• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.2
• /
• pp.19-24
• /
• 2010

This paper analyzes potential interference effect of DTV service on Radio Microphone in adjacent channel. For analysis, we assume that DTV operates on CH 51(692 MHz ~ 698 MHz) and radio microphone operates on CH 52 (698 MHz ~ 704 MHz) according to the Korea Communications Commission policy. Minimum Coupling Loss(MCL) method is used to determine the required protection distance and Monte Carlo method is used to determine guard band to meet interference probability of 0 % below. In conclusions, protection distance of 1.71 km and guard band of 2.4 MHz are required for indoor and protection distance of 18.86 km and guard band of 5.7 MHz are required for outdoor.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12A
• /
• pp.1161-1167
• /
• 2005

In this Paper, a concept of virtual smart antenna (SA) is introduced for orthogonal Sequency division multiplexing (OFDM)-based cellular systems with a frequency reuse factor equal to 1. The OFDM-based cellular system is robust to multipath channels but has a disadvantage that the intercell interference (ICI) caused by adjacent base stations is large at the edge of a cell. In this paper, after deriving the symbol timing offset estimation scheme for the OFDM signal received from multiple base stations in a quasi-static fading channel, the ICI cancellation method based on virtual smart antenna is proposed using the steering vector formed by the symbol timing offset of the desired signal and interference signals.

• Journal of Communications and Networks
• /
• v.10 no.2
• /
• pp.118-126
• /
• 2008

The use of beamforming is effective for users in limited power environments. However, when it is applied to the downlink of a cellular system with universal frequency reuse, users near the sector boundary may experience significant interference from more than one sector. The use of a minimum mean square error (MMSE)-type receiver may not sufficiently cancel out the interference unless a sufficient number of receive antennas are used. In this paper, we consider the use of inter-sector beamforming that cooperates with a neighboring sector in the same cell to mitigate this interference problem in time-division duplex (TDD) environments. The proposed scheme can avoid interference from an adjacent sector in the same cell, while enhancing the transmit array gain by using the TDD reciprocity. The performance of the proposed scheme is analyzed in terms of the output signal-to-interference-plus-noise power ratio (SINR) and the output capacity when applied to an MMSE-type receiver. The beamforming mode can be analytically switched between the inter-sector and the single-sector mode based on the long-term channel information. Finally, the effectiveness of the proposed scheme is verified by computer simulation.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.3 no.1
• /
• pp.47-54
• /
• 2003

New efficiency enhancement techniques have been devised and implemented to InGaP/GaAs HBT MMIC power amplifiers for W-CDMA mobile terminals applications. Two different types of bias current control circuits that select the efficient quiescent currents in accordance with the required output power levels are proposed for overall power efficiency improvement. A dual chain power amplifier with single matching network composed of two different parallel-connected power amplifier is also introduced. With these efficiency enhancement techniques, the implemented MMIC power amplifiers presents power added efficiency (PAE) more than 14.8 % and adjacent channel leakage ratio(ACLR) lower than -39 dBc at 20 dBm output power and PAE more than 39.4% and ACLR lower than -33 dBc at 28 dBm output power. The average power usage efficiency of the power amplifier is improved by a factor of more than 1.415 with the bias current control circuits and even up to a factor of 3 with the dual chain power amplifier.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.12 s.91
• /
• pp.1199-1206
• /
• 2004

In this paper, we analyzed the orthogonal MC DS-CDMA system and no-overlapping MC DS-CDMA System, which were divided by the normalized spacing between adjacent subcarrier over Nakagami-m fading channels. In order to reduce the number of selective paths occurring in the MC system, the Hybrid SCMRC technique was applied, which was compared with the case when the MRC technique was used. As a result of simulations, it was found that the Hybrid SC/MRC method could be replaced by the MRC method and if the number of subcarriers was increased when the given bandwidth was fixed, the interval between subcarriers increased and bigger bandwidths were required. an, the number or subcarriers should be selected in consideration or given bandwidth.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.1
• /
• pp.54-62
• /
• 1999

In this paper, we investigated the signal-to-noise ratio improvement in a differential detector, which is a function of the optical noise coupling ratio and the differential gain ratio. A differential detector consists of two photodiodes and a differential amplifier. The differential detector reduced the noise component and improved the signal-to-noise ratio by about 20 dB when the differential gain ratio equals to the optical noise coupling ratio. The differential detector is very effective in removing the environmental optical noise or interference from an adjacent optical channel. This method is also effective when the noise wavelength is similar to the signal.

• Journal of electromagnetic engineering and science
• /
• v.9 no.2
• /
• pp.78-84
• /
• 2009

This paper represents the effects of drain bias on the linearity and efficiency of an analog pre-distortion power amplifier(PA) for wideband code division multiple access(WCDMA) repeater applications. For verification, an analog predistorter(APD) with three-branch nonlinear paths for memory-effect compensation is implemented and a class-AB PA is fabricated using a 30-W Si LOMaS. From the measured results, at an average output power of 33 dBm(lO-dB back-off power), the PA with APD shows the adjacent channel leakage ratio(ACLR, ${\pm}$5 MHz offset) of below -45.1 dBc, with a drain efficiency of 24 % at the drain bias voltage($V_{DD}$) of 18 V. This compared an ACLR of -36.7 dEc and drain efficiency of 14.1 % at the $V_{DD}$ of 28 V for a PA without APD.

• Journal of Mechanical Science and Technology
• /
• v.15 no.12
• /
• pp.1784-1793
• /
• 2001

The flow fields around an elliptic cylinder of axis ratio AR=2 adjacent to a free surface were investigated experimentally using a water channel. The main objective is to understand the effect of the free surface on the flow structure in the near-wake. The flow fields were measured by varying the depth of cylinder submergence, for each experimental condition, 350 velocity fields were measured using a single-frame PIV system and ensemble-averaged to obtain the spatial distribution of turbulent statics. For small submergence depths a large-scale eddy structure was observed in the near-wake, causing a reverse flow near the free surface, downstream of the cylinder. As the depth of cylinder submergence was increased, the flow speed in the gap region between the upper surface of the cylinder and the free surface increased and formed a substantial jet flow. The general flow structure of the elliptic cylinder is similar to previous results for a circular cylinder submerged near to a free surface. However, the width of the wake and the angle of downward deflection of the shear layer developed from the lower surface of the elliptic cylinder are smaller tan those for a circular cylinder.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.233-236
• /
• 2001

We have designed and fabricated ASK modulator MMIC operating at 5.8GHz for OBE used in AGPS (Automatic Gate Passing System). ASK modulator MMIC was designed to apply a sing1e supply voltage of 3V to the drain in order to decrease ACP (Adjacent Channel Power). The measurement result of this chip exhibits on/off characteristic over 30dB. The design parameters are optimized through ADS simulation tool. The layouts and fabrication o( ASK Modulator MMIC were designed and fabricated by using ETRI 0.5${\mu}{\textrm}{m}$ MESFET library. The chip sizes were 1mm $\times$1mm. The performance analysis of the implemented ASK Modulator based on the design parameters is accomplished.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.4
• /
• pp.106-112
• /
• 1997

We demonstrate a novel wavelength -division add/drop multiplexer employing fiber bragg gratings and polarization beam splitters. the multiplexer is easy to fbricate without any special technique such as UV trimming, and yet shows very stable performance with less than 0.3-dB crosstalk power penalty in a 0.8-nm-spaced, 2.5Gbps-per-channel WDM transmission system. We find that the rejection of adjacent channels is more than -6dB, and the signal leakage through output port is less than -34dB.