• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.6
• /
• pp.989-994
• /
• 2011

Nitrate contamination of groundwater is a common problem throughout intensive agriculture areas (non-point source pollution). Current processes (e.g. ion exchange and membrane separation) for nitrate removal have various disadvantages. The objective of this study was to evaluate electrochemical method such as electroreduction using bipolar ZVI packed bed electrolytic cell to remove nitrate from groundwater at field pilot. In addition ammonia stripping tower continuously removed up to 77.0% of ammonia. Bipolar ZVI packed bed electrolytic cell also removed E.coli. In the field pilot experiment for groundwater in 'I' city (average nitrate 30~35 mg N/L, pH 6.4), maximum 99.9% removal of nitrate was achieved in the applied 600 V.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.5
• /
• pp.651-658
• /
• 2011

Nitrate is a common contaminant in industrial wastewater and ground water. The maximum contaminant level set by EPA for nitrate of 10 mg/L as N. In this study, nitrate was removed using bipolar ZVI packed bed electrolytic cell that maximized the contact area between each electrode and contaminants under 600 V. Also this study investigates the simultaneously deals with removal of ammonia by operating air stripping tower. In addition to the air stripping also helped to precipitate iron ions to the form of iron oxides. Bipolar ZVI packed bed electrolytic cell was also effective in removing coliform by electrical power. In the continuous experiments for the simulated wastewater (initial nitrate for 25 mg/L as N), maximum 96.3% removal of nitrate was achieved in the applied 600 V at the flow rate of 6 mL/min.

• Applied Chemistry for Engineering
• /
• v.19 no.4
• /
• pp.366-369
• /
• 2008

To evaluate the performance of a bipolar packed bed cell (BPBC) filled with granular aluminium, the experiments were carried out in two groups as batch and continuous processes. In a batch process, removal efficiency of total phosphate (T-P) was 88% in case of electrolytic treatment of phosphate solution, T-P 10 mg/L at 6 V during 3 h by BPBC filled with granular aluminium. In a continuous process, residual T-P concentration was about 2 mg/L in case of electrolytic treatment of phosphate solution, 10 mg/L at 6 V, HRT 3 h by BPBC filled with granular aluminium. Break-through point was observed after running for 120 h at hydraulic retention time (HRT) of 3 h.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.7
• /
• pp.686-689
• /
• 2005

This study was conducted to investigate the effect of ammonium and nitrate nitrogen removal to applied voltage, electrolytic time and activated carbon packing height. Batch bipolar packed bed electrolytic cell reactor was packed with $4{\times}8$ mesh granular activated carbon (GAC). Afterward electrolysis was performed in 20 V for 30 min. As a result, as the filling height adjusted to 80 mm high, the removal efficiency of ammonium nitrogen was 99.9%. and as the electrolytic time varied to 60 min, the removal efficiency of ammonium nitrogen was 97.6%. and in case of continuous electrolytic treatment of ammonium and nitrate nitrogen removal efficiency of total nitrogen was over 80% in bipolar packed bed electrolytic cell reactor for 72 hours as the packing height, sample concentration and input rate of sample adjusted to 280 mm, 30 mg/L, 6.7 mL/min, respectively.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.1B
• /
• pp.79-84
• /
• 2012

Nitrate is a common contaminant in groundwater aquifer. The present study investigates the performance of the bipolar zero valent iron (ZVI, $Fe^0$) packed bed electrolytic cell in removing nitrate in different operating conditions. The packing mixture consists of ZVI as electronically conducting material and silica sand as non-conducting material between main cathode and anode electrodes. In the continuous experiments for the simulated wastewater (contaminated groundwater, initial nitrate about 30 mg/L as N and electrical conductivity about 300 ${\mu}S/cm$), over 99% removal of nitrate was achieved in the applied voltage 600 V and at the flow rate of 20 mL/min. The optimum packing ratio (v/v) and flow rate were determined to be 1:1~2:1 (silica sand to ZVI), 30 mL/ min respectively. Effluent pH was proportional to nitrate influx concentration, and ammonia which is the final product of nitrate reduction was about 60% of nitrate influx. Magnetite was observed on the surface of the used ZVI as major oxidation product.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.2B
• /
• pp.187-192
• /
• 2011

Nitrate nitrogen is common contaminant in groundwater aquifers, its concentration is regulated many countries below 10 mg/L as N (As per WHO standards) in drinking water. An attempt was made to get optimal results for the treatment of nitrate nitrogen in groundwater by conducting various experiments by changing the experimental conditions for ZVI bipolar packed bed electrolytic cell. From the experimental results it is evident that the nitrate nitrogen removal is more effective when the reactor conditions are maintained in acidic range but when the acidic environment changes to alkaline due to the hydroxide formed during the process of ammonia nitrogen there by increasing the pH reducing the hydrogen ions required for reduction which leads to low effectiveness of the system. In the ZVI bipolar packed bed electrolytic cell, the packing ratio of 0.5~1:1 was found to be most effective for the treatment of nitrate nitrogen because ZVI particles are isolated and individual particle act like small electrode with low packing ratio. It is seen that formation of precipitate and acceleration of clogging incrementally for packing ratio more than 2:1, decreasing the nitrate nitrogen removal rate. When the voltage is increased it is seen that kinetics and current also increases but at the same time more electric power is consumed. In this experiment, the optimum voltage was determined to be 50V. At that time, nitrate nitrogen was removed by 94.9%.

• Applied Chemistry for Engineering
• /
• v.3 no.4
• /
• pp.657-662
• /
• 1992

For describing the bipolar packed-bed electrode cell filled with graphite pellete electrode, the application of the model of equivalent circuit was studied. The ratio between the Faradaic current through bipolar electrodes and the applied current was dependent on the resistance coefficient, specific conductivity of electrolyte, and electrolyte circulation rate. The ratio of the Faradaic current through bipolar electrodes to the applied current increased with the applied current(or cell voltage), but decreased with the increase of electrolytic conductivity and circulation rate of the electrolyte.

• Journal of Environmental Science International
• /
• v.11 no.4
• /
• pp.355-360
• /
• 2002

This study was to analyze the right of wrong of gray-water treatment by applying BPBE electrode cell to the effluence water in the terminal disposal plant of sewage. The results were as follows : The best result was obtained with applied voltage 40V and detention time 6 minutes for the BPBE electrode cell which has the graphite-plate in main electro-de, packing coconut activated carbon. The elimination rate of COD of Al-plate was higher than that of graphite-plate in main electrode. The result of electrolysis for 3 hour in parallel circuit showed the using possibility of gray-water according to each elimination rate : COD 59%, T-N 69 %, T-P 69%. The BPBE electrode cell with the Al-plate in main electrode made the best effect for the elimination of algae in lake water and algae were not occurred in electrolytic water.

• Design & Manufacturing
• /
• v.11 no.3
• /
• pp.51-55
• /
• 2017

Micro fuel cells have high reliability and long usage time. Among them, PEMFC (polymer Electrolyte Membrane Fuel Cell) is suitable as a portable power source because it is easy to fix electrolyte and simple structure. The bipolar plate, a key component of the fuel cell, is produced by cutting. In the case of micro fuel cell separator, burr is very small and the flow channel size in the separator is very small. Therefore, it is difficult to remove burrs in the usual way such as a brushing or ultra-sonic method. Therefore, this study proposed electrolytic polishing process and analyzed the characteristics of each condition by introducing the concept of roughness reduction rate. In addition, the ultrasonic process was added to analyze the effect of ultrasonic addition.

• Journal of Korean Society of Environmental Engineers
• /
• v.29 no.6
• /
• pp.684-688
• /
• 2007

The results of potentiostatic electrolysis of aqueous solution containing fluoride by bipolar packed bed electrolytic cell filled with granular aluminium were summarized. Removal efficiency of fluoride ion which it analyzed with ion chromatograph were 53, 73, 90% in applied voltage. Control the concentration of supporting electrolyte were 10, 30, 50, 70 mg/L and volume of packing material were 0, 25, 50, 75%, respectively, the quantity of electricity was $2.58A{\cdot}hr$ when the concentration of supporting electrolyte was 50 mg/L and the volume of packing material was 75%. As the results of electrolytsis of fluoride aqueous solution containing fluoride 10, 30, 50, 70 mg/L for 3 hours at 10 V, the removal efficiency of fluoride were 93.3, 80, 68.6%. Then the quantity of electricity were 2.58, 3.89, $5.43A{\cdot}hr$ and the fluoride removal amounts per quantity of electricity were 4.0, 3.5, $2.0mg/A{\cdot}hr$.