• The Plant Pathology Journal
• /
• v.15 no.2
• /
• pp.119-123
• /
• 1999

Chrysanthemums showing leaf mottling were collected from three southern locations in Korea in 1998. Two kinds of viruses were isolated from the leaves and were identified as tomato aspermy virus ch-TAV) and chrysanthemum virus B (ch-CVB), according to their host range, morphology, intracellular location, agar gel double diffusion test, and double-stranded RNA (dsRNA) analysis. The purified ch-TAV was spherical particles of approximately 29 nm in diameter and ch-CVB was filamentous particles of 685 nm long. Inclusion bodies were not observed in ch-TAV and/or ch-CVB infected chrysanthemum. ch-TAV showed positive serological reaction with TAV antiserum (ATCC-127) but not with CMV-pepper antiserum. In dsRNA analysis, four kinds of viral dsRNA were observed on ch-TAV and one viral dsRNA was shown on ch-CVB. Rate of co-infection with TAV and CVB in commercial chrysanthemums was 20.9%. On the other hand, infection with CVB alone was 97.2%. However, chrysanthemums naturally infected with TAV alone were not found.

• Korean Journal Plant Pathology
• /
• v.2 no.3
• /
• pp.145-149
• /
• 1986

A tomato Aspermy Virus (TAV-B) served as a helper virus for multiplication and encapsidation of satellite RNAs which were isolated from two different CMV isolates, D and K. These two satellite RNAs induced renarkable attenuation of TAV symptoms in infected tobacco, which was correlated with a reduction of virus content in the plant. The CMV satellite RNAs also caused lethal necrosis in TAV-infected tomato as in the case of CMV system.

• Research in Plant Disease
• /
• v.28 no.4
• /
• pp.237-244
• /
• 2022

Chrysanthemum plants are one of the most economically important plants in South Korea. Both virus and viroid can cause diseases and economic damage to the plants. In this study, we investigated the detection of seven viruses and two viroids in 350 chrysanthemum plants cultivated in Yesan-gun, Chungcheongnam-do. Two viruses, chrysanthemum virus B (CVB) and tomato aspermy virus (TAV), and two viroids, chrysanthemum chlorotic mottle viroid (CChMVd) and chrysanthemum stunt viroid (CSVd), were detected in this study. The two viruses were detected in six samples and one sample, respectively. The two viroids were detected in 97 samples and 21 samples, respectively. The nucleotide sequences of the CVB-CN-Y, TAV-CN-Y, CChMVd-CN-Y, and CSVd-CN-Y obtained in this study showed 83.7-86.9%, 99.2-100.0%, 94.4-99.5%, and 95.7-99.7% identity, respectively, compared to their other strains/isolates. The CVB-CN-Y and TAV-CN-Y showed the greatest nucleotide sequence homology to CVB-GS1 and three TAV isolates (TAV-V, TAV-P, and TAV-ChJ), respectively. The CChMVd-CN-Y and CSVd-CN-Y showed the greatest nucleotide sequence homology to CChMVd-Horst and four CSVd isolates (Au1.1, K4pop, Sagae, and Tochigi), respectively. This study is the report on the infection rate of viruses and viroids in chrysanthemum plants cultivated in Yesan-gun in 2021.

• Journal of the Korean Society of Visualization
• /
• v.21 no.1
• /
• pp.12-17
• /
• 2023

Aortic valve stenosis is a heart valve disease caused by the accumulation of calcium in the valve, which can divide into tricuspid aortic valve (TAV) stenosis and bicuspid aortic valve (BAV) stenosis depending on the shape of natural valve. In this study, pig heart-based TAV and BAV ex vivo models were fabricated, and the flow characteristics behind a valve were analyzed using 4D flow MRI. Flow behind normal TAV was uniformly distributed, while BAV asymmetrically opened with an eccentric strong jet. Especially, BAV ex vivo model exhibited a secondary flow in the region where the valve closed. In addition, BAV had a 26% higher peak velocity while maintaining similar stroke volume compared with normal TAV. This study would be helpful for understanding the flow characteristics for BAV AS patients.

• Corrosion Science and Technology
• /
• v.9 no.1
• /
• pp.12-15
• /
• 2010

Ti-13Nb-13Zr (TNZ) alloy has attracted considerable research attention in the last decade as a suitable substitute for the commercially used Ti-6Al-4V (TAV) alloy for orthopedic and dental implant applications. Hence, in the present work, a comparative evaluation has been performed on the electrochemical corrosion behavior of TNZ and TAV alloys in 0.9 wt.% NaCl solution. The result of the study showed that both the alloys had similar electrochemical behavior. The corrosion resistance of TAV alloy is found to be marginally superior to that of TNZ alloy.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.27 no.12
• /
• pp.1359-1367
• /
• 2003

본 연구에서는 실제 의복 관리와 생산 면에서 접할 수 있는 모 직물의 접착심과의 접착 후, 프레싱 처리 후, 드라이클리닝 및 프레스로 처리 후 직물의 형태안정성과 의복형성능의 변화를 살펴보았다. 겉감으로는 신사복 춘하용 모 100% 또는 모 혼방 직물 15종류를 사용하였으며 심지로는 신사복에 많이 쓰이는 3종류 심지를 사용하였다. FAST시스템과 KES시스템을 이용하여 직물의 접착 후, 프레싱 처리 후, 드라이크리닝과 프레싱 처리 후의 형태안정성과 의복형성능의 변화를 시험하였으며 다음과 같은 결과를 얻었다. 1) 모직물의 형태안정성에서 주요인자인 습윤팽창(HE)은 접착으로 크게 감소하였고 프레싱 처리와 드라이크리닝과 프레싱 처리 후는 접착 후보다 큰 변화를 보이지 않는다. 모직물의 습윤팽창(HE)의 조절시 접착심이 습윤팽창(HE)의 안정성에서 중요한 역할을 하는 것으로 나타났다. 2) 완화수축(RS)은 접착 후 조금 감소하였으나 큰 변화를 보이지 않고 프레싱 처리 후 현저한 감소를 보인다. 드라이크리닝과 프레싱 처리 후는 직물이 수축하고 볼륨감이 생김으로 완화수축(RS)은 더욱 감소하였다. 모직물의 완화수축(RS)의 조절시 프레싱이 중요한 역할을 하는 것으로 나타났다. 3) 모직물의 의복형성능(TAV)은 접착으로 크게 향상되었다. 드라이크리닝과 프레싱 처리 후 직물이 좀더 부드러워지고 볼륨감이 생기면서 의복형성능(TAV)은 적게 향상됨을 보인다. 이와 같이 3가지 처리는 서로 보완되어 모직물의 형태안정성과 의복형성능을 향상시키는 것으로 나타났다.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.20 no.6
• /
• pp.1138-1150
• /
• 1996

This study was carried out to investigate the effects of dyeing on the mechanical properties, primary hand, total hand value (THV), and total appearance value (TAV) of woven fabrics. Cotton, PET, nylon, cotton/PET, and cotton/nylon woven fabrics were used as test specimens. Each of fabric was dyed under the same conditions as the fabrics for sportswear which consumers have selected as best. Mechanical properties of specimens were measured by KES-FB system and primary hand and THV were calculated by equation KN -201-MDY and KN-301-WINTER respectively. TAV was calculated by KN (eq. 10). The results were as follows: 1. In mechanical properties. tensile energy increased when cotton and two cotton mixture fabrics were dyed and decreased when polyester and nylon fabrics were dyed. Bending rigidity and shear rigidity decreased after all fabrics were dyed except nylon and cotton/ nylon mixture fabrics showing higher rigidities. Cotton fabrics showed higher surface roughness while other fabrics did lower values after dyeing. 2. In evaluation of primary hand and total hand , four primary hands of cotton fabrics so decreased after dyeing that THV were lowered. Numeri, Fukurami, and Sofutosa in primary hand of polyester, cotton/polyester, and cotton/nylon fabrics and Koshi and Numeri of nylon fabrics increased after dyeing and therefore THV of four fabrics were improved. 3. Cotton and polyester fabrics showed higher TAV due to their lower bending and shear rigidity, while nylon and cotton/nylon fabrics did lower values due to their higher shear rigidity. 4. It was proposed that the method of dyeing or treatment for minimizing the decrease of THV of cotton fabrics and TAV of nylon fabrics should be developed.

• Fashion & Textile Research Journal
• /
• v.19 no.3
• /
• pp.344-352
• /
• 2017

This study investigated the formability and appearance performance of 20 women's worsted fabrics. For this purpose, 10 foreign fabrics (9 Italian + 1 Japan fabrics) were prepared and 10 domestic worsted fabrics for women were made in Cheil woolen textile company for comparing with foreign fabrics. The mechanical properties of the 20 fabrics were measured using KES-FB and FAST systems; subsequently, fabric formability (F) and total appearance value (TAV) were calculated and compared with a virtual 3-D simulation silhouette by i-designer CAD system. The fabric formability of the domestic fabrics, calculated by KES-FB system, was lower than foreign fabrics, which was assumed to be caused by the stiff tactile property. The result was similar to that of the FAST system. Good wearing performance of the foreign worsted fabric was assumed to be caused by high extensibility and the compressibility of the fabrics. The TAV's of the domestic fabrics were also lower than foreign fabrics. Both the correlation between TAV and formability by the KESFB system and the correlation between TAV and formability by FAST system showed a good correlation coefficient. Fabric formability between KES-FB and FAST systems also showed a good correlation. The 3-D simulation silhouette of the foreign fabric by i-designer CAD system appeared superior to the domestic one, and assumed to be attributed to the low extensibility of the weft direction, stiff bending and high shear properties of the fabric.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.24 no.7
• /
• pp.1015-1024
• /
• 2000

The purpose of this study is 1) to analyse the bending property of the fused fabric and each component of the fused fabrics. 2) to examine the effect of fusing temperature on the bending property of the fused interlining and fused fabrics. 3) to examine the changes of B/W, 2HB/W and TAV of the fused fabrics according to the types of face fabric, interlining, fusing temperature. Five types of wool fabric, four types of shingosen fabric and four types of interlining were used for this study. The fusing condition in this study were the three types of fusing temperature of 10$0^{\circ}C$, 12$0^{\circ}C$, 14$0^{\circ}C$, the pressure of 4 kgㆍf/$cm^2$, and pressing time of 12 seconds. The results obtained from this study were as follows. 1) The bending rigidities and hysteresis of fabrics after fusing were increased. The bending behavior of fused fabrics were governed by the bending behavior of face fabric and interlinings and $\alpha$$_{B}$ values. 2) The KES standardized basic values of B/W and 2HB/W were increased after fusing. The B/Ws of fused fabrics were mainly determined by the $\alpha$$_{B}$ values of interlinings. The 2HB/Ws of fused fabrics seemed to be controlled by the fusing temperature. 3) The changes of TAVs of wool fused fabrics differed from those of shingosen fused fabrics. As the $\alpha$$_{B}$ values of fabric were larger and fusing temperature were increased, the TAVs of wool fused fabrics were smaller though those of shingosen fused fabrics were larger. 4) The TAVs of fused fabrics were highly correlated with the B/Ws of fused fabrics. In the case of wool fused fabrics, the TAVs of fused fabrics were negativly correlated with the 2HB/Ws of wool fabrics and used interlinings.nings.

• Applied Biological Chemistry
• /
• v.43 no.1
• /
• pp.67-71
• /
• 2000

Termiticidal activities of Chamaecyparis obtusa were quantitatively evaluated, and the activity differences between supporting materials such as woodmeal and filter paper or between species were defined based on the termiticidal activity value(TAV). It was found that TAV was high in the following order ; C. obtusa>Litsea coreana>C. obtusa var. formosensis>Ternstroemia gymnanthera. In particular, termiticidal activity of C. obtusa heartwood was stronger by 5 to 9 times than that of other three species. Median survival dosage(MSD) of C. obtusa was 108.8 mg. In case of woodmeal or filter paper tests with C. obtusa, termiticidal activities were inversely proportional to logarithms values of an added sample weight and median survival time(MST). The difference of termiticidal activities between woodmeal and filter paper in the methanol extracts was small, but that in the neutral fraction was enormous as 3.21 times. However, termiticidal activity of neutral fraction was corresponded to 17 to 53% of original woodmeal, and 47 to 83% of termiticidal activity was considered as a loss in test process.