• Progress in Superconductivity
• /
• v.2 no.1
• /
• pp.11-14
• /
• 2000

The notion of the finite pairing interaction energy range Td is shown to result in a linear temperature dependence of the London magnetic penetration depth length, ${\Delta}{\lambda}{/\lambda}(0)=(T/Td)2/\pi)ln2$ at low T in the case of the s-wave pairing state, accounting for data of high Tc superconductor by Hardy et al.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.11a
• /
• pp.796-799
• /
• 2002

BSCCO thin films are fabricated via a co-deposition process at an ultra-low growth rate using ion beam sputtering. The sticking coefficient of Bi element exhibits a characteristic temperature dependence. This temperature dependence of the sticking coefficient was explained consistently on the basis of the evaporation and sublimation processes of Bi$_2$O$_3$.

• Transactions on Electrical and Electronic Materials
• /
• v.17 no.6
• /
• pp.329-334
• /
• 2016

In this work, the temperature dependence of electrical parameters of nanoscale SOI (silicon-on-insulator) TG (triple gate) n-FinFET (n-channel Fin field effect transistor) was investigated. Numerical device simulator $ATLAS^{TM}$ was used to construct, examine, and simulate the structure in three dimensions with different models. The drain current, transconductance, threshold voltage, subthreshold swing, leakage current, drain induced barrier lowering, and on/off current ratio were studied in various biasing configurations. The temperature dependence of the main electrical parameters of a SOI TG n-FinFET was analyzed and discussed. Increased temperature led to degraded performance of some basic parameters such as subthreshold swing, transconductance, on-current, and leakage current. These results might be useful for further development of devises to strongly down-scale the manufacturing process.

• Korean Journal of Materials Research
• /
• v.15 no.12
• /
• pp.786-790
• /
• 2005

We investigated the particularity of temperature and composition changes in $xNa_2O{\cdot}(52.5-x)B_2O_3{\cdot}47.5SiO_2$ glasses by use of FT-IR, $^{11}B$ NMR, Raman spectrometer. From FT-IR and $^{11}B$ NMR spectrometer, we thought that tetrahedral boron, $BO_4$ units are created $N_4$ increasing tendency generated near $600^{\circ}C$. It's expected that composition ana heat treatment directly contributed to structural changes, this changes are following to $Na_2O$ increasing or decreasing. caused by $N_4\;and\;BO_4$ units are caused by relatively increasing or decreasing in the glasses' structure. Particularly, $BO_4$ units are converted to $BO_3$ units after $600^{\circ}C$ heat treatment for 50h in the composition of $x<18(R<0.5,\;R=Na_2O/B_2O_3\;mol\%)$. On the order hand, $BO_3$ units are converted to, $BO_4$ units after $600^{\circ}C$ heat treatment for 50h in the composition of $x{\geq}18\;(R>0.5)$. This particularity of composition and temperature dependence of structural changes are similarly represented by Raman analysis results.

• Electrical & Electronic Materials
• /
• v.10 no.2
• /
• pp.105-112
• /
• 1997

Undoped and Co$^{2+}$-doped Zn$_{4}$GeSe$_{6}$ single crystals were grown by the Chemical Transport Reaction method using iodine as a transporting agent. The crystal structure of these compounds determined by X-ray diffraction analysis was monoclinic structure. The direct energy gaps of these compounds were measured and the temperature dependence of the optical energy gap were closely investigated over the temperature range 10-290K. The temperature dependence of the optical energy gap is well presented by the Varshni equation. Also the optical absorption peaks of Zn$_{4}$GeSe$_{6}$ :Co$^{2+}$ single crystal observed, centered at 5437, 6079, 7142, 12950, 13462, 14786 and 15735 $cm^{-1}$ /, can be explained in terms of the electronic transitions of Co$^{2+}$ ions located at Td symmetry of the host materials. According to the crystal-field theory, the crystal-field, Racah and spin-orbit coupling parameters obtained from the absorption bands are given by Dq = 361$cm^{-1}$ /, B = 655$cm^{-1}$ / and .lambda. = 284$cm^{-1}$ / respectively.ively.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.52 no.2
• /
• pp.68-73
• /
• 2003

$Zn_4SnSe_6$ and $Zn_4SnSe_6:Co^{2+}$ single crystals were grown by the chemical transport reaction(CTR) method. They were crystallized in the monoclinic structure. These temperature dependence of the optical energy gap were closely investigated over the temperature range 10[K]~300[K]. The direct energy gaps of $Zn_4SnSe_6$ and $Zn_4SnSe_6$:$Co^{2+}$ single crystals were given by 2.146[eV] and 2.042[eV] at 300[K]. The temperature dependence of the optical energy gap is well presented by the Varshni equation.

• Current Photovoltaic Research
• /
• v.2 no.3
• /
• pp.135-139
• /
• 2014

Different power output of solar cells can be observed at high-temperature regions such as desert areas. In this study, performance dependence on operating temperature of crystalline silicon solar cells with different emitter types was analyzed. Based on the light current-voltage (LIV) measurement, temperature coefficients of short-circuit current density ($J_{SC}$), open-circuit voltage ($V_{OC}$), fill factor (FF) and power conversion efficiency were measured and compared for two groups of crystalline silicon solar cells with different emitter types. One group had homogeneously doped (conventional) emitter and another selectively doped (selective) emitter. Varying the operating temperature from 25 to 40, 60, and $80^{\circ}C$, LIV characteristics of the cells were measured and the properties of saturation current densities ($J_0$) were extracted from dark current-voltage (DIV) curve. From the DIV data, effect of temperature on the performance of the solar cells with different electrical structures for the emitter was analyzed. Increasing the temperature, both emitter structures showed a slight increase in $J_{SC}$ and a rapid degradation of $V_{OC}$. FF and power conversion efficiency also decreased with the increasing temperature. The degrees of $J_{SC}$ increase and $V_{OC}$ degradation for two groups were compared and explained. Also, FF change was explained by series and shunt resistances from the LIV data. It was concluded that the degradation of solar cells shows different values at different temperatures depending on the emitter type of solar cells.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.1
• /
• pp.9-14
• /
• 2004

In this paper, temperature dependence of effective ionization coefficient in Si is formulated as a single polynomial function of temperature, which allows analytical expressions for breakdown voltage of Si $p^+n$ junction as a function of temperature. The analytical breakdown voltages agree well with the simulation as well as the experimental ones reported within $3\%$ in error for the doping concentrations in the range of $10^{14}cm^{-3}{\~} 10^{17}cm^{-3}$ at 100K, 300K and 500K.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.30 no.7 s.250
• /
• pp.809-815
• /
• 2006

The temperature and loading-rate dependence on the mechanical behavior of single-walled carbon nanotubes under axial compression and torsion is examined with classical molecular dynamics simulation. The critical buckling is found to depend on the temperature and loading-rate. The yielding under torsion is also found to depend on the temperature and loading-rate. But it is shown that the compression and torsional stiffness are independent of the varied temperatures and loading-rates.

• Journal of the Optical Society of Korea
• /
• v.15 no.3
• /
• pp.237-243
• /
• 2011

Thermal characteristics, such as diffusivity and temperature induced change in the fiber mode index of rotation sensing fiber coil are critical factors which determine the time varying, thermo-optically induced bias drift of interferometric fiber-optic gyroscopes (IFOGs). In this study, temperature dependence of the transient effect is analyzed in terms of the thermal characteristics of the fiber coil at three different temperatures. By applying an analytic model to the measured bias in the experiments, comprehensive thermal factors of the fiber coil could be extracted effectively. The validity of the model was confirmed by the fact that the extracted values are reasonable results in comparison with well known properties of the materials of the fiber coil. Temperature induced changes in the critical factors were confirmed to be essential in compensating the transient effect over a wide temperature range.