• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.9
• /
• pp.2298-2306
• /
• 2014

In this paper, we propose an open loop power control algorithm to control transmission power of the On-The-Move(OTM) Satcom terminal in GEO satellite communication environment. The proposed algorithm identifies the current channel state restricted by an obstacle or an antenna depointing loss based on the received beacon signal strength. On the basis of the determined signal attenuation causes, the OTM Satcom terminal turns off the RF output when an antenna tracking is failed. If the OTM Satcom terminal experiences a channel blockage by an obstacle, the terminal spreads the transmit data to increase data reception probability. To evaluate the performance of the proposed algorithm, we compare an adjacent satellite interference level and an outage probability. The results show the performance of the proposed algorithm is better than that of the conventional algorithm.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.3
• /
• pp.140-149
• /
• 2002

This paper describes the characteristics of beam-tilting slot away waveguide antennas for mobile DBS reception. As a basic study of slotted waveguide array, design for 16 slot elements located on a broad-wall waveguide is considered. Design parameters such as slot length, space between each slot and cross slot angle of antennas with the beam-tilting characteristics are calculated by method of moments. Based on these results, the radiation waveguide antennas with 16-element $\times$16-array are designed and fabricated. The measured main beam direction angles of the fabricated antennas are 48$^{\circ}$to 50$^{\circ}$depending on the measured frequencies and it shows good agreement with prediction. The measured 3 dB beam width of elevation pattern is about 13$^{\circ}$, and the axial ratio and the gain measured at DBS band are observed 2.8 dB below and 24 dBi above, respectively. In order to evaluate a performance of the fabricated waveguide planar antenna, it is combined with the satellite tracking control system and the field performance test of antenna mounted on a mobile vehicle is carried out at highway. During the measurement, it was possible to watch television without a break signal in a driving vehicle and an excellent performance of the proposed antennas was demonstrated.

• Journal of Broadcast Engineering
• /
• v.21 no.5
• /
• pp.803-815
• /
• 2016

In this paper, we design a direct radio frequency (RF) sampling receiver for multiband GNSS signals and demonstrate its performance. The direct RF sampling is a technique that does not use an analog mixer, but samples the passband signal directly, and all receiver processes are done in digital domain, whereas the conventional intermediate frequency (IF) receiver samples the IF band signals. In contrast to the IF sampling receiver, the RF sampling receiver is less complex in hardware, reconfigurable, and simultaneously converts multiband signals to digital signals with an analog-to-digital (AD) converter. The reconfigurability and simultaneous reception are very important in military applications where rapid change to other system is needed when a system is jammed by an enemy. For simultaneous reception of multiband signals, the sampling frequency should be selected with caution by considering the carrier frequencies, bandwidths, desired intermediate frequencies, and guard bands. In this paper, we select a sampling frequency and design a direct RF sampling receiver to receive multiband global navigation satellite system (GNSS) signals such as GPS L1, GLONASS G1 and G2 signals. The receiver is implemented with a commercial AD converter and software. The receiver performance is demonstrated by receiving the real signals.

• Korean Journal of Remote Sensing
• /
• v.23 no.2
• /
• pp.137-144
• /
• 2007

In KORDI (Korea Ocean Research and Development Institute), the KOSC (Korea Ocean Satellite Center) construction project is being prepared for acquisition, processing and distribution of sensor data via L-band from GOCI (Geostationary Ocean Color Imager) instrument which is loaded on COMS (Communication, Ocean and Meteorological Satellite); it will be launched in 2008. Ansan (the headquarter of KORDI) has been selected for the location of KOSC between 5 proposed sites, because it has the best condition to receive radio wave. The data acquisition system is classified into antenna and RF. Antenna is designed to be $\phi$ 9m cassegrain antenna which has 19.35 G/T$(dB/^{\circ}K)$ at 1.67GHz. RF module is divided into LNA (low noise amplifier) and down converter, those are designed to send only horizontal polarization to modem. The existing building is re-designed and arranged for the KOSC operation concept; computing room, board of electricity, data processing room, operation room. Hardware and network facilities have been designed to adapt for efficiency of each functions. The distribution system which is one of the most important systems will be constructed mainly on the internet. and it is also being considered constructing outer data distribution system as a web hosting service for offering received data to user less than an hour.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.4
• /
• pp.173-180
• /
• 2015

In this study, an algorithm that detects a spoofing signal for a GPS L1 signal was proposed, and the performance was verified through RF spoofing signal simulation. The proposed algorithm determines the reception of a spoofing signal by detecting a correlation distortion of GPS L1 C/A code caused by the spoofing signal. To detect the correlation distortion, a detection criterion of a spoofing signal was derived from the relationship among the Early, Prompt, and Late tap correlation values of a receiver correlator; and a detection threshold was calculated from the false alarm probability of spoofing signal detection. In this study, an RF spoofing environment was built using the GSS 8000 simulator (Spirent). For the RF spoofing signal generated from the simulator, the RF spoofing environment was verified using the commercial receiver DL-V3 (Novatel Inc.). To verify the performance of the proposed algorithm, the RF signal was stored as IF band data using a USRP signal collector (NI) so that the data could be processed by a CNU software receiver (software defined radio). For the performance of the proposed algorithm, results were obtained using the correlation value of the software receiver, and the performance was verified through the detection of a spoofing signal and the detection time of a spoofing signal.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.1
• /
• pp.215-220
• /
• 2013

In this paper, the signal reception environment of the satellite communications was analyzed on urban, suburban and rural environment. The correct analysis of received environment is very important in the satellite communications because the presence of various attenuation factors. Analyze attenuation factor through the simulation and that apply to each receiving environment. The urban and suburban various received sensitivity is determined according to building height and density. Moreover, attenuation occurs in rural areas due to the mountainous and vegetation. In this paper, we analysis of variety receiving environment according to movement of the ground station and the satellites can be utilized to provide stable multimedia services.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.1
• /
• pp.23-28
• /
• 2016

In this paper, a Multi-Band Ku-band down converter was designed for reception of multi-band digital satellite broadcasting. The Multi-band low-nose down converter was designed to form four local oscillator frequencies (9.75, 10, 10.75 and 11.3GHz) representing a low phase noise due to VCO-PLL with respect to input signals of 10.7 to 12.75GHz and 3-stage low noise amplifier circuit by broadband noise matching, and to select an one band of intermediate frequency (IF) channels by digital control. The developed low-noise downconverter exhibited the full conversion gain of 64dB, and the noise figure of low-noise amplifier was 0.7dB, the P1dB of output signal 15dBm, and the phase noise -73dBc@100Hz at the band 1 carrier frequency of 9.75GHz. The low noise block downconverter (LNB) for receiving four-band digital satellite broadcasting designed in this paper can be used for satellite broadcasting of vessels navigating international waters.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.5
• /
• pp.995-1002
• /
• 2022

Global Navigation Satellite System(GNSS) is a convenient system that acquires position and time information of a receiver if only satellite signals can be received anywhere in the world. However navigation signals include errors and a position error occurs according to the reception state of the signal. Also, a position error is affected by the geometric arrangement of the satellites. Therefore a receiver position performance varies by the number and status of visible satellites The condition of satellite signals is not good when the satellite rises or sets and the position change of receiver occurs when the signal is blocked by an obstacle such as a building in the urban area. In this paper, we proposed methods to improve the GNSS performance by using pseudorange correction method estimating the correction amount and the visible satellites selection method. By applying the proposed methods to an environment in which the number of visible satellites changes variously, the performance enhancement was verified.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.11 s.114
• /
• pp.1021-1029
• /
• 2006

In this paper, we designed and implemented a dual wideband dipole type antenna for the reception of S-DMB (Satellite Digital Multimedia Broadcasting) and 2.4/5 GHz WLAN(Wireless Local Area Network) signals. The proposed antenna based on conventional monopole type dual band antenna was implemented as planar wideband dipole type antenna with the volume of $8{\times}33.8{\times}1.68mm^3$. The proposed antenna is printed type on FR4 substrate of 1.6 mm thick and composed of a dipole type antenna for low frequency band and two symmetric structured resonance elements for high frequency band. We confirmed antenna area with dense surface current for each frequency band with simulation. By varying the length of the antenna area with dense surface current, we could vary resonance frequency of each frequency band separately. Impedance bandwidths$(VSWR{\leq}2)$ are 362 MHz(14.23 %) for 2 GHz band and 1188 MHz(22.13, %) for 5 GHz band which show wideband characteristic. Measured maximum gains were 4.33 dBi for 2 GHz band and 5.48 dBi for 5 GHz band which showed improved performance. And the implemented antenna has a good omni-directional radiation pattern characteristic.

• Journal of Satellite, Information and Communications
• /
• v.12 no.4
• /
• pp.1-10
• /
• 2017

Sudden natural disasters such as earthquakes, typhoons, heavy rainfall, etc., which come without warning, often threaten our lives and property, so it is important to spread the disaster quickly and accurately. Thus, in this paper, we present a method for the activating of FM radio receiver chip embedded in smartphone to receive disaster broadcasting in case of disaster. One is to investigate the roles and limits in a domestic disaster broadcasting system and disaster relay broadcasting by media, and the other is to present the method for the activation of smartphone FM radio receiver chip by conduct an expert survey.