• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.24 no.2
• /
• pp.128-137
• /
• 2012

This paper deals with the local scour around a pipeline exposed to combined waves and current in the shallow water zone. To investigate the characteristics of the scour around a pipeline on the sea bed, experiments were performed according to the various pipe diameters, wave periods, wave heights, and current velocities. Wave generator and current generator were used for the experiments. Two current directions were used ; co-direction and counter direction to the waves. With the experimental results, the correlations between the scour depths and non-dimensional parameters such as Keulegan-Carpenter number(KC), Froude number(Fr), Ursell number(Ur) and velocity ratio were analysed. The relative scour depths were found obviously to be dominated by the wave component when the velocity ratio function approaches zero and those are gorverned by the current component when the velocity ratio approaches unity. Velocity ratio function was approved to be a proper parameter which is able to express the change of the scour in the combined wave and current zone. Also considering the orbital velocity and the current velocity into Fr numer and KC number respectively, scour depths show more favorable correlationship with the parameters.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.4 no.4
• /
• pp.2-12
• /
• 1967

A pair of insulated-gate metal-oxide-semiconductor field-effect transistor has been used to measure the direct current produced from the ionization chamber in the range of to A. An analisis of direct-current differential amplifier giving the expressions of the common-mode rejection ratio and the rralization of the constant-current generator to give very large effective source resistance has been presented. Voltage gain is 6.6, drift at the room temperature is 1.5mv per day. The common-mode rejection ratio is obtained maximum 84db. These facts give the feasibility of small direct-current measurements by utilizing this type transistors.

• Journal of Power Electronics
• /
• v.5 no.1
• /
• pp.36-44
• /
• 2005

This paper presents an implementation of high performance control of a reluctance synchronous motor (RSM) using a neural network with a direct torque control. The equivalent circuit in a RSM, which considers iron losses, is theoretically analyzed. Also, the optimal current ratio between torque current and exiting current is analytically derived. In the case of a RSM, unlike an induction motor, torque dynamics can only be maintained by controlling the flux level because torque is directly proportional to the stator current. The neural network is used to efficiently drive the RSM. The TMS320C3l is employed as a control driver to implement complex control algorithms. The experimental results are presented to validate the applicability of the proposed method. The developed control system shows high efficiency and good dynamic response features for a 1.0 [kW] RSM having a 2.57 ratio of d/q.

• Journal of Power Electronics
• /
• v.13 no.2
• /
• pp.250-255
• /
• 2013

This paper proposes an optimal current distribution method of dual-rotor brushless DC machines (DR-BLDCMs) which have inner and outer surface-mounted permanent-magnet rotors. The DR-BLDCM has high power density and high torque density compare to the conventional single rotor BLDCM. To drive the DR-BLDCM, dual 3-phase PWM inverters are required to excite the currents of a dual stator of the DR-BLDCM and an optimal current distribution algorithm is also needed to enhance the system efficiency. In this paper, the copper loss and the switching loss of a DR-BLDCM drive system are analyzed according to the motor parameters and the switching frequency. Moreover, the optimal current distribution method is proposed to minimize the total electrical loss. The validity of the proposed method was verified through several experiments.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.6
• /
• pp.1503-1511
• /
• 2013

This paper deals with the analysis of leakage current characteristics of silicone rubber insulator in order to develop a new condition monitoring tool to identify the flashover of outdoor insulators. In this work, laboratory based pollution performance tests are carried out on silicone rubber insulator under ac voltage at different pollution levels and relative humidity conditions with sodium chloride (NaCl) as a contaminant. Min-Norm spectral analysis is adopted to calculate the higher order harmonics and Signal Noise Ratio (SNR). Choi-Williams Distribution (CWD) function is employed to understand the time frequency characteristics of the leakage current signal. Reported results on silicone rubber insulators show that the flashover development process of outdoor polymer insulators could be identified from the higher order harmonics and signal noise ratio values of leakage current signals.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.54 no.1
• /
• pp.20-29
• /
• 2005

This paper presents an implementation of efficiency optimization of reluctance synchronous motor (RSM) using a neural network (NN) with a direct torque control (DTC). The equipment circuit considered with iron losses in RSM is analyzed theoretically, and the optimal current ratio between torque current and exiting current component are derived analytically. For the RSM driver, torque dynamic can be maintained with DTC using TMS320F2812 DSP Controller even with controlling the flux level because a torque is directly proportional to the stator current unlike induction motor. In order to drive RSM at maximum efficiency and good dynamics response, the Backpropagation Neural Network is adapted. The experimental results are presented to validate the applicability of the proposed method. The developed control system show high efficiency and good dynamic response features with 1.0 [kW] RSM having 2.57 inductance ratio of d/q.

• Transactions on Electrical and Electronic Materials
• /
• v.3 no.2
• /
• pp.28-31
• /
• 2002

The Cdl-xZnxTe film was fabricated by thermal evaporation for the flat-panel X-ray detector. The stoichimetric ratio and the crystal structure of a polycrystalline Cd$_{1-x}$ Zn$_{x}$Te were investigated by EPMA and XRD, respectively. The leakage current and X-ray sensitivity of the fabricated films were measured to analyze the X-ray response characteristic of Zn in the polycrystalline CdZnTe thin film. The leakage current and the output charge density of Cd$_{0.7}$Zn$_{0.3}$Te thin film were measured to 0.37 nA/cm$^2$ and 260 pc/cm$^2$ at an applied voltage of 2.5 V/${\mu}{\textrm}{m}$, respectively. Experimental results showed that the increase of Zn doping rates in Cd$_{1-x}$ Zn$_{x}$Te detectors reduced the leakage current and improved the signal to noise ratio significantly.

• Journal of the Korean Ceramic Society
• /
• v.22 no.5
• /
• pp.29-34
• /
• 1985

The PTCR characteristics of the $BaTiO_3$ as a function of the molten KCl and dopant $Sb_2O_3$ were investitated. When the weight ratio of KCl to raw materials was above 0.1, $BaTiO_3$ was synthesized by calcining at 80$0^{\circ}C$ for 6 hrs. As the amount of the KCl increased the resistivity of the $BaTiO_3$ at room temperature incr-eased. This can be explained by charge compensation effect between electrons and holes and with microstruc-tures change of the specimens. The resistivity of the $BaTiO_3$ decreased with increasing amount of $Sb_2O_3$. In the time-current characteristics initial current decreased with increasing the ratio of KCl to raw materials but initial current increased and then decreased with the increase of the dopant $Sb_2O_3$. These results of the time-current characteristics can be explained by the resistivity-temperature characteristics.

• Proceedings of the KIEE Conference
• /
• 2002.11d
• /
• pp.21-23
• /
• 2002

We designed and manufactured helical magnetic flux compression generator, in which, the current density was reduced by increasing the number of wires by stages, and the voltage between wires was reduced by decreasing the time rate of inductance change. The figure of merit and the energy multiplication ratio of the generator were measured as a function of current density flowing through coil and their characteristics were analyzed. When the current density of coil was more than 250 kA/cm, the figure of merit and the energy multiplication ratio were decreased rapidly.

• Journal of the Korean Vacuum Society
• /
• v.1 no.1
• /
• pp.134-138
• /
• 1992

The GaAs/AlAs double barrier structures was grown by MBE(Mo1ecular Beam Epitaxy). Mesa diode was fabricated and I-V characteristics of the diode were measured by semiconductor parameter analyser at room temperature. TEM pictures show the double barrier structure with abrupt interface. PVCR(Peak to Valley Current Ratio) proves to be independent of barrier thickness. These results show that increase in barrier thickness leads to larger valley current by non-resonant tunneling.