• International Journal of Highway Engineering
• /
• v.13 no.4
• /
• pp.143-150
• /
• 2011

Roundabouts, which belong to traffic circles, are intersections which are similar to the existing rotary form. Roundabouts recently have been constructed all around the world. And interests in roundabouts are increasing in Korea. However, there are lacks of research on pedestrian volume which has a great influence on operation efficiency of roundabouts in urban area. Therefore, this study suggests efficiency analysis and pedestrian signals in roundabouts according to the pedestrian volume. First, VISSIM simulation was organized to analyse volume of one lane roundabouts in urban area. Second, average delay of intersections was calibrated by VISSIM simulation dividing signalized intersections and non-signalized intersections depending on pedestrian volume. Finally, this study showed that roundabouts are suitable when pedestrian volume was under 200person/hr and traffic circles with a pelican signal are suitable when pedestrian volume was over 200person/hr. And when pedestrian volume and traffic volume are over 600person/hr and 1,500vph respectively, fixed signalized intersections fit well.

• Journal of Korean Society of Transportation
• /
• v.29 no.1
• /
• pp.113-123
• /
• 2011

The application of micro-simulation model has been extended farther with improvement of computer performance and development of complicated model. To make a micro-simulation model accurately replicate field traffic conditions, model calibration is very crucial. Studies on calibration of micro-simulation model have not been enough while lots of studies on calibration of macro-simulation model have been continued in our country. This paper presents an auto-calibration of parameter values in micro-simulation model(VISSIM) using genetic algorithm. RMSE(Root Mean Square Error) of collected volume on the urban expressway versus simulated volume is set as MOP(measure of performance) and objective function of optimization is set as to minimize the RMSE. Applying to urban expressway(Nae-bu circular) as a case study, it shows that RMSE of optimized parameter values decrease 60.4%($19.3{\longrightarrow}7.6$) compared to default parameter values and the proposed auto-calibration system is very effective.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.89-98
• /
• 2015

PURPOSES : This study evaluated the feasibility of implementing protected-permissive left-turn (PPLT) signals at three-leg signalized intersections. METHODS: A three-leg signalized intersection with permissive left-turn was first selected. A VISSIM simulation model was constructed using data collected from the test site. The VISSIM network was calibrated by adjusting related parameter values in order to minimize the difference between the simulated and surveyed critical gap. The calibrated network was validated by the number of waiting left-turning vehicles per cycle. Finally, the mobility and safety measures were extracted from simulation runs in which permissive, protected left turns as well as PPLTs were realized based on diverse traffic volume scenarios. RESULTS : The mobility-related measures of effectiveness (MOEs) of the case with PPLT outperformed the other two left-turn treatment scenarios. In particular, the average waiting time per cycle for the left-turn vehicles in the case with PPLT was reduced by 30 s. The safety-related MOEs of the case with PPLT were somewhat higher than those in the case with protected left-turns and much higher than those in the case with permissive left-turns. CONCLUSIONS : Based on the mobility- and safety-related MOEs generated from the VISSIM simulation runs, the use of PPLT seems to be feasible at three-leg signalized intersections where the left-turn is permissive and a pedestrian signal exists at the conflicting approach. However, in order to use the PPLT in earnest, it is necessary to revise the road traffic act, traffic signs, and related manuals.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.4
• /
• pp.87-94
• /
• 2013

This study estimated the changes in delays and speeds of vehicles in exclusive bus lane and road when the High Occupancy Vehicles(HOV) use the median bus lane. Synchro simulation tool was used to optimize the traffic signal time on the network and VISSIM was applied to simulate various scenarios. Here, drivers behavior parameters in VISSIM was optimized using Simultaneous Perturbation Stochastic Approximation(SPSA) algorithm in order to represent real traffic condition. Based on the simulation results, the delay in Doan daero was decreased when the volume of HOV in current condition runs on the median bus lane, whereas delay in Doan dongro was increased in all scenarios. The changes in bus speed was not sharply decreased for both study sites, even though the number of HOV increased to 10%. Thus, it could be allowed that the HOV use the median bus lane in Doan dongro and Doan daero. Future research tasks include studying about changes in delay when the HOV use the curb bus lane.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.4
• /
• pp.54-62
• /
• 2018

As a part of realization of artificial intelligence signal(AI Signal), this study proposed an actuated signal algorithm based on vehicle queue length that estimates in real time by deep learning. In order to implement the algorithm, we built an API(COM Interface) to control the micro traffic simulator Vissim in the tensorflow that implements the deep learning model. In Vissim, when the link travel time and the traffic volume collected by signal cycle are transferred to the tensorflow, the vehicle queue length is estimated by the deep learning model. The signal time is calculated based on the vehicle queue length, and the simulation is performed by adjusting the signaling inside Vissim. The algorithm developed in this study is analyzed that the vehicle delay is reduced by about 5% compared to the current TOD mode. It is applied to only one intersection in the network and its effect is limited. Future study is proposed to expand the space such as corridor control or network control using this algorithm.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.22 no.5
• /
• pp.30-42
• /
• 2023

Various studies have been conducted using microtraffic simulation (VISSIM) to analyze the safety of traffic flow when introducing autonomous vehicles. However, no studies have analyzed traffic safety in mixed traffic while considering the driving behavior of general vehicles as a parameter in VISSIM. Therefore, the aim of this study was to optimize the input variables of VISSIM for non-autonomous vehicles through genetic algorithms to obtain realistic behavior. A traffic safety analysis was then performed according to the penetration rate of autonomous vehicles. In a 640 meter section of US highway I-101, the number of conflicts was analyzed when the trailing vehicle was a non-autonomous vehicle. The total number of conflicts increased until the proportion of autonomous vehicles exceeded 20%, and the number of conflicts decreased continuously after exceeding 20%. The number of conflicts between non-autonomous vehicles and autonomous vehicles increased with proportions of autonomous vehicles of up to 60%. However, there was a limitation in that the driving behavior of autonomous vehicles was based on the results of the literature and did not represent actual driving behavior. Therefore, for a more accurate analysis, future studies should reflect the actual driving behavior of autonomous vehicles.

• International Journal of Highway Engineering
• /
• v.19 no.3
• /
• pp.45-55
• /
• 2017

PURPOSES: The objective of this study is to estimate required minimum spacing between Freeway IC for high-speed roadways. METHODS : Since high-speed roadways with over 140 km/h design speed do not exist in Korea, VISSIM Simulation Program was used for analysis. Acceleration noise and conflicts were selected for Evaluation Index. Standard deviation size for acceleration and deceleration was calculated by VISSIM to estimate acceleration noise. Conflicts were produced in areas between Freeway IC with SSAM. RESULTS : As a result, required minimum spacing was 6 km for acceleration noise analysis, while 5 km was deducted for conflict analysis. For Model Evaluation, with SAS, conflicts did not show much difference in 5~6 km area by 90% confidence interval. CONCLUSIONS : For acceleration noise, results showed lacking in its discrimination between index per Minimum Spacing. However, conflicts were valid in difference; required minimum spacing was 5 km by validation result.

• International Journal of Highway Engineering
• /
• v.15 no.2
• /
• pp.159-167
• /
• 2013

PURPOSES : In this study, the effects of when median exclusive bus lanes were applied to Daejeon trunk road (Wolpyeng crossway~Seodaejeon crossway, 6.3km) and (Daeduck Bridge 4~Kyeryong 4, 2.6km) by Microscopic Simulation VISSIM (5.0) was studied. The median exclusive bus lanes are one of the measures of transportation system manage techniques that can especially improve the efficiency of public transportation facilities. METHODS : According to the analysis of VISSIM on the Gyerong mainroad and Daedeok mainroad, when the median exclusive bus lanes were applied unlike when the roadside bus-only lanes were applied, the average travel speed of vehicles decreased but the average delay time and travel time increased. This arised from the changes in the geometric structure of the road which occurred the reduction of vehicle lane in the center of the road. RESULTS : In the case of bus, on the other hand, the average travel speed increased but the average delay time and travel time decreased. This is because the problems such as illegal parking and stopping, secondary road in out vehicle, and conflict of intersection right turn that roadside bus-only lanes occurred was solved. CONCLUSIONS : Although the introduction of median exclusive bus lanes will have a negative effect on general traffic flow due to the aggravation of travel, decrease of passenger car usage will lead to decrease of traffic volume. Therefore, smooth vehicle travel is expected.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.42 no.3
• /
• pp.409-415
• /
• 2022

The length of the acceleration lane in the area of entrance terminals is calculated based on 13 PS/ton horsepower of a cargo truck in Korea, so it is generally overestimated compared with the capacity of most vehicles traveling on an entrance ramp. Most drivers have, therefore, an indiscreet tendency to enter the main lane in all sections of an acceleration lane, which affects the traffic flow of the main lane. Because of this tendency, measures are required to minimize the impact on traffic flow of the main lane. The operating speed, rate of entrance, and traffic volume for each vehicle were investigated at the entrance terminals of the interchanges (ICs) of Yangji IC, Suseok IC, Yongin IC, and Osan IC, and the level of improvement in traffic flow was analyzed via VISSIM simulation. From the VISSIM simulation analysis, 74.0 % of the total vehicles traveled over the specified speed from the nose point where drivers would be able to recognize the traffic condition of the main carriageway, or the point at which there is a simplification of the curve section. In addition, 88.6 % of the vehicles entered the main carriageway up to 0.8 points compared with the entire length of the acceleration lane. It was subsequently found that an improvement of average speed in the main carriageway and at the entrance ramp can be achieved from 60.1 km/h to 68.5 km/h by intentionally limiting the entrance point onto the main carriageway up to 0.265 points of the entrance ramp.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.5
• /
• pp.23-35
• /
• 2011

The pedestrian green time is usually long at wide width intersections. This sometimes causes the increase of delay on the whole intersection because of long cycle length and thus small g/C ratio on some direction. In this paper, to improve these problems, staggered pedestrian crossing was evaluated on the vehicular and pedestrian aspects. The results were gained by using both TRANSYT-7F and VISSIM model. The vehicle control delay of the staggered pedestrian crossing was estimated to be decreasing than that of the general pedestrian crossing by 14.9% to 85.6%. The pedestrian average delay of two pedestrian crossing systems was examined by analytical method and VISSIM. According to the analytical method there was no significant difference between each pedestrian crossing system. The pedestrian delay of staggered pedestrian crossing was from 13.4% to 22.3% than the general pedestrian crossing by VISSIM. In conclusion, the staggered pedestrian crossing was more effective than general pedestrian crossing for both the vehicle and the pedestrian. However this conclusion was resulted from micro simulation where traffic volume condition, v/c, was from 0.8 to 1.1.