beginning of enclosure installation than that of the outflowing water from wetland. And then, it has fluctuated and decreased with time. The wetland was in equilibrium state of settling, accumulation of organic debris, and regeneration of dissolved material from sediment. So ultimately high primary production by dense vegetation in the wetland may be the reason of unfavorable or low treatment efficiency of wetland after many years of operation for wastewater treatment. However, the water quality of effluent from the wetland showed smaller variation and better condition than that of inflow, especially during storm events. It can be concluded that this wetland is suitable for the improvement of water quality from nonpoint sources.

• Journal of Veterinary Clinics
• /
• v.27 no.1
• /
• pp.1-5
• /
• 2010

Enterocytozoon bieneusi, a microsporidian species, has emerged as an opportunistic pathogen in AIDS patients. This organism has also been identified in a wide range of animals, and the zoonotic potential of human infections is of particular interest. This study revealed that this organism was found with relatively high prevalence in feces of asymptomatic cattle in Korea. Fecal specimens were obtained from a total of 1,720 cattle in a slaughterhouse located in Chungnam province, Daejeon city and Chonbuk province. After removal of fecal debris by sieving and density gradient centrifugation, samples were examined by microscopic examination and then nested polymerase chain reaction (PCR). Microscopic examination with the modified trichrome staining for the fecal specimens revealed 194 (11.28%) positive calves for microsporidia spore. PCR using the specific primer for E. bieneusi revealed 79 (4.59%) positive calves. The infection ratio of microsporidia was higher in March than other season.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.37 no.11
• /
• pp.1349-1354
• /
• 2013

Sealing structure to prevent flowing hot gas into the driving device, located between the driving shaft and the liner of On-Off valve for controlling the hot gas flow path was studied. Wear occurs due to the constant movement of the driving shaft controlled by actuator on graphite as the sealing material. In this paper, the dynamic wear behavior in high temperature of graphite(HK-6) to be used as sealing material was evaluated. Reciprocating wear test was carried out for the graphite(HK-6) to the relative motion between shaft materials(W-25Re). The results of friction coefficient and specific wear rate according to contact load, sliding speed at room temperature and $485^{\circ}C$ considering the actual operating environment were evaluated. Through the SEM analysis of the worn surface, third body as lubricant films were observed and lubricant effect of third body was considered.

• Journal of Korea Water Resources Association
• /
• v.43 no.11
• /
• pp.967-976
• /
• 2010

AFDA (Approximate Full Distribution Approach) model of FORM (First-Order Reliability Model) which can quantitatively calculate the probability that storm sewer reach to performance limit state was developed in this study. It was defined as a failure if amount of inflow exceed the capacity of storm sewer. Manning's equation and rational equation were used to determine the capacity and inflow of reliability function. Furthermore, statistical characteristics and distribution for the random variables were analyzed as a reliability analysis. It was found that the statistical distribution for annual maximum rainfall intensity of 10 cities in Korea is matched well with Gumbel distribution. Reliability model developed in this study was applied to Y shaped storm sewer system to calculate the probability that storm sewer may exceed the performance limit state. Probability of failure according to diameter was calculated using Manning's equation. Especially, probability of failure of storm sewer in Mungyeong and Daejeon was calculated using rainfall intensity of 50-year return period. It was found that probability of failure can be significantly increased if diameter is decreased below the original diameter. Therefore, cleaning the debris in sewer pipes to maintain the original pipe diameter should be one of the best ways to reduce the probability of failure of storm sewer. In sewer system, two sewer pipes can flow into one sewer pipe. For this case, probability of system failure was calculated using multiple failure mode. Reliability model developed in this study can be applied to design, maintenance, management, and control of storm sewer system.

• Journal of the Korean association of regional geographers
• /
• v.2 no.2
• /
• pp.173-182
• /
• 1996

The intent of this paper is to examine the talus in Chon-hwang-san in the southern part of Korean Peninsula, and then analyze its geomorphic feature and origin. The research is summarized as follows; (1) The talus is 220m long and the range of the width from 10 to 75m. The mean gradient is $33^{\circ}$ and the mean block size is $110{\times}59cm$(long axis$\times$short axis). The overall appearance of the talus is tongue-shaped and the geology of the constituent blocks is dacite. (2) This talus has two particular geomorphic landscapes. One is that the talus has not free face as source of blocks back of itself; the free face of the talus has been parallel retreated to disappearance by frost attack. The other is that the upper part of the talus is on the ridge. (3) This talus is classified into rock fall talus type, and the shape of rock fragments is angular. When considered in conjunction with face of being mentioned above, the morphology and lithology of the talus are best explained on the basis of origin under periglacial environment during late pleistocene time. (4) Most constituent rock debris are now lichen-covered, or covered with a mantle of weathering. There is no evidence of appreciable movement and for supplying block. Therefore, the talus appears to be relict or fossil form stage, currently.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.14 no.2
• /
• pp.169-178
• /
• 2016

The properties of wastes for melting need to be considered to minimize the maintenance of refractory and to discharge the molten slags smoothly from a plasma torch melter. When the nonflammable wastes from nuclear facilities such as concrete debris, glass, sand, etc., are melted, they become acid slags with low basicity since the chemical composition has much more acid oxides than basic oxides. A molten slag does not have good characteristics of discharge and is mainly responsible for the refractory erosion due to its low liquidity. In case of a stationary plasma torch melter with a slant tapping port on the wall, a fixed amount of molten slags remains inside of tapping hole as well as the melter inside after tapping out. Nonmetallic slags keep the temperature higher than melting point of metal because metallic slags located on the bottom of melter by specific gravity difference are simultaneously melted when dual mode plasma torch operates in transferred mode. In order to minimize the refractory erosion, the compatible refractories are selected considering the temperature inside the melter and the melting behavior of slags whether to contact or noncontact with molten slags. An acidic refractory shall not be installed in adjacent to a basic refractory for the resistibility against corrosion.

• Economic and Environmental Geology
• /
• v.29 no.4
• /
• pp.421-428
• /
• 1996

The occurrence, optical property, chemical composition, crystal structure and formation environments of the phillipsite within deep-sea manganese nodules were systematically investigated in this study. Phillipsite in manganese nodules occurs in nucleus of nodules along with consolidated bottom sediments, weathered volcanic debris, and interstitial grains in the each layer of manganese encrusts. Phillipsite is predominantly pseudomorphs of volcanic shards, and occurs as white to pale yellow in color lath-shaped and equant crystals. These show aggregations of prismatic, blocky, and bladed of 2 to $20{\mu}m$ long, and 2 to $5{\mu}m$ thick. The simplified average chemical formula of phillipsite is $({Ca_{0.1}Mg_{0.3}Na_{1.1}K_{1.5}})_3{(Fe_{0.3}Al_{4.2}Si_{11.8})O_{32}{\cdot}10H_2O}$ with a very siliceous and alkalic. The $Si/(Al+Fe^{+3})$ ratio is 2.37 to 2.78 and alkalis greatly exceed the divalent exchangeable cations, and Na/K ratio is 0.59 to 0.81. The phillipsite is monoclinic ($P2_l/m$) with the unit-cell parameters, $a=10.005{\AA}$, $b=14.129{\AA}$, $c=8.686{\AA}$, ${\beta}=124.35^{\circ}$, and $V=1013.6{\AA}^3$. Phillipsites in manganese nodules formed apparently authigenically at a temperature less than $10^{\circ}C$, and they crystallized at a pressure of less than 0.7 kb, and pH of about 8 in deep-sea environments.