• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.5
• /
• pp.402-409
• /
• 2009

Sodium bicarbonate ($NaHCO_3$) was used as a reactant for the removal of acid gases from a waste incinerator. The removal efficiencies of HCl and $SO_x$ were tested with a reactant mixing apparatus and a distributor installed at the bag filter inlet. It was shown that the stoichiometric ratio of $NaHCO_3$ to the acid gases which allows a removal of over 90% for both HCl and $SO_2$ was about 1.2. When a reactant mixing apparatus was installed on the duct, the removal efficiencies of HCl and $SO_2$ at the end of the duct were increased by approximately 1.5 and 3 times respectively, compared to when the apparatus was not installed. At the end of the bag filter, the removal efficiencies of the both were as high as 98% with a stoichiometric ratio of 1.35. Installing a reactant mixing apparatus on the duct and a distributor at the entrance of the bag filter and using $NaHCO_3$ as a reactant helped overcome the problem of low removal efficiencies of acid gases by dry scrubbing.

• Journal of Environmental Science International
• /
• v.1 no.2
• /
• pp.105.1-113
• /
• 1992

The present study was performed to develop the removal system of the offensive gases, including hydrogen sulfide of acid gas, ammonia or amice of base gas, from the nightsoil treatment plant. In order to remove the offensive gases, the Fe-EDTA system liquid phase catalytic oxidation method with the bubble lift column reactor was employed. From the results obtained, it was confirmed that the offensive gases can be deodorized simultaneously and also hydrogen sulfide of acid gas, ammonia of base gas completely removed at pH 6.45. In addition, as input gases feed rate the efficiency of acid gas did not change but the efficiency of base gases decreased to approximately 90 % at pH 6, 0. From the result of particle size analyzer, it was found that the particle sizes including sulfur and other impurites grew up to $21{\mu}m$ over 72hour reaction time.

• Membrane Journal
• /
• v.28 no.2
• /
• pp.90-95
• /
• 2018

A process design was performed for a removal of acid gases using membrane-absorption hybrid system in LNG-FPSO. Commercial process simulator Promax version 4.0 was utilized for comparing acid gases removal capabilities of amine absorption process and hybrid process. Simulation results show hybrid process could be small amine solvent circulate rate, energy consumption, equipment sizing compared to typical amine absorption process. As a result, hybrid process which is small footprint and energy saving process may be a good solution for the pre-treatment of natural gas in LNG-FPSO.

• Journal of Microbiology and Biotechnology
• /
• v.13 no.2
• /
• pp.207-216
• /
• 2003

A number of different sources, such as composts, leachates, and pig feces samples, were collected from different pig farms in Korea, and several microorganisms were screened for their ability to deodorize the malodorous gases. Consequently, a novel malodorous gases-deodorizing bacterial strain, KJ-108. was isolated, because it was highly abundant in nitrate-supplemented minimal medium ($MM-NO_3^-$) under anaerobic culture conditions. Airtight crimp-sealed serum bottles containing $MM-NO_3^-$ , medium were inoculated with KJ-108. Nitrate concentration was decreased rapidly after 20 h of incubation, and incubation was carried out until nitrite production reached almost zero. Taxonomic identification, including 16S rDNA base sequencing and phylogenetic analysis, indicated that the isolate had $100\%$ homology in its 165 rDNA base sequence with Lactobacillus pentosus. Among the volatile fatty acids, acetic acid contained in large amounts in fresh piggery slurry was decreased by about $40\%$ after 50 h incubation with strain KJ-108. n-Butyric acid, n-valeric acid, and isovaleric acid were gradually decreased, and isobutyric acid and capronic acid were dramatically eliminated at theinitial period with the treatment. Moreover, NH, removal efficiency reached a maximum of $98.5\%$ after 50 h of incubation, but the concentration of $H_2S$ was not changed.

• Journal of Korean Society for Atmospheric Environment
• /
• v.23 no.6
• /
• pp.744-751
• /
• 2007

Wet scrubber is widely used to remove toxic gaseous contaminants in various industries such as semi-conductor industry, display manufacturing industry and so on. In this study, to optimize a packed bed scrubber as one of typical wet scrubber size while keeping its performance, four different packing materials were investigated at different air flow rates, liquid-gas ratios and pH values. Ammonia, hydrochloric acid and hydrofluoric acid were used as test gases to characterize the scrubber performance. Gas removal efficiency increased as the packing size decreased, which resulted in the increase of specific surface area. The increase of air flow rate led to the decrease of gas removal efficiency, while the increase of liquid-gas ratio led to the increase of gas removal efficiency. For the case of $NH_3$ gas, lower pH, and for the cases of HCl and HF, higher pH contributed to higher gas removal efficiency. Gas removal efficiency of a wet scrubber increased in the order of HCl < $NH_3$ < HF according to its water solubility.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.11a
• /
• pp.233-236
• /
• 1997

An investigation has been made of the various plasma chemistry reactions that occur in the corona discharge of an electrostatic precipitator operating in a typical flue gas. As the results of investigation, sulphur dioxide is removed principally by reactions with OH radicals to produce sulphuric acid, while nitrogen oxides are removed principally by reduction via the N radical to molecular nitrogen. If electrostatic precipitator\ulcorner used for flue gases are operated with positive voltages instead of negative dc voltages, there are significant reductions in the emission of the undesirable gases SO$_2$, NO, and NO$_2$. Thus, in this paper we design the bidirectional pulse generator for removal of flue gas, where the pulse width is more than 50[nsec] and the maximum output voltage is more than 100[kVl.

• Journal of Energy Engineering
• /
• v.25 no.1
• /
• pp.171-176
• /
• 2016

Sour gas is natural gas or any other gas containing significant amounts of hydrogen sulfide ($H_2S$). Natural gas is usually considered sour gas if there are more than 5.7 milligrams of $H_2S$ per cubic meter of natural gas, which is equivalent to approximately 4 ppm by volume under standard temperature and pressure We have surveyed on the treatment and removal technology of sour gas, sour gas include a lot of hydrogen sulfide($H_2S$), Carbon dioxide($CO_2$), utane($C_4H_{10}$) and mercaptan($C_nH_{4n-1}SH$) etc. We need high technology for development for these kinds of raw gases and we should specially take care of treating and removal of theses raw gases. Therefor we are going to describe about these kinds of raw gases and about methods how to treat these kinds of gases.

• Microbiology and Biotechnology Letters
• /
• v.32 no.3
• /
• pp.265-270
• /
• 2004

To select a promising technologies for removal of odorous gases emitted from a wastewater pump station, four methods such as activated carbon (A/C) adsorption, chemical absorption (acid and alkali scrubber), and two biofilters (polyurethane (PU) and worm cast) were investigated. The average odor removal efficiencies in the PU biofilter and A/C column was over 98%, but in a worm cast biofilter and chemical absorption were below 60-80%. The removal efficiency of PU biofilter was very stable (about 98-99%) in the range of retention times of 4-36s, and a maximum elimination capacity was $1.6${\times}$10^{ 7}$ $OUm^{-3}$$h^{-1}$ Deodorization costs for an activated carbon adsorption and a biofiltration method were investigated. With increasing odor intensity, the operating cost of the A/C column increased linearly, but the operating cost of the biofilteration increased slightly. The capital cost in a biofilter is about two times higher than that in an A/C column, but the operating cost is very lower than that of in A/C column. In conclusion, the biofiltration was evaluated one of the most promising technologies to control odor in a wastewater pump station.

• Proceedings of the Korean Environmental Health Society Conference
• /
• 2003.06a
• /
• pp.152-156
• /
• 2003

Air pollution problems due to the emission of pollutants from the various industrial facilities become serious issues and lots of air pollution control processes have been developed. To remove the SO$_2$ and NOx emitted from the solid waste incinerator and coal fired power plants, we studied the Ca-based sorbent which was prepared by waste clam and limestone. The objectives of this study were to develop a clam-based sorbent for removal of SO$_2$ and NOx, and to investigate the physicochemical properties of the waste clam sorbent. In order to determine acid gas removal capacity of sorbent, the batch study on SO$_2$ and NOx removal was performed with the Ca-based sorbent in the fixed bed reactor. Results of the research revealed that clam-based sorbent can be used as the iron-manufacturing industry and chemical adsorbents for the removal of acid gases because the lime content of the waste calm was more than 53.92%. From physicochemical analysis and gas reaction experiments, it could be concluded that clam is good sorbent for the removal of SO$_2$ and NOx in waste incinerator and flue gas desulfurization processes.

• Applied Chemistry for Engineering
• /
• v.23 no.1
• /
• pp.23-27
• /
• 2012

To make synthetic liquid fuel from biomass such as wood pellet, energy crop and so on, a biomass to liquid (BTL) process by using a biomass gasifier with Fisher-Tropsch (FT) reaction was developed. However $H_2S$, COS and $CO_2$ in syngas from biomass gasifiers resulted in a decrease of the conversion efficiency and the deactivation of the catalyst. To remove acid gases in syngas, a lab-scale methanol absorption tower was developed and the removal characteristics of acid gases were investigated. The methanol absorption tower efficiently removed $H_2S$ and COS with a removal of $CO_2$, so it could be useful process for the BTL process.