• Bulletin of the Korean Chemical Society
• /
• 제27권5호
• /
• pp.725-732
• /
• 2006

A rapid flotation methodology for zinc(II) separation and enrichment from human biofluids is established. At pH 6.0 and ambient temperature, using oleic acid (HOL) as a foaming reagent, zinc(II) was separated with phenanthraquinone monophenyl thiosemicarbazone (PPT) as a new flotation collector for Zn(II). The floated red colored 1 : 2 Zn(II)-PPT complex was measured spectrophotometrically at 526 nm with a molar absorptivity of $1.83 \;{\times}\; 10^5\; L$ mol $L ^{-1}\;cm ^{-1}$. Beer's law was obeyed over a concentration range 0.05-1.0 mg $L ^{-1}$ in the aqueous as well as in the scum layers. The proposed preconcentration flotation methodology was applied to determine Zn(II) in human biofluids. Application was, also, extended to determine Zn(II) in pharmaceutical samples and natural water samples spiked with known amounts of Zn(II) with a preconcentration factor of 100 and a detection limit of 10 ng m$L ^{-1}$. The method was verified by comparison of the spectrophotometric results with flame atomic absorption spectrometric (AAS) measurements. Moreover a postulation for the mechanism of flotation is proposed.

• Transactions on Electrical and Electronic Materials
• /
• 제14권4호
• /
• pp.216-220
• /
• 2013

The etching characteristics of indium zinc oxide (IZO) in $Cl_2/Ar$ plasma were investigated, including the etch rate and selectivity of IZO. The IZO etch rate showed non-monotonic behavior with increasing $Cl_2$ fraction in the $Cl_2/Ar$ plasma, and with increasing source power, bias power, and process pressure. In the $Cl_2/Ar$ (75:25%) gas mixture, a maximum IZO etch rate of 87.6 nm/min and etch selectivity of 1.09 for IZO to $SiO_2$ were obtained. Owing to the relatively low volatility of the by-products formation, ion bombardment was required, in addition to physical sputtering, to obtain high IZO etch rates. The chemical state of the etched surfaces was investigated with X-ray photoelectron spectroscopy. These data suggested that the IZO etch mechanism was ion-enhanced chemical etching.

• 한국환경과학회지
• /
• 제20권12호
• /
• pp.1607-1615
• /
• 2011

The adsorption performance of cupper and zinc ions($Cu^{2+}$ and $Zn^{2+}$) in aqueous solution was investigated by an adsorption process on reagent grade Na-A zeolite(Z-WK) and Na-A zeolite (Z-C1) prepared from coal fly ash. Z-C1 was synthesized by a fusion method with coal fly ash from a thermal power plant. Batch adsorption experiment with Z-C1 was employed to study the kinetics and equilibrium parameters such as initial metal ions concentration and adsorption time of the solution on the adsorption process. Adsorption rate of metal ions occurred rapidly and adsorption equilibrium reached at less than 120 minutes. The kinetics data of $Cu^{2+}$ and $Zn^{2+}$ ions were well fitted by a pseudo-second-order kinetics model more than a pseudo-first-order kinetics model. The equilibrium data were well fitted by a Langmuir model and this result showed $Cu^{2+}$ and $Zn^{2+}$ adsorption on Z-C1 would be occupied by a monolayer adsorption. The maximum adsorption capacity($q_{max}$) by the Langmuir model was determined as $Cu^{2+}$ 99.8 mg/g and $Zn^{2+}$ 108.3 mg/g, respectively. It appeared that the synthetic zeolite, Z-C1, has potential application as absorbents in metal ion recovery and mining wastewater.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권7호
• /
• pp.719-726
• /
• 1996

DLTS measurements were performed to study the annealing induced changes of the trap centers in MOV and to shed more light on the stability mechanism of the MOV. Two electron traps, Ec-0.26[eV] and Ec-(O.2-0.3)[eV], were observed in the unannealed samples in large quantities(7-9 X 1014[CM 3]), whereas the three electron traps Ec-0.17 [eV], Ec-0.26[eV] and Ec-(O.2-0.3)[eV] were observed far less in the annealed samples. The minima in the Ec-0.26[eV] trap density, coupled with the presented results that unannealed devices are unstable whereas 600.deg. C annealed devices are most stable, suggests that the instability of the MOV under long term electrical stressing is related to the Ec-0.26[eV] trap. This results support that the ion migration model for the device instability where the Ec-0.26[eV] defects may be the interstitial zinc or the migrating ions. The interstitial zinc originated as a result of the nonstoichiometric nature of ZnO might cause the degradation of the I-V characteristics of the MOV with long term electrical stressing.

• 청정기술
• /
• 제9권2호
• /
• pp.63-69
• /
• 2003

도금산업은 제조 공정상 다량의 환경오염물질을 배출하는데 일반적으로 산 알칼리 폐수 뿐만아니라 크롬화합물, 시안화합물, 중금속류, 부식성물질, 독성물질 등이 발생하여 환경오염을 초래한다. 본 연구에서는 도금 산업에서 가장 환경오염부하가 크고 많이 적용하는 아연도금공정의 공정진단 및 분석을 통해 아연도금공정의 청정생산 실행효과가 큰 우선순위별 단위공정에 최적기술을 적용하여 현 도금공장의 열악한 근무환경과 환경오염을 개선하고자 하였다.

• Korean Chemical Engineering Research
• /
• 제55권5호
• /
• pp.685-689
• /
• 2017

We studied the removal of zinc ions from synthetic brackish water by an adsorption method using natural Algerian Bentonite (NAB). The effect of the main physico chemical parameters-contact time, pH, temperature, ionic strength, clay weight and initial metal ion concentrations on the removal of $Zn^{+2}$-were investigated. The results showed that equilibrium was attained within 10 min of stirring time. The retention capacity of $Zn^{+2}$ increased with the increase of pH, the adsorbent dose and ionic strength. A modelization study showed that the adsorption follows Langmuir isotherm, while its kinetics was pseudo-second-order. Based on the results, it was concluded that NAB, which is natural and available, could be used as an alternative for the removal of zinc from saline aqueous solutions.

• 한국전기전자재료학회논문지
• /
• 제26권5호
• /
• pp.373-379
• /
• 2013

Mg-doped zinc tin oxide (ZTO:Mg) thin films were prepared on glasses by rf magnetron sputtering. $O_2$ was introduced into the chamber during the sputtering. The optical properties of the films as a function of oxygen flow rate were studied. The crystal structure, elementary properties, and depth profiles of the films were investigated by X-ray diffraction (XRD), x-ray photoelectron spectroscopy (XPS), and secondary ion mass spectrometry (SIMS), respectively. Bottom-gate transparent thin film transistors were fabricated on $N^+$ Si wafers, and the variation of mobility, threshold voltage etc. with the oxygen flow rate were observed.

• Bulletin of the Korean Chemical Society
• /
• 제19권3호
• /
• pp.354-358
• /
• 1998

The effect of thermal conditions on the clustering of sulfonated polystyrene ionomers was investigated. It was found that when the zinc-sulfonated ionomer was dried above a matrix glass transition temperature (Tg), the cluster Tg was observed at ca. 310 ℃, which is ca. 45 ℃ higher than that for the ionomer dried below the matrix Tg. This difference is believed to be the result of the increase in chain mobility at higher temperatures, which improves the multiplet formation and clustering; thus the cluster Tg increases. In the lithium ionomer case, however, the increase in the cluster Tg was ca. 6 ℃ upon annealing. From the results, it was suggested that in the zinc ionomer, the zinc ion is soft and divalent, which results in weaker interactions in multiplets, and thus decreases the stability of the multiplets. Therefore, the thermal effect is more significant for the zinc ionomers than for the lithium ionomers.

• The Korean Journal of Physiology and Pharmacology
• /
• 제19권5호
• /
• pp.389-399
• /
• 2015

Zinc has been considered as a vital constituent of proteins, including enzymes. Mobile reactive zinc ($Zn^{2+}$) is the key form of zinc involved in signal transductions, which are mainly driven by its binding to proteins or the release of zinc from proteins, possibly via a redox switch. There has been growing evidence of zinc's critical role in cell signaling, due to its flexible coordination geometry and rapid shifts in protein conformation to perform biological reactions. The importance and complexity of $Zn^{2+}$ activity has been presumed to parallel the degree of calcium's participation in cellular processes. Whole body and cellular $Zn^{2+}$ levels are largely regulated by metallothioneins (MTs), $Zn^{2+}$ importers (ZIPs), and $Zn^{2+}$ transporters (ZnTs). Numerous proteins involved in signaling pathways, mitochondrial metabolism, and ion channels that play a pivotal role in controlling cardiac contractility are common targets of $Zn^{2+}$. However, these regulatory actions of $Zn^{2+}$ are not limited to the function of the heart, but also extend to numerous other organ systems, such as the central nervous system, immune system, cardiovascular tissue, and secretory glands, such as the pancreas, prostate, and mammary glands. In this review, the regulation of cellular $Zn^{2+}$ levels, $Zn^{2+}$-mediated signal transduction, impacts of $Zn^{2+}$ on ion channels and mitochondrial metabolism, and finally, the implications of $Zn^{2+}$ in health and disease development were outlined to help widen the current understanding of the versatile and complex roles of $Zn^{2+}$.

• Journal of Microbiology and Biotechnology
• /
• 제26권12호
• /
• pp.2019-2029
• /
• 2016

Zinc finger proteins are among the most extensively applied metalloproteins in the field of biotechnology owing to their unique structural and functional aspects as transcriptional and translational regulators. The classical zinc fingers are the largest family of zinc proteins and they provide critical roles in physiological systems from prokaryotes to eukaryotes. Two cysteine and two histidine residues ($Cys_2His_2$) coordinate to the zinc ion for the structural functions to generate a ${\beta}{\beta}{\alpha}$ fold, and this secondary structure supports specific interactions with their binding partners, including DNA, RNA, lipids, proteins, and small molecules. In this account, the structural similarity and differences of well-known $Cys_2His_2$-type zinc fingers such as zinc interaction factor 268 (ZIF268), transcription factor IIIA (TFIIIA), GAGA, and Ros will be explained. These proteins perform their specific roles in species from archaea to eukaryotes and they show significant structural similarity; however, their aligned amino acids present low sequence homology. These zinc finger proteins have different numbers of domains for their structural roles to maintain biological progress through transcriptional regulations from exogenous stresses. The superimposed structures of these finger domains provide interesting details when these fingers are applied to specific gene binding and editing. The structural information in this study will aid in the selection of unique types of zinc finger applications in vivo and in vitro approaches, because biophysical backgrounds including complex structures and binding affinities aid in the protein design area.