• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.7 no.6
• /
• pp.34-41
• /
• 1993

This paper describes an effort to develop a microcomputer-based parameter identification system for three phase and two phase brushless DC motor. Back EMF equation is derived from back EMF waveform of three phase and two phase brushless DC motor. In this paper, a new identification algorithm for the brushless DC motor parameters by Pasek's technique is de veloped. It is found that Pasek's equation is valid for the brushless DC motor, too. The results obtained clearly shows that it is possible to implement the identification system for the determination of the brushless DC motor parameters. To minimize errors due to the ripple component in the measured armature current, dlgital averaging filter is employed. The whole identification process of signal generation, measuring, parameter determination is fully automated. The use of the pmpased method in the parameter identification system shows that the averaged current curve is in excellent agreement with the estimated current curve. Therefore, this close agreement conf i i the validity of this technique.

• Journal of the Korean Data and Information Science Society
• /
• v.23 no.6
• /
• pp.1093-1102
• /
• 2012

In this paper, we predicted the interest spread using the VAR (vector autoregressive) model. Variables used in the VAR model were selected among 56 domestic and foreign macroeconomic time series through crosscorrelation and Granger causality test. The performance of the VAR model was compared with the univariate time series model, AR (autoregressive) model, in view of MAPE (mean absolute percentage error) and RMSE (root mean square error) of forecasts for the last twelve months.

• Journal of Environmental Health Sciences
• /
• v.10 no.1
• /
• pp.1-12
• /
• 1984

The stochastic characteristics of the daily range of water temperature variation was analyzed by employing the techniques of autocorrelation coefficient, autoreggresive model and crosscorrelation model. These time series included daily observations on maximum and minimum values of water temperature and air temperature. The measurement was made by automatic recording instrument at Gu-yee and Dook-do in Han River, and at Waegwan and Gu-mi in Nackdong River in 1981. As a result of this study, it was found that (1) The correlogram of daily water temperature ranges $\Delta AT_i$ and daily air temperature $\Delta AT_i$ at Gu-mi and Gu-yee showed the exponential curves. (2) The most high frequency values of $\Delta AT_i$ and $\Delta WT_i$ were 11$\circ$C and 0.5${\circ}C$ respectively at every measuring site. (3) The correlation coefficients between the daily mean air temperature AT$_i$ and the daily mean water temperature were fairly high as 0.966 at Dook-do and 0.949 at Gu-yee, but the correlation coefficients between $\Delta AT_i$ and $\Delta WT_i$ were very low as 0.1074 at Gu-yee and 0.0324 at Dook-Do.

• 제어로봇시스템학회:학술대회논문집
• /
• 1999.10a
• /
• pp.141-144
• /
• 1999

The authors have recently developed a new method for identification of Volterra kernels of nonlinear systems by use of pseudorandom M-sequence and correlation technique. And it is shown that nonlinear systems which can be expressed by Volterra series expansion are well identified by use of this method. However, there exist many nonlinear systems which can not be expressed by Volterra series mathematically. A nonlinear system having backlash type nonliear element is one of those systems, since backlash type nonlinear element has multi-valued function between its input and output. Since Volterra kernel expression of nonlinear system is one of the most useful representations of non-linear dynamical systems, it is of interest how the method of Volterra kernel identification can be ar plied to such backlash type nonlinear system. The authors have investigated the effect of application of Volterra kernel identification to those non-linear systems which, accurately speaking, is difficult to express by use of Volterra kernel expression. A pseudorandom M-sequence is applied to a nonlinear backlash-type system, and the crosscorrelation function is measured and Volterra kernels are obtained. The comparison of actual output and the estimated output by use of measured Volterra kernels show that we can still use Volterra kernel representation for those backlash-type nonlinear systems.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.1
• /
• pp.53-59
• /
• 2000

We propose a modified nonlinear fiber optic interferometer which can serve to generate binary optical pulse sequences for CDMA networks, and to decode them. In one arm cross-phase modulation between a CW signal and a counter- or copropagating high-power pulse takes place in sequences of segment connected via VDM couplers. Preliminary experimental results on code generation as well as autocorrelation and crosscorrelation are presented, using Sagnac interferometer. As we expected, the experimental results show that the outputs of the interferometer device are not summed simply on the basis of power, but the sin-squared version of it. Arbitrary codes can in principle be implemented.

• Proceedings of the IEEK Conference
• /
• 2001.06d
• /
• pp.151-154
• /
• 2001

In this Paper, a new harmonic imaging technique is proposed and evaluated experimentally. In the proposed method, a weighted chin signal with a hanning window is transmitted. The RF samples obtained on each array element are individually compressed by correlating with the reference signal defined as the 2nd harmonic (2f0) component of a transmitted chirp signal generated in a square-law system. The proposed method uses the compressed 2f0 component to form an image, for which the crosscorrelation term with f0 component should be suppressed below at least -60dB. After experiment, the 6dB pulse width and peak sidelobe level of the compressed 2f0 component were 0.7us and -60dB, respectively. This result shows that the proposed method can successfully eliminate the f0 component with a single transmit-receive event and therefore is more efficient than the conventional pulse inversion (PI) method in terms of frame rate. We also observed that the 2nd harmonic compont starts to decrease for source pressure higher than 210kPa in water, which implies that SNR of the 2nd harmonic imaging using short pulses cnanot be incresed beyond a certain limit.

• Proceedings of the IEEK Conference
• /
• 2001.06d
• /
• pp.155-158
• /
• 2001

A new method for simultaneous multiple transmit focusing using orthogonal weighted FM chirp is proposed. Weighted chirp signals focused at different depths are transmitted at the same time. These chirp signals are mutually orthogonal in the approximate sense that the autocorrelation function of each signal has a narrow mainlobe width and low sidelobe levels, and the crosscorrellation function of any pair of the signals has smaller values than the sidelobe levels of each autocorrelation function. This means that each weighted chirp signal can be separately compressed into a short pulse, focused individually and combined with other focused beams to form a frame of image. Theoretically, any two chirp signals defined in two nonoverlapped frequency bands are mutually orthogonal. In the present work, however, a fractional overlap of adjacent frequency bands, by up to 25%, were permitted to design more chirp signals within a given transducer bandwidth. The crosscorrelation values due to the frequency overlap could be reduced by alternating the direction of frequency sweep of the adjacent chirp signals. The simulation results show that this method can improve the lateral resolution of image without sacrifice in the frame rate compared with the conventional pulse system.

• 제어로봇시스템학회:학술대회논문집
• /
• 1998.10a
• /
• pp.451-454
• /
• 1998

This paper proposes a new method of Model Predictive Control (MPC) of nonlinear process by us-ing the measured Volterra kernels as the nonlinear model. A nonlinear dynamical process is usually de-scribed as Volterra kernel representation, In the authors' method, a pseudo-random M-sequence is ar plied to the nonlinear process, and its output is measured. Taking the crosscorrelation between the input and output, we obtain the Volterra kernels up to 3rd order which represent the nonlinear characteristics of the process. By using the measured Volterra kernels, we can construct the nonlinear model for MPC. In applying Model Predictive Control to a nonlinear process, the most important thing is, in general, what kind of nonlinear model should be used. The authors used the measured Volterra kernels of up to 3rd order as the process model. The authors have carried out computer simulations and compared the simulation results for the linear model, the nonlinear model up to 2nd Volterra kernel, and the nonlinear model up to 3rd order Vol-terra kernel. The results of computer simulation show that the use of Valterra kernels of up to 3rd order is most effective for Model Predictive Control of nonlinear dynamical processes.

• Water for future
• /
• v.14 no.4
• /
• pp.19-26
• /
• 1981

The auto-and cross-correlation function, power spectrum, coherence function and Markov model are applied to investigate the statistical characteristics of discharge and each factor of water quality and the interrelation-ship between the variation of discharge and water quality factors. The analysis of discharge, dissolved oxygen and electric conductivity, which were only obtainable data at the Indogyo gagining station in the downstream of the Han River, clearly showed that they hace distinct period of 12 months and three different periods of 6, 4 and 3 months weaker than the former. The cross-correlation between the discharge and water quality(DO, COND) is rather weak and the crosscorrelation function has its peak at lag one. It is considered therefrom that the variation of discharge behaves on water quality facotrs with one day's difference. In the examination of linear regression model for the serial generation and predictive measures, discharge series is fit to first and second order Markov model and DO, COND to first order Markov model.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1C
• /
• pp.1-5
• /
• 2008

Optical code division multiple access(OCDMA) systems make the active users to share the bandwidth by simply assigning distinct optical orthogonal codeword to each active user. An optical orthogonal code(OOC) is a collection of binary sequences with good correlation properties which are important factors of determining the capacity of OCDMA systems. Recently, 2-D OOC construction method is frequently researched which is able to support more users than 1-D OOC. In this paper, a combinatorial construction of simple multi-weight 2-D OOC with autocorrelation 0 and crosscorrelation 1 is proposed and the bound on the size of these codes is derived.