• Journal of the Society of Disaster Information
• /
• v.17 no.3
• /
• pp.617-626
• /
• 2021

Purpose: The purpose of this study is to evaluate the fire srpead risk of building exterior and roofing materials due to the firebrand of forest fire occurring in the urban areas. Method: In order to achieve this research purpose, by selecting building materials used for exterior and roofing materials of buildings, the time to ignition, total heat release, and heat release rate were investigated, and a forest fire firebrand system was established to the possibility of fire spread was confirmed. Result: As a result of the cone calorimeter test, the roofing material had a similar or faster ignition time due to radiant heat compared to the exterior material with the steel plate exposed to the outside, and showed a higher heat release rate and total heat release than the exterior material. Although it was affected by the flammable material, it was confirmed that it did not spread easily due to the limited amount of combustible material, and carbonization marks appeared inside. Conclusion: The cone calorimeter test method has been shown to be useful in understanding the combustion characteristics of building materials by radiant heat, but the fire spread due to a firebrand in a forest fire is directly affected by the flame due to the ignition of surrounding combustibles, so finding a direct correlation with the cone calorimeter method is difficult. It is judged that the roof material may be more vulnerable to the spread of fire due to the fire than the exterior material.

• Journal of Conservation Science
• /
• v.37 no.2
• /
• pp.90-100
• /
• 2021

Outdoor cultural buildings and their accessories receive different amounts of solar radiation depending on their location's latitude, azimuth, and tilt. Shading is also affected by the surrounding terrain and objects, necessitating individual and quantitative shading analysis. In July 2019, this study conducted a shading analysis on the tops, midpoints, and bottoms of wooden pillars in the azimuth of Cheongpunggak, a traditional building in South Korea's National Research Institute of Cultural Heritage. The shading analysis found that the solar access/shade predicted by the solar trajectory meter was 30 minutes slower than measured in the field. The highest solar access and solar radiation levels came from the south, followed by the west, east, and north. The pillars' bases received the highest solar access and solar radiation, followed by their midpoints and tops. Solar access was high at tilt 90°, but solar radiation was high at tilt 0°, due to the light-collection efficiency and the irradiance. Shading on the pillars' tops was caused by the roof eaves, while shading on the midpoints and bases were affected by the surrounding pillars, topography, and other objects. Simultaneous solar access at the tops, midpoints, and bottoms was possible for 365 days for the northwest, west, and southwest pillars but only from October to March for the south and southeast pillars.

• Journal of the Korea Convergence Society
• /
• v.9 no.11
• /
• pp.263-269
• /
• 2018

Asan Oeam village is a town that has been formed since about 500 years ago. It is a folk village centered on Yean Lee and designated as National Folk Cultural Property No. 236. However, the original shape of the thatch, which has regional characteristics, is disappearing. Therefore, I want to study the architectural characteristics of the house which is well preserved in the original shape. The Genjaegotaek is located in the center of the Oeam village. The composition of the house consists of a Munganchae, Salangchae, Anchae, Sadang. The Anchae is an 'ㄱ' shaped house, and it is shaped like a 'ㅁ' which is opened by facing. The wide yard in front of the Salangchae is made of strangely shaped rocks, a hundred-year-old pine, old pagodas, ponds, pavilion. Outside the main gate, there is an 'ㅡ' shape thatch on the west. The Galabjib of Geonjaegotaek is a servant house, and the shape is a ㄱ type. The plane remained well in its original shape, thatch is consisting of a kitchen-room-daecheong maru-room. A Galabjib of Geonjaegotaek can not represent all the thatch of a Oeam village. However, it is expected that this study will be used as a basic data when the study by the thatch in this area is conducted through the analysis of the type.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.37 no.3
• /
• pp.143-156
• /
• 2019

The purpose of this study is to examine whether the Sinseo Innovation City of Daegu has been eco-friendly developed by analyzing changes in NDVI (Normalized Difference Vegetation Index) and LST (Land Surface Temperature) and conducting field surveys. Using Landsat satellite images, it compares NDVI and LST changes between the years of 2008 and 2018. The results of the study are as follows. First, the NDVI has decreased by 0.07 and the zLST has increased by $0.85^{\circ}C$ over the past 10 years. Second, districts with lower NDVI and higher zLST were concentrated with infrastructure with impermeable materials. Districts with higher NDVI and lower zLST were utilized urban design techniques such as permeable parking lot, green roof, and permeable pavement. Third, districts with higher NDVI and lower zLST were applied eco-friendly planning items properly by district unit plan guideline. It is meaningful to suggest planing directions and urban planning elements considering the environmental friendly development.

• Korean Journal of Heritage: History & Science
• /
• v.47 no.2
• /
• pp.68-84
• /
• 2014

The royal tombs of Baekje(백제), after the transfer of the capital to the Geumgang(riv)(금강) basin, changed to Songsanri(송산리) style(stone chamber) ${\rightarrow}$ Southern dynastic(남조) style(brick chamber) ${\rightarrow}$ Neungsanri(능산리) style(stone chamber). The most special feature of this process is the change of the ceiling structure. The ceiling had been changed from dome(Songsanri style) ${\rightarrow}$ tunnel ceiling(transition period of brick tombs and Neungsanri style) ${\rightarrow}$ a roof style(is Neungsanri style of three imitate type, trapezoid, triangle, flattened ceiling). The most special feature among this process is Neungsanri style(stone chamber), created especially in Baekje. The royal tombs of Baekje didn't lay stress on the mound, so the mound is not noticeable. It is result that they more stressed on basin of the boundary than showed off individual tomb, and this is count as an element of China Southern dynasty. Boundary of the royal tomb of Baekje, after the transfer of the capital to south, were changed from royal family's boundary to single independent's. Those are Songsanri's and Neungsanri's, these are the pair tombs(쌍릉) of Iksan(익산). That is influence of the Southern dynasty, reflect the theory of divination based on topography completely, this is influence of the China Sui(수) and the early Tang(당) dynasty's system of boundary of the royal tomb. Besides the royal tomb, they also buried a closely related person, in the boundary of the royal tomb. And facilities for memorial ceremony were existed too. An altar was equipped in Songsanri's boundary of the royal tomb, it was seen a kind of character of a sanctuary for progenitor. Neungsanri's boundary of the royal tomb were equipped with an open-aired altar that performed memorial ceremony about communal royal tombs, and also equipped a temple, was needed to pray for the happiness of the dead. This structure and arrangement are very similar to Seoakdong(서악동) of Silla(신라).

• Geomechanics and Engineering
• /
• v.17 no.4
• /
• pp.333-342
• /
• 2019

Geological dynamic hazards during coal mining can be caused by the failure of a composite system consisting of roof rock and coal layers, subject to different loading rates due to different advancing velocities in the working face. In this paper, the uniaxial compression test simulations on the composite rock-coal layers were performed using $PFC^{2D}$ software and especially the effects of loading rate on the stress-strain behavior, strength characteristics and crack nucleation, propagation and coalescence in a composite layer were analyzed. In addition, considering the composite layer, the mechanisms for the advanced bore decompression in coal to prevent the geological dynamic hazards at a rapid advancing velocity of working face were explored. The uniaxial compressive strength and peak strain are found to increase with the increase of loading rate. After post-peak point, the stress-strain curve shows a steep stepped drop at a low loading rate, while the stress-strain curve exhibits a slowly progressive decrease at a high loading rate. The cracking mainly occurs within coal, and no apparent cracking is observed for rock. While at a high loading rate, the rock near the bedding plane is damaged by rapid crack propagation in coal. The cracking pattern is not a single shear zone, but exhibits as two simultaneously propagating shear zones in a "X" shape. Following this, the coal breaks into many pieces and the fragment size and number increase with loading rate. Whereas a low loading rate promotes the development of tensile crack, the failure pattern shows a V-shaped hybrid shear and tensile failure. The shear failure becomes dominant with an increasing loading rate. Meanwhile, with the increase of loading rate, the width of the main shear failure zone increases. Moreover, the advanced bore decompression changes the physical property and energy accumulation conditions of the composite layer, which increases the strain energy dissipation, and the occurrence possibility of geological dynamic hazards is reduced at a rapid advancing velocity of working face.

• Journal of Conservation Science
• /
• v.34 no.6
• /
• pp.503-515
• /
• 2018

Stupa of State Preceptor Jigwang at Beopcheonsa temple site, Wonju, was conserved and restored in 1957. It was necessary to assess the degree of damage to the used mortar and to provide objective data on the necessity of its removal. Therefore, the HCP(half-cell potential) measurement used in concrete fields was applied. Multi-regression analysis of HCP data, following the rapid corrosion test of the roofstone mortar used by the rebar, resulted in a high correlation of HCP values(0.86), depending on the amount of corrosion and cover depth used for the steel bar. As a result, high correlation values(0.86) for the coefficients of determination were derived. The showed that the measurement of the wet conditions -431 to -663 mV on the roofstone indicated a corrosion damage rate of 90% or more after removal and restoration.

• Korean Journal of Heritage: History & Science
• /
• v.45 no.1
• /
• pp.70-85
• /
• 2012

Uiseong Tamni-ri Five-storied Stone Pagoda is composed of andesitic tuff and partially combined with tuff breccia and fine-grained granite. The andesitic tuff is identical to basement rock of Geumseongsan Mountain based on lithological, mineralogical and geochemical characteristics. The pagoda has suffered physical weathering such as crack and scaling, discoloration and biological colonization with complex reaction. Expecially, dark gray and brown discoloration appeared whole over the surface of the pagoda, and three to five-layered exfoliation and granular disintegration dominantly occurred in the fourth and fifth roof stones. It is assuming that the stone elements of the pagoda are evaluated as third to forth grades (average third grade) of weathering compared to fresh rock in Geumseongsan Mountain. The physical strength of the stone elements shows low values in the south and west sides of the pagoda that corresponds high weathering degree of the west side due to exfoliation, crack and granular disintegration. It is necessary to investigate the pagoda for precise deterioration assessment, monitoring and conservation treatment.

• Korean Journal of Heritage: History & Science
• /
• v.49 no.1
• /
• pp.68-83
• /
• 2016

Pan-jang(板墻) has become the lost facility, and the examples of its original form can be found no more due to its variable material characteristics. In order to study panjang as a lost facility, the following are needed: - To bring to light its usage and examples. - To investigate its components and structure. Panjang refers to the wall made of wooden plate and is classified as a special wall according to its material characteristics. In addition, Chinese mokyeongbyuk(木影壁) and Japanese panbyeong(板?) are similar to Korean panjang in terms of the materials, but there are clear differences in their structures. Panjang was also transformed into various types according to their materials or forms. As the wooden elements of panjang, sinbang(信防), pillars, do-ri(道里), jungbang(中枋), inbang(引枋), parn(板), dae(帶), choyeop(草葉), bangyeon(方椽), gaeparn(蓋板), pyeonggodae(平高臺), and yeonharm(椽檻) were selectively used, and they are similar, in particular, to the components of ilgakmoon(一角門). The stylobate of panjang is largely classified into three according to the kinds and structures of the wooden elements; and its frame into two according to whether sanginbang(上引枋) is used or not. The materials for the roof area include planks(蓋板) and tiles and have the distinct structural differences according to each material.

• Korean Journal of Heritage: History & Science
• /
• v.37
• /
• pp.349-369
• /
• 2004

Today, in the cultural properties research, there are several methods for knowing the culture of the past through a lot of information that remains and relics contain. Especially, statistical method like presumption of producing center were introduced from computer development at the early 20th century. This study showed the characteristic about firing historic sites presumed as a tile-kiln in the remains of Cheonwang temple sites, Hanam, Gyeonggi province. Also, I used nature scientific methods for correlation between tiles excavated at historic sites and circumference building and obtained there results as follows. First, soft tile parts showed similar water suction ratio(over 10%) like another tiles, except hard tile parts. Second, identification about mineral crystallization in a sample showing low water suction ratio confirmed a result that Mullite, Tridymite, Cristobalite as high temperature crystal form were presented. I know that firing temperature was higher than the other tile parts from this result. Third, statistical analysis from micro-component resulted that tiles excavated at firing historic sites and Cheonwang temple sites were closely connected. As the results, I knew that the tiles got a supply after the establishment of tile-kiln, not at a long distance at the period of Cheonwang temple construction.