• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.2
• /
• pp.246-251
• /
• 2014

In this paper, a high-speed CMOS Image Sensor (CIS) based on a 10-bit two step Single Slope A/D Converter (SS-ADC) is proposed. The A/D converter is composed of both 5-bit coarse ADC and a 6-bit fine ADC, and the conversion speed is 10 times faster than that of the single-slope A/D convertor. In order to reduce the pixel noise, further, a Hybrid Correlated Double Sampling (H-CDS) is also discussed. The proposed A/D converter has been fabricated with 0.13um 1-poly 4-metal CIS process, and it has a QVGA ($320{\times}240$) resolution. The fabricated chip size is $5mm{\times}3mm$, and the power consumption is about 35 mW at 3.3 V supply voltage. The measured conversion speed is 10 us, and the frame rate is 220 frames/s.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.16 no.1
• /
• pp.14-21
• /
• 1979

This paper deals with tIne interface error in the on-line computer systems by using the FSK radio communications. The wideband frequency shrift keying method is used for briary data transmission between the remote terminals and the main computer. To mintmize the error rate In the decoder systems of the main computer, a synchronizing pulse is added to the frame, so that the phase In both receiver and transmitter are synchronized. When the information signal with a constant error bit is received through FSK, It is designed to use the microprocessor for calculation of error bit. As results, most bit error are caused in FSK radio communications. and a few error bit Is me - asured to enter the mirroprocessor from the input buffer.

• ETRI Journal
• /
• v.29 no.4
• /
• pp.445-451
• /
• 2007

An adaptive modulation scheme is presented for multiuser orthogonal frequency-division multiplexing systems. The aim of the scheme is to minimize the total transmit power with a constraint on the transmission rate for users, assuming knowledge of the instantaneous channel gains for all users using a combined bit-loading and subcarrier allocation algorithm. The subcarrier allocation algorithm identifies the appropriate assignment of subcarriers to the users, while the bit-loading algorithm determines the number of bits given to each subcarrier. The proposed bit-loading algorithm is derived from the geometric progression of the additional transmission power required by the subcarriers and the arithmetic-geometric means inequality. This algorithm has a simple procedure and low computational complexity. A heuristic approach is also used for the subcarrier allocation algorithm, providing a trade-off between complexity and performance. Numerical results demonstrate that the proposed algorithms provide comparable performance with existing algorithms with low computational cost.

• Journal of Korea Society of Industrial Information Systems
• /
• v.17 no.5
• /
• pp.37-42
• /
• 2012

Audio steganography is quite similar to the procedure of modifying the least significant bit(LSB) of image media files. The most widely used technique today is hiding of secret messages into a digitized audio signal. In this paper, I propose a new method for hiding messages from attackers, high data inserting rate is achieved. In other words, based on the LSB hiding method and digitized to change the bit position of a secret message, an encrypted stego medium sent to the destination in safe way.

• Explosives and Blasting
• /
• v.38 no.1
• /
• pp.14-22
• /
• 2020

Bit damage is one of the primary causes of decreasing drilling efficacy. Nevertheless the management of bit ware and failure are often left for field engineers' experience. Thus it is imperative to establish a proper system to predict and manage the bit damage during the rock drilling process. In this study, the drilling sound signal has been recorded and analyzed using wavelet transform analysis to identify the exact moment of bit failure. Through the analysis wavelet time-frequency spectrums have been constructed and an abnormal point has been identified with 0.9 of wavelet transform value at the 652.8s on a frequency band around 500Hz. Furthermore it is also observed that the penetration rate of the damaged bit has been decreased to 23mm/s which is 9mm/sec lower than the average of undamaged bit. The study verifies that wavelet transform analysis can be used to build a system to diagnose the bit damage while drilling.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.5B
• /
• pp.448-456
• /
• 2003

In this parer, an ABR (Available Bit Rate) congestion control algorithm for voice transmission in ATM networks was proposed. To deal with the network congestion problem, not only the buffer level of a switch but also the variation of the buffer level were considered. Also, to resolve the unfairness among sources where the bit transfer rates vary, a loading factor that is used to adjust the bit rate was introduced. To show the superiority of this paper over others, simulation was done with a network of 7 voice sources and 4 switches, which was represented by Petri net model. ExSpect was used for simulation. The simulation results showed that there was improvement in network utilization and that unfairness among sources were resolved a lot.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.5C
• /
• pp.469-477
• /
• 2007

Most multimedia source coders exhibit unequal bit error sensitivity. Efficient transmission system design should therefore incorporate the use of matching unequal error protection (UEP). In this paper, we present and evaluate a flexible space-time coding system with unequal error protection. Multiple transmit and receive antennas and bit-interleaved coded modulation techniques are used combined with rate compatible punctured convolutional codes. A near optimum iterative receiver is employed with a multiple-in multiple-out inverse mapper and a MAP decoder as component decoders. We illustrate how the UEP system gain can be achieved either as a power or bandwidth gain compared to the equal error protection system (EEP) for the identical source and equal overall quality for both the UEP and EEP systems. An example with two/three transmit and two receive antennas using BPSK modulation is given for the block fading channel.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.771-774
• /
• 2010

In this paper, BER performance of LDPC(Low-Density Parity-Check) decoder for WiMAX is analyzed, and optimal design conditions of LDPC decoder are derived. The min-sum LDPC decoding algorithm which is based on an approximation of LLR sum-product algorithm is modeled and simulated by Matlab, and it is analyzed that the effects of LLR approximation bit-width and maximum iteration cycles on the bit error rate(BER) performance of LDCP decoder. The parity check matrix for IEEE 802.16e standard which has block length of 2304 and code rate of 1/2 is used, and AWGN channel with QPSK modulation is assumed. The simulation results show that optimal BER performance is achieved for 7 iteration cycles and LLR bit-width of (8,6).

• Journal of Broadcast Engineering
• /
• v.22 no.2
• /
• pp.193-206
• /
• 2017

In this paper, we propose a rate control method based on the $R-{\lambda}$ model that supports a parallel encoding structure in GOP levels or IDR period levels for 4K UHD input video in real-time. For this, a slice-level bit allocation method is proposed for parallel encoding instead of sequential encoding. When a rate control algorithm is applied in the GOP level or IDR period level parallelism, the information of how many bits are consumed cannot be shared among the frames belonging to a same frame level except the lowest frame level of the hierarchical B structure. Therefore, it is impossible to manage the bit budget with the existing bit allocation method. In order to solve this problem, we improve the bit allocation procedure of the conventional ones that allocate target bits sequentially according to the encoding order. That is, the proposed bit allocation strategy is to assign the target bits in GOPs first, then to distribute the assigned target bits from the lowest depth level to the highest depth level of the HEVC hierarchical B structure within each GOP. In addition, we proposed a processing method that is used to improve subjective image qualities by allocating the bits according to the coding complexities of the frames. Experimental results show that the proposed bit allocation method works well for frame-level parallel HEVC software encoders and it is confirmed that the performance of our rate controller can be improved with a more elaborate bit allocation strategy by using the preprocessing results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.3A
• /
• pp.406-411
• /
• 2000

In wireless ATM system, powerful FEC code is required for highly reliable data transmission. In this paper, we propose an adaptive hybrid ARQ scheme using RCPSCCC for WATM system. The code rate of RCPSCC is adjusted to match channel conditions and data types. By using only the effective free distances of outer and inner encoders, we derive upper bounds of the bit and word error probabilities over Rayleigh and Rician fading channels. By applying RCPSCC to the adaptive hybrid ARQ protocol, highly reliable data transmission can be achieved.