• Journal of IKEEE
• /
• v.24 no.3
• /
• pp.859-866
• /
• 2020

This paper proposes a 2-ch DC-DC converter with a wide-input voltage range from 2.9V~5.6V for wearable AMOLED displays. For positive voltage V_POS, a boost converter is designed using an over-charged voltage permissible circuit (OPC) which generates a normal output voltage even if over-input voltage is applied, and a SPWM-PWM dual mode with 3-segmented power transistors to improve efficiency at light load. For negative voltage V_NEG, a 0.5x regulated inverting charge pump is designed to increase power efficiency. The proposed DC-DC converter was designed using a 0.18-㎛ BCDMOS process. Simulation results show that the proposed DC-DC converter generates V_POS voltages of 4.6 V and V_NEG voltage of -0.6V~-2.3V for input voltage of 2.9V to 5.6V. In addition, it has power efficiency of 49%~92%, output ripple voltage has less than 20 mV for load current range of 1 mA~70 mA.

• 제어로봇시스템학회:학술대회논문집
• /
• 1997.10a
• /
• pp.508-511
• /
• 1997

Recently the development of motor speed control systems with both good dynamic performance and simple implementation has been required. The vector control scheme considering flux harmonics for the permanent-magnet AC servo motor having low inertia, low weight, and high efficiency is proposed. To reduce the torque harmonics, current harmonics is employed. The vector control strategy is verified through digital simulation.

• Proceedings of the KIPE Conference
• /
• 2017.11a
• /
• pp.109-110
• /
• 2017

본 논문에서는 듀얼 액티브 브릿지에서 SPWM(Single Pulse Width Modulaton)과 DPWM(Dual Pulse Witdh Modulation)을 적용하였을 때, 인덕터 전류의 특성을 비교하고자 한다. 인덕터 전류의 특성을 이론적으로 분석하고, 실험을 통해서 결과를 분석하였다.

• Proceedings of the KIPE Conference
• /
• 2012.11a
• /
• pp.205-206
• /
• 2012

A general method to measure the inverter DC bus capacitor current is described. It is an indirect estimated method. By measuring the input and out voltage and current can calculate DC bus capacitor current. This paper will develope the theory that describes the indirect method. It will discuss and verify the feasibility of this approach through the use of the PSIM. Using SPWM control method will be simulated and compared.

• Proceedings of the KIPE Conference
• /
• 1999.07a
• /
• pp.256-259
• /
• 1999

A new PWM method for voltage source inverters is described. The switching instants determination of the proposed PWM scheme is simple. Therefore, hardware implementation with a microprocessor system is easy and high frequency operation of an inverter can be obtained. The maximum line-to-line output voltage of 3-phase inverter with the proposed scheme is larger than that of the SPWM inverter under a linear modulation region. Principle of the proposed PWM method is described and harmonic characteristic analysis is carried out.

• Proceedings of the KIPE Conference
• /
• 1998.10a
• /
• pp.159-164
• /
• 1998

This paper proposes a SVPWM (space vector pulse width modulation) strategy for a multi-level voltage source inverter. This strategy is easily implemented as SPWM (sinusoidal pulse width modulation) and has the same DC-link voltage utilization as general SVPWM. The method to keep the voltage balancing of DC-link also is proposed by the analysis model of DC-link voltage fluctuation. The usefulness of the proposed SVPWM is verified through the simulation.

• Proceedings of the KIPE Conference
• /
• 2013.07a
• /
• pp.382-383
• /
• 2013

본 논문에서는 대용량 3상 전류형인버터의 효율향상을 위해 스위칭손실을 저감시킬 수 있는 3단계 스위칭시퀀스 기반 SVPWM 제어기법을 제안하고, 기존 SPWM 혹은 SVPWM 제어기법과 비교/검토하여 시뮬레이션 해석을 통해 유효성을 검증한다.

• Proceedings of the KIPE Conference
• /
• 2015.11a
• /
• pp.145-146
• /
• 2015

본 논문은 3상 T-type 3-레벨 인버터의 중성점 전압 제어를 위한 예측제어에 관한 연구이다. 최근 인버터의 효율 향상 등의 장점으로 멀티레벨 인버터가 주목받고 있다. 모델예측제어 방식은 물리적 입력 상태를 반영하여 최적의 성능을 제공할 수 있는 제어기법이다. 3-레벨 인버터에서는 전압벡터의 개수가 많아 예측제어기법을 적용하기에는 계산시간이 오래걸리는 단점이 있다. 본 논문에서는 SPWM 방식에 예측저어를 통해 offset 을 주는 방식으로 DC-link단 중성점 전압제어를 하였다.

• Journal of Energy Engineering
• /
• v.12 no.2
• /
• pp.154-163
• /
• 2003

Grid connection essentially requires a wind energy conversion system (WECS) to not only supply adequate power responding to constantly varying wind speed but also provide a specified level of voltage magnitude and frequency that is acceptable in the electric power network. To satisfy such requirements, appropriate control schemes of a wind turbine to be connected to the power grid should be employed. This paper presents an output control strategy of a grid-connected wind power generation, which consists of a fixed-pitch wind turbine, a synchronous generator and a AC-DC-AC component with a voltage source inverter built in, and performs modelling and analysis of the strategy using PSCAD/EMTDC, an electromagnetic transient analysis software. Real power output control of the voltage source inverter is implemented to extract the maximum energy from wind speed inputted through wind blades and reactive power control, to keep the terminal voltage of WECS at a specific level. SPWM switching method is used to reduce the harmonics and maintain 60 ㎐ of the output frequency. The wind turbine performance and output corresponding to wind variation and the terminal load change is simulated and analysed.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.3 no.4
• /
• pp.365-374
• /
• 1998

The SHE(Selected Harmonic Elimination) PWM scheme which eliminates specific lower order harmonics can generate h high quality output waveforms in 3-level PWM inverters. However. its application has limited since SHE switching a angles cannot be calculated on-line by a microprocessor-implemented control system. Based on off-line optimization. in which multiple SHE solutions were found and analysed for 2 to 5 switching angles per quarter in the 3-level SHE PWM pattern. this paper presents an algebraic algorithm for an ordinary microprocessor to calculate approximate SHE S switching angles on-line with such high resolution that it makes no practical difference between the accurate and the a approximate SHE switching angles. By employing the variable of the dc-link voltage Vdc' the proposed SHE PWM p pattern can ideally compensate the dc input fluctuation together with selected harmonics eliminated.