• Journal of the Korean Wood Science and Technology
• /
• v.47 no.5
• /
• pp.557-566
• /
• 2019

Radial and tangential water diffusion in Eucalyptus globulus wood was investigated using three mature trees from a forest in Khemis Sahel (North Morocco). Absorption and desorption kinetics experiments were conducted at ambient temperature ($25^{\circ}C$) and $30^{\circ}C$, respectively, and a relative humidity of 60%. The diffusion coefficients in the two directions were determined under imposed hygrothermal conditions; they were greater in the radial direction for the absorption as well as desorption processes. Convective drying under load, preceded by reconditioning and followed up by balancing, revealed the drying conditions that corresponded to the appropriate drying schedules for E. globulus wood. This was verified by measuring the cracks and bowsbefore and after drying of boards.

• Membrane and Water Treatment
• /
• v.10 no.6
• /
• pp.405-415
• /
• 2019

Microcystins (MCs) are toxins produced by cyanobacteria causing a major environmental threat to water resources worldwide. Although several MCs have been reported in previous studies, microcystin-LR (m-LR) has been extensively studied as it is highly toxic. Among the several techniques employed for the removal of this toxin, adsorption with AC has been extensively studied. AC has gained wide attention as an effective adsorbent of m-LR due to its ubiquity, high sorption capacity, cost effectiveness and renewability. In this review, the adsorption of m-LR onto AC was evaluated using the information available in existing scientific literature. The effects of the pore volume and surface chemistry of AC on the adsorption of m-LR considering the structural and chemical properties of ACs were also discussed. Furthermore, we identified the parameters that influence adsorption, including natural organic matter (NOM), pH, and ionic strength during the m-LR adsorption process. The effect of these parameters on MCs adsorption onto AC from previous studied is compiled and highlighted. This review may provide new insights into future activated carbon-m-LR adsorption research, and broaden its application prospects.

• Journal of Soil and Groundwater Environment
• /
• v.27 no.1
• /
• pp.60-70
• /
• 2022

We evaluated the performance of in-situ capping to prevent the release of phenol, one of hazardous chemicals of concern for their impact on sediment. Sediment near the estuary of Hyeongsan River, Korea, and commercially-available sand were collected to evaluate their physical properties and phenol sorption characteristics. Biodegradation kinetics of phenol spiked into the sediment was evaluated under freshwater and estuarine salinity conditions. These experimental measurements were parameterized and used as input parameters for executing CapSim, a software predicting the performance of in-situ capping. The CapSim simulation demonstrated that capping with 50-cm sand reduced the phenol release by several orders of magnitude over 0.25- and 1-year duration for almost all simulation scenarios. The variables tested, i.e., cap thickness, pore-water movement, and biodegradation rate, showed high correlation to each other to influence the extent of phenol release from sediment to the water column. The findings and the framework employed to evaluate the performance of in-situ capping in this study can be adopted to determine whether in-situ capping is appropriate remedial approach at sediment sites impacted by hazardous chemicals due to accidental spills.

• Nuclear Engineering and Technology
• /
• v.54 no.6
• /
• pp.1991-2003
• /
• 2022

The problem of water contamination by long-living cesium and strontium radionuclides is an urgent environmental issue. The development of facile and efficient technologies based on nanostructured adsorbents is a perspective for selective radionuclides removal. In this regard, current work aimed to obtain the nanostructured magnetic zeolite composites with high adsorption performance to cesium and strontium ions. The optimal conditions of hydrothermal synthesis were established based on XRD, SEM-EDX, N₂ adsorption-desorption, VSM, and batch adsorption experiment data. The role of chemical composition, textural characteristics, and surface morphology was demonstrated. The monolayer ionexchange mechanism was proposed based on adsorption isotherm modeling. The highest Langmuir adsorption capacity of 229.6 and 105.1 mg/g towards cesium and strontium ions was reached for composite obtained at 90 ℃ hydrothermal treatment. It was shown that magnetic characteristics of zeolite composites allowing to separate spent adsorbents by a magnet from aqueous solutions.

• Journal of the Korean GEO-environmental Society
• /
• v.4 no.2
• /
• pp.39-46
• /
• 2003

An immobilization zone can be constructed by modifying soils in the vadose zone with surfactants, which can be used to promote retardation of organic contaminants in the subsurface. Column experiments were conducted to investigate the behavior of surfactants and organic contaminants in unsaturated and saturated conditions with different water contents (25%, 50%, 75%, 100%). Transport and sorption of surfactant (dialkylated disulfonated diphenyl oxide) in the columns containing aluminum oxide was similar under the conditions at different water contents. However, transport of a model organic compound (naphthalene) was retarded as the water content decreased by enhanced partitioning of the compound into the surfactants that were sorbed on the aluminum oxide. This suggests that the immobilization method could well be applied to vadose zone as well as to saturated zone.

• Korean Journal of Food Science and Technology
• /
• v.41 no.1
• /
• pp.32-36
• /
• 2009

The physical properties of freeze-dried Aloe vera gel powders were examined according to the influence of the concentration degrees of the gel solutions as raw materials during freeze-drying. As a pre-treatment prior to freeze-drying, the gel solutions were vacuum-concentrated at three concentration levels (g water/g solids): high (H), 76; medium (M), 119; and low (L), 159. The water contents of the three powder samples were almost the same. For their viscosity measurements, non-Newtonian fluid behavior with shear thinning was observed in samples H and M, whereas Newtonian liquid behavior was found in sample L. In electrical conductivity measurements, sample H showed the highest conductivity upon dissolving the powder in water. For their water sorption isotherms, sample H was analyzed to have the least amount of bound water. Finally, it was determined that the degree of concentration caused only slight differences in the physical properties of freeze-dried Aloe gel powders.

• Food Science and Preservation
• /
• v.13 no.3
• /
• pp.285-291
• /
• 2006

The effects of sorbitol mixture as plasticizers on moisture sorption property (MSP), water vapor permeability (WVP), color, tensile strength (TS), elongation at break (E), and total soluble matter (TSM) of soy protein isolate (SPI) films were investigated. Two different types of sorbitols, aqueous and crystalline, were added to film-forming solutions in various ratios of crystalline to aqueous (0:1, 0.25:0.75, 0.5:0.5, 0.75:0.25, or 1:0, based on weight). In addition, the characteristics of the SPI films plasticized by sorbitol mixtures and glycerin were compared with moisture sorption rate against time. Sorbitol-plasticized films had higher in TS, but lower in WVP and E than the glycerin-plasticized films. However the properties of SPI films did not differ appreciably by the type of sorbitol added to film-forming solutions. To explain the high solubility and low WVP of sorbitol-plasticized films, cumulative amounts of moisture content gained during adsorption and lost during desorption of films were compared between sorbitol and glycerin-plasticized films. The result suggest that use of sorbitol as a plasticizer for preparing SPI films improves moisture barrier properties of the films. However the high solubility of sorbitol-plasticized films needs to be reduced for improving the functionality of SPI films in potential packaging applications.

• Clean Technology
• /
• v.17 no.2
• /
• pp.166-174
• /
• 2011

The xAl-yCe oxide catalysts with different mol ratios of Al/(Al+Ce) were prepared by a co-precipitation method and Pt supported on xAl-yCe oxide catalysts were synthesized by an incipient wetness impregnation method. The catalysts were characterized by X-ray Diffraction (XRD), $N_2$ sorption, and $H_2$/CO-temperature programmed reduction ($H_2$/CO-TPR) to correlate with catalytic activities in co oxidation. Among the catalysts studied here, Pt/1Al-9Ce oxide catalyst showed the highest activity in dry and wet reaction conditions and the catalytic activity showed a typical volcano-shape curve with respect to Al/(Al+Ce) mol ratio. When the presence of 5% water vapor in the feed, the temperature of $T_{50%}$ was shifted ca. $30^{\circ}C$ to lower temperature region than that in dry condition. From CO-TPR, the desorption peak of $CO_2$ on Pt/1Al-9Ce oxide catalyst showed the highest value and well correlated the catalytic performance. It indicates that the Pt/1Al-9Ce oxide catalyst has a large amount of active sites which can be adsorbed by co and easy to supplies the needed oxygen. In addition, the amount of pentacoordinated $Al^{3+}$ sites obtained through $^{27}Al$ NMR analysis is well correlated the catalytic performance.

• Clean Technology
• /
• v.19 no.4
• /
• pp.437-445
• /
• 2013

To develop SEWGS (sorption enhanced water gas shift) system using dry $CO_2$ absorbent for pre-combustion $CO_2$ capture, hydrodynamic characteristics of $CO_2$ absorbents were measured and investigated. The minimum fluidization velocity of $CO_2$ absorbent was measured and the effects of the operating conditions were investigated to operate the system at bubbling fluidized bed condition. The minimum fluidization velocity decreased as pressure and temperature increased. Moreover, the minimum fluidization velocity decreased as column diameter increased. The effects of operating conditions on the solid circulation rate were measured and investigated to select appropriate operating conditions for continuous $CO_2$ capture and regeneration. The measured solid circulation rates were ranged between 10 and 65 kg/h and increased as the solid injection velocity, gas velocity in the regeneration reactor, and solid height increased.

• Journal of Korean Society of Environmental Engineers
• /
• v.39 no.1
• /
• pp.26-33
• /
• 2017

The objective of this study was to evaluate the characteristic of adsorption by using a meso-porous adsorbent (MPA), and investigate the removal efficiency of geosmin which taste and odor causing compounds in drinking water supplies through batch test. The results for the adsorption isotherm was analyzed by using the Langmuir equation and Freundlich equation, generally being applied. And the study showed that the both Langmuir and Freundlich equation explains the results better. Both of pseudo-first-order model and pseudo-second-order model were respectively applied for evaluation of kinetic sorption property of geosmin onto MPA. The adsorption experiment results using MPA showed that maximum adsorption capacity of MPA was lower 7 times than that of GAC, and adsorption rate of MPA was faster 11 times than that of GAC, on the basis of pseudo-first-order model. Therefore, it was determined that MPA was effectively able to remove geosmin in drinking water supplies in short EBCT condition, but regeneration cycle in MAP process was shorter than that in conventional process.