• 한국해양학회지
• /
• v.25 no.1
• /
• pp.36-48
• /
• 1990

This study was carried out to obtain some informations on the species composition and distribution pattern of Polychate community on the continental shelf and slope area in the East Sea. Fauna samples were collected from three sampling cruises in April of 1985, and April and October of 1987. Total 112 polychaete taxa included in 36 families were collected. Dominant species in the study area were Chaetozone setosa, Aglaophamus malmgreni, Ampharete arctica Terebellides horikoshii, Tharyx sp., and Magelona pacifica. Northern and cold water species were major contributors of polychaete communities in this study area. Dominant species showed their specific depth ranges from shelf area to upper slope and middle slope depth. The overall density was 300 indiv./m$\^$2/ and species richness was around 12 species/0.2m$\^$2/. Significant changes in mean polychaete density and species richness along depth gradient were found approximately at 600 m or deeper depth. Among physical factors, water depth, temperature and clay content, mean grain size were significantly correlated with the mean density of dominant species.

• Journal of Korea Water Resources Association
• /
• v.47 no.12
• /
• pp.1177-1185
• /
• 2014

This study suggests a new hydrostatic pressure distribution corrected for nonuniform flow over a channel of large slope. For analyzing shallow-water flows over large slope accurately, it is developed a finite-volume model incorporating the pressure distribution to the shallow water equations. Traveling speed of the hydraulic jump downstream a parabolic bump in the drain case is quite reduced by the weakened bottom gradient source term in the model with the pressure correction. In simulating the dam-break flow over a triangular sill, it is identified that the model with pressure correction could capture the water surface by the digital imaging measurements more than the model without that. Due to the pressure correction decreasing the reflected flows on and increasing overflows over the sill, there are good agreements in the experiment and the simulation with that. Therefore, this model is expected to be applied to such practical problems as flows in the spillway of dam or run-up on the beach.

• The Journal of Engineering Geology
• /
• v.23 no.3
• /
• pp.257-269
• /
• 2013

Prevention plans for landslide and slope disasters should be appropriate for a country's budget when considering a systematic investment plan. The systematic management of slopes adjacent to national highways should incorporate reasonable investment risk and the expected degree of damage should be calculated by considering the investment priorities. In terms of priority of investment, the major factors used to determine the degree of hazard are gradient, soil characteristics, RMR (Rock Mass Rating), stability interpretation, type of discontinuities, and history of collapse, among others. The likely consequences of slope failure can be determined by considering traffic volume, the number of lanes, and average vehicle risk. We performed such calculations regarding the priority of investment and performed a regression analysis for 392 slopes located in Yeongseo region, Gangwon province. The calculation results show that collapsed slopes have a higher priority for investment, as do slopes with a high proportion of dangerous sections and locations in valleys.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.30 no.5
• /
• pp.467-475
• /
• 2012

In this study, the problems were analyzed that derived a different position evaluation results depending on the unit grid size that are applied to the terrain slope analysis conducted to assess the its position and environmental impacts in the prior environment reviewing process of golf course construction projects. For this purpose, the unit grid size were analyzed that can precisely reflect a actual terrain by analyzing the change of a slope percentage according to the change of unit grid size about 12 golf courses is currently in progress of construction work through the environmental consultation or ongoing consultation. And the consultation availability of environmental assessment was reverified by applying the unit grid size derived through this study about a study golf course. In the result of study, the bigger grid size for slope analysis is set, the greatly gradient is changed and the slope ratio of the higher elevation was lowly evaluated in comparison with actual terrain. The analytical result that most closely match the actual terrain was extracted in the case applied $5m{\times}5m$ of the unit grid sizes setting in this study. So, we proposed this study results to the ministry of environment and could be amended the unit grid size of $5m{\times}5m$ as standard for the analysis of slope. Also, if new grid size for site evaluation is applied to the study sites, 4 sites exceed the standard suggested the existing regulations and they are not proper as golf course site in flank of environment.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.35 no.3
• /
• pp.130-139
• /
• 1993

In order to evaluate the long-term permeability performace of the geotextiles, for five different combination of geotextiles and soils the long-term column test method The results obtained are as follows; 1.The gradient range of the initial stage of the long-term permeability curves varied with respect to the soil types, while that of the final stage varied according to the interaction of the soil/geotextile system. 2.The time required for a given soil/geotextile system to reach a interactive stable stage was measured ahout 100 hours for the standard sand and 150 to 600 hours for the silty content soils, respectively. 3.There were no differences between the plain woven geotextile and the non-geotextile in the long-term permeability performance. 4.As the silt content increased, the long-term performance of the geotextiles decreased, and the limiting silt content was about 15%. 5.The thickness and area density of the geotextiles did not influence on the variation of the seepage quantities. 6.The ayerage slope and the transition time of the long-time flow curve were calculated. 7.In order to evaluate the mechanism of soil/geotextile system more perfectly, the gradient ratio test or the hydraulic conductivity test is required.

• The Korean Journal of Ecology
• /
• v.10 no.3
• /
• pp.119-127
• /
• 1987

On the east slope of the front ranges of the Colorado Rockies, USA, three species of Populus are distributed at different elevations from the Great Plains to the timberline. At elevations 1, 720m (P. sargentii), 2, 335m (P.angustifolia) and 3, 190m (P.tremuloides) chlorophyll cotents of leaves of thses dioecious trees were determined. Total chlorophyll content was in the range of 0.86-1.56mg/g leaf, increasing with elevation as a second-degree polynomial, and the peak content was estimated to be reached at about 2, 800m. Total chlorophyll content was greater in female than in male trees in the two higher elevation species, but not in P. sargentii, the low elevation species. Chlorophyll b content was greater than chlorophyll a content in the same two higher elevation species. The increase of chlorophyll b than to increase of chlorophyll a content. These phenomena appear to be the result of adaptation of these species to different environmental conditional at different elevation. Sequential distribution of plant populations on environmental gradients in such a way that variation in given plant characters paralell the environmental gradient must occur not only in ecotypes of a species, but also in different but closely related species.

• Journal of the Korean Geographical Society
• /
• v.28 no.2
• /
• pp.77-98
• /
• 1993

The intent of this study is to analyze the characteristics of distribution, patter, and deposits of the exposed debris slope landform by aerial photography interpretation, measure-ment on the topographical maps and field surveys in the southern part Taebaek mountains. It also aims to research the arrangement types of mountain slope and the landform development of debris slopes in this area. In conclusion, main observations can be summed up as follows. 1. The distribution characteristics 1)From the viewpoint of bedrocks, the distribution density of talus is high in case of the bedrock with high density of joints, sheeting structures and hard rocks, but that of the block stream is high in case of intrusive rocks with the talus line. 2)From the viewpoint of bedrocks, the distribution density of talus is high in case of the bedrock with high density of joints, sheeting structures and hard rocks, but that of the block stream is high in case of inrtusive rocks with the talus line. 2) From the viewpoint of distribution altitude, talus is mainly distributed in the 301~500 meters part above the sea level, while the block stream is distributed in the 101~300 meters part. 3) From the viewpoint of slope oriention, the distribution density of talus on the slope facing the south(S, SE, SW) is a little higher than that of talus on the slope facing the north(N, NE, NW). 2. The Pattern Characteristics 1) The tongue-shaped type among the four types is the most in number. 2) The average length of talus slope is 99 meters, especially that of talus composed of hornfels or granodiorite is longer. Foth the former is easy to make free face; the latter is easdy to produce round stones. The average length of block stream slope is 145 meters, the longest of all is one km(granodiorite). 3) The gradient of talus slope is 20~45${^\circ}$, most of them 26-30${^\croc}$; but talus composed of intrusive rocks is gentle. 4) The slope pattern of talus shows concave slope, which means readjustment of constituent debris. Some of the block stream slope patterns show concave slope at the upper slope and the lower slope, but convex slope at the middle slope; others have uneven slope. 3. The deposit characteristics 1) The average length of constituent debris is 48~172 centimeters in diameter, the sorting of debris is not bad without matrix. That of block stream is longer than that of talus; this difference of debris average diameter is funda-mentally caused by joint space of bedrocks. 2) The shape of constituent debris in talus is mainly angular, but that of the debris composed of intrusive rocks is sub-angular. The shape of constituent debris in block stream is mainly sub-roundl. 3) IN case dof talus, debris diameter is generally increasing with downward slope, but some of them are disordered and the debris diameter of the sides are larger than that of the middle part on a landform surface. In block stream, debris diameter variation is perpendicularly disordered, and the debris diameter of the middle part is generally larger than that of the sides on a landform surface. 4)The long axis orientation of debris is a not bad at the lower part of the slope in talus (only 2 of 6 talus). In block stream(2 of 3), one is good in sorting; another is not bad. The researcher thinks that the latter was caused by the collapse of constituent debris. 5) Most debris were weathered and some are secondly weathered in situ, but talus composed of fresh debris is developing. 4. The landform development of debris slopes and the arrangement types of the mountain slope 1) The formation and development period of talus is divided into two periods. The first period is formation period of talus9the last glacial period), the second period is adjustment period(postglacial age). And that of block stream is divided into three periods: the first period is production period of blocks(tertiary, interglacial period), the second formation period of block stream(the last glacial period), and the third adjustment period of block stream(postglacialage). 2) The arrangement types of mountain slope are divided into six types in this research area, which are as follows. Type I; high level convex slope-free face-talus-block stream-alluvial surface Type II: high level convex slope-free face-talus-alluvial surface Type III: free face-talus-block stream-all-uvial surface Type IV: free face-talus-alluval surface Type V: talus-alluval surface Type VI: block stream-alluvial surface Particularly, type IV id\s basic type of all; others are modified ones.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.904-909
• /
• 2004

The study area adjoins with Yangsan fault in Sangbuk-myeon, Samsam-ri, Kyongsang-namdo and consist of the natural steep slope. After drawing data layer which have altitude by using digital topography data, it is converted to lattice DEM of $10m{\times}10m$ size. From this, gradient map of unit lattice, slant direction map and shadow relif map are made. Using flow apportioning algorithm, upper slope contributing area and wetness index by established lattice can be calculated. Area that have high wetness index shows lineament structure of northwest-southeast direction, and this agrees with shear fracture system. The result of electricity specific resistance survey in the study area shows that area of high wetness index has low electricity specific resistance anomaly. That is, wetness index conforms with distribution of fractured zone that accompanied chemical weathering of rock. Therefore, wetness index can be used as the method of detecting fractured zones and judging the stability of the area.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.5 no.4
• /
• pp.1-8
• /
• 1985

Stability analysis of the embankment as to water level varation is the most important problem in the safety of the slope because the stress of embankment inside varies as to drawdown of seepage line. Especially when the water level is rapidly drawdown, because the flow direction of the free surface changes the toe of embankment, the factor of safety comes to small, therefore the embankment is dangered. For the purpose of studing these phenomena, the experimental models are built with sand in the laboratory. In the experimental consideration, the falling seepage line and the shape of failure are measured. This paper intends to study the failure slip surface, the relationship between the factor of safety and drawdown velocity, and hydraulic gradient. The results of the experimental study are summarized as follows; 1. Owing to the drawdown of free surface, sliding failure occurred in the upstream fill, the height of failure is 5~10, 9~15, and 13~21(cm) in each model. 2. In consideration of the distribution of pore water pressure Table-5 shows each factor of safety. In the relationship between the drawdown velocity and the factor of factor it's velocity should be limited to 0.21~0.28 (cm/sec), according to each models. In the relationship between the factor of safety and the hydraulic gradient within the upstream slope, it's gradient must be below 0.36~0.43.

• Journal of the Korean association of regional geographers
• /
• v.9 no.4
• /
• pp.481-492
• /
• 2003

This study aims to analyze quantitatively changes of forest and cropland landscape due to cropland increase toward higher mountain slope during 9 years from 1993 to 2002, using Landsat images and field survey in the vicinity of Manpo and Gangae cities, Jagang Province, Northwest Korea, During 9 years, cropland has increased as 49.9%, forest area decreased as 16%. The spatial characteristics of cropland changes present that average elevation of cropland are increased from 381m of 1993 year to 412m of 2002 year, and average gradient increased from $10^{\circ}$ to $13^{\circ}$. In increased area of cropland during 9 years, the average elevation is 455m, and average gradient is $15^{\circ}$ with maximum gradient $70^{\circ}$. Analysis of the patch phenomena by fragmentation of vegetation landscape show that number of patch increased from 394 to 1,241 and also values of shape index, and fractal dimension of vegetation are increased slightly, during 9 years. Croplands have developed mainly in mountain slopes of elevation between 450 to 750m. For improvement of agricultural productivity, it should be required political and social stabilization, international and South Korea's assistance, and restoration of mountain forest.