• Korean Chemical Engineering Research
• /
• v.50 no.1
• /
• pp.25-29
• /
• 2012

$TiO_2$ nanotubes are prepared from rutile prticles via an alkaline hydrothermal synthesis and the consequent heat treatment at $300{\sim}500^{\circ}C$. The physical and electrochemical properties of the $TiO_2$ nanotubes are characterized for use as a anode material of rechargeable lithium battery. In particular, the microscale dusts as an impurity component occurred in the purification step after the hydrothermal reaction are completely removed to yield $TiO_2$ nanotube with a higher specific surface area and more obvious crystalline phases. As the annealing temperature increases, the specific surface area is slightly decreased due to some aggregation between the isotropically dispersed nanotubes. Highest initial discharge capacity of 250 mAh $g^{-1}$ is achieved for the $TiO_2$ nanotube annealed at $300^{\circ}C$, whereas the $400^{\circ}C$ $TiO_2$ nanotube shows the superior cycle performance and high-rate capability.

• Food Science and Preservation
• /
• v.24 no.5
• /
• pp.714-724
• /
• 2017

Soju is a Korean traditional distilled alcoholic beverage produced from mashes various crops and Nuruk which is cultured with wild microorganisms. This study was conducted to investigate rice-Soju brewing characteristics of yeasts isolated from Korean traditional Nuruk. The general components of rice (Hanarumbyeo) raw materials were 14.7 g of water, 6.8 g of crude protein, 0.9 g of crude lipid, 0.4 g of crude ash, and 76.5 g of carbohydrate in 100 g. Saccharifying and proteolytic activities in Hanarumbyeo ipguk (solid-state culture of Aspergillus luchuensis) were also determined. The alcohol content of the fermented wash from isolates was 15.37-16.58% (v/v), which is 16.7-36.0% higher than that of industrial yeasts (12.33-13.19%). Reducing sugar contents were 2.04-3.92 and 7.92-8.78 g/100 mL in the isolates and industrial yeasts, respectively. The isolated yeasts showed 25.2-52.7% higher yield of distillates (41% alcohol) compared to industrial yeasts. Forty-one components were detected in the rice distillated Soju (25% alcohol) and principal component analysis revealed differences between the isolated and industrial yeasts with respect to the contents of i-BuOH, isobutanal diethyl acetal, ethyl caprate, and tetradecanoic acid.

• Korean Journal of Medicinal Crop Science
• /
• v.20 no.2
• /
• pp.124-128
• /
• 2012

When ginseng seedlings are cultured in paddy fields, quality degradation and yield reduction are induced by severe plant loss with chlorosis on leaves occurred physiological disorder by excessive salt and poor drainage, rusty-root occurrence, and root rot etc. Accordingly, in order to solve these problems, this study was performed to investigate the treatment method, concentrations and time of activated ion calcium as environment-friendly agricultural materials. Activated ion calcium is an enriched and purified water-soluble mineral calcium component for absorbing quickly into plant as a highly functional calcium and it is an alkaline calcium of 37% (370 $m{\ell}$/1 ${\ell}$) concentration with pH 13. Treatment method was that ginseng seeds were sown after removing water in the shade after seed immersion for 1 minute with active ion calcium of 20-fold diluted solution, and then irrigated $4{\ell}$ per 3.3 $m^2$ with 200-fold, 400-fold, and 600-fold diluted solution before emergence on late March, and supplied 1 time on leaves with 500-fold diluted solution in June and July respectively. The disease rate by treatment of activated ion calcium was that on the treatment of soil irrigated with 200-fold diluted solution compared to non-treated soil, damping-off was 33%, anthracnose was 100% reduced and the occurrence rate of rusty-root was 30% reduced. In addition, when active ion calcium of 200-fold diluted solution were soil irrigated, first and second grade ginseng were respectively 26% and 22% produced more, compared with control.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.36 no.2
• /
• pp.201-208
• /
• 2007

Functional oils (FOs) were produced from commercial diacylglycerol oil and red yeast rice extracts from 80% ethanol for 1 hr in a shaking water bath at $35^{\circ}C$ and 175 rpm. FOs contained (A) 600, (B) 1200, (C) 1800, and (D) 2280 ppm of red yeast-rice extracts, respectively. The Hunter a value and b value were risen whereas L value was reduced along with the increase of extract concentration. Content of monacolin K and total phenolic compounds in FOs significantly increased according to the increase of extract concentration. The oxidation stability of FOs was observed by Rancimat at $98^{\circ}C$. Induction time decreased according to the increase of extract concentration. The major volatile compounds of FOs were compared using the electronic nose (EN) system and solid phase microextraction (SPME) method combined with gas chromatograph/mass spectrometry (GC/MS). EN was composed of 12 different metal oxide sensors. Sensitivities (Rgas/Rair) of sensors from EN were analyzed by principal component analysis (PCA), whose proportion was 99.66%. For qualitative or quantitative analysis of volatile compounds by SPME-GC/MS, the divinylbenzene/carboxene/polydimethyl-siloxane fiber and sampling temperature of $50^{\circ}C$ were applied.

• Food Science and Preservation
• /
• v.14 no.6
• /
• pp.722-726
• /
• 2007

Extracting and analytical conditions of curcumin, and removal of bitterness substance from Curcuma longa L. were investigated. Absorption maxima was shown to be 424 nm at methanol solvent. Optimal conditions for analysis of curcumin was Zorbax eclipse $C_{18}$ column ; mobile phase, 75% MeOH ; flow rate, 0.8 mL/min ; wave length, UV 424 nm. Curcumin component was analyzed to be the highest content in methanol extract. In all samples, extraction yield by heating was shown to be effective as compared to room temperature. Curcumin contents of methanol and ethanol extracts in extraction of room temperature were 14.4 and 14.2 times higher than that of water extract, respectively. Two hot solvent extracts has a high curcumin content being 150 mg% as compared to room temperature. Extracting time was an effective condition when it was extracted for 60 minutes for elevating the curcumin content of water and methanol extracts. Bitter substance (BS) was markedly decreased in water extract by heat treatment of above $80^{\circ}C$. BS was weak in $121^{\circ}C$ treatment than in room temperature and it was however strong in $100^{\circ}C$ treatment. RT and $70^{\circ}C$ heat treatment were not different in BS intensity.

• Food Science and Preservation
• /
• v.22 no.1
• /
• pp.56-62
• /
• 2015

In this study, the quality characteristics of different drying methods of Aronia melanocarpa, which contains large amounts of bioactive substances, were investigated for the improvement of their practical use. During the drying period, the weight reduction was the highest with vacuum freeze drying (81.6%). The water content was reduced to the maximum level when vacuum freeze-drying was used. With regard to the color value measurement results, there were no significant differences in the $L^*$ value. Values of $a^*$ and $b^*$ were increased in vacuum freeze drying and cold air drying, but decreased in hot air drying. The hardness was increased dramatically after 36 hours of hot air drying, while with cold air drying, it increased slowly until 132 hr and increased rapidly after 132 hr. The dried yield was the highest with cold air drying (24.2%). As for the general component analysis results of Aronia melanocarpa, the moisture content was the lowest, and the crude protein and crude fat contents were the highest with vacuum freeze drying. No difference in pH value was shown among the dried Aronia melanocarpa obtained from the different drying methods, but the sugar content was the highest with vacuum freeze drying. The mineral content was the highest with cold air drying, and K, Ca, Mg, and Na were the major minerals. The free sugar content of dried Aronia melanocarpa was found to be 5.92~20.59 g/100 g, and the highest free sugar content was found with vaccum freeze drying.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.37 no.4
• /
• pp.512-520
• /
• 2008

In order to examine the effective components and antioxidative characteristics of Acanthopanacis cortex, response surface methodology was used to optimize the hot water extraction process by analyzing and monitoring the extraction condition characteristics. The total extraction yield was optimized using the extraction temperature of $84.28^{\circ}C$, extraction time of 3.59 hr and 18.37 mL/g as the amount of solvent per sample. For the effective component of eleutheroside E, the optimal extraction temperature, time and amount of solvent per sample were $81.16^{\circ}C$, 3.56 hr, and 19.06 mL/g, respectively; also, for total phenolics, the optimal conditions were $88.45^{\circ}C$, 4.33 hr, and 21.12 mL/g, respectively. Regression equations were deduced for each variable and then eleutheroside E, chlorogenic acid, and antioxidative characteristics were superimposed with the optimal conditions to obtain values for each extraction process factor. The predicted results were $81{\sim}88^{\circ}C$, $3.5{\sim}4.3hr$, and $18{\sim}21mL/g$, respectively. The estimated values for the optimal extraction conditions of Acanthopanacis cortex's effective components and antioxidative characteristics were similar to the experimental results.

• Horticultural Science & Technology
• /
• v.16 no.2
• /
• pp.222-225
• /
• 1998

The objective of this study was to observe the effects of potassium-carboxymethyl cellulose (K-CMC), which is a natural polymer derivative, and polyacrylamide (PAM), which is a commercial synthetic polymer, on soil physicochemical properties and yields of the cabbage. To increase water absorbing capacity (WAC), hydrophilic carboxymethyl group was introduced to cellulose chain and it was confirmed by FT-IR. WAC was tested by tea-bag method in distilled water and 3% NaCl solution. PAM is slightly more absorptive than K-CMC in distilled water, but in NaCl solution, K-CMC is more absorptive than PAM. Soil particle sizes above $1_{mm}$ were immediately increased from 9.6 to approximately 16.6% by the application of K-CMC and PAM, respectively. Infiltration rates of soil were approximately twice as great as those of the control when conditioned with the K-CMC and PAM treatment. K content of soil treated with K-CMC was significantly higher than those of PAM and control, but the other components of soil chemical properties were not different. The early growth and vegetative production of cabbage in the K-CMC and PAM treatments were significantly higher than the control. The contents of vitamin C were increased with the treatment of K-CMC. It was proposed that K-CMC treatment influence K component of the soil and vitamin C content of the cabbage, therefore, it improved the yields as well as crop quality.

• Journal of Life Science
• /
• v.12 no.1
• /
• pp.87-95
• /
• 2002

It was observed that the hot water extract of the leaves of Capsicum annuum L., a Korean edible plant, had a potent anti-complementary activity. Crude polysaccharide fraction(CAL-0) was obtained by methanol reflux, ethanol precipitation, dialysis and lyophilization. CAL-0 contained 51.8% of total sugar, 8.2% of uronic acid and 16.8% of protein, and consisted of mainly arabinose, galactose and glucose as neutral sugars and galacturonic acid as uronic acid. The anti-complementary activity of CAL-0 decreased greatly by periodate oxidation, but was not changed by pronase treatment. Also, the anti-complementary activity of CAL-0 was reduced partially in the absence of the $Ca^{2+}$ ion. The crude polysaccharide CAL-0 was found to activate the C3 component both in the presence and in the absence of $Ca^{2+}$ through the crossed-immunoelectrophoresis suggesting that those involved in both classical and alternative complement pathway CAL-0 was further separated to an unabsorbed fraction(CAL-1) and six absorbed fractions(CAL-2longrightarrowCAL-7) on DEAE Sepharose CL-6B ion exchange column. Among them four major fractions in activity and yield were obtained, and consisted mainly of arabinose, galactose and glucose with various molar ratios. The major fraction, CAL-2, was purified to give a high molecular fraction(CAL-2-I) and a low molecular fraction(CAL-2-II) on Sepharose CL-6B column. The anti-complementary activity of CAL-2-I, a molecular weight of about 61,000, was higher than it of CAL-2-II.-II.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.35 no.3
• /
• pp.132-142
• /
• 2019

Purpose: The purpose of this finite element analysis study is to introduce the novel Lock screw system and analyze its mechanical property to see if it can prevent abutment screw loosening. Materials and Methods: The Lock screw is a component tightened on the inside of the implant abutment which applies compressive force to the abutment screw head. To investigate the effect, modeling was done using CAD program and it was analyzed by finite element analysis under various load conditions. First, the preload was measured according to the tightening torque of the abutment screw then it was compared with the theoretical value to verify the analytical model. The validated analytical model was then divided into those with no external load and those with 178 N, and the tightening torque of the lock screw was changed to 10, 20, 30 Ncm respectively to examine the property of stress distribution on the implant components. Results: Using Lock screw under various loading conditions did not produce equivalent stresses beyond the yield strength of the implant components. In addition, the axial load was increased at the abutment-abutment screw interface. Conclusion: The use of Lock screw does not exert excessive stress on the implant components and may increase the frictional force between the abutment-abutment screw interface, thus it is considered to prevent loosening of the abutment screw.