• ETRI Journal
• /
• v.31 no.3
• /
• pp.342-344
• /
• 2009

From a hydrodynamic device simulation for the pseudomorphic high electron mobility transistors (pHEMTs), we observe an increase of maximum extrinsic transconductance and a decrease of source-drain capacitances. This gives rise to an enhancement of the switching speed and isolation characteristics as the upper-to-lower planar-doping ratios (UTLPDR) increase. On the basis of simulation results, we fabricate single-pole-double-throw transmitter/receiver monolithic microwave integrated circuit (MMIC) switches with the pHEMTs of two different UTLPDRs (4:1 and 1:2). The MMIC switch with a 4:1 UTLPDR shows about 2.9 dB higher isolation and approximately 2.5 times faster switching speed than those with a 1:2 UTLPDR.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.63 no.1
• /
• pp.29-33
• /
• 2014

This paper proposes an alternate time-switched space-frequency block coding transmission technique for single-carrier modulation with frequency domain equalization. There are two antennas in the transmitter but it still has only a baseband and RF and a switch that alternates between the antennas at every symbol timing. Alternating transmit symbols result in zeros which make maximal ratio receive combining possible in the receiver. Simulation results show that it has better performance than the traditional algorithm at the expense of one additional antenna.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.52 no.8
• /
• pp.452-461
• /
• 2003

The reliability and accuracy of the information on control rod position are very important to the reactor safety and the design of the core protection system. A survey on the RSPT(Reed Switch Position Transmitter) type control rod position indicator system and its actual implementation in the existing nuclear power plants in Korea was performed first. The control rod position indicator having the high performance for SMART was developed on the basis of RSPT technology identified through the survey. The arrangement of permanent magnet and reed switches is the most important procedure in the design of control rod position indicator. The hysteresis of reed switches is one of the important factors in a repeat accuracy of control rod position indicator as well. This paper investigates efficiency of the magnetic flux concentrator and the hysteresis using FEM and verified differences in physicals characteristics by comparing the results of FEM and those of the experiment. As a result, it is shown that the characteristics of prototype control rod position indicator have a good agreement with the results of FEM.

• Journal of Satellite, Information and Communications
• /
• v.7 no.1
• /
• pp.75-81
• /
• 2012

This study is to design the transmitter and receiver of short range UWB(Ultra Wide Band) imaging radar that is able to display high resolution radar image for front area of a UGV(Unmanned Ground Vehicle). This radar can help a UGV to navigate autonomously as it detects and avoids obstacles through foliage. The transmitter needs two transmitters to improve the azimuth resolution. Multi-channel receivers are required to synthesize radar image. Transmitter consists of high power amplifier, channel selection switch, and waveform generator. Receiver is composed of sixteen channel receivers, receiver channel converter, and frequency down converter, Before manufacturing it, the proposed architecture of transceiver is proved by modeling and simulation using several parameters. Then, it was manufactured by using industrial RF(Radio Frequency) components and all other measured parameters in the specification were satisfied as well.

• Journal of Biosystems Engineering
• /
• v.26 no.5
• /
• pp.481-486
• /
• 2001

To increase the production efficiency in dairy industry, proper artificial insemination is the most important operation. For the successful artificial insemination, accurate estrus detection is required. The Korean dairy farmers usually depended on visual observation for estrus detection of cows. Mounting behaviour is one of major inidications observed when cows are at an estrus. A mounting activity detection system for cows using radiotelemetry was developed. This system included a transmitter with a pressure switch, a receiver, a serial communication interface, a personal computer and a computer software. All components and a whole system were tested both in a laboratory and in a farm. The results of this study are as follows: 1. All components including transmitter, receiver and serial interface were operated according to the design specification. 2. A whole system tested with simulated mounting activity of 400 times showed 100% of success rate. 3. In the farm test for 4 days with three cows expecting estrus, one cows experiencing mounting activities showed correct response with this system. However two cows did not show mounting activities because of weak estrus and cold weather during the testing period.

• The Journal of the Acoustical Society of Korea
• /
• v.27 no.7
• /
• pp.342-349
• /
• 2008

Multipath makes clear message transfer difficult in the underwater communication. To solve this problem, we propose a new method producing proper MFSP (Modulation Frequency Shift Period) which could be obtained by calculating time delay caused by different path from a transmitter to a receiver. At the transmitter end, messages were divided according to the size of the MFSP and transmitted accordingly alternating Frequency. At the receiver end, the received messages were demodulated in order to recover the original message by the adaptive BISMO algorithm which is constructed at the algorithm design stage. Adaptive MFSP and estimated BER (Bit Error Rate) were calculated through simulation test.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.11
• /
• pp.1304-1310
• /
• 2010

This study is to design FMCW radar transceiver of K-band which is used to detect and track approaching high speed targets with low altitude. The transmitter needs high output power due to small RCS targets and wide beamwidth of transmit antenna. Multi-channel receivers are required to detect and track targets by interferometer method. Transmitter consists of high power amplifier, waveguide switch, and frequency up-converter. Receiver is composed of five channel receivers, up and down converters, X-band local oscillator and waveform generator. Before manufacturing it, the proposed architecture of transceiver is proved by modeling and simulation using several parameters. Then, it is manufactured by using industrial RF components. The performance parameters are measured through experiment. In the experiment, transmitting power and receiver gain were measured with 39.64 dBm and 29.1 dB, respectively. All other parameters in the specification were satisfied as well.

• Proceedings of the KSME Conference
• /
• 2008.11a
• /
• pp.593-596
• /
• 2008

The reed switch position transmitter (RSPT) is used as a position indicator for the control rod in commercial nuclear power plants made by ABB-CE. But this position indicator has some problems when directly adopting it to the integral reactor. The Control Element Drive Mechanism (CEDM) for the integral reactor is designed to raise and lower the control rod in steps of 2mm in order to satisfy the design features of the integral reactor which are the soluble boron free operation and the use of a nuclear heating for the reactor start-up. Therefore the resolution of the position indicator for the integral reactor should be achieved to sense the position of the control rod more precisely than that of the RSPT of the ABB-CE. This paper adopts seismic resistance reed switches to the position indicator in order to reduce the damages or impacts during the handling of the position indicator and earthquake.

• ETRI Journal
• /
• v.41 no.4
• /
• pp.536-548
• /
• 2019

In this study, an electronically steerable parasitic array radiator (ESPAR) antenna via analog radio frequency (RF) switches for a single RF chain MIMO system is presented. The proposed antenna elements are spaced at ${\lambda}/64$, and the antenna size is miniaturized via a dielectric radome. The optimum reactance load value is calculated via the beamforming load search algorithm. A switch simplifies the design and implementation of the reactance loads and does not require additional complex antenna matching circuits. The measured impedance bandwidth of the proposed ESPAR antenna is 1,500 MHz (1.75 GHz-3.25 GHz). The proposed antenna exhibits a beam pattern that is reconfigurable at 2.48 GHz due to changes in the reactance value, and the measured peak antenna gain is 4.8 dBi. The reception performance is measured by using a $4{\times}4$ BPSK signal. The measured average SNR is 17 dB when using the proposed ESPAR antenna as a transmitter, and the average SNR is 16.7 dB when using a four-conventional monopole antenna.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.65 no.4
• /
• pp.316-320
• /
• 2016

This paper proposes an alternate time-switched multiplexed space-frequency block coding technique for single-carrier modulation with frequency domain equalization. The traditional multiplexed space-frequency block coding technique for single-carrier modulation uses multiple groups of two transmitters and suppresses the interference signals of other SFBC groups at the receiver. In this paper, we reconfigure transmit signals to adapt them for alternate time-switched multiplexed SFBC for single-carrier modulation with frequency domain equalization and receiver structures and propose a structure for transmitter and receiver, show that its performance is better than the traditional algorithm by simulations.