• Advances in concrete construction
• /
• 제14권5호
• /
• pp.317-330
• /
• 2022

This paper investigated computationally and experimentally the interaction here between a notch as well as a micropore under uniaxial compression. Brazilian tensile strength, uniaxial tensile strength, as well as biaxial tensile strength are used to calibrate PFC2d at first. Then, uniaxial compression test was conducted which they included internal notch and micro pore. Experimental and numerical building of 9 models including notch and micro pore were conducted. Model dimensions of models are 10 cm × 10 cm × 5 cm. Joint length was 2 cm. Joints angles were 30°, 45° and 60°. The position of micro pore for all joint angles was 2cm upper than top of the joint, 2 cm upper than middle of joint and 2 cm upper than the joint lower tip, discreetly. The numerical model's dimensions were 5.4 cm × 10.8 cm. The fractures were 2 cm in length and had angularities of 30, 45, and 60 degrees. The pore had a diameter of 1 cm and was located at the top of the notch, 2 cm above the top, 2 cm above the middle, and 2 cm above the bottom tip of the joint. The uniaxial compression strength of the model material was 10 MPa. The local damping ratio was 0.7. At 0.016 mm per second, it loaded. The results show that failure pattern affects uniaxial compressive strength whereas notch orientation and pore condition impact failure pattern. From the notch tips, a two-wing fracture spreads almost parallel to the usual load until it unites with the sample edge. Additionally, two wing fractures start at the hole. Both of these cracks join the sample edge and one of them joins the notch. The number of wing cracks increased as the joint angle rose. There aren't many AE effects in the early phases of loading, but they quickly build up until the applied stress reaches its maximum. Each stress decrease was also followed by several AE effects. By raising the joint angularities from 30° to 60°, uniaxial strength was reduced. The failure strengths in both the numerical simulation and the actual test are quite similar.

• 지역사회간호학회지
• /
• 제17권4호
• /
• pp.482-491
• /
• 2006

Purpose: Hemiplegia patients who were attacked by a stroke suffer from hemiplegic disabilities as well as motor disabilities. For them, rehabilitation cure is being carried out broadly. However, it is not enough for them to use the upper extremity than the lower extremity. For the use of the upper extremity, we examined the effect of constraint-induced movement therapy developed in this research on patients who experienced a stroke following hemiplegia. Method: For this study we selected 36 stroke patients who were registered at the community health center through accidental sampling, and assigned 21 of them to the experimental group, and 15 to the control group. The experimental group had constraint-induced movement therapy for 5 days and 7 hours a day from 9 to o'clock in the morning 9 to 4 o'clock in the afternoon 4 including warmup exercise and main exercise in the rehabilitation room, whereas the control group were restricted. Result: As a result of constraint-induced movement therapy, affected side elbow joint flexion range, side shoulder joint extension range and side shoulder joint of the flexion range of motions increased obviously in the experimental group compared to those in the control group. Conclusion: The result above clearly shows that constraint-induced movement therapy is an effective intervention for the rehabilitation of hemiplegia patients in increasing affected side elbow joint of the flexion range of motion, the shoulder joint extension, and the increase of flexion range of motion.

• 대한정형도수물리치료학회지
• /
• 제27권3호
• /
• pp.1-15
• /
• 2021

Objective: The purpose of this study was to examine the differences in joint position sense (JPS), force sense (FS), and performance level of the upper extremities according to the injury and pain experiences of Korean elite archers. Methods: A total of 15 subjects were briefed about the purpose of this study and agreed to participate voluntarily. JPS was evaluated using the laser-point attached to the wrist while aiming at the target. The difference when relocating while aiming was used as JPS factor. FS was evaluated using load cell through reproduces same muscle strength. Fear-Avoidance Beliefs Questionnaire (FABQ) was used to evaluate psychosocial factors, Kerlan-Jobe Orthopedic Clinic overhead athlete scores (KJOC) and numerical rating scale (NRS) was used to evaluate pain. and performance was evaluated by tournament match score. Results: There is a strong correlation between the current pain and KJOC. Moreover, moderate correlation between KJOC and FABQ also current pain and both upper trapezius and lower trapezius in elite archers. The mean (SD) between groups based on current pain display relatively large margin in force sense than without pain group. The result presents that there is a significant difference in performance and pain. There is a significant difference in the force sense of the upper and lower trapezius and pain. Conclusions: Result present there is a significant difference in functional level in the average comparison between groups according to the presence of absence of current pain. There is a significant difference in the force sense of the upper trapezius as well as lower trapezius and without pain group present a relatively low joint position sense error compared to the groups.

• Archives of Reconstructive Microsurgery
• /
• 제14권1호
• /
• pp.63-69
• /
• 2005

Purpose: The purpose of this study was to analyze the clinical results after Steindler flexoplasty. Materials and Methods: We analyzed 6 cases who had nearly normal finger and wrist joint flexion function, but could not flex elbow joint actively because of upper arm type brachial plexus injury. We performed operation during the period from February 1997 to July 2003. There were 5 males and 1 female with mean age of 28 years (range: $19{\sim}51$ years) when Steindler flexoplasty was done. The average follow-up period was 3 years 11 months (range: 12 months${\sim}$7 years 4 months). We assessed active range of motion of elbow joint, muscle power and elbow function by Mayer & Green grade scale at last follow-up. We assessed how much they were favorable for Steindler flexoplasty and had improvement of upper extremity function and correction of deformity. Results: Postoperative, flexion range of elbow joint improved to average $111.7^{\circ}$ (range: $90{\sim}130^{\circ}$). $25.8^{\circ}$ (range: $15{\sim}45^{\circ}$) in flexion contracture and $16.6^{\circ}$ (range: $10{\sim}35^{\circ}$) in pronation contracture were remained. Range of motion of elbow joint improved to average $85.3^{\circ}$ (range: $45{\sim}105^{\circ}$). Flexion power of elbow joint improved to Grade 5 in all cases. Postoperatively on Mayer & Green grade scale, there were excellent in 3 cases(50%), good in 2 cases(33.3%), fair in 1 case(16.7%). On patient's own assessment of functional improvement, there were excellent in 4 cases(66.6%), good in 1 case(16.7%) and fair in 1 case(l6.7%). Conclusion: Steindler flexoplasty can reserve good clinical results with being improved to active flexion of elbow joint in cases who have functional hand and wrist, but paralysis upper arm muscle in brachial plexus injury.

• 한방재활의학과학회지
• /
• 제26권1호
• /
• pp.63-77
• /
• 2016

Objectives The objective of this study is to interpretate Yangsaeng-Doinbub presented in [Jebyungwonhuron Huhrobyungjehu] in a modern kinesiologic approach. Methods Based on the interpretation of [Jebyungwonhuron Huhrobyungjehu] and implementation of its kinesiology, this study presents similar kinesiologies and their purposed, with the reference to various documents on modern kinesiology. Results 1) Exercises in Yangsaeng-Doinbub presented in [Jebyungwonhuron Huhrobyungjehu], which are similar to resistance exercise, can be used for isometric exercise of knee joint extensor and cervical extensor. 2) Exercises in Yangsaeng-Doinbub presented in [Jebyungwonhuron Huhrobyungjehu], which are similar to stretching exercise, has its purpose to stretch semitendinosus m., semimembranous m., gastrocnemius m., quadriceps femoris m., upper trapezius m., levator scapulae m., serratus m., and splenius capitis m. 3) Exercises in Yangsaeng-Doinbub presented in [Jebyungwonhuron Huhrobyungjehu], which are similar to active exercise, can be used for strengthen quadriceps femoris m.. 4) Yangsaeng-Doinibub also describes breathing methods, which help normalization of breathing exercised and increase the efficiency of spine and joint exercises. Conclusions The modern interpretation on kinesiology of Yangsaeng-Doinbub presented in [Jebyungwonhuron Huhrobyungjehu] leads to a conclusion that Yangsaeng-Doinbub consists of various exercises for knee joint, neck and upper extremity.

• 한국융합학회논문지
• /
• 제5권2호
• /
• pp.7-11
• /
• 2014

본 연구에서는 텅스텐합금강의 상부구조와 폴리에틸렌소재로 구성된 하부구조의 무릎 인공관절이 하중을 받았을 때에 인공관절의 하중분포와 인공관절의 설치를 위한 지지구멍에 가해지는 응력분포에를 유한요소해석에 의하여 연구하였으며, 이러한 결과들을 이용하여 실물에 대한 실험을 위한 기초자료를 얻을 수 있었다. 상부구조의 모서리 끝부분부터 하중이 집중되어 크랙이 발생되며 이는 의학계에 보고된 인공관절파손에 의한 조직괴사사례와 그 거동이 일치하였다.

• 대한금속재료학회지
• /
• 제47권4호
• /
• pp.261-266
• /
• 2009

The mechanical and electrical properties of ball grid array (BGA) solder joints were measured, consisting of Sn-3.5Ag, with organic solderability preservative (OSP)-finished Cu pads and Electroless Nickel/Immersion Gold (ENIG) surface finishes. The mechanical properties were measured by die shear test. When ENIG PCB was upper joint and OSP PCB was lower joint, the highest shear force showed at the third reflow. When OSP PCB was upper joint and ENIG PCB was lower joint, the highest shear force showed at the forth reflow. For both joints, after the die shear results reached the highest shear force, shear force decreased as a function of increasing reflow number. Electrical property of the solder joint decreased with the function of increasing reflow number. The scanning electron microscope results show that the IMC thickness at the bonding interface gets thicker while the number of reflow increases.

• Journal of Korean Neurosurgical Society
• /
• 제38권2호
• /
• pp.111-115
• /
• 2005

Objective : Upper lumbar disc herniation is rare disease, compared with lower. The lamina of this high level lumbar vertebra is narrower than that of low level, and this have taken surgeon into important consideration for surgical methods because partial removal of lamina for discectomy weakens the base of the articular process and may result in fracture. The authors an accurate preoperative diagnosis that enables the surgeon to operative approach for preserving the facet joint. Methods : Thirteen patients with upper lumbar disc herniation have underone surgical procedure by midline approach for removal of ruptured disc fragment and paraspinal approach for removal of residual disc materials simultaneously without instrumentation. All patients who underwent surgery were analyzed and long-term follow-up was conducted. Results : At a mean follow-up of 24months, there were complete resolution of presenting radiating leg pain in 85% of the patients, 7.5% were left with minimal residual discomfort, and 7.5% derived little or no benefit from surgery. The follow-up radiologic findings of all patients shows that lamina and facet joint have preserved safely and no instability. Conclusion : Simultaneously, paraspinal with midline approach provides highly satisfactory operating methods by simplifying exposure and greatly limiting the risk of complications. This provides the basis for a planned surgical approach in which destruction of the facet joint can be avoided.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 G
• /
• pp.2309-2311
• /
• 1998

The attitude control of a double inverted pendulum with a periodical disturbance at link top is dealt in this paper. The proposed system is consisted of the double inverted pendulum and a disturbance link. The lower link is hinged on the plate to free for rotation in the vertical plane. The upper link is connected to the lower link through a DC motor. The DC motor is used to control the posture of the pendulum by adjusting the position of the upper link. The periodical disturbance can be generated by the additional link attached at the end of link 2 through another DC motor, which is the modeling of a posture for a biped supporting with one leg. The motor for the joint simulates the knee joint(or hip joint) and the disturbance for the legs moving in air. The algorithm for controlling a proposed inverted pendulum is consisted of a state feedback control and a fuzzy logic controller. The fuzzy controller keeps the center of gravity of the biped within the specified range through the nonlinear feedback compensator. The state feedback control takes over the role to maintain a desired posture regardless the disturbance at the link top. In these case, the change of the angle and COG of an upper link is compensated with on-line. Simulations with a mathematical model are conducted to show the validity of the proposed controller.

• 근관절건강학회지
• /
• 제19권1호
• /
• pp.37-45
• /
• 2012

Purpose: This study was to compare pain, upper extremity function, and anxiety among disease characteristics in the breast cancer survivors and to clarify the relationship among these variables. Methods: One hundred twenty two participants with breast cancer survivors over the age of 30 were recruited from a general hospital. Data were collected from November 1 to December 25, 2006 using a structured questionnaire. Results: The mean age was 51.17 and their mean survival period was 38.08 months. The breast cancer survivors who had received radiation therapy reported lower levels of pain and upper extremity function, and higher levels of anxiety than those who had other treatments. Pain and anxiety were positively related, and upper extremity function was negatively related to pain and anxiety. Conclusion: The breast cancer survivors experienced pain, upper extremity function disorder and anxiety. This study indicates that nursing interventions for the breast cancer survivors may be needed to improve upper extremity function, and to reduce pain and anxiety.