• Journal of the East Asian Society of Dietary Life
• /
• v.20 no.3
• /
• pp.452-457
• /
• 2010

To obtain basic information on the utilization of Suaeda (S.) asparagoides $M_{IQ}$ as a raw material in food, it's chemical components of were investigated. S. asparagoides $M_{IQ}$ from the Hwaseong-si in Korea was used after drying and grinding with powder. The total dietary fiber, insoluble dietary fiber and soluble dietary fiber contents of S. asparagoides $M_{IQ}$ were found to be 39.41%, 37.63% and 1.78%, respectively. Macromineral components of S. asparagoides $M_{IQ}$ were Na (7.6%), K (2.4%) and Mg (0.6%). High contents of microminerals such as Cu, Mn and Zn were also found. Lysine and methionine which are essential amino acids were detected with the value of 215 mg/100 g and 23.2 mg/100 g, respectively. S. asparagoides $M_{IQ}$ that was harvested in May was higher in crude protein than that harvested in September but the crude fat content of that which was harvested in September was twice as high as that harvested in May.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.4
• /
• pp.565-571
• /
• 2021

In this paper, a compensation scheme of frequency selective IQ mismatch for high-performance radar systems based on commercial RFIC's is proposed. Besides, an optimization model and its solution based on the dimension reduction scheme using singular value decomposition are also proposed to design the optimal IQ mismatch compensation digital filter with complex coefficients. The performance of the proposed method had been analyzed through experiments using the IQ mismatch measurement and compensation system implemented on an FPGA board with a target RFIC and compared with the previous method. The experiment result showed a performance improvement of the proposed method over the existing one without noticeable increments in complexities. These performance analysis results showed that the limitation of using commercial RFIC's in high-performance radar systems due to the undesirable maximum SNR cap caused by their IQ mismatches could be overcome by employing the proposed method.

• Applied Microscopy
• /
• v.47 no.1
• /
• pp.43-49
• /
• 2017

A new method was introduced to distinguish the ferrite, bainite and martensite in transformation induced plasticity (TRIP) steel by using electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM). EBSD is a very powerful microstructure analysis technique at the length scales ranging from tens of nanometers to millimeters. However, iron BCC phases such as ferrite, bainite and martensite cannot be easily distinguished by EBSD due to their similar surface morphology and crystallographic structure. Among the various EBSD-based methodology, image quality (IQ) values, which present the perfection of a crystal lattice, was used to distinguish the iron BCC phases. IQ values are very useful tools to discern the iron BCC phases because of their different density of crystal defect and lattice distortion. However, there are still remaining problems that make the separation of bainite and martensite difficult. For instance, these phases have very similar IQ values in many cases, especially in deformed region; therefore, even though the IQ value was used, it has been difficult to distinguish the bainite and martensite. For more precise separation of bainite and martensite, IQ threshold values were determined by a correlative TEM analysis. By determining the threshold values, iron BCC phases were successfully separated.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.38 no.2
• /
• pp.81-89
• /
• 2022

Purpose: Wireless endodontic handpieces (WEH) are widely used in dental clinics due to their convenience and portability. This study aimed to compare the vibration magnitudes and patterns generated by five WEH. Materials and Methods: Vibration acceleration of five WEH (X-Smart IQ, E connect S, Endo A Class, ENDOIT, and TRAUS ENDO) in the rotary and reciprocating motion was measured with accelerometer The average vibration acceleration was analyzed using the t-test, Welch's ANOVA test, and Dunnett T3 test at P < 0.05. Results: In all WEH, the average vibration acceleration in reciprocating motion was significantly higher than that in rotary motion (P < 0.001). In rotary motion, repeated vibration graphs of constant amplitude were obtained without sudden changes in the magnitude of vibration, and the average vibration acceleration value was high in the order of X Smart IQ, Endo A Class, ENDOIT, E Connect S, and TRAUS ENDO (P < 0.001), there was no statistically significant difference between X Smart IQ and Endo A Class. In reciprocating motion, a vibration graph was obtained in which large amplitude peaks appear at specific points within one cycle are repeated. The average vibration acceleration value was highest in the order of X Smart IQ, E Connect S, Endo A class, ENDOIT, and TRAUS ENDO (P < 0.001). Conclusion: Regardless of the type of WEH, greater vibration occurred in the reciprocating motion than in the rotary motion (P < 0.001). In the reciprocating motion, there was a difference in vibration for all handpieces (P < 0.001).

• The Korean Journal of Financial Management
• /
• v.25 no.2
• /
• pp.103-135
• /
• 2008

We test the hypothesis whether foreign direct investments(hereafter "FDI") can affect the changes of the firm value. In this study, we use a newly developed event study technique, referred to as value-based event study approach(hereafter "VESA"), which is based on the seminal papers of M&M(1958, 1961, 1963) and Lee(2006, 2007). The empirical findings about the effects of FDI's on the intrinsic firm values, which can be measured by intrinsic Q(hereafter "IQ") values of the VESA, are as follows; First, the FDI's are carried out by healthy firms in terms of high IQ's. The IQ values become higher during the post-FDI period than prior to performing FDI's. Second, among the four components of IQ values, the value of assets-in-place, the value of intangible assets, and the value of growth opportunities are all increased during the post-FDI period, except the value of current earnings. Third, the same results are observed in all the samples classified by industry. In sum, thanks to the above findings in this study, we can conclude that the announcements of the FDI's are good and reliable indicators for the firm to signal to the market that the FDI firms are healthy in intrinsic firm values, and also that they have good chances to increase their firm values through the new investments abroad.

• Journal of Korea Trade
• /
• v.27 no.1
• /
• pp.19-41
• /
• 2023

Purpose - Conventional supply chains (SCs) must identify facilitating roles, such as port or terminal operators, shipping companies, and freight forwarders in executing the various logistical activities that support the organizational strategies of shippers. Meanwhile, supply chain collaborative practices can engender a willingness to share relevant and mutually helpful information. To this end, this study seeks to identify the impact of supply chain integration (SCI) on information sharing (IS) and the operational performance (OP) of Korea's container-shipping industry from the perspective of social capital. Design/methodology - We established the research model for this study based on previous studies. In administering the survey, we obtained 149 valid responses from employees working in liner-shipping companies and freight forwarders in Korea. With the collected questionnaires, the study's hypotheses were tested using SPSS 26.0 and AMOS 26.0 Findings - The results indicate the existence of a mediated relationship where the impact of SCI on OP is mediated by IS. The effect of external integration (EI) on OP is fully mediated by information quality (IQ) and information-sharing content (ISC). Furthermore, EI, IQ and ISC partially mediate the relationship between internal integration (II) and OP. Originality/value - This study expands SCI contexts, where ISC and IQ respectively serve as bridges between EI and OP which has crucial implications for container-shipping companies in terms of improving their performance.

• The Journal of the Korea Contents Association
• /
• v.22 no.5
• /
• pp.367-382
• /
• 2022

This study examined the impact of smart factory's quality factors on the intention to accept Advance Smart Factory(ASF) by mediating Perceived Value(PV) and Smart Factor Performance(SFP) of domestic SMEs that had introduced smart factor. As a result, First, Information Quality(IQ) and Service Quality(SQ) had a significant positive impact on Perceived Value(PV). Second, System Quality(SysQ), IQ, and SQ had a significant positive impact on SFP. Third, PV had a significant positive impact on intention to ASF, and PV and SFP had a significant positive impact on the intention to accept ASP. Also, PV had a mediating effect between SysQ, IS and Perfromance, and PV and Performance had a moderation between SQ and ASF. These results could provide one implication to SMEs that are taking into account to improve their smart factor to be advanced.

• Journal of the Korean Society of Radiology
• /
• v.14 no.4
• /
• pp.353-360
• /
• 2020

This research aims at suggesting exposure condition that shows maintaining the value of the physical image quality factor by decreasing tube voltage and tube current from the standard exposure condition(80 kV, 7 mA) of a CBCT apparatus. To measure the value of the physical image quality factor, modular transfer function(MTF) was analyzed and dose-area product(DAP) was used for the measurement of exposure dose. CBCT images of a Sedentex IQ phantom were obtained under 15 exposure conditions of different combination of tube voltage(80, 78, 76 kV) and tube current(7, 6, 5, 4, 3 mA) and MTF 10 was calculated under each exposure conditions. There were no significant differences in MTF 10 under 80 kV-6 mA, 80 kV-5 mA exposure conditions in comparison with standard exposure condition. Based on the results of this research, 80 kV-5 mA condition are expected to be able to reduce exposure dose with maintaining the value of the physical image quality factor of the standard exposure condition.

• Journal of Distribution Science
• /
• v.20 no.8
• /
• pp.21-31
• /
• 2022

Purpose: This study aims to enrich the literature related on Patronage intention in the context of omnichannel in Tunisia. It reveals the determinants of Patronage intention in the fashion retailer context by examining the roles of omnichannel integration quality (IQ), omnichannel perceived value (PV), flexibility, operational logistics service quality (OLSQ) and customer satisfaction. Research design and methodology: A quantitative online survey with 400 customers of fashion retailers was executed. A structural equation modeling approach was applied to test the research hypotheses using AMOS 25 and SPSS 25 software. Results: The findings show that the omnichannel integration quality, omnichannel perceived value, and operational logistics service quality affect play crucial roles in customer satisfaction. A positive relationship between flexibility and operational logistics service quality was also highlighted. And it is also found that a higher omnichannel integration quality led to a higher omnichannel perceived value in the omnichannel retailing context. Furthermore, customer satisfaction within omnichannel retailing can enhance patronage intention. Conclusions: This research adds to the body of knowledge in omnichannel retailing and presents a comprehension of the omnichannel system from the customer's point of view. In addition, this study provides practical implications for omnichannel retailers to improve customer satisfaction and patronage intention.

• Journal of the Korean Academy of Child and Adolescent Psychiatry
• /
• v.27 no.4
• /
• pp.313-318
• /
• 2016

Objective: The purpose of this study was to investigate the clinical utility of the Korean Wechsler Intelligence Scale for Children-Fourth Edition (K-WISC-IV) and General Ability Index (GAI) in children with attention-deficit hyperactivity disorder (ADHD). Methods: The GAI and Full Scale IQ (FSIQ) in K-WISC-IV were compared for a group of 79 children with ADHD and 234 normal children. The mean differences within each group were testified by the t-test and Cohen's d. The Wechsler's descriptive classifications for each GAI and FSIQ score were analyzed in the children with ADHD. Additionally, the critical value for the difference between the means of the FSIQ and GAI was calculated in the normal children. Results: The score on the GAI was higher than that on the FSIQ in the children with ADHD, with a mean difference of 2.19 points. The implications of these findings are discussed regarding the cognitive characteristics of the children with ADHD. According to Wechsler's descriptive classification, the application of the GAI showed a lower (7.59%), equal (61.65%) or higher (60.76%) prevalence of ADHD compared to the application of FSIQ. Conclusion: The implications of these findings are discussed regarding the cognitive characteristics of the children with ADHD. The GAI reflecting the attention and behavioral problems in children with ADHD could be utilized as an alternative global intelligence estimate that considers their potential for development.