• The Journal of the Petrological Society of Korea
• /
• v.10 no.3
• /
• pp.172-178
• /
• 2001

K-Ar dating system of Korea Basic Science Institute (KBSI) was installed in 1997 and has been used since then. The system consists of high temperature graphite furnace, gas purification system, and mass spectrometer with data acquisition system. K-Ar age is determined by the measurement of the concentrations of Ar and K through isotope dilution method using $^{38}Ar$ as spike and flame spectroscopy, respectively. The accuracy and reliability for the K-Ar age are checked using the several K-Ar standard materials. Although the exact age determination for young samples of less than 1 Ma is hampered by small fluctuations of sensitivity and mass discrimination, the present system yields the reliable K-Ar age compared to the standard materials of Tertiary and Mesozoic age. The measurements for the SORI93 biotite with the recommended K-Ar age of $92.6\pm$0.6 Ma and Bern4M muscovite of $18.5\pm$0.6 Ma yield the reliable age of $92.1\pm$1.1 Ma and $17.8\pm$0.2 Ma, respectively.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.7 no.3
• /
• pp.248-256
• /
• 1995

The numerical study on the surface buoyant jets has remained of requiring more intensive investigation for problems due to the treatments of free surface, Reynolds stress/flux terms in turbulent flow and especially buoyancy effects on the turbulent fluctuation. etc. The verification of predicted results from the numerical study continues in the qualitative study. because of the lack of experimental data, which seems to be due to the difficulties in measuring the turbulent fluctuations in concentration or temperature fields. In this study, the computer program of Algebraic Stress Model has been developed to investigate the behaviours of two-dimensional surface buoyant jets with free surface boundary condition. The computational results are compared with published experimental data. By comparing these results with experimental data. it is found that this model can predict fairly well the flow characteristics of two-dimensional surface buoyant jets in the momentum-dominant region and buovancy-dominant region. Especially, it is proved that this model can predict the flow characteristics reasonably in buoyancy-dominant region stably stratified due to buoyancy effect.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.43 no.8
• /
• pp.677-683
• /
• 2015

Hybrid rocket combustion displays low frequency instability(LFI, 10~30Hz) at a certain condition. Vortex shedding in the post-chamber is suspected to cause the occurrence of LFI. This study focused on the visualization of flow image using light emissions from high temperature combustion gas. Results shows that combustion pressure oscillates at a frequency of about 18 Hz, which is in phase with oscillations of light emission. Since LFI is not a property of thermo-acoustic instability, this result suggested there exists a physical coupling of pressure fluctuations with light emissions proportional to chemical reaction. Also POD analysis shows that dominant symmetric spatial modes in the stable combustion shift suddenly into asymmetric spatial pattern with the appearance of LFI. Especially, the appearance of mode 3 is a typical change of flow dynamics in unstable combustion representing a rotational fluid motions associated with vortex shedding.

• Journal of The Korean Astronomical Society
• /
• v.37 no.4
• /
• pp.281-284
• /
• 2004

Optical imaging and spectroscopy of G353.2+0.9, the brightest part of the giant H II region NGC 6357, shows that this H II region is optically thin, contains ${\~}300\;M_{\bigodot}$ of ionized gas and is probably expanding into the surrounding medium. Its chemical composition is similar to that found in other H II regions at similar galactocentric distances if temperature fluctuations are significant. The inner regions are probably made of thin shells and filaments, whereas extended slabs of material, maybe shells seen edge-on, are found in the periphery. The radio continuum and H$\alpha$ emission maps are very similar, indicating that most of the optical nebula is not embedded in the denser regions traced by molecular gas and the presence of IR sources. About $10^{50}$ UV photons per second are required to produce the H$\beta$ flux from the 1l.3'${\times}$10' region surrounding the Pis 24 cluster that is south of G353.2+0.9. Most of the energy powering this region is produced by the 03-7 stars in Pis 24. Most of the 2MASS sources in the field with large infrared excesses are within G353.2+0.9, indicating that the most recent star forming process occured within it. The formation of Pis 24 preceded and caused the formation of this new generation of stars and may be responsible for the present-day morphology of the entire NGC 6357 region.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.10 no.2
• /
• pp.71-81
• /
• 2007

One of the most important hydrologic components is evapotranspiration. It is a process by which water is evaporated from moist land surfaces and transpired into atmosphere by plants. There are many methods of estimating evapotranspiration rate and its potential such as the methods of soil-moisture sampling, lysimeter measurements, water balance, energy balance, groundwater fluctuations and evapotranspiration. But it is very difficult to estimate evapotranspiration in terms of regional discrete characteristics of topography and/or vegetation. The evapotranspiration is strongly affected by ground covering vegetation, and the degree of vegetation growth. In order to grasp vegetation condition over a vast study area, NDVI (Normalized Difference Vegetation Indices) calculated from the data obtained from NOAA/AVHRR were utilized. Through multi-regression analysis, we developed a model equation to estimate the evapotranspiration using NDVIs and temperature data.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.10 no.4
• /
• pp.167-176
• /
• 2008

Airborne pollen is known as one of the major causal agents to respiratory allergic reactions. Daily number of pollen grains was monitored using Burkard volumetric spore traps at seven locations including Seoul and Jeju during 1997-2007. Pollen grains were observed throughout the year especially from February to November. They showed similar distribution patterns of species among locations except in Jeju, where Japanese cedar vegetation is uniquely found. Peak seasons for pollen grains from trees and weeds were March to May and August to October, respectively. Tree pollens were mainly composed of pine, oak, alder, and birch. Weed pollens were mainly from Japanese hop, Worm wood, and ragweed. Diameter of pollen grains, which has a typical range of $20{\sim}60{\mu}m$, has close relationship with allergenicity. Allergenicity of tree and weed pollens is higher than that of grass pollens in general. In the case of trees and shrubs, pine trees account for about 70% of all tree pollens. However, pine pollens are weak allergens. The remaining 30% of tree pollens, including alder trees, white birches, and oaks, are moderate to strong allergens despite the smaller numbers. Grass and weeds are also highly likely to cause allergies. Especially, the pollens of Wormwood and Japanese hop are highly likely to cause allergies. Daily fluctuations in the number of pollens have to do with a variety of meteorological factors, such as temperature and rainfall.

• Journal of the Korea Convergence Society
• /
• v.12 no.2
• /
• pp.185-191
• /
• 2021

The characteristics of the foundry sand were analyzed for water jacket core required to prevent structural deformation from the heat generated in the cylinder bore during the casting of the cylinder block of an automobile. The sand core tensile strength tester, AFS-GFN, and optical microscope were used to evaluate the its properties. If the SiO2 content is high in the foundry sand, the dimensional defects and veining defects occur due to high temperature expansion. Also, if it is too low, the core breakage, porosities, chemical burn-on defects occur. The particle size index and grain shape influenced the core strength and resin consumption, resulting in fluctuations in defect types. The higher the alkalinity of the dried sand, the lower the core strength. And the more basic, the lower the core strength. At the resin content of 1.6~1.8%, the increase in core strength after 1 hour curing was approximately at its maximum.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.4
• /
• pp.625-632
• /
• 2022

Gas turbine generators in load-following operation in the domestic power system play a major role in maintaining the rated frequency, but often have poor frequency control. Therefore, after examining the control characteristics of the governor, which is a gas turbine speed control device, and analyzing the failure types, countermeasures were suggested for each case. In addition, it was confirmed through the governor response test that the gas turbine helps in frequency recovery depending on the speed of fuel control, but also acts as a factor impeding stable operation, such as rapid fluctuations in combustion chamber temperature and combustion vibration. Therefore, in order to maintain stable power quality, there was a need for thorough facility management as well as research on the governor control method in which the traditional PID control method and the machine learning algorithm, a core field of the 4th industry, were fused.

• Ocean and Polar Research
• /
• v.45 no.2
• /
• pp.43-55
• /
• 2023

This study was conducted to understand the seasonal patterns and variation of the copepod community in the Anma Islands of Yeonggwang, Yellow Sea, with a focus on seasonal surveys to assess the factors affecting their occurrence. Throughout the survey period, Acartia hongi, Paracalanus parvus s. l., and Ditrichocorycaeus affinis were dominant species, while Acartia ohtsukai, Acartia pacifica, Bestiolina coreana, Centropages abdominalis, Labidocera rotunda, Paracalanus sp., Tortanus derjugini, Tortanus forcipatus occurred differently by season and station. As a results of cluster analysis, the copepod communities were distinguished into three distinct groups: spring-winter, summer, and autumn. The results of this study showed that the occurrence patterns of copepod species can vary depending on environmental conditions (topographic, distance from the inshore, etc.), and their spatial occurrence patterns between seasons were controlled by water temperature and prey conditions. One of the physical mechanisms that can affect the distribution of zooplankton in the Yellow Sea is the behavior of the Yellow Sea Bottom Cold Water (YSBCW), which shows remarkable seasonal fluctuations. More detailed further studies are needed for clear grounds for mainly why to many Calanus sinicus in the central region of the Yellow Sea are seasonally moving to the inshore, what strategies to seasonally maintain the population, and support the possibilities of complex factors.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2022.10a
• /
• pp.13-13
• /
• 2022

Recently, stable crop production is threatened by the effects of climate change. In particular, it is difficult to consistently maintain agricultural policies due to large price fluctuations depending on the difference in total domestic rice production from year to year. For stable rice production amid changes in the crop growing environment, development of varieties with improved disease resistance and abiotic stress stability is becoming more important. In here, drought and cold tolerant trait have been studied. First, for the development of drought tolerant varieties, we analyzed which agricultural traits are mainly affected by domestic drought conditions. As a result, it was observed that drought caused by the lack of water during transplanting season inhibits the development of the number of tiller and reduces the yield. 'Samgang' was selected as a useful genetic resource with strong drought tolerant and stable tiller number development even under drought conditions by phenotype screening. Three of drought tolerant QTLs were identified using doubled haploid (DH) population derived from a cross between Nacdong and Samgang, a drought sensitive and a tolerant, respectively. Among these QTLs, when qVDT2 and qVDTl1 were integrated, it was investigated that the tiller number development was relatively stable in the rainfed paddy field conditions. It is known that the high-yielding Tongil-type cultivars are severely affected by cold stress throughout the entire growth stage. In this study, we established conditions that can test the cold tolerance phenotype with alternate temperature to treat low temperatures in indoor growth conditions similar to those in field conditions at seedling stage. Three cold tolerant QTLs were explored using population derived from a cross between Hanareum2 (cold sensitive variety, Tongil-type) and Unkwang (cold tolerant variety, Japonica). Among these QTLs, qSCT12 showed strong cold tolerant phenotype, and when all of three QTLs were integrated, it was investigated that cold tolerant score was relatively similar to its donor parent, Unkwang, in our experimental conditions. We are performing that development of new variety with improved cold tolerant through the introduction of these QTLs.