• Food Science and Preservation
• /
• v.13 no.1
• /
• pp.37-42
• /
• 2006

In recent, Kimchi is produced in the scale of industry, Consumers show increased demand of safety and high quality and hygienic process control. So, sun drying, hot air drying and cold air drying methods were investigated to compare the demand Sun drying took 96 hrs, hot air drying took 4 hrs at $70^{\circ}$ and cold air drying took 102 hrs at $10^{\circ}C$ in removing water to $90\%$ from radish. Brownness of radish was expressed as absorbance. Absorbance were 0.20, 2.04 and 1.87 and also Vit-C contents were 0.14 mg/g, 0.12 mg/g and 0.096 mg/g in dried radish according to cold air drying, hot air drying and sun drying, respectively. From overall experimental results, cold air drying method was found as superior drying method to other drying methods.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.4
• /
• pp.397-410
• /
• 2018

When considering the long-term safety assessment of spent-nuclear fuel management, americium is one of the most radio-toxic actinides. Although spectroscopic methods are widely used for the study of actinide chemistry, application of those methods to americium chemistry has been limited. Herein, we purified $^{241}Am$ to obtain a highly pure stock solution required for spectroscopic studies. Quantitative and qualitative analyses of purified $^{241}Am$ were carried out using liquid scintillation counting, and gamma and alpha radiation spectrometry. Highly sensitive absorption spectrometry coupled with a liquid waveguide capillary cell and time-resolved laser fluorescence spectroscopy were employed for the study of Am(III) hydrolysis and oxalate (Ox) complexation. $Am^{3+}$ ions under acidic conditions exhibit maximum absorbance at 503 nm, with a molar absorption coefficient of $424{\pm}8cm^{-1}{\cdot}M^{-1}$. $Am(OH)_3(s)$ colloidal particles formed under near neutral pH conditions were identified by monitoring the absorbance at around 506-507 nm. The formation of ${Am(Ox)_3}^{3-}$ was detected by red-shifts of the absorption and luminescence spectra of 4 and 5 nm, respectively. In addition, considerable enhancements of the luminescence intensities were observed. The luminescence lifetime of ${Am(Ox)_3}^{3-}$ increased from 23 to 56 ns, which indicates that approximately six water molecules are replaced by carboxylate ligands in the inner-sphere of the Am(III). These results suggest that ${Am(Ox)_3}^{3-}$ is formed through the bidentate coordination of the oxalate ligands.

• Journal of the Korean Chemical Society
• /
• v.56 no.2
• /
• pp.228-235
• /
• 2012

A $N_2O_2$ Schiff base ligand, N,N'-bis(4-methoxysalicylidene)phenylendiamine (4-$CH_3O$-salphen) was synthesized. Using the 4-$CH_3O$-salphen, the spectrophoto-metric quantitative analysis of Cu(II) ion in aqueous solution was performed. The optimum condition for the quantitative analysis of Cu(II) ion was determined as the following; the concentration of 4-$CH_3O$-salphen is $2.0{\times}10^{-4}\;mol/L$, ratio between solvent DMSO and water is 50/50(v/v), pH is 5.5. After 1 hr water incubation at $55^{\circ}C$ and then the absorbance measurements at 388 nm, a calibration curve (${\varepsilon}=3.6{\times}10^4\;mol^{-1}cm^{-1}$) with a correlation coefficient ($R^2$=0.9963) was obtained in this condition. Using this optimized condition, the quantitative analysis of Cu(II) ion was performed with various samples such as hot spring water, semiconductor factory waste water and treated water from sewage treatment plant. The average value of the measured values agreed well with standard value with a range of 0.6~5.4%. The limit of determination was 31.77 ng/mL ($5.0{\times}10^{-7}\;mol/L$).

• Analytical Science and Technology
• /
• v.6 no.3
• /
• pp.289-296
• /
• 1993

The formation of Mo(VI)-alizarin red S chelate ion and its extraction into an organic solvent by ion-pairing were studied for the separative determination of trace Mo(VI) in natural water samples. Natural water 100mL was sampled in 250mL separatory funnel. After Mo(VI)-ARS chelate ion was formed by adding 0.01M alizarin red S solution 0.5mL to the water sample of pH 4.0, 0.2% aliquat-336 chloroform solution 10mL was added and the solution was vigorously shaked for about 30 seconds to from the ion-pair between Mo(VI)-ARS and aliquat-336, completely. The solution was stood for about 90 minutes. And the organic phase was taken for the absorbance measurement of the ion-pair at 520 nm. The content of Mo(VI) in sample was obtained from the standard calibration curve. Several extraction conditions such as pH, adding amounts of alizarin red S and aliquat-336, and shaking and standing times were optimized. This procedure was applied to the analysis of river and tap waters. It could be confirmed from the recoveries of over 99% in samples spiked with a given amount of Mo(VI) that this method was quantitiative in the determination of trace Mo(VI) in a natural water.

• Membrane Journal
• /
• v.21 no.2
• /
• pp.127-140
• /
• 2011

The effects of $TiO_2$ photocatalyst coating bead concentration, water-back-flushing period (FT), and back-flushing time (BT) were investigated in hybrid process of ceramic ultrafiltration and photocatalyst for advanced drinking water treatment in this study. Photocatalyst coating bead concentration was changed in the range of 10~40 g/L, FT in 2~10 min and BT in 6~30 sec. Then, we observed the effects on resistance of membrane fouling $(R_f)$, permeate flux (J) and total permeate volume $(V_{\Upsilon})$ during total filtration time of 180 min. As decreasing photocatalyst coating bead concentration, $R_f$ increased and J decreased. $V_{\Upsilon}$ was the highest value of 8.85 L at 40 g/L of photocatalyst coating bead concentration. At FT change experiment, $R_f$ decreased and J increased as decreasing FT. Then $R_f$ decreased and J increased according to increasing BT at BT change experiment. Because at NBF (no back-flushing) dramatic membrane fouling reduced membrane pore size, turbid and dissolved organic matters ($UV_{254}$ absorbance) could be removed efficiently. Therefore, treatment efficiencies of turbidity and dissolved organic matters were the highest at NBF. Then by cleaning effect of photocatalyst coating bead, the treatment efficiencies of turbidity and dissolved organic matters increased as decreasing FT and increasing BT.

• Membrane Journal
• /
• v.18 no.3
• /
• pp.191-197
• /
• 2008

In this study, we used hybrid module that was composed of packing granular activated carbon (GAC) between module inside and outside of ceramic microfiltration membrane for advanced drinking water treatment. Instead of natural organic matters (NOM) and fine inorganic particles in natural water source, synthetic water was prepared with humic acid and kaolin. Packing fraction of GAC was changed from 0 to 24.05% to see effect of packing fraction. As a result, changing curves of resistance of membrane fouling ($R_f$) and permeate flux (J) during 3 h operation were almost overlapped independent of packing fraction of GAC. Treatment efficiencies of turbidity were very high above 99.46% at all packing fractions of GAC. And treatment efficiency of NOM, which was measured by $UV_{254}$ absorbance, was the highest value of 99.43% at packing fraction of 24.05%. Then, we operated the hybrid process during 13 h at packing fraction of 24.05%. As a result, J was rapidly dropped according to increase of membrane fouling within initial 1 h of operation, and almost constant after 3 h. And treatment efficiencies of turbidity and NOM were stable and high values of 99.52% and 96.63%, respectively.

• Journal of the Korean Chemical Society
• /
• v.55 no.3
• /
• pp.463-471
• /
• 2011

A novel $N_2O_2$ Schiff base ligand, N,N'-bis(4-methoxysalicylidene)phenylendiamine(4-$CH_3O$-Salphen), has been synthesized. It has been revealed that the compound is very useful for the spectrophotometric quantification of Fe(II) and Fe(III) ions in aqueous solutions, such as mineral water, hot spring water, sea water, and waste water. The optimum conditions for the quantitative analysis are the followings; [4-$CH_3O$-Salphen]=$4.0{\times}10^{-4}\;M$, DMF/$H_2O$=70/30(v/v), pH=3.4~3.8, T= at $55^{\circ}C$, and prereaction time=1.0 hr. The sample of single valence state was prepared by the preliminary oxidation or reduction using $H_2O_2$ ($5.0{\times}10^{-4}\;M$) and $NH_2OH{\cdot}HCl$ ($5.0{\times}10^{-4}\;M$). The quantitative analyses of Fe(II) and Fe(III) ion were performed by measuring the absorbance at 434 nm and 456 nm, respectively. The estimated mean values agreed well with the standard values within the range of 2.00~6.90%. The limit of detection was 27.9 ng/mL for Fe(II) and 55.8 ng/mL for Fe(III).

• Journal of Mushroom
• /
• v.12 no.4
• /
• pp.299-303
• /
• 2014

This study was to comparative analysis that different methods of extraction about total sugar content which the major functional components of edible and medicinal mushrooms. Through the phenol-sulfuric acid method was measured that Hot water extraction, acid extraction, and alkaline extraction. Drawing the standard curve to obtain the concentration of the glucose solution and the sample by applying the measured absorbance on the standard curve. Total sugar contents was measured after extraction with different solvents.(Hot water, 70% EtOH, 80% MeOH). The level of total sugar in Cordyceps militaris is highest in the hot water extraction with 658.4(${\mu}g/g$) and Coriolus versicolor in 649.7(${\mu}g/g$) and 679.0(${\mu}g/g$) was found as the highest in the acid extraction and the alkaline extraction. C. militaris and ASI 7025 showed the highest level in the hot water extraction. Finally, C. versicolor, Sparassis crispa showed that higher than the other mushrooms at the 1hr, 2hr microwave extraction. It was varied total sugar content according to the different extraction solvent and the extraction method.

• Economic and Environmental Geology
• /
• v.46 no.6
• /
• pp.495-508
• /
• 2013

Recently, stable isotopes (${\delta}^{18}O$ and ${\delta}D$) of water are increasingly analyzed using laser-based technologies. These methods have advantages over Isotope Ratio Mass Spectrometry (IRMS) in that they can be used for in-situ measurements and require much less maintenance and preparation work. Two types of laser-based methods are currently available, which have different analytical principles; OA-ICOS (off-axis integrated cavity output spectroscopy) and WS-CRDS (wavelength-scanned cavity ring-down spectroscopy). In the WS-CRDS instrument, water is vaporized at controlled environment and transferred to an optical cavity by nitrogen carrier gas, and stable isotopic compositions of water vapor are measured using the degree of absorbance of specific wavelengths and the ratios of attenuation time of the laser intensity with the sensitivity of ppb to tens of ppt level. In this study, we introduce the principle of the WS-CRDS technology and the performance results including stability and comparisons with Isotope Ratio Mass Spectrometry (IRMS) and suggest possible applications of various topics in isotope hydrology.

• Journal of Environmental Science International
• /
• v.15 no.8
• /
• pp.785-797
• /
• 2006

The formation characteristics of trihalomethanes (THMs) and haloacetic acids (HAAs) were investigated in chlorination of raw water of different organic mallet characteristics. The samples used in this study were hydrophobic (N-HPO) and hydrophilic fraction (N-HPI) (which were concentrated and separated from Nakdong river water), and humic acid (HA) (which is known as a strong hydrophobic acid) as a reference organic matter, the specific UV absorbance (SUVA) of which was 2.19, 1.15 and 7.92, respectively. With increasing chlorine contact time, THMFP and HAAFP (the formation potential of THMs and HAAs) increased, but their increase was different depending on the organic mallet characteristics (i.e., for N-HPI, THMFP was higher than HAAFP, but the inverse result was obtained for N-HPO and HA and the ratio between them was greater for HA), and the mainly formed chemical species were CHCI$_3$ in case of THMs and dichloroacetic acid (DCAA) and trichloroacetic acid (TCAA) in case of HAAs for N-HPO and HA (and the ratios of CHCI$_3$ to total THMs and DCAA and TCAA to total HAAs for HA were higher than those for N-HPO), but for N-HPI, the ratio of brominated THMs was a little higher than that of CHCI$_3$ and the ratio of DCAA and TCAA to total HAAs was lower than that of N-HPO, although they are main chemical species in case of HAAs. Comparing THMFP and HAAFP with the increase in bromide concentration added with those in not adding it, the former increased greatly and its increase was higher for the organic mallet with stronger hydrophobicity, but the latter was lower for N-HPO and N-HPI and was similar for HA. The main chemical species with increasing bromide concentration were CHBt$_3$ in case of THMs regardless of organic matter characteristics, and dibromoacetic acid (DBAA) for N-HPO and N-HPI, DBAA and tribromoacetic acid (TBAA) for HA in case of HAAs. With increasing reaction temperature and pH, THMFP and HAAFP increased for the former, but for the latter, THMFP increased and HAAFP decreased, although the rate of increase or decrease was different with organic mallet characteristics.