• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.6
• /
• pp.742-750
• /
• 2018

In this paper, in order to enable zero-layer FTP cell using only 5V MOS devices on the basis of $0.13{\mu}m$ BCD process, the tunnel oxide thickness is used as the gate oxide thickness of $125{\AA}$ of the 5V MOS device at 82A. The HDNW layer, which is the default in the BCD process, is used. Thus, the proposed zero layer FTP cell does not require the addition of tunnel oxide and DNW mask. Also, from the viewpoint of memory IP design, a single memory structure which is used only for trimming analog circuit of PMIC chip is used instead of the dual memory structure dividing into designer memory area and user memory area. The start-up circuit of the BGR (Bandgap Reference Voltage) generator circuit is designed to operate in the voltage range of 1.8V to 5.5V. On the other hand, when the 64-bit FTP memory IP is powered on, the internal read signal is designed to maintain the initial read data at 00H. The layout size of the 64-bit FTP IP designed using the $0.13-{\mu}m$ Magnachip process .is $485.21{\mu}m{\times}440.665{\mu}m$($=0.214mm^2$).

• Journal of the Korean Solar Energy Society
• /
• v.38 no.4
• /
• pp.55-66
• /
• 2018

nZEH (net-Zero Energy House) is defined as a self-sufficient energy building where the sum of energy output generated from new & renewable energy system and annual energy consumption is zero. The electricity generated by new & renewable energy system with the form of distributed generation is preferentially supplied to electrical demand, and surplus electricity is transmitted back to grid. Due to the recent expansion of houses with photovoltaic system and the nZEH mandatory by 2025, the rapid increase of distributed generation is expected. Which means, we must prepare for an electricity-power accident and stable electricity supply. Also electricity charges have to be reduce and the grid-connected should be operated efficiently. The introduction of ESS is suggested as a solution, so the analysis of the load matching and grid interaction is required to optimize ESS design. This study analyzed the load matching and grid interaction by expected consumption behavior using actual data measured in one-minute intervals. The experiment was conducted in three nZEH with photovoltaic system, called all-electric houses. LCF (Load Cover Factor), SCF (Supply Cover Factor) and $f_{grid}$ (Grid Interaction Index) were evaluated as an analysis indicator. As a result, LCF, SCF and $f_{grid}$ of A house were 0.25, 0.23 and 0.27 respectively; That of B house were 0.23, 0.23, 0.19, and that of C were 0.20, 0.19, 0.27 respectively.

• Journal of the Society of Naval Architects of Korea
• /
• v.47 no.2
• /
• pp.141-149
• /
• 2010

It is essential to find oscillating angles and periods in a seaway when designing and manufacturing stabilizers. It is difficult to find oscillating angles and periods in high speed turning and they vary with ship speed and wave heading angles, therefore, proper algorithm to measure oscillating periods in a seaway. In the present study, three kinds of algorithms are developed to measure oscillating angles periods in a seaway. Dual axis tilt sensor of low price is used to measure oscillating angles, and the effect of lateral accelerations on tilt sensor have been reduced by the fusion algorithm using the gyro sensor signals. Analog and digital filters are applied to minimize the noise of the signals. Three kinds of algorithms, zero crossing, peak to peak and moving zero crossing algorithm, are developed to measure oscillating periods in a seaway. It is found that the moving zero algorithm showed the best results in the sea trials.

• The Korean Journal of Applied Statistics
• /
• v.25 no.2
• /
• pp.363-376
• /
• 2012

Excessive zeroes are often observed in ordinal categorical response variables. An ordinary ordered Probit model is not appropriate for zero-inflated data especially when there are many different sources of generating 0 observations. In this paper, we apply a two-stage zero-inflated ordered Probit (ZIOP) model which incorporate the zero-flated nature of data, propose a Bayesian analysis of a ZIOP model, and apply the method to alcohol consumption data collected by the National Bureau of Statistics, Korea. In the first stage of a ZIOP model, a Probit model is introduced to divide the non-drinkers into genuine non-drinkers who do not participate in drinking due to personal beliefs or permanent health problems and potential drinkers who did not drink at the time of the survey but have the potential to become drinkers. In the second stage, an ordered probit model is applied to drinkers that consists of zero-consumption potential drinkers and positive consumption drinkers. The analysis results show that about 30% of non-drinkers are genuine non-drinkers and hence the Korean alcohol consumption data has the feature of zero-inflated data. A study on the marginal effect of each explanatory variable shows that certain explanatory variables have effects on the genuine non-drinkers and potential drinkers in opposite directions, which may not be detected by an ordered Probit model.

• Proceedings of the KIPE Conference
• /
• 2007.11a
• /
• pp.133-135
• /
• 2007

This research presented the new zero-current switching pulse width modulation SEPP(Single Ended Push-Pull)high frequency inverter for solving the problem of the zero-current SEPP high frequency inverter circuit which is using widely in the practical application of an induction heating apparatus, the soft switching operation and power control are impossible when the lowest power supply in the zero-current switching pulse width modulation SEPP high frequency inverter. The inverter circuit which is attempted by on-off operation of a switch has the reduction effect of the power loss due to a soft switching and a high frequency switching. And it confirmed that the power regulation is possible continuously from 0.25[kW] until 2.84[kW] in the case the duty rate(D) changes from 0.08 to 0.3 under zero-current switching operating by a dissymmetry pulse width modulating control and the power conversion efficiency comes true the efficiency of 95[%]. Due to the result above, the ZCS PWM SEPP high frequency inverter will be effective as sources of an induction heating apparatus.

• Proceedings of the KIEE Conference
• /
• 2007.11c
• /
• pp.119-124
• /
• 2007

This research presented the new zero-current switching pulse width modulation SEPP(Single Ended Push-Pull)high frequency inverter for solving the problem of the zero-current SEPP high frequency inverter circuit which is using widely in the practical application of an induction heating apparatus, the soft switching operation and power control are impossible when the lowest power supply in the zero-current switching pulse width modulation SEPP high frequency inverter. The inverter circuit which is attempted by on-off operation of a switch has the reduction effect of the power loss due to a soft switching and a high frequency switching. And it confirmed that the power regulation is possible continuously from 0.25[kW] until 2.84[kW] in the case the duty rate(D) changes from 0.08 to 0.3 under zero-current switching operating by a dissymmetry pulse width modulating control and the power conversion efficiency comes true the efficiency of 95[%]. Due to the result above, the ZCS PWM SEPP high frequency inverter will be effective as sources of an induction heating apparatus.

• The Journal of the Korea Contents Association
• /
• v.11 no.1
• /
• pp.9-15
• /
• 2011

Zero-watermarking is a digital watermarking technique that can escape from data distortion and quality degradation by no watermark insertion into digital images to be watermarked. This paper proposes DCT0CRT, a CRT-based zero-watermarking technique in the domain of DCT. One of the DC and low-frequency AC coefficients of each DCT block chosen in chaotic way from an image is selected by testing whether it satisfies the CRT-based condition matching with the watermark bit to be embedded. Such selection information forms a key to extract the watermark from the watermarked image. Experimental results show that the image quality watermarked by DCT0CRT is better than that watermarked by any other CRT-based watermarking techniques and the inserted watermark is robust against some common attacks such as sharpening, blurring, and JPEG lossy compression.

• Journal of Power Electronics
• /
• v.16 no.5
• /
• pp.1661-1668
• /
• 2016

A fixed off-time controlled high power factor ac-dc LED driver is proposed in this paper, which employs a novel zero-crossing-compensation (ZCC) circuit based on a fixed off-time controlled scheme. Due to the parasitic parameters of the system, the practical waveforms have a dead region. By detecting the zero-crossing boundary, the proposed ZCC circuit compensates the control signal VCOMP within the dead region, and is invalid above this region. With further optimization of the parameters KR and Kτ of the ZCC circuit, the dead zone can be eliminated and lower THD is achieved. Finally, the chip is implemented in HHNEC 0.5μm 5V/40V HVCMOS process, and a prototype circuit, delivering 7~12W of power to several 3-W LED loads, is tested under AC input voltage ranging from 85V to 265V. The test results indicate that the average total harmonic distortion (THD) of the entire system is approximately 10%, with a minimum of 5.5%, and that the power factor is above 0.955, with a maximum of 0.999.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2008.10a
• /
• pp.241-243
• /
• 2008

This research presented the new zero-current switching pulse width modulation SEPP(Single Ended Push-Full)high frequency inverter for solving the problem of the zero-current SEPP high frequency inverter circuit which is using widely in the practical application of an induction heating apparatus, the soft switching operation and power control are impossible when the lowest power supply in the zero-current switching pulse width modulation SEPP high frequency inverter. The inverter circuit which is attempted by on-off operation of a switch has the reduction effect of the power loss due to a soft switching and a high frequency switching. And it confirmed that the power regulation is possible continuously from 0.25[kW] until 2.84[kW] in the case the duty rate(D) changes from 0.08 to 0.3 under zero-current switching operating by a dissymmetry pulse width modulating control and the power conversion efficiency comes true the efficiency of 95[%]. Due to the result above, the ZCS PWM SEPP high frequency inverter will be effective as sources of an induction heating apparatus.

• Archives of Pharmacal Research
• /
• v.15 no.2
• /
• pp.162-168
• /
• 1992

Release characteristics of five different types of hydrophilic albumin microspheres (HAM) containing different ratios of methotrexate-albumin (MTX-HSA) conjugates to free MTX: 1 : 0 (HAMC), 3 :1 (HAMC 3F), 1 :1 (HAMCF), 1:3 (HAMCF3) and 0 : 1 (HAMF) were investigated in the absence or presence of protease using dissolution tester. In all the HAMs studied except HAMC, the MTX was released bi-exponentially in the absence of protease; an initial fast release period up to approximately 6h, and thereafter the release rate was very much slower. The fast release of MTX from the HAMs (such as HAMC3F, HAMCF, HAMCF3 and HAMF) at the initial phase in probably due to the release of "physically associated" MTX from the core of the HAMs. The initial rate constants were 7.2, 8.7, 8.5 and 5.9 times greater than the second rate constants for HAMF, HAMCF3, HAMCF and HAMC3F, respectively. MTX release from HAMC was very slow and mono-phasic. It was at most 2.2% of the total entrapped amount by 24 h. The protease accelerated the release of MTX from the HAMs. The percentages of MTX released from HAMs up to 24 h were 100, 89.0, 75.0, 66.0 and 61.0% for HAMF, HAMCF3, HAMCF, HAMC3F and HAMC, respectively in the presence of protease and the corresponding values in the absence of protease were 30.2 19.0, 10.0, 6.5 and 2.2%, respectively. In vitro release of MTX in the presence of protease varied according to the ratios of MTX-HSA conjugates to MTX; the data set from HAMF, HAMCF3 and HAMCF fits better to monophasic first-order profile more adequately than to zero-order profile, that of HAMC3 monophasic first-order, and that of HAMC to bi-phasic zero-order. Above results suggested that zero-order release rate can be achieved by adjusting the ratio of MTX-HSA conjugates to MTX in the preparation of HAMs such as HAMC3F.as HAMC3F.