• Journal of Broadcast Engineering
• /
• v.25 no.1
• /
• pp.36-47
• /
• 2020

The improved belief-propagation-based algorithms, such as normalized min-sum algorithm (NMSA) or offset min-sum algorithm (OMSA), are widely used to decode LDPC(Low-Density Parity-Check) codes because they are less computationally complex and work well even at low SNR(Signal-to-Noise Ratio). However, these algorithms work well only when an appropriate normalization factor or offset value is used. A new method that uses a CMD(Check Node Message Distribution) chart and least-square method, which has been recently proposed, has advantages on computational complexity over other approaches to get optimal coefficients. Furthermore, this method can be used to derive coefficients for each iteration. In this paper, we apply this method and propose an algorithm to derive a combination of normalization factor and offset value for a combined normalized and offset min-sum algorithm to further improve the decoding of LDPC codes. Simulations on the next-generation broadcasting standards, ATSC 3.0 LDPC codes, prove that a combined normalized and offset min-sum algorithm which takes the proposed coefficients as correction coefficients shows the best BER performance among other decoding algorithms.

• The KIPS Transactions:PartC
• /
• v.11C no.3
• /
• pp.353-360
• /
• 2004

In this Paper, We propose an efficient iteration decoding control method with variable iteration decoding of iteration codes decoding using Cyclic Redundancy Check. As the number of iterations increases, the bit error rate and frame error rate of the decoder decrease and the incremental improvement gradually diminishes. However, when the iteration decoding number is increased, it require much delay and amount of processing time for decoding. Also, It can be observed the error nor that the performance cannot be improved even though increasing of the number of iterations and SNR. So, Suitable number of iterations for stopping criterion is required. we propose variable iteration control method to adapt variation of channel using Frame Error-Check indicator. Therefore, the amount of computation and the number of iterations required for iteration decoding with CRC method can be reduced without sacrificing performance.

• Atmosphere
• /
• v.25 no.4
• /
• pp.707-718
• /
• 2015

This study investigates the characteristics of turbulent fluxes observed at Ieodo Ocean Research Station (IORS) in autumn 2014. The 10 Hz IORS data is quality controlled and calculated to be the 30 minutes turbulent fluxes. The quality control consists of five steps: a weather check, Vickers and Mahrt (VM) sequential check, VM parallel check, flag check, and direction check. Since the IORS is an open-sea station with no orographic influence, there are no significant diurnal variations for the turbulent fluxes and 10 m wind speed. According to stabilities, the unstable and semi-unstable states appear more than 28% and 70% in autumn, respectively and they have strong winds of over $10m\;s^{-1}$. In addition, the turbulent fluxes increase with increasing wind speed. In particular, the latent heat flux and its deviations are clearly shown because the latent heat flux is influenced by the change of both the sea surface roughness and wave height induced by the wind. To demonstrate the changes of the turbulent fluxes before and after typhoon, Vongpong (1419), which is the most intense typhoon affecting the Korean Peninsula in 2014, is considered. The turbulent flux fluctuates in accordance with the location of Vongpong. The turbulent fluxes have a large (small) variation when Vongpong approaches (retreats) at the IORS. The overall results represent that the IORS data helps us understand physical processes related to air-sea interaction by providing the valuable and reliable observed data.

• Archives of Plastic Surgery
• /
• v.35 no.2
• /
• pp.219-222
• /
• 2008

Purpose: The purpose of this study is to develop hydroxyapatite cement simplified procedures for reconstruction of craniofacial deformities. Due to its expense and characteristics of quick hardening time, it may be inappropriate for forehead reconstruction or augmentation. Therefore we hear by introduce a more precise, easy and cheap method. The authors report forehead reconstruction with hydroxyapatite cement for a patient who suffered from craniofacial deformity. Methods: Case report and literature review. Results: A 35 year old man came to us with forehead and temporal area depression. He had a history of brain operations due to traumatic epidural hematoma. A physical exam showed an evidence of right side forehead weakness sign. Authors made RP model of his skull and applied check framework with Kirschner's wires for measuring accurate volume and contour on the depressed right side forehead area on the RP model. After complete exposure of defect area by bicoronary insicion, absorbable plate which applied on skull area was removed. Using three Kirschner's wires, authors made check framework on the right forehead lively and fixed with 2-hole miniplates on the boundary of the defect. After checking asymmetry, hydroxyapatite was applied on check shape framework just above Kirschner's wire. After removing Kirschner's wire, we corrected minimal unbalance and contour with bur. Conclusion: Check framework with Kirschner's wire was very convenient and cost saving methods for forehead reconstruction with hydroxyapatite cement.

• Korean Journal of Clinical Laboratory Science
• /
• v.40 no.1
• /
• pp.55-61
• /
• 2008

Obesity is correlated with diabetes mellitus, hyperlipidemia, hypertension, cardiovascular, renal, neurologic, psychological and many other disease. Owing to the elevated income and behavioral changes, the prevalence of obesity has remarkably increased in Korea also. Considering the trend of the epidemic, we can easily expect the excessive spendings for the treatment of the obesity-related diseases in near future. In order to check the prevalence of obesity and serum lipid levels of Korean employees, we analyzed the medical check-up sample data of 10,332 adults who took physical check-ups at an institute in 2006. Through the logistic regression analysis we found the prevalence rate of total risk group showing ${\geq}23.0Kg/m^2$ was 57.4% and uric acid was found to be a definitive factor in the prevalence of obesity. Among the adults who eat more meat, drink more and smoke more smoking, the values of BMI, uric acid, cholesterol, HDL- and LDL-cholesterol and TG were significantly higher than rest of the examinees. And the average BMIs were significantly higher among those who have risk factors of liver disease, hypertension, cardiovascular and heart disease, and diabetes mellitus.

• Korean Journal of Veterinary Research
• /
• v.57 no.4
• /
• pp.227-233
• /
• 2017

To reduce swine production costs, a slaughter check system has been developed in countries with an advanced swine industry. Evaluation of lung lesions in carcasses is a critical part of the slaughter check system. This study was performed to collect background information for use in developing a slaughter check system in Korea. Lung tissues and their gross images were collected from slaughterhouses in Gyeonggi-do, Korea. Scoring of the gross lung lesions was performed on the lung images. Histopathologic examination was conducted to classify the pulmonary lesions as bronchopneumonia or interstitial pneumonia. Scores of the gross lung lesions were significantly different between bronchopneumonia and interstitial pneumonia groups (p < 0.001). A 90% confidence interval of gross lung lesion scores was established for the bronchopneumonia group, and the lesion scoring had a sensitivity of 100% and specificity of 77.3%. The gross lung lesion scoring test was subjected to a diagnostic distinction evaluation by examining the receiver operating characteristic curve and was appraised as having good discrimination for bronchopneumonia. Establishment of a gross lung lesion scoring test for the diagnosis of bronchopneumonia could be valuable as a screening test of macroscopic bronchopneumonia in swine slaughter check system.

• The Research Journal of the Costume Culture
• /
• v.7 no.5
• /
• pp.80-92
• /
• 1999

The objectives of this study were to investigate the relation between personality(activity, emotional stability, and dominance) and clothing design preferences, and to examine the differences of clothing design preferences according to demographic variables of men. Subjects for the study were 255 male white-collar workers ranging in ages from twenties to fifties, in Seoul and Kwangju City, Korea. The men with higher activity of personality preferred the double jacket with 4 buttons, the combination of light color jacket and dark trousers, glen check pattern jacket, herringbone pattern jacket, light beige color dress shirts. The higher the emotional stability, the higher the preferences on diverse patterns such as fine stripe, plaid, hound\`s-tooth check, and small check pattern. The men with higher dominance preferred dark blue color suit, glen check pattern suit, and necktie of red circle, and disliked the necktie of gray circle. The men in their 20\`s and 30\`s liked the single jacket with 3 buttons, the suit of fine stripe and the necktie of gray circle more among three income groups. The higher the men\`s age and income were, the more they liked the conservative style such as a single jacket with 2 buttons. The men who reside in Seoul liked the suit of gray circle, the jacket and trousers of same color, the patternless jacket, and the patternless suit more than the men in Kwangju. Therefore, the men in methropolitan area preferred conservative clothing image. Fine stripe pattern and patternless materials were preferred when men wore jacket and trousers of same color, while glen check pattern was preferred as the pattern of jacket when jacket and trousers of different color. Male white-collar worker liked single jacket more than double jacket, and preferred the dark blue color suit and necktie, patternless suit, fine stripe suit, and the pale blue dress shirts generally. The present findings provide that the personality of male has influence on the clothing design preferences, and it is possible to infer men\`s personality by their attire.

• Journal of the Korean Geographical Society
• /
• v.44 no.3
• /
• pp.282-300
• /
• 2009

This paper attempts to focus the ways in which Seoul as an urban space can be read and interpreted from gender perspective, assuming Seoul as a cultural text which represents modernity and post-modernity. Drawing on discussions of urban sociology and human geography which have analyzed the relationship between material spaces and social subjects, this paper explores the gendered segregation and representations of space in Seoul which has been constructed through the process of modernization. The framework of spatial interpretation of Seoul, concentrating on imageablity and legibility, consists of three dimensions; gendered division of labour and sphere, dichotomy of representations along with femininity and masculinity, and the ways of interlocking between modernity and post-modernity. In this paper, 'fl$\check{a}$nerie', Benjamin's method of interpretation of urban culture and the way of seeing with 'speculum' of Irigaray are adopted as metaphoric methodologies. It is an attempt to develop a new methodology to analyze and interpret urban space from gender-cultural perspective.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.6
• /
• pp.1-9
• /
• 2010

This paper proposes a test method for compliance of SMS encoder and decoder modules with 3GPP (3rd Generation Partnership Project) specification on SMS PDU (Protocol Data Unit). The existing tools have focused on providing an SMS gateway and on helping to view and edit a single SMS PDU, which rarely help to resolve the compliance test problem. The proposed compliance test method is based on an automatic generation of SMS PDUs fully compliant with the 3GPP specification by using QuickCheck library written in Haskell. By applying the proposed method to a C-based SMS encoder and decoder in Linux Mobile platform, we have found out several critical bugs such as wrong interpretation of time stamps in BCD format. The automatic SMS PDU generator is reusable in that it only depends on the 3GPP SMS specification. The QuickCheck library is also applicable for testing other network protocol data encoders and decoders, as used in this paper.

• Proceedings of the Korean Institute Of Construction Engineering and Management
• /
• 2007.11a
• /
• pp.509-512
• /
• 2007

In Domestic, the beginning of CM system was at December 1996 by 'Construction Industry fundamental law'. Today the needs of CM is more and more during 10 years. Although the time of CM's induction and high-quality human resources are insufficiency, various studies and developments's level through theoritical base and academic level is good which are compared by developed countries's. But still now the effort of CM product measure part, especially public sector is not enough. Besides, the existing check-list is for project owner so it needs to make up for balanced view as organized 4way-view of owner, CMr, designer, constructor. On this study, produce the list of check-list and then weight of each list by view of owner, CMr, designer, constructor. The completec check-list will be useful for CM product measure objectively .