• Journal of the Korean Chemical Society
• /
• v.28 no.3
• /
• pp.149-154
• /
• 1984

The electrical conductivity of p-type yttrium sesquioxide has been measured as a function of temperature and of oxygen partial pressure at temperatures from 650 to 1050$^{\circ}C$C and oxygen partial pressures from $1 {\times}10^{-5}\;to\;2{\times}10^{-1}$atm. Plots of log conductivity vs. 1/T at constant oxygen partial pressures are found to be linear with low-and high-temperature dependences of conductivity. The high-temperature dependence of conductivity shows two different defect structures. The plots of log conductivity vs. log $Po_2$ are found to be linear at $Po_2$'s of $10^{-5}\;to\;10^{-1}$ atm. The electrical conductivity dependences on $Po_2$ are found to be ${{\sigma}{\propto}Po_2}^{1/6}$at $850{\sim}950^{\circ}C,\;{{\sigma}{\propto}Po_2}^{3/16}$ at $950{\sim}1050^{\circ}C\;and\;{{\sigma}{\propto}Po_2}^{1/7.5}{\sim}{{\sigma}{\propto}Po_2}^{1/8.3}\;at\;650{\sim}800^{\circ}C$, respectively. The defect structures are$O_i{''}$ at $850{\sim}950^{\circ}C$ and $V_M{'''}$ at $950{\sim}1050^{\circ}C$. The electron hole is main carrier type, however, ionic contribution is found at lower temperature portion.

• Journal of the Korean Ceramic Society
• /
• v.38 no.11
• /
• pp.1008-1014
• /
• 2001

Nanosize YIG powders added by Cerium which is exellent element in magneto-optical effect were synthesized by Sol-Gel method using Ethylene Glycol solvent. In 120 to 150 minute reaction time, stable sol solution which showed no change in viscosity, pH, and aging time was obtained. Monolithic YIG was synthesized at 80$0^{\circ}C$ with DTA and XRD measurement and its lattice parameter had a tendency to increase from 12.3921 $\AA$. Increasing annealing temperature from 80$0^{\circ}C$ to 105$0^{\circ}C$, average particle size was in the range of 40 nm to 330 nm. Saturation magnetization (M$_{s}$) value was increased from 18.37 to 21.25 emu/g due to enhancement of YIG crystallity and decreasing of orthoferrite phase. On the other hand, coercivity (H$_{c}$) value increased up to 90$0^{\circ}C$ and then decreased above 90$0^{\circ}C$. With increasing Ce addition, coercivity was almost not changed but saturation magnetization value was maximum at Ce 0.1 mol% and then decreased because of increasing a orthoferrite amount. Also, curie temperature (T$_{c}$) of YIG were not changed with Ce addition.ion.

• Journal of Korea Foundry Society
• /
• v.35 no.5
• /
• pp.114-119
• /
• 2015

This paper reports the effect of a refractory crucible type on the microstructure of duplex stainless steel (DSS) cast with the addition of gadolinium using air-induction melting. Grade 4A DSSs with 1 wt% of gadolinium (Gd) were fabricated in various crucibles including alumina ($Al_2O_3$), magnesia (MgO), calcia (CaO) coated with yttria ($Y_2O_3$) and graphite. The standard free energies of the formation of calcium and yttrium oxide were lower than those of gadolinium oxide and other crucible elements based oxide. The yield of Gd in DSS using $Al_2O_3$, MgO, CaO-coated $Y_2O_3$ and graphite was 5, 19, 83 and 96%, respectively. As Gd yield increased, the amount of Gd-based inclusions increased, the size of the inclusions were reduced, and the inclusions became evenly distributed.

• Journal of the Korean Ceramic Society
• /
• v.51 no.5
• /
• pp.481-486
• /
• 2014

Environmental barrier coatings (EBCs) are used to protect SiC-based ceramics or composites from oxidation and corrosion due to reaction with oxygen and water vapour at high temperatures above $1000^{\circ}C$. Mullite ceramics have been studied for environmental barrier coatings for Si-based ceramics. More recently, rare earth silicate ceramics have been identified as more water vapour-resistant materials than mullite for environmental barrier coatings. In this study, we fabricate mullite and yttrium silicate ceramics by an atmospheric plasma spray coating method using spherical granules fabricated by spray drying. As a result, EBCs with thicknesses in the range of $200-300{\mu}m$ are successfully fabricated without any macroscopic cracks or interfacial delamination. Phase and microstructure analysis are conducted, and the basic mechanical properties, such as hardness and indentation load-displacement curves are evaluated.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.140-140
• /
• 2012

최근에 고체산화물 연료전지(SOFC) 연료극 조건에서 우수한 상 안정성, 높은 혼합 전자/이온 전도도 및 황/탄소 저항성 때문에 yttrium-doped strontium titanium oxide (Y-doped SrTiO3)가 대체 연료극 재료로 주목을 받아 왔다. 그러나 Y-doped SrTiO3는 연료 산화에 대해서 기존의 Ni 계열 연료극보다 낮은 전기화학적 활성을 보이는 단점이 있다. 따라서, 효율적인 Y-doped SrTiO3 계열의 연료극 재료를 개발하기 위해서는 Y-doped SrTiO3의 연료극 특성 및 반응성의 이해가 필수적이다. 본 발표에서는 SOFC 연료극에서 수소 산화 반응성을 결정함에 있어 표면 산소 vacancy 형성 에너지의 역할에 대한 spin-polarized DFT (density functional theory) 결과를 발표할 예정이다. 표면 산소 vacancy 형성 에너지는 수소 산화 반응[H2+O (surface) ${\rightarrow}$ OH+OH ${\rightarrow}$ H2O+O (vacancy)]과 밀접한 관계가 있다는 것을 확인하였다. 또한 Y-doped SrTiO3의 표면을 3d-전이금속을(Sc, V, Cr, Fe, Co, Mn, Ni, Cu) 도핑함으로써 표면 산소 vacancy 형성 에너지를 제어할 수 있다는 것을 보였다.

• Journal of the Korean Chemical Society
• /
• v.13 no.2
• /
• pp.181-186
• /
• 1969

The concentration of Strontium-90 in liquid whole milk produced in Korea were measured during past four years. The samples of milk were purchased from dairies in Seoul. Strontium-90 was analysed radiochemically and the amount of stable calcium was also determined. Radioactivity of Yttrium-90 was counted in low background beta counter which has the background of 1.38 cpm. The concentrations of Strontium-90 in the milk are 25.1 PCi $^{90}Sr$/g.Ca in 1965, 26.8 PCi $^{90}Sr$/g. Ca in 1966, 13.7 PCi 90Sr/g.Ca in 1967 and 18.2 PCi $^{90}Sr$/g.Ca in 1968 in annual average. The concentrations of Strontium-90 in the milk of 1967 and of 1968 were decreased approximately compared with the values of 60% 1965 and 1966. From the results we can see that Strontium-90 concentrations in the milk vary roughly proportionally with the specific activity of fallout. Considering on the safety problems, the Strontium-90 levels in the milk produced in Korea were far below the maximum permissible level recommended by ICRP.

• Korean Journal of Materials Research
• /
• v.27 no.8
• /
• pp.445-450
• /
• 2017

YSZ (Yttria-stabilized zirconia) is a ceramic material that is used for electronic and structural materials due to its excellent mechanical properties and specific electrical characteristics according to the Yttrium addition. Hydrothermal synthesis has several advantages such as fine particle size, uniform crystalline phase, fast reaction time, low process temperature and good dispersion condition. In order to synthesize YSZ nanoparticles with high crystallinity, hydrothermal synthesis was performed at various concentrations of NaOH. The hydrothermal process was held at a low temperature ($100^{\circ}C$), with a short process time (2,4,8 hours); the acidity or alkalinity of solution was controlled in a range of pH 2~12 by addition of NaOH. The optimum condition was found to be pH 12, at which high solubility levels of Y(OH) and Zr(OH) were reported. The synthesized nano powder showed high crystallinity and homogenous composition, and uniform particle size of about 10 nm.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.715-718
• /
• 2004

Substantially improved methods for the preparation of europium-doped yttrium oxide red phosphor with the inclusion of alkali metal halides having a general formula $(Y_{1-x}Eu_x)_2O_3$:MX where 0.025${\leq}$x${\leq}$0.2 and MX is alkali halide in the mole ratio 0.025 to 0.6, more preferably between 0.05 to 0.2 mole, are reported. Another series of the red phosphor materials with general formula $(Y_{1-x-y}Gd_xEu_y)_2O_3$:MX where 0.05${\leq}$x${\leq}$0.40 and 0.025${\leq}$y${\leq}$0.20 and MX is alkali halide in the mole ratio 0.025 to 0.5, more preferably between 0.1 to 0.2 mole, has also been presented. The inclusion of alkali halide greatly increase the luminance of the materials. The materials are very soft with fine particle size less than 100nm. The phosphorescent materials have good luminance in VUV region.

• Journal of the Korean Ceramic Society
• /
• v.38 no.8
• /
• pp.710-715
• /
• 2001

반응소결공정(RSP : Reaction Sintering Process)을 이용하여 YF댸₃와 Fe₂O₃의 성분에 소결첨가재 Bi₂O₃를 첨가하여 YIG를 합성하였다. Bi₂O₃첨가량과 소결온도에 따른 YIG 소결체의 미세구조 및 자기적 특성변화에 대해 주사전자현미경, X-선 회절분석기 및 시료 진동형 자력계를 이용하여 조사하였다. 소량의 소결첨가재 Bi₂O₃첨가시 YIG 소결체의 격자상수는 12.387에서 12.420 Å으로 증가하였다. 이는 상대적으로 이온반경이 큰 Bi 이온이 12면체 Y 이온 자리로 치환되었기 때문인 것으로 여겨진다. Bi₂O₃를 1.0 wt% 첨가하였을 때 비교적 균질한 미세구조를 보였으며, 1350℃에서 소결한 YIG의 밀도가 이론밀도의 98% 이상의 치밀화를 보였다. Bi₂O₃가 0.0 wt%에서 1.5 wt%로 첨가량이 증가함에 따라 상온에서의 포화자화값(M/sub s/)은 조금씩 증가하는 경향을 보였으나 큰 변화는 없었다. 반응소결공정을 이용 YIG 소결시 소결첨가제 Bi₂O₃가 1.0 wt%이고, 소결온도 1350℃에서 비교적 우수한 소결특성과 자기특성을 가지는 YIG 소결체를 얻을 수 있었다.

• IEIE Transactions on Smart Processing and Computing
• /
• v.4 no.5
• /
• pp.324-329
• /
• 2015

A decreased number of readout method is investigated to provide precise pixel information for small-animal positron emission tomography (PET). Small-animal PET consists of eight modules, and each module is composed of a $6{\times}6$ array of $2{\times}2{\times}20mm^3$ lutetium yttrium orthosilicate (LYSO) crystals optically coupled to a $4{\times}4$ array of $3{\times}3mm^2$ silicon photomultipliers (SiPMs). The number of readout channels is reduced by one-quarter that of the conventional method by applying a simplified row and column matrix algorithm. The performance of the PET system and detector module was evaluated with Geant4 Application for Emission Tomography (GATE) 6.1 and DETECT2000 simulations. In the results, all pixels of the $6{\times}6$ LYSO array were decoded well, and the spatial resolution and sensitivity, respectively, of the PET system were 1.75 mm and 4.6% (@ center of field of view, energy window: 350-650 keV).