• 한국태양에너지학회:학술대회논문집
• /
• 2008.04a
• /
• pp.241-246
• /
• 2008

In this paper, we analyze the I-V curve and hot-spot phenomenon caused by solar cells' serial and parallel connected circuit. The mis-match loss of parallel interconnection with low Isc string decrease lower than serially interconnected one and temperature caused by hot-spot does. Also, mis-match loss of parallel interconnection with low Voc string increase more than serially interconnected one. The string having low Voc happened hot-spot phenomenon when open circuit. The bad solar cell in string gives revere bias to good solar cell and make hot-spot phenomenon. If we consider the mis-match loss, when designing PV module and array. the efficiency of PV system might increase.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.8
• /
• pp.1255-1259
• /
• 1990

A new ripple analog-to-digital converter (ADC) has been developed. It consists of two parallel ADCs and a switching network. The circuit operates on the analog input signal in two serial steps. First, a coarse conversion is made to determine the most significant bits by the first parallel ADC. The resultant bits control the switching network to connect a series resistor segment, within which the analog signal is contained, to the second parallel ADC. At second step, a fine conversion is made to determine the least significant bits by the second parallel ADC. The circuit requires 2(2\ulcorner\ulcorner1) comparators, 2(2\ulcorner\ulcorner resistors, and 2(2\ulcorner\ulcorner swithches for N-bit resolution.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.9 no.3
• /
• pp.323-332
• /
• 1997

It was reported by some researchers that two-stage parallel-plate ESPs, commonly called electronic air cleaners, show decreasing behavior of collection efficiency as particle size decreases below about $0.03{\mu}m$. This phenomenon is attributed to partial particle charging characteristics, where some of incoming particles are not charged in the charging cell of 2-stage parallel-plate ESP. One way to improve the decreasing collection efficieny in that particle size range is to enforce particle charging quantity in the charging cell. In the present study, in order to do this a 2-wire series-type charging cell modified from a 1-wire normal-type one was suggested and investigated theoretically and experimentally concerning improvement of the collection efficiency. It was confirmed from the experimental and theoretical works that the collection efficiency was apparently improved.

• Proceedings of the KIPE Conference
• /
• 2003.07b
• /
• pp.957-960
• /
• 2003

Many solar cell way need to be connected by series or parallel to extract the high power Especially, during parallel operation to reduce circulation current the individual converter has to share and control the load current. Generally, Current Sharing(CS) can be implemented using droop and active current sharing method. In this paper, one 3[KW] PWM converter was replaced as one 3[KW] solar cell array(3 parallels, each parallel has twenty single modules), two 3[KW] solar cell way Is Paralleled to generate 6[KW] power. Also each converter used voltage-current controller and Automatic MSCPM(Master-Slave Current-programming Method) for current sharing(AS).

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.571-573
• /
• 1988

A new ripple analog-to-digital converter(ADC) has been developed. It consists of two parallel ADCs and a switching network. The circuit operates on the input signal in two serial steps. First a coarse conversion is made to determine the most significant bits by the first parallel ADC. The results control a switching network to connect the series resistor segment, the analog signal is contained within, to the second parallel ADC. At second step, a fine conversion is made to determine the least signification bits by the second parallel ADC. The circuit requires 2(2$\frac{N}{2}$) comparators, 2(2$\frac{N}{2}$) resistors, and 2(2$\frac{N}{2}$) switches for N-bit resolution.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.57 no.2
• /
• pp.198-201
• /
• 2008

We investigated the operating characteristics of the flux-lock type superconducting fault current limiter(SFCL) with the parallel connection between the primary and secondary windings which are connected with two superconducting units in series. The parallel connection for current level increase of the flux-lock type SFCL is necessary to apply the SFCL into the power system. The resistance generated in superconducting units was dependent upon the winding direction of the primary and the secondary coils, which can reduce the power burden. The resistance of the superconducting elements in the subtractive polarity winding is higher than that of the additive polarity winding. The fault current limiting effect of the subtractive polarity winding is better than that of the additive polarity winding. From this results, we confirmed that the power capacity of the flux-lock type SFCL could be increased by the parallel connection of the superconducting units.

• Proceedings of the KIEE Conference
• /
• 2000.07d
• /
• pp.3004-3006
• /
• 2000

In this paper, we propose an optimal design method of Fuzzy-Neural Networks model with parallel structure for complex and nonlinear systems. The proposed model is consists of a multiple number of FNN connected in parallel. The proposed FNNs with parallel structure is based on Yamakawa's FNN and it uses simplified inference as fuzzy inference method and Error Back Propagation Algorithm as learning rules. We use a HCM clustering and GAs to identify the structure and the parameters of the proposed model. Also, a performance index with a weighting factor is presented to achieve a sound balance between approximation and generalization abilities of the model. To evaluate the performance of the proposed model. we use the time series data for gas furnace and the numerical data of nonlinear function.

• Journal of the Korean Data and Information Science Society
• /
• v.14 no.4
• /
• pp.837-844
• /
• 2003

In this paper, we obtain the estimator of system reliability for the bivariate Pareto model with bivariate type 1 censored data. We obtain the estimators and approximated confidence intervals of the reliability for the parallel system based on likelihood function and the relative frequency, respectively. Also we present a numerical example by giving a data set which is generated by computer.

• Proceedings of the KIPE Conference
• /
• 1999.07a
• /
• pp.97-100
• /
• 1999

AC to DC single phase PWM converter for traction application requires rated high power and voltage. Therefor, series or parallel operation converters are necessary with considering the limitation of the power device specification. This paper compares the characteristic between two parallel operation of conventional PWM converter and Single phase three level converter about comparison of power circuit, cooling system control method and harmonic current by computer simulation.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.76.5-76
• /
• 2001

This paper considers the parameter estimation for the state-space model based time-delay systems in the case that the Lyapunov stability of the system is guaranteed. In order to estimate the parameters, two estimation methods can be proposed which are known as the parallel model and the series parallel model. It is shown that the parameters can be estimated using each method, and also certied that the results are correct by simulations.