• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.2
• /
• pp.156-165
• /
• 2014

This paper is the first investigation on the effect of flow control methods on the part load performance in a spark ignition engine. For comparison of the methods, two control devices, port throttling and masking, were applied to a conventional engine without any design change of the intake port. Steady flow evaluation shows that steady flow rates per unit opening area and swirl ratio are very low compared with the port throttling and saturated from mid-stage valve lift, however, swirl increases slightly as the lift is higher in case of 1/4 masking control. In the part load performance, the effect of simple port throttling on lean misfire limit expansion is limited and insufficient; on the other hand a masking improves the limit considerably without any port modification for increasing swirl. Also the results show that the intake flow control improves the combustion with following two mechanisms: stratification induced by the combination of the flow pattern and the fuel injection timing attribute to ignition ability and the intensified flow ensure fast burn. In addition fuel consumption reduces under the flow controls and the reduction rate is different according to the operation conditions and control methods. At the Stoichiometric and/or low speed and low load the throttling method is more advantageous; however vice versa at lean and high load condition. Finally, the throttling is more efficient for HC reduction than masking, on the other side the NOx emissions increase under the masking and decrease under the port throttling compared with conventional port scheme.

• Proceedings of the KIPE Conference
• /
• 2009.11a
• /
• pp.182-184
• /
• 2009

본 논문은 램프 점등을 위한 공진회로와 정상상태에서의 저주파수 구형파(low frequency square-wave) 인버터 전류 제어를 실현하는 HID 전자식 안정기에 풀브리지 인버터(FB)와 LC 필터를 제안한다. 점등은 LC필터의 공진주파수에서 풀브리지 인버터 제어에 의한 공진에 의해서 이루어지고, 점등 후에 회로는 풀브리지 제어에 의해 벅컨버터 저주파수 구형파 인버터로 동작한다. 점등이 일어나는 동안의 LC필터의 공진주파수는 ($f_o$=120kHz)이고, 고조파를 감소시키고 음향공명현상을 피하기 위한 벅컨버터스위칭 주파수($f_{sw}$=50kHz)를 선택하였다.

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.214-215
• /
• 2010

본 논문은 공진 인버터를 적용한 HID램프를 구동하기 위한 전자식 안정기를 설계하고 구현하였다. 제안된 전자식 안정기는 스위치 턴온 오프시의 손실을 줄이기 위해서 소프트 스위칭 기법인 ZVS(Zero-Voltage Switching)을 도입하였다. 점등은 LC필터의 공진주파수범위에서 풀브리지 인버터 제어에 의한 공진으로 이루어 진다. 점등후에 컨버터는 저주파수 구형파로 동작한다. 공진 기동시의 LC필터의 공진주파수는 ($f_o$=160kHz)이고, 고조파를 감소시키고 음향공진현상을 피하기 위한 벅컨버터 스위칭 주파수(고주파수 : 50~60kHz 와 저주파수 : 170Hz)를 선택하였다. 실험을 통해 공진 인버터를 적용한 HID램프용 전자식 안정기가 안정적으로 동작함을 확인하였다.

• Applied Science and Convergence Technology
• /
• v.27 no.2
• /
• pp.23-25
• /
• 2018

With respect to the electrode structure and the discharge characteristics, the atmospheric pressure plasma sheet of a thin polyimide film is introduced in this study; here, the flexible plasma device of a dielectric-barrier discharge with the ground electrode and the high-voltage electrode formulated on each surface of a polyimide film whose thickness is approximately $100{\mu}m$, that is operated with a sinusoidal voltage at a frequency of 25 kHz and a low voltage from 1 kV to 2 kV is used. The streamer discharge is appeared along the cross-sectional boundary line between two electrodes at the ignition stage, and the plasma is diffused on the dielectric-layer surface over the high-voltage electrode. In the development of a plasma sheet with thin dielectric films, the avoidance of the insulation breakdown and the reduction of the leakage current have a direct influence on the low-voltage operation.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.17 no.1
• /
• pp.89-96
• /
• 2013

Combustion pressures were measured to study combustion stability for an oxygen rich preburner by both of static and dynamic pressure sensors. The resolutions of each static and dynamic pressure sensor are the 1,000 Hz and 25,600 Hz, respectively. The nominal combustion pressure of the preburner was 200 bar but 80 bar was used at the several initial tests for the safety reason. Two stage ignition was applied to reduce the ignition impact for every tests including the tests with 200 bar combustion pressure. The tests lasted for 10 sec. max. and a little fluctuations of pressure was observed during the main mode. The measured pressures were studied by FFT analysis and no noticeable frequency coupling was found. Thus the preburner can be regarded as stable and it can be utilized for further study on staged combustion cycle liquid rocket engine.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.5
• /
• pp.449-456
• /
• 2010

The HCCI engine is a prospective internal combustion engine with which high diesel-like efficiencies and very low NOx and particulate emissions can be achieved. However, several technical issues must be resolved before HCCI engines can be used for different applications. One of the issues concerning the HCCI engine is that the operating range of this engine is limited by the rapid pressure rise caused by the release of excessive heat. This heat release is because of the self-accelerated combustion reaction occurring in the engine and the resulting engine knock in the high-load region. The purpose of this study is to evaluate the role of thermal stratification and fuel stratification in reducing the pressure rise rate in an HCCI engine. The concentrations of NOx and CO in the exhaust gas are also evaluated to confirm combustion completeness and NOx emission. The computation is carried out with the help of a multizone code, by using the information on the detailed chemical kinetics and the effect of thermal and fuel stratification on the onset of ignition and rate of combustion. The engine is fueled with dimethyl ether (DME), which allows heat release to occur in two stages, as opposed to methane, which allows for heat release in a single stage.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.15 no.1
• /
• pp.52-59
• /
• 2010

The conventional CCFL (Cold Cathode Fluorescent Lamp) inverter used in the backlight unit for LCD-TV, composed of the three power stage, can degrade the whole power conversion efficiency. In this paper, a novel scheme to drive the CCFL, composed only of the two power stage without using a dc/dc power stage, is proposed to enhance the whole power conversion efficiency. By adopting the proposed "4-in-1 Transformer", the current balance and the simultaneous ignition among the four CCFL lamp are assured with the one inverter circuit. The proposed scheme features the simple circuit structure, which can save the volume and the cost in the LCD backlight unit. Design considerations are discussed and design procedures are derived. Experimental results of the proposed scheme for 40" LCD-TV are presented to confirm the theoretical analysis.

• International Journal of Automotive Technology
• /
• v.8 no.4
• /
• pp.395-402
• /
• 2007

Homogeneous Charge Compression Ignition (HCCI) shows great potential for low $NO_x$ emission but is hampered by the problem of no direct method to control the combustion process. Therefore, HCCI combustion becomes unstable easily, especially at lower and higher engine load. This paper presents a method to achieve diesel-fueled HCCI combustion, which involves directly injecting diesel fuel into the cylinder before the piston arrives at top dead center in the exhaust stroke and adjusting the valve overlap duration to trap more high temperature residual gas in the cylinder. The combustion stability of diesel-fueled HCCI combustion and the effects of engine load, speed, and valve overlap on it are the main points of investigation. The results show that: diesel-fueled HCCI combustion has two-stage heat release rate (low temperature and high temperature heat release) and very low $NO_x$ emission, combustion stability of the HCCI engine is worse at lower load because of misfire and at higher load because of knock, the increase in engine speed aids combustion stability at lower load because the heat loss is reduced, and increasing negative valve overlap can increase in-cylinder temperature which aids combustion stability at lower load but harms it at higher load.

• Journal of ILASS-Korea
• /
• v.14 no.1
• /
• pp.8-14
• /
• 2009

This paper present the diesel fuel spray evolution and atomization performance in a multi-hole nozzle in terms of injection rate, spray evolutions, and mean diameter and velocity of droplets in a compression ignition engine. In order to study the effect of split injection on the diesel fuel spray and atomization characteristic in a multi-hole nozzle, the test nozzle that has two-row small orifice with 0.2 mm interval was used. The time based fuel injection rate characteristics was analyzed from the pressure variation generated in a measuring tube. The spray characteristics of a multi-hole nozzle were visualized and measured by spray visualization system and phase Doppler particle analyzer (PDPA) system. It was revealed that the total injected fuel quantities of split injection are smaller than those of single injection condition. In case of injection rate characteristics, the split injection is a little lower than single injection and the peak value of second injection rate is lower than single injection. The spray velocity of split injection is also lower because of short energizing duration and small injection mass. It can not observe the improvement of droplet atomization due to the split injection, however, it enhances the droplet distributions at the early stage of fuel injection.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.16 no.3
• /
• pp.260-264
• /
• 1983

Organic matters as COD, ignition loss, phaeophytin pigment, and sulfide in the superficial bottom mud in the shellfish farms during summer in 1981 were determined to find an eutrophication level for the conservation of the farms. Both the Goseong Bay and the Jaran Bay, which are productive shellfish farms, are located along the southern coast of the Korean Peninsula. The Goseong Bay is 8m deep with a narrow mouth and approximately $17.5km^2$ in area, and the Jaran Bay 10m deep with $27.3km^2$. The bottoms are silty. Major shellfishes cultured are the oyster by the off-bottom method and the arkshell in the bottom. COD contents were $12.5{\sim}19.5\;mg/g$ dry mud, ignition loss $6.70{\sim}11.83\%$, phaeophytin pigment $6.8{\sim}11.0{\mu}g/g$ dry mud, and sulfide $0.18{\sim}0.64{\mu}g/g$ dry mud. There were no significant differences in the determined quantities between two bays. All quantities except the sulfide which is a little over than an eutrophication level, 0.3 mg/g dry mud, shows that the bottom muds are in an early stage of eutrophication. In addition, there was no particular increase in quantities of aforementioned four paramenters in comparision with those of 1976. It means that the eutrophication in the Goseong-Jaran Bay makes slow progress.