• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.2
• /
• pp.177-185
• /
• 2007

Hydraulic efficiency($T_{10}/T$) in clearwell is often estimated by L/W ratio. However, this estimation is not accurate because other factors which give an effect on hydraulic efficiency such as shape of basin, diffuser wall and intra-basin is ignored. Therefore, in this research, hydraulic efficiency is predicted by the quantitative analysis of dead zone using CFD simulation in a pilot scale clearwell. The results show that the reason why higher L/W ratio increase the hydraulic efficiency is to decrease the dead zone of linear region which is located between baffles. Diffuser wall or intra-basin also affects on hydraulic efficiency with this process. Also, we conclude that hydraulic efficiency can not be reached to 0.8 or higher.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.4
• /
• pp.289-296
• /
• 2001

The piezoelectric transformers of 2.0x10x48 ㎣ size were fabricated with PSN-PMN-PZT(T10 and PNW-PMN-PZT(T2) composition ceramics. Effects of micro structural and piezoelectric properties on the electrical characteristics of the piezoelectric transformers were investigated. Under the fixed output power of 6 W, temperature rise of T1 transformer at the optimum load was smaller than T2 one because of fine grain size effect. Voltage step-up ratio of T1 transformer showed higher value than T2 one T1 transformer showed an excellent properties with voltage step-up ratio of 12.41, efficiency of 95.23% and temperature rise of 7.2$^{\circ}C$ at 200㏀ load resistance. And also, T2 transformer showed an excellent properties with voltage step up ratio of 9.81, efficiency of 95.51% and temperature rise of 9$^{\circ}C$ at 150㏀ load resistance.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2008.11a
• /
• pp.731-732
• /
• 2008

• Journal of the Korean Society of Tobacco Science
• /
• v.7 no.1
• /
• pp.15-23
• /
• 1985

Growth response and evapotranspiration of tobacco as to each soil moisture condition treated with different height of ground water table such as 30cm, 100cm, 170cm, and 230cm were investigated. The results obtained were as follows; 1. Soil water potential in the rhizosphere (25cm depth from surface) treated with ground water table (G.W.T) of 230 cm was less than -6.5 bar at 60 days after transplanting. 2. Dry weight of leaves per plant was the highest in the pot treated with 100 cm G.W.T and was the lowest in the pot treated with 230 cm G.W.T.. Leaves/Stem ratio of dry weight was the lowest in the pot treated with 230 cm G.W.T. This would show that extension of leaves as compared with elongation of stem was suppressed. .3. In the roster stress condition of 230 cm G.W.T., extension of leaves was continued until the latter growth stage, Relative growth rate of leaf area per plant of the pot with 30 cm G.W.T. was the highest through all growth period after fixation of G.W.7., but owing to lower density of leaf, the dry weight of leaves per plant was less rather than that of the pot with 170 cm G.W.T. at 64 days after transplanting. 4. The highest evapotranspiration per plant per day was shown at the 45th day after transplanting in the pots with 30cm and 100cm G.W.T. and at 60 days in the pots with 170cm and 230cm G.W.T respectively. 5. In the soil moisture conditions with 30cm and 100cm G.W.T., evapotranspiration per plant per hour was much higher in the daytime that at night as well as in clear day than in rain-cloudy day owing to loner relative humidity , but in the water stress condition with 230 cm G.W.T., that was much lower. 6. Total evapotranspiration per plant during the whole growing period of 64 days was in order of 30cm > 100 cm > 170 cm > 230 cm G.W.T.. Total evapotranspiration for 34 days after fixation of G.W.T was much higher at night than in the daytime in case of water stress conditions i.e 170cm and 230cm G.W.T. but in normal condition of the pots with 30cm and 100cm G.W.T. that was much higher in the daytime than at night. 7. Leaf water potential of the 3rd and 6th leaf from top at 64 days after transplanting was in order of 100cm > 30 cm > 170cm > 230cm G.W.T. The reason why leaf water potential in the pot with 30cm was less than that in the pot with 100cm G.W.T. would be the abnormal turgidity with low density of cell substrates by the excess water absorption in the pot with 30cm G.W.T..

• Journal of Nutrition and Health
• /
• v.28 no.10
• /
• pp.1004-1014
• /
• 1995

Effect of age and dietary fatty acid composition on immune responses were investigated in Sprague-Dawley male rets. The animals weighing 88.6$\pm$2.2g were fed 10% dietary fat (W/W, 20% of calorie) with P/S ratio of 0.5, 1 and 2, and in each group, there were three different levels of n-6/n-3 fatty acid ratio; 2, 4 and 8(3$\times$3). The experimental periods were 1 month, 6 months and 12 months. The results of this study were; 1) Weights of thymus and spleen were significantly reduced with increasing age, moreover thymus weights were reduced with increasing the degree of unsaturation in dietarty fatty acid at 12 month. 2) The proportion of splenic lymphocyte in the total T-cell was increased with increased with age. The proportion of helper T-cell was not changed, while the proportion of suppressor T-cell was decreased. Thus at 12 month, the ratio of helpe $r^pressor T-cell was appeared to increase significantly, and showed the tendency to increase by consuming the low amount of dieraty n-3 fatty acid. 3) Proliferation stimulated by Con A or PWM reduced significantly at 12 month in which are high in dietary P/S ratio, representing the similar pattern with decrease in thymus weight. 4) Natural killer cell activities were shown significantly higher at 1 month than those at 6 month or 12 month.th.

• Weed & Turfgrass Science
• /
• v.7 no.2
• /
• pp.120-129
• /
• 2018

This experiment was conducted to find the most suitable crop establishment method and weed management practices for transplanted aman rice in Bangladesh. Rice variety Bangladesh Rice Research Institute (BRRI) dhan44 was used as planting materials where three crop establishment methods ($T_1$: direct wet seeding by drum seeder; $T_2$: hand broadcasting; $T_3$: transplanting) and four weeding options ($W_1$: Hand weeding (HW); $W_2$: BRRI weeder+HW; $W_3$: Herbicide+HW; and $W_4$: no weeding) were tested. Among the crop establishment methods, the highest grain yield ($5.12t\;ha^{-1}$) was obtained with the $T_3$, while the highest benefit cost ratio (BCR) of 2.08 was found in $T_2$. In case of the weed management method, $W_1$ showed superior results on the plant $density/m^2$ (139.66) at 60 days after transplanting (DAT), grain yield ($4.97t\;ha^{-1}$), and BCR (2.03). On the other hand, the highest plant dry matter (36.20 g) at 60 DAT and the highest yield ($6.10t\;ha^{-1}$) were obtained in a $T_3W_1$ combination. The results of this study show that the productivity of rice during aman season could be most significantly increased with the use of transplanting ($T_3$) alone, hand weeding ($W_1$) alone, or a combination of the two methods ($T_3W_1$).

• Journal of the Korean Statistical Society
• /
• v.33 no.4
• /
• pp.411-433
• /
• 2004

The shrinkage preliminary test ridge regression estimators (SPTRRE) based on Wald (W), Likelihood Ratio (LR) and Lagrangian Multiplier (LM) tests for estimating the regression parameters of the multiple linear regression model with multivariate Student's t error distribution are considered in this paper. The quadratic biases and risks of the proposed estimators are compared under both null and alternative hypotheses. It is observed that there is conflict among the three estimators with respect to their risks because of certain inequalities that exist among the test statistics. In the neighborhood of the restriction, the SPTRRE based on LM test has the smallest risk followed by the estimators based on LR and W tests. However, the SPTRRE based on W test performs the best followed by the LR and LM based estimators when the parameters move away from the subspace of the restrictions. Some tables for the maximum and minimum guaranteed efficiency of the proposed estimators have been given, which allow us to determine the optimum level of significance corresponding to the optimum estimator among proposed estimators. It is evident that in the choice of the smallest significance level to yield the best estimator the SPTRRE based on Wald test dominates the other two estimators.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2002.05a
• /
• pp.163-168
• /
• 2002

Through the developing measuring system of gas diffusivity, the experiments on carbon dioxide diffusivity in concrete carry out. From this, some important results was achieved. First, the times of reaching the steady state condition don't depend on the water/cement ratio with linearity. But, for the 0.42 w/c ratio the duration of the non-steady state condition is long. Second, in constant relative humidity, the diffusion coefficient shows linearity for the w/c ratio. Third, for the same w/c ratio, the influence of relative humidity on the diffusivity is very large. This shows the importance of the environmental condition for the carbonation. This study on $CO_2$ diffusivity in concrete is the first attempt within a country and will be important data.

• Journal of Advanced Marine Engineering and Technology
• /
• v.24 no.6
• /
• pp.24-33
• /
• 2000

This paper investigates the relationship between J-integral and crack tip opening displacement, ${\delta}_t$ using Gordens results of numerical analysis. Estimation were carried out for several strength levels such as ultimate, flow, yield, ultimate-flow, flow-yield stress to determine the influence of strain hardening and the ratio of crack length to width on the $J-{\delta}_t$ relationship. It was found that for SE(B) specimens, the $J-{\delta}_t$ relationship can be applied to relate J to ${\delta}_t$ as follows $J=m_j{\times}{\sigma}_i{\times}{\delta}_t$ where $m_j=1.27773+0.8307({\alpha}/W)$, ${\sigma}_i:{\sigma}_U$, ${\sigma}_{U-F}={\frac{1}{2}} ({\sigma}_U+{\sigma}_F$), ${\sigma}_F$, ${\sigma}_F}$ $Y=({\sigma}_F+{\sigma}_Y)$, ${\sigma}_Y$

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.6
• /
• pp.819-826
• /
• 2005

To guarantee the disinfection ability in clearwell, a value of CT is considered where C[mg/l] is disinfectant residual at the exit of clearwell and T[min] means $T_{10}$, the contact time when 10% of tracer is out of clearwell after introducing the tracer at the inlet. To meet a CT value required, increasing the C value is not recommended because high C value can increase potential of producing disinfection by product like THMs. Increasing the hydraulic efficiency surrogated by $T_{10}$ is thus an option widely recommended. Right now, it is widely adopted estimating $T_{10}$ considering LW ratio only due to the suggestions of previous researches. The authors think however there are other factors to consider including shape, flow rate, configuration of inlet and outlet, and the existence of intra basin. This study is initiated to closely look at the effects of two factor on hydraulic efficiency. The factors are shape and inlet flow velocity, i.e., inflow. For that, computational fluid dynamics (CFD) model is developed and pilot test is also carried out. The results show that at a L/W ratio, disinfection ability is overestimated with larger length in shape and higher inlet flow velocity. This suggests that in determining $T_{10}$, the shapes of clearwell and inlet flow velocity should also be considered as well as L/W ratio.