• Elastomers and Composites
• /
• 제52권1호
• /
• pp.59-68
• /
• 2017

The effect on the hydrolysis resistance properties by the addition of maleic anhydride grafted EMDM (MA-g-EPDM) and PP (MA-g-PP) to a PA66/GF composite was investigated with respect to the mechanical properties, thermal properties, and morphology. The degree of hydrolysis of the PA66/GF composite was measured using py-GC/MS analysis. When compared to the PA66/GFcomposite in MEG/water solution, the composites where MA-g-EPDM and MA-g-PP were added to PA66/GF showed a higher degree of hydrolysis resistance, impact strength, and thermal properties, whereas their tensile strength, tensile modulus, flexural strength and flexural modulus decreased. As immersion time in the solution increases, the rate of tensile strength drop of the MA-g-PP added composite appeared lower than that of the PA66/MA-g-EPDM/GF and PA66/GF composites. The py-GC/MS analysis confirmed the formation of PA66 hydrolysis reaction by products such as carboxylic acid and alkylamine with increasing immersion time.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 춘계학술대회논문집A
• /
• pp.103-108
• /
• 2000

Since the ceramic/metal joint material is made at a high temperature, the residual stress development when it is cooled from bonding temperature to room temperature due to remarkable difference of thermal expansion coefficient between ceramic and metal. As residual stress at ceramic/metal joints influences the strength of joints, it is important to estimate residual stress quantitatively. In this study, it is attempted to estimate joint residual stress of $Si_3N_4/STS304$ joints quantitatively and to compare the strength of Joints. The difference of residual stress is measured when repeated thermal cycle is loaded under the conditions of the practical use of the ceramic/metal joint. And 4-point bending test is performed to examine the influence of residual stress on fracture strength. As a residual it is known that the stress of joint decreases as the number of thermal cycle increases.

• 한국건축시공학회지
• /
• 제2권1호
• /
• pp.163-169
• /
• 2002

In this study, there are kind of property experiments like fluidity, compressive strength, bleeding measurement, concrete sink for CFT use high fluidity concrete. The property difference between before transmit and after transmit concrete in the mock up test with ready mixed concrete equipment is examined. The variable factors in mock up are diaphragm existence and nonexistence, diaphragm placing hole sizes. To investing the concrete Property under diaphragm, concrete packing ability, hydration heat, core specimen strength tests are performed.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2016년도 춘계 학술논문 발표대회
• /
• pp.109-110
• /
• 2016

The recent introduction of Metal spraying method apply to construction and civil steel structure is increasing. In applying the metal spraying lining process of construction and civil steel structure to secure the adhesion strength between the metal thermal spray coating and the steel structure and the highest priority requirements are required bond strength test reliable measurement accordingly. In this study, by calculating the deposition intensity and the standard deviation, coefficient of variation corresponding to the bonding area, unlike the shape of the attachment we compared the results.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1991년도 가을 학술발표회 논문집
• /
• pp.107-112
• /
• 1991

The object of this study is to investigate material characteristics and flexural behavior of high strength concrete. Principal causes of variations of high compressive strength include the strength-producing capabilities of cement and silica hume. Compressive strength of 1200 kgf/$\textrm{cm}^2$ is introduced for identifying the effect of the variation of the size of porocity and alternative method of measurement, Acoustic Emition method, is applied to examine the phenominon of concrete failure. The main test variables in the beam element are tensile steel ratios, presence of shear reinforcement, and change of steel shape. The estimation of stress block in the flexural test of this element tends to support the present theory and may suggest a desirable shape of the stress block.

• 한국세라믹학회지
• /
• 제11권3호
• /
• pp.3-13
• /
• 1974

In order to clarify, factors affecting on mechanical strengthof porcelain bodies, some experiments were carried out for bobies consisting of Hadong kaolin, quartz of optical glass grade and potash-feldspar. At first, degree of vitrification of the fired bodies were examined from the results of bulk density measurement. Constituent minerals of these fired bodies were mainly examined by means of X-ray diffraction, and their microstructure were observed by means of the polarization microscope and scanning electron microscope. Transverse and impact strength of the bodies were also determined. Finally, relations between their mechanical strength and the other properties obtained were discussed. The mechanical strength, at least the transverse strength increased with increasing densification of the bodies and accompanied with an increase of stress produced in the quartz grains and, perhaps other phases composing the bodies.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.484-487
• /
• 2000

This study is for assessing a reliability of diagnostic device through comparing diagnostic results to ACDB strength. The dielectric diagnosis using IRC (isothermal relaxation current) measurement was carried on service-aged cables. From this study, there was little correlation between dielectric diagnosis and ACBD strength in long distance cables. But the correlation between them showed in short distance below 200 m. Therefore, it is desirable to diagnose the URD cables in short distance.

• 한국소음진동공학회논문집
• /
• 제23권11호
• /
• pp.1020-1026
• /
• 2013

An accurate railway environmental noise prediction model is required to make the proper solution of the railway noise problems. In this paper, an engineering model for predicting the noise of conventional passenger cars is presented considering the acoustic source strength in octave-band frequencies and the propagation over grounds with varying surface properties. Since the formation of a train can be variable, the source strength of each locomotive and passenger car was estimated by measuring the pass-by noise and analysing the wheel-rail rolling noise. Some validation cases show on the average small differences between the predictions of the present model and the measurement results.

• 대한통합의학회지
• /
• 제11권1호
• /
• pp.121-130
• /
• 2023

Purpose : This study aimed to investigate the effect of blood flow restriction exercise on ankle muscle strength and balance ability to achieve maximum efficiency with the same exercise intensity and time. Methods : Twenty-six adults are randomly assigned to experimental group (n=13) and comparison group (n=13). The experimental group performed ankle joint strength exercises with blood flow restriction applied while the comparison group performed ankle joint strength exercises without blood flow restriction applied three times a week for four weeks. The digital muscle measurement, Y-balance test, and Cumberland ankle instability tool were used to evaluate the subject's muscle strength, dynamic balance, and ankle instability index before and after the intervention. Results : In within-group comparison muscle strength, all the two groups showed significant improvements post intervention (p<.05). In between-group comparison, there was significant difference in the change of dorsiflexion, eversion strength pre and post intervention (p<.05). but plantarflexion was no significant difference between pre and post intervention in the group comparison (p>.05). In within-group comparison dynamic balance, all the two groups showed significant improvements post intervention (p<.05). In between-group comparison, there was no significant difference in the change of Y-balance score pre and post intervention (p>.05). In within-group comparison ankle instability index, all the two groups showed significant improvements post intervention (p<.05). In between-group comparison, there was no significant difference in the change of CAIT score pre and post intervention (p>.05). Conclusion : The results of this study show that ankle joint strength exercise improved the strength and balance ability of those complaining of chronic ankle instability, and ankle joint strength exercise applied with blood flow restriction was more effective in dorsiflexion and eversion strength exercise than ankle joint strength exercise without blood flow restriction.

• 한국인터넷방송통신학회논문지
• /
• 제10권5호
• /
• pp.277-286
• /
• 2010

본 논문에서는 다가올 초고속 무선 서비스의 핵심 서비스 중의 하나로 부각되고 있는 UWB 무선통신 시스템에서 광대역 저출력 주파수 특성의 방사출력 측정방법에 대하여 연구하였다. UWB 시스템의 측정환경에서는 RMS 전계강도 측정, UWB PSD 측정, 검출 가능한 UWB 신호레벨, UWB 천이신호 수집 등에 대해서 언급하였다. 또한, CIDPR16-1에서 언급한 축력 측정법에 대해 분석하였으며 저 준위 e.i.r.p 복사 측정법에 대해 세부적으로 분석하였다. 마지막으로는 신호분석기를 이용하여 측정시의 고려사항에 대해 서술함으로써 UWB 시스템 상용화에 필요한 방사출력 측정에 필요한 내용을 마무리하였다.